MV Product Specifications

Transcription

1 MODULAR VARIABLE SPEED BLOWER CABINET 2, 3, 4, and 5 TONS FEATURES Variable Speed modular blower Supports two-stage outdoor units Dehumidification Speed: 80% Airflow Efficient low continuous fan selection: 50% Airflow Upflow, horizontal right or left applications Downflow requires sub-base accessory Electronic fan control board Adjustable Blower time delay Accepts accessory two stage outdoor thermostats Matches with AC and HP cased coils (Hot water coil may be used, but doesn t match case size) /-- supply voltage Requires a NO HEAT KIT if installed without electric heat. Field installed electric heater packages from 5kW- 25kW, single or three phase available separately SERVICE Direct drive slide-out blower assembly QUALITY Internally lined with ½ inch Tuf-Skin insulation Thermosetting powder coated steel cabinet WARRANTY 5 year parts limited warranty Product Specifications Model Nominal Tons Nominal CFM Motor HP 08004C /2 2007C /2 02C 4 0 3/ C /4 Dimensions H x W x D in (mm) 24 x 4-3/6 x 20-/2 ( x 3 x 52) 24 x 7-/2 x 20-/2 ( x 445 x 52) 25 x 2 x 20-/2 (635 x 533 x 52) 25 x 24-/2 x 20-/2 (635 x 622 x 52) Unit Weight lbs/kg Ship Weight lbs/kg 54/25 58/26 58/26 62/28 70/32 75/34 73/33 79/36 Specifications subject to change without notice. X00746 Rev.A May 202

2 UNIT SPECIFICATIONS - BLOWER COILS Model Number 08004C 2007C 02C C Application Electrical Volt - Phase - Hz. Upflow / Downflow / Horizontal * / - - Data** Minimum Circuit Ampacity Blower Data Size DD0-7 DD0-8 DD0-9 DD0-9 Transformer Time Delay Fuse (Amps) Maximum Fuse or Breaker Size Horsepower - Speed /2 - VAR /2 - VAR 3/4 - VAR 3/4 - VAR Full Load Amps Primary / Secondary - VA (- / 24 - VAC) 40 VA Weight Unit / Shipping Lbs. (Kg.) 54/58 (25/26) 58/62 (26/28) 70/75 (32/34) 73/79 (33/36) * Accessory subbase kit required for downflow application. ** Disregard if electric heat is added. Refer to Electric Heat table Dimensions and Clearances in (mm) 2-7/6 (36) 08-3/4 (400) 2 9-/4 (489) /4 (578) 20 CLEARANCES NO HEATERS ALL Sides 0 From Supply Duct. 0 Recommended Service From Front.. 20 (508mm) (Service for blower, filter if installed) 4-3/6 (3) 08 7-/2 (445) 2 2 (533) 6 24-/2 (622) () 08 & 2 25 (635) 6 & 20 WITH HEATERS ALL Sides 0 From First Three Feet of Supply Duct to Combustibles. (26mm) From Duct after Three Feet... 0 Recommended Service From Front.. 20 (508mm) (Service for blower, heaters if installed) ALL DIMENSIONS IN (MM) MODEL NUMBER IDENTIFICATION GUIDE 2 3,4 5,6 7,8 9 0 M V C M = Cased Modular Blower V = Variable Speed ECM Motor - /-- F = PSC Motor - /-- B = PSC Motor - -- TYPE 08 = = = 0 20 = 2000 NOMINAL MAX CFM 00 = No Electric Heat FACTORY INSTALLED ELECTRIC HEAT 4 = 4.5'' 7 = 7.5'' 2 = 2'' 24 = 24.5'' CABINET WIDTH Sales Digit (Major Revision) Engineering Digit (Minor Revision) 2 Specifications subject to change without notice. X00746 Rev.A

3 AIRFLOW DELIVERY (CFM) IN COOLING (EITHER A/C HP) Modular Outdoor -Stage Two-Stage Cooling Unit Unit A/C Cooling A/C Cooling - High A/C Cooling - Low Fan Only Size Size Nominal Dehum Nominal Dehum Nominal Dehum LOW MED HI ** ** ** ** NOTES:. The above airflows result with the AC/HP CFM ADJUST select jumper set on NOM. 2. Airflow can be adjusted +% or -0% by selecting Hi or Lo respectively for all modes except fan only. 3. Dry coil at volts and with 0 kw heater and filter installed. 4. Airflows shown are valid for systems with total static pressure between 0. and 0.7 in. wc. ** Unit without electric heat installed X00746 Rev.A Specifications subject to change without notice. 3

4 No Heat Kit Model EHIA00KN0* UNIT SPECIFICATIONS No Heat Kit Cabinet 08** 2** 6** 20** Volts * No Heat Kit ** Unit without electric heat installed Phase Hertz Supply circuit No. H.P. /2 /2 3/4 3/4 Maximum Motor Amps MCA Branch Circuit Ampacity Maximum Overcurrent Protection (Amps) Recommended Supply Wire 75ºC copper Ground Wire No. of Max. Ft. No. of Wire Size Wires Length Wires Wire Size (36 m) (36 m) (25 m) (25 m) 4 AIRFLOW DELIVERY (CFM) IN HEAT PUMP HEATING MODE ONLY Modular Outdoor -Stage Two-Stage Heating Unit Unit Tap HP Heating HP Heating - High HP Heating - Low Fan Only Size Size Comfort Eff Comfort Eff Comfort Eff LOW MED HI 8 D ** 24 C B A D ** 30 C B A D ** 36 C B A D ** 42 C B A NOTES:. The above airflows result with the AC/HP CFM ADJUST select jumper set on NOM. 2. Airflow can be adjusted +% or -0% by selecting Hi or Lo respectively for all modes except fan only. 3. Dry coil at volts and with 0 kw heater and filter installed. 4. Airflows shown are valid for systems with total static pressure between 0. and 0.7 in. wc. ** Unit without electric heat installed 4 Specifications subject to change without notice. X00746 Rev.A

5 ELECTRIC HEATER STATIC DROP IN. W.C. -Phase CFM EHIA05 EHIA07 EHIA0 EHIA EHIA20 EHIA Three-Phase CFM EHIA0 EHIA EHIA20 EHIA DO NOT OPERATE IN THIS AREA CFM / KW LIMIT EXCEEDED X00746 Rev.A Specifications subject to change without notice. 5

6 6 Specifications subject to change without notice. X00746 Rev.A

7 International Comfort Products, LLC Lewisburg, Tennessee 3709 U.S.A. X00746 Rev.A Specifications subject to change without notice. 7