NEW S.T.E.M. BUILDING NO

Transcription

1 PROJECT MANUAL AND SPECIFICATIONS FOR PASSAIC COUNTY TECHNICAL INSTITUTE WAYNE, NEW JERSEY NEW S.T.E.M. BUILDING NO ARCHIT ECT: COMERRO COPPA ARCHITECTS, P.C. 97 LACKAWANNA AVENUE TOTOWA, NEW JERSEY CONSTRUCT ION MA NAGER: CONSTRUCTION & MANAGEMENT CONSULTANTS CONSTRUCTION MANAGERS CCA PROJECT NO January 11, 2017

2 PROJECT MANUAL COUNTY OF PASSAIC NEW S.T.E.M. BUILDING PASSAIC COUNTY TECHNICAL INSTITUTE WAYNE, NEW JERSEY BOARD OF EDUCATION SCHOOL ADMINISTRATION ALBERT A. ALEXANDER DAMARIS M. SOLOMON SCOTT RIXFORD MICHAEL COSCIA GLENN BROWN MAE REMER GERALD S. KEEGAN. ALBERT C. BUGLIONE PRESIDENT VICE PRESIDENT COMMISSIONER/ INTERIM PASSAIC COUNTY EXECUTIVE SUPERINTENDENT OF SCHOOLS COMMISSIONER COMMISSIONER BOARD SECRETARY COUNSEL COUNSEL DIANA C. LOBOSCO RICHARD GIGLIO CHIEF SCHOOL ADMINISTRATOR PRINCIPAL BUSINESS ADMINISTRATOR ARCHITECT: COMERRO COPPA ARCHITECTS, P.C. CONSTRUCTION MANAGER: A&A CONSTRUCTION & MANAGEMENT CONSULTANTS, INC. CCA PROJECT NO. 1422

3 PROJECT DESCRIPTION 1. Project will include the construction of a new Science, Technology, Engineering and Math (S.T.E.M.) High School Academic Building at the Passaic County Technical Institute, 45 Reinhardt Road, Wayne New Jersey. The new building will be 3 levels set into a sloped site allowing for grade access on each level. The new space will include classrooms, science and engineering labs. And open learning areas and offices spaced throughout the approximately +/- 118,700 SF building. The +/- 21,700 SF lower level will be the main entrance with a new exterior canopy and will primarily contain educational spaces that connect to an exterior plaza an expanded parking lot. The +/- 40,100 SF Intermediate level connects to a new outdoor plaza and path that will connect to the existing schools FX-Wings ground floor. This level will contain a cafeteria, in addition to, classrooms and offices. The +/- 57,000 Upper Level will house classrooms, gymnasium with locker rooms and 2 large lecture rooms with an operable partition. 2. The building will be constructed of poured concrete foundations and steel frame super structure. The perimeter walls will be insulated metal panels with a cold formed metal stud back up. Aluminum windows will occur at the classroom areas with curtain walls at the entries and cafeteria. A translucent wall system is scheduled for the gym, canopies and roof skylights. 3. Interior finishes include predominately painted GWB stud wall partitions with interior glass windows and operable glass walls, wood doors with hollow metal frames with access control, LVT flooring, polished concrete flooring, carpet, Epoxy flooring and ceramic tile. Acoustical, GWB and exposed painted structure as finish will occur at ceilings, At the gymnasium maple flooring with motorized bleachers will be installed. 4. Site work includes rock removal and excavation, new storm and sanitary lines, electrical and gas utility services, as well as, additional low voltage interface between the new S.T.E.M. Building and the existing main building campus. For areas within the building pad foot print, the site was previously cleared and prepared under separate contract for the installation of the building within its footprint. PROJECT DESCRIPTION 1

4 PROJECT MANUAL TABLE OF CONTENTS TOC VOLUME 1 Table of Contents Project Description BIDDING REQUIREMENTS Instructions to Bidders AIA-A701 Supplementary Instruction to Bidders General Conditions of the Contract for Construction AIA-A232 P001 Checklist INFORMATION / FORMS FOR BID REQUIREMENTS P002 Request for Bids P003 Form of Proposal P004 Mandatory Affirmative Language P005 Non-Collusion Affidavit P006 Consent of Surety Bid Bond - AIA A310 P007 Stockholder s Disclosure P008 Ownership Declaration P009 Inspection of Site Form P010 Contractor Questionnaire/Certification P011 Intention to Sub-Contract P012 Affirmative Action Questionnaire P013 Equipment Certification P014 Qualification Form P015 Notice of Required Initial Project Manning and Information Report P016 State of New Jersey - Prevailing Wage Rates P017 Business Registration Certification and Sample P018 Public Works Contractor Registration(s) and (Sample) P019 Contractor s Qualification Statement AIA A305 P020 Iran Disclosure Form Contractor Hazardous Substance Survey State of New Jersey Form AA-201, Revised 10/03 Initial Project Workforce State of New Jersey, Form AA202 Revised 9/01 Payroll Certification for Public Works Standard Form of Agreement AIA A132 Payment Bond - AIA A312 Performance Bond AIA 312 Application and Certification for Payment - AIA G732 Application and Certification for Payment -Continuation Sheet G703 Architect s Supplemental Instructions, AIA G710 Change Order AIA G701CMa Certificate of Substantial Completion AIA G704CMa Contractor s Affidavit of Payment of Debts and Claims - G Contractor s Affidavit of Release of Liens AIA G706A Consent of Surety AIA G707 DIVISION 1 - GENERAL REQUIREMENTS 01100: Summary of Work 01210: Allowances 01230: Alternates 01250: Contract Modification Procedures 01270: Unit Prices - NONE 01290: Payment Procedures 01310: Project Management and Coordination TABLE OF CONTENTS TOC - Page 1 of 6

5 01320: Construction Progress Documentation 01322: Photographic Documentation 01330: Submittal Procedures 01400: Quality Requirements 01420: References 01500: Construction Facilities and Temporary Controls 01600: Product Requirements 01700: Execution Requirements 01770: Closeout Procedures 01782: Operation and Maintenance Data 01783: Project Record Documentation 01820: Demonstration and Training VOLUME 2 DIVISION 2 SITE CONSTRUCTION 02010: Project Survey and Layout 02201: Blasting Requirements Related Referenced Attachments Preliminary Geotechnical Investigation and Report By SESI Status Update and Geotechnical Review By SESI Geotechnical Investigation Boring Plan FIG By SESI Drawing C-3 Excavation and Grading Plan (building footprint) Last Dated 11/18/16 Prepared by Comerro Coppa Architects Drawing BP-1 Utility Boring Location Plan Dated 12/19/16 Prepared by Comerro Coppa Architects. Drawing PC-043 Partial Topographical Survey, prepared by Boswell Engineering, dated 12/20/ : Select Fill 02230: Site Clearing 02240: Dewatering 02260: Excavation Support and Protection 02270: Soil Erosion and Sediment Control 02276: Keystone Concrete Modular Retaining Walls 02300: Earthwork 02520: Portland Cement Concrete Paving 02530: Sanitary Sewer 02582: Lighting poles and Standards 02628: Cultec Recharger 280HD 02630: Storm Drainage 02631: Water Service 02632: Pipe and Pie Fittings 02741: Hot Mix Asphalt Paving 02764: Pavement Joint Sealants 02770: Concrete Sidewalks and Curbs 02821: Chain-Link Fences and Gates 02900: Landscaping DIVISION 3 CONCRETE 03251: Expansion and Control Joints 03252: Concrete Anchors 03300: Cast-In-Place Concrete 03301: Cast In Place Concrete(Limited Applications) 03600: Grout TABLE OF CONTENTS TOC - Page 2 of 6

6 DIVISION 4 MASONRY 04100: Mortar 04200: Unit Masonry Construction (Load Bearing Walls) 04201: Unit Masonry Construction 04210: Clay Unit Masonry DIVISION 5 METALS : Structural Steel Framing : Steel Joists : Steel Deck : Cold-Formed Metal Framing 05500: Metal Fabrications 05510: Metal Stairs 05515: Ladders 05521: Pipe and Tube Railings DIVISION 6 - WOOD & PLASTICS 06100: Rough Carpentry 06105: Miscellaneous Carpentry 06402: Interior Architectural Woodwork 06651: Solid Surface Fabrications DIVISION 7 - THERMAL AND MOISTURE PROTECTION 07112: Waterproofing 07160: Bituminous Damp Proofing 07190: Water Repellents 07210: Building Insulation 07222: Air Barrier/Weather Resistant Barrier 07270: Firestopping 07412: Insulated Core Metal Wall Panels Thermoplastic Membrane Roofing Adhered System 07620: Sheet Metal Flashing and Trim 07720: Roof Accessories 07841: Through-Penetration Firestop Systems 07900: Backerseal 07901: Joint Sealants DIVISION 8 - DOORS, WINDOWS AND GLASS : Door Hardware Sets : Hollow Metal Doors and Frames : Fiberglass Reinforced Polyester (FRP) Doors : Flush Wood Doors 08305: Access Doors 08330: Overhead Coiling Service Doors 08331: Coiling Fire Doors 08410: Aluminum Entrances and Storefronts 08433: Folding Glass Storefronts : Glazed Aluminum Curtain walls : Insulated Translucent Wall System : Insulated Translucent Canopy System : Insulated Translucent Skylight System : Door Hardware 08720: Thresholds and Seals : Access Control Hardware 08800: Glazing 08952: Aluminum Canopies TABLE OF CONTENTS TOC - Page 3 of 6

7 DIVISION 9 FINISHES 09260: Gypsum Board Assemblies 09271: Glass Reinforced Gypsum Sheathing 09310: Ceramic Tile 09511: Acoustical Panel Ceilings 09642: Wood Gymnasium Flooring 09650: Rubber Stair Treads and Nosing : Resilient Tile Flooring 09672: Resinous Flooring : Tile Carpeting : Sheet Carpeting : Decorative Fiberglass Reinforced Wall Panels 09911: Exterior Painting 09912: Interior Painting DIVISION 10 SPECIALTIES 10100: Visual Display Boards 10155: Toilet Compartments 10200: Louvers and Vents 10350: Flagpoles 10425: Signs 10505: Metal Student Lockers 10523: Fire Extinguishers, Cabinets and Accessories 10650: Operable Partition DIVISION 11 EQUIPMENT 11005: Equipment 11480: Physical Education Equipment : Large Venue Projection Screens DIVISION 12 FURNISHINGS 12345: Wood Laboratory Casework and Equipment 12520: Window Shades : Fixed Tables 12661: Telescoping Bleachers DIVISION 14 CONVEYING SYSTEMS 14240: Hydraulic Elevator # : Hydraulic Elevator #1 VOLUME 3 DIVISION 21 FIRE PROTECTION : Sleeves and Sleeve Seals for Fire Suppression Piping : Escutcheons for Fire Suppression Piping : General Duty-Valves for Water Based Suppression Piping : Identification for Fire Suppression Piping and Equipment : Fire Department Connections : Wet Pipe Sprinkler Systems DIVISION 22 PLUMBING : Sleeves and Sleeve Seals for Plumbing Piping : Escutcheons for Plumbing Piping : Meters and Gauges for Plumbing Piping : General Duty Valves for Plumbing Piping : Ball Valves for Plumbing Piping TABLE OF CONTENTS TOC - Page 4 of 6

8 : Check Valves for Plumbing Piping : Hangers and Supports for Plumbing Piping and Equipment : Identification for Plumbing Piping and Equipment : Plumbing Piping Insulation : Facility Water Distribution Piping : Domestic Water Piping : Domestic Water Piping Specialties : Domestic Water Pumps : Sanitary Waste and Vent Piping : Sanitary Waste Piping Specialties : Facility Storm Drainage Piping : Storm Drainage Piping Specialties : Sump Pumps : General-Service compressed-air Piping : Fuel-Fired, Domestic Water Heaters : Plumbing Fixtures : Compressed-Air Equipment for Laboratory : Chemical Waste Systems for Laboratory and Healthcare Facilities DIVISION 23 MECHANICAL : Common Work Results for HVAC : Common Motor Requirements for HVAC Equipment : Sleeves and Sleeve Seals for HVAC Piping : Escutcheons for HVAC Piping : Identification for HVAC Piping and Equipment : Testing, Adjusting, and Balancing for HVAC : Duct Installation : HVAC Piping Insulation : Direct Digital Control (DDC) System for HVAC : Facility Natural-Gas Piping : Hydronic Piping : Refrigerant Piping : Metal Ducts : Nonmetal Ducts : Air Duct Accessories : HVAC Power Ventilators : Air Terminal Units-Variable Volume : Air Cooled Condensing Units : Air to Air Energy Recovery Equipment : Central Station Air Handler A: Packaged Rooftop Air Conditioning Units B: Packaged Rooftop Air Conditioning Units : Multi Indoor Unit, Variable Refrigerant Flow-Water Source/Air Source, Heat Recovery, Heat Pump, and Single Phase VRF Models : Ductless Split Units DIVISION 26 ELECTRICAL : Low Voltage Electrical Power Conductors and Cables : Control-Voltage Electrical Power Cables : Grounding and Bonding for Electrical Systems : Hangers and Supports for Electrical Systems : Raceways and Boxes for Electrical Systems : Under floor Raceways for Electrical Systems : Sleeves and Sleeve Seals for Electrical Raceways and Cabling : Identification for Electrical Systems TABLE OF CONTENTS TOC - Page 5 of 6

9 260572: Over Current Protective Device Short Circuit Study : Over Current Protective Device Coordination Study : Lighting Control Devices : Relay-Based Lighting Controls : Low Voltage Transformers : Low Voltage Switchgear : Panel Boards : Wiring Devices : Fuses : Enclosed Switches and Circuit Breakers : Lighting Protection for Structures : LED Interior Lighting DIVISION 27 COMMUNICATION : Grounding and Bonding for Communications systems : Pathways for Communications systems : Sleeves and Sleeve Seals for Communications Pathways and Cabling : Communications Equipment Room Fittings : Communications Backbone Cabling : Communications Horizontal Cabling : Educational Intercommunications and Program Systems A: Lecture Hall A/V System : Gymnasium A/V System DIVISION 28 ELECTRONIC SAFETY AND SECURITY : Grounding and Bonding for Electronic Safety and Security : Pathways for Electronic Safety and Security : Sleeves and Sleeve Seals for Electronic Safety and Security Pathways and Cabling : Fire Alarm System END OF TABLE OF CONTENTS TABLE OF CONTENTS TOC - Page 6 of 6