Material Safety Data Sheet

Transcription

1 Material Safety Data Sheet Revision Number: Issue date:06/01/14 1. PRODUCT AND COMPANY IDENTIFICATION Product type: Coating Item number: Region: United States Company address: Contact information: Glaze 'N Seal Telephone: E. McDurmott Street Suite C Emergency telephone: Irvine, CA HAZARDS IDENTIFICATION EMERGENCY OVERVIEW HMIS: Physical state: Liquid HEALTH: 2 Color: Clear FLAMMABILITY: 3 Odor: Characteristic PHYSICAL HAZARD: 1 WARNING: FLAMMABLE LIQUID AND VAPOR. VAPOR MAY CAUSE FLASH FIRE. HARMFUL IF SWALLOWED OR INHALED. MAY CAUSE EYE, SKIN AND RESPIRATORY TRACT IRRITATION. Personal Protection: See MSDS Section 8 Relevant routes of exposure: Skin, Inhalation, Eyes, Ingestion Potential Health Effects Inhalation: Skin contact: Eye contact: Ingestion: Existing conditions aggravated by exposure: Inhalation of vapors or mists of the product may be irritating to the respiratory system. Prolonged or repeated skin contact may cause skin irritation or allergic skin sensitization reaction. This product is severely irritating to the eyes. Prolonged eye contact may cause severe eye damage. Harmful if swallowed. See Section 11 for additional toxicological information. 3. COMPOSITION / INFORMATION ON INGREDIENTS Hazardous components CAS NUMBER % p-chloro-a,a,a-trifluorotoluene Propenoic acid, 2-methyl-, polymer with butyl 2-methyl- 2-propenoate and methyl 2-methyl-2-propenoate Acetone Xylenes Ethylbenzene FIRST AID MEASURES Inhalation: Skin contact: Move to fresh air, consult doctor if complaint persists. Rinse with running water and soap. Remove contaminated clothes. Page 1 of 5

2 Eye contact: Ingestion: Immediately flush eyes with water for at least 15 minutes, while holding eyelids open. Seek medical attention at once. Immediate medical treatment necessary. Give one to two glasses of water or milk. Do not induce vomiting. 5. FIRE FIGHTING MEASURES Flash point: Autoignition temperature: Flammable/Explosive limits - lower: Flammable/Explosive limits - upper: Extinguishing media: Special firefighting procedures: Unusual fire or explosion hazards: Hazardous combustion products: 1.67 C (35.01 F) 2.5 % (Acetone) 12.8 % (Acetone) Carbon dioxide, foam, powder Wear self-contained breathing apparatus. Formation of toxic gases is possible during heating or in fires. Oxides of carbon. Hydrofluoric acid. Hydrochloric acid. 6. ACCIDENTAL RELEASE MEASURES Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Environmental precautions: Clean-up methods: Dispose of according to Federal, State and local governmental regulations. Do not empty into drains / surface water / ground water. Wipe up using absorbent material 7. HANDLING AND STORAGE Handling: Storage: Avoid skin and eye contact. Ventilate working rooms thoroughly. Avoid naked flames, sparking and sources of ignition. Switch off electrical devices. Do not smoke, do not weld. Do not empty waste into waste water drains. Keep out of the reach of children. Keep container closed. For safe storage, store at or below C (248 F) For information on product shelf life, please review labels on container or check the Technical Data Sheet. 8. EXPOSURE CONTROLS / PERSONAL PROTECTION Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure controls and protective equipment for each task performed. Hazardous components ACGIH TLV OSHA PEL AIHA WEEL OTHER p-chloro-a,a,a-trifluorotoluene 2-Propenoic acid, 2-methyl-, polymer with butyl 2- methyl-2-propenoate and methyl 2-methyl-2- propenoate Acetone Xylenes Ethylbenzene None 500 ppm TWA 750 ppm STEL 100 ppm TWA 150 ppm STEL 20 ppm TWA None 1,000 ppm (2, ppm ( ppm (435 Engineering controls: Page 2 of 5

3 Respiratory protection: Eye/face protection: Skin protection: Not normally required. Observe OSHA regulations for respiratory use (29 CFR ). Wear protective goggles in event of spray hazard. Butyl, Neoprene, PVC or Nitrile gloves recommended. 9. PHYSICAL AND CHEMICAL PROPERTIES Physical state: Color: Odor: Odor threshold: ph: Vapor pressure: Boiling point/range: Melting point/ range: Specific gravity: Vapor density: Flash point: Flammable/Explosive limits - lower: Flammable/Explosive limits - upper: Autoignition temperature: Not Evaporation rate: Solubility in water: Par Partition coefficient (n-octanol/water): VOC content: Liquid Clear Characteristic 1 at 20 C (68 F) 1.67 C (35.01 F) 2.5 % (Acetone) 12.8 % (Acetone) available tially soluble < 100 g/l 10. STABILITY AND REACTIVITY Stability: Hazardous reactions: Hazardous decomposition products: Incompatible materials: Conditions to avoid: Stable Will not occur. Oxides of carbon. Hydrofluoric acid Hydrochloric acid. Keep away from sources of ignition and naked flames. 11. TOXICOLOGICAL INFORMATION Hazardous components NTP Carcinogen IARC Carcinogen OSHA Carcinogen (Specifically Regulated) p-chloro-a,a,a-trifluorotoluene No No No 2-Propenoic acid, 2-methyl-, polymer with butyl 2-methyl-2-propenoate and methyl No No No 2-methyl-2-propenoate Acetone No No No Xylenes No No No Ethylbenzene No Group 2B No Hazardous components p-chloro-a,a,a-trifluorotoluene 2-Propenoic acid, 2-methyl-, polymer with butyl 2-methyl- 2-propenoate and methyl 2-methyl-2-propenoate Acetone Xylenes Ethylbenzene Health Effects/Target Organs Adrenals, Blood, Central nervous system, Immune system, Irritant, Kidney, Liver, Lung, Skin, Thyroid No Records Blood, Central nervous system, Irritant, Reproductive Cardiac, Central nervous system, Irritant, Kidney, Liver Irritant, Central nervous system Page 3 of 5

4 12. ECOLOGICAL INFORMATION Ecological information: No data available. 13. DISPOSAL CONSIDERATIONS Information provided is for unused product only. Recommended method of disposal: Hazardous waste number: Dispose of according to Federal, State and local governmental regulations. 14. TRANSPORT INFORMATION The shipping classification in this section are for bulk packaging only. Shipping classification may be different for non-bulk packaging as exceptions may apply. Refer to shipping documents for package specific transportation classification. U.S. Department of Transportation Ground (49 CFR) Coating solution DOT Reportable quantity: Xylene (mixed), Acetone Consumer Commodity, ORM-D. International Air Transportation (ICAO/IATA) Coating solution Consumer Commodity, ORM-D. Water Transportation (IMO/IMDG) COATING SOLUTION Consumer Commodity United States Regulatory Information 15. REGULATORY INFORMATION TSCA 8 (b) Inventory Status: TSCA 12(b) Export Notification: CERCLA/SARA Section 302 EHS: CERCLA/SARA Section 311/312: CERCLA/SARA 313: California Proposition 65: All components are listed or are exempt from listing on the Toxic Substances Control Act inventory. Formaldehyde (CAS# ). Immediate Health, Delayed Health, Fire This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. This product contains a chemical known in the State of California to cause cancer. Canada Regulatory Information CEPA DSL/NDSL Status: All components are listed on or are exempt from listing on the Domestic Substances List. 16. OTHER INFORMATION This material safety data sheet contains changes from the previous version in sections: New Material Safety Data Sheet format. Page 4 of 5

5 Prepared by: Regulatory Affairs Specialist DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Glaze 'N Seal Corporation does not assume responsibility for any results obtained by persons over whose methods Glaze 'N Seal Corporation has no control. It is the user's responsibility to determine the suitability of Glaze 'N Seal products or any production methods mentioned herein for a particular purpose, and to adopt such precautions as may be advisable for the protection of property and persons against any hazards that may be involved in the handling and use of any of Glaze 'N Seal Corporation's products. In light of the foregoing, Glaze 'N Seal Corporation specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness for a particular purpose, arising from sale or use of Glaze 'N Seal Corporation's products. Glaze 'N Seal Corporation further disclaims any liability for consequential or incidental damages of any kind, including lost profits. Page 5 of 5