ENERGY SAVING ACCESSORIES AVAILABLE REDUCE POWER CONSUMPTION BY HALF CAMSS30 CALIFORNIA MEDIUM SHELTER SYSTEM

Transcription

1 ENERGY SAVING ACCESSORIES AVAILABLE REDUCE POWER CONSUMPTION BY HALF CAMSS30 CALIFORNIA MEDIUM SHELTER SYSTEM

2 CHOICE OF THE UNITED STATES MILITARY SERVICES The (CAMSS30) is the Official Medium Shelter System of the United States Air Force and is an integral part of all BEAR Base Shelter Packages. As well, the is in use with all branches of the United States Military including Air Force, Army, Navy and Marine Corps. DEPLOYED AROUND THE WORLD More than 2,000 s are deployed in locations around the world. Extreme climates such as Balad, Iraq, Kandahar, Afghanistan, Kadena, Japan, Osan AB, Korea, Eilson AFB, Alaska and Djibouti. Field tested through hurricanes, sand storms, high humidity, scorching heat and extreme cold. Field proven for more than a decade. TESTING, TESTING AND MORE TESTING The success of the comes from extensive development through engineering and Government laboratory testing. in 125 Degree F with full solar load and high humidity at McKinley Climatic Laboratory, Eglin AFB. in Minus 55 Degree F at McKinley Climatic Laboratory, Eglin AFB. at U.S. Army Aberdeen Proving Grounds during high wind and rain tests. at Holloman AFB, New Mexico during AFOTEC Testing. at U.S. Army Natick Laboratories with chem./bio liner.

3 (P/N CAMSS30Q-SF-T) Tan (P/N CAMSS30Q-SF-G) Green CAMSS30 SOLARFLY The CAMSS Solarfly provides thermal protection from intense sun, significantly reducing energy to cool the shelter. The CAMSS30 Solarfly includes a unique frame system that slides up and over the frame and is tensioned down to the shelter. The CAMSS30 Solarfly is unique because it does not require additional framework to be anchored to the ground and it creates a continuous air gap throughout the length of the shelter. The CAMSS30 Solarfly has been tested in extreme heat and the testing shows a reduction in air conditioning required of 17%. This reduction significantly reduces power usage and demand on generators for forward operating bases. Also available with PV Solar Panels. TM INSULCAM LINER SYSTEM The CAMSS Insulcam insulating liner with Solarfly was tested and proven to reduce the usage of the ECU by half compared to the baseline system with a basic liner. This translates to a significant savings on energy consumption. With the Insulcam liner system installed in deployed billeting shelters it helps reduce the fuel requirements at forward operating bases. We currently have our Insulcam liner system deployed to forward operating bases throughout Afghanistan. (P/N CAMSS-30-HLLE)

4 COMPLETE SHELTER SYSTEM The (CAMSS30) measures 29 6 W x 52 L. The system includes the shelter, high heat, high humidity and extreme cold liner system, fabric floor, aluminum personnel doors, vehicle doors, lighting, three phase distribution panel, outlets, vents, windows, four HVAC plenums with spot cooling, anchors, complexing connector, spares kit, all tools necessary for erection, verified technical manual and the composite container it all fits into. EASY TO SHIP AND FAST TO DEPLOY Two Shelter Systems ready to ship The complete shelter system with all tools fits into one 463L compatible container measuring 8 x 7 x 4. The container is forkliftable and stackable. It may be shipped by air, truck or ship. The complete packed container weighs 4,000 pounds, though each individual part, including the container, may be hand lifted. The erects in less than four hours with six personnel. No special tools are required and all necessary tools are included. Color coding, aluminum frame, interchangeable parts, and a logical assembly sequence make the shelter easy to erect. System includes verified technical manual with illustrations. The overall design and quality of the product continues to be outstanding. (CAMSS30) design reduced the C-130 airlift burden by 66%; reduced set up time to 3-4 hrs from 15 hrs normally required for previous shelter systems and met our temperature requirements in accordance with the performance specifications. The (CAMSS30) provides increased operational capabilities and flexibility for the war fighter in our time of need. APPLICATIONS The (CAMSS30) is deployed world wide to extreme climates From -55 to 130 degrees Fahrenheit. The California Medium Shelter is in use as command centers, communication facilities, billeting, recreation centers, community centers, transit centers, offices, custom processing, kitchens, dining rooms, commissaries, house keeping, flight line support, maintenance shops, warehousing, UAV hangars and fire engine houses. ECUs, POWER GENERATION & MORE The (CAMSS30) is available with many different options to meet users requirements. This includes environmental control units, generators, power distribution systems and internal equipment to meet specific applications. The complete package of equipment allows users to have a fully integrated facility with only placing one order. QUOTES & ORDERING Available on GSA Contract and DLA GSA Contract No. GS-07F-0029L shelters@camss.com Available for commercial as well as military users Copyright 2011 CIFR, Inc. All Rights Reserved

5 (CAMSS30) National Stock Number: (Tan) Part Number: CAMSS-HIT T National Stock Number: (Green) Part Number: CAMSS-HIT G Government Testing Aberdeen Proving Ground Tests: Wind Testing of 65 MPH for 30 Minutes End and Side of Shelter Driving Rain Test of 5 in./hr. with 40 MPH Wind Without Leaks Government Reviewed Certified Engineering To 100 MPH and 20 PSF Snow Load McKinley Climatic Laboratory, Eglin AFB Tests: Extreme Heat and Solar Load Test: Maintains Less Than 80 Degrees F In 125 Degree F With Full Solar Load Utilizing Standard Military ECUs Extreme Cold Test: Maintains Above 60 Degrees F At Minus 55 Degrees F U.S. Army Natick Laboratories developed chem/bio liner. Successfully tested with live agents as chem/bio shelter complexed with other standard military shelters. Air Force Operational Test and Evaluation Center (AFOTEC) Tests: Set-Up Time of Less Than Three Hours with Six Personnel with No Heavy Equipment Verified All Tools Required For Erection Included As Part of Shelter System After 20 Erect/Strike Cycles Inspected To Be Fully Mission Capable Technical Manual Verified During Erect/Strike Sequence by a Government AFOTEC Testing Compatibility with Government Furnished Military Environmental Control Units (ECUs) Verification of Operation in Desert Conditions Framework Specifications: All aluminum framework is designed to resist corrosion and other environmental deterioration. Framework is color coded to speed assembly. Framework parts are interchangeable with DOD inventory. Deep 4 arches are formed in T4 condition to assure aluminum arches are uniform to provide stronger shelter. Permanently attached hook and loop fastener on inside of arches to quickly accept internal shelter attachments (Heat, Humidity and Water Tested). Aluminum purlins interconnect using hitch pins with lanyards. Includes vertical and horizontal aluminum bracing in end walls to meet high wind loads. Base frame includes chromate conversion process and powder coating to resist corrosion. Base frame interconnects using hitch pins with lanyards End base includes patented pulley cover tensioning system. Removable end base frame allows full access to vehicles and equipment (Removable without removing anchors). Cover/Ends/Floor Specifications (Cover NSN ) (Floor NSN ): Cover manufactured from 44103D Mil-Spec fabric with blackout and IR with minimum weight of 16.5 ounce per square yard. All fabric seals are Radio Frequency welds with minimum 1.5 overlap. Inferior and weak hot air and wedge welds are not used. Kevlar cable tensions main cover securely to frame. Includes Eight (8) blackout windows. Includes Eighteen (18) reinforced guy D-rings Nine per side. Fabric windows include camouflage mesh and blackout window flap secured with hook and loop fasteners. Includes Four (4) sets of 18 ECU ports with electrical pass through ports. Includes top liner to protect main cover during installation. Includes slip resistant fabric floor with vector proofing to prevent sand and insect penetration. Personnel and Vehicle Doors Specifications: Two aluminum framed vehicle doors 11 wide by 10 6 high on either end. (Doors may be partially opened to 5 6 wide by 10 6 high to conserve heating and cooling). Vehicle doors may be operated by one person. Vehicle doors assemble and install in 15 minutes without the use of any heavy equipment. Vehicle doors install without use of zippers or tack stripping. No screws penetrate fabric. Vehicle doors lock in place when closed. Vehicle doors include top, side and bottom weather stripping. Vehicle doors tested for rain tight seal in government test. Includes Two (2) painted aluminum insulated personnel doors with blackout windows. Personnel doors include locking handles. Personnel doors install without the use of zippers or tack stripping. No screws penetrate fabric. Extreme Temperature Kit (Fabric Liner) (NSN ; ) Verified extreme temperature kit maintains internal working condition temperatures in temperatures of -65 degrees F to 125 degrees F with full solar load utilizing standard military ECUs. Manufactured of bright white Mil-Spec liner fabric with minimum 8 ounce per square yard weight. Liner fabric is flame resistant Per Test Method ASTM D6413: After Flame 2 Sec. Max Char Length 6 Max. Internal liner system fastens directly to permanently attached fastener on arches without tie straps. Internal liner system provides attic space which vents out each end panel. Air Flow Specification (NSN ; ) Air flow distribution system includes Four (4) 16 plenum with adjustable spot cooling to provide cooling throughout the shelter. Plenum designed for use with 16 diameter HVAC ducts. Includes elbow section to attach to supply duct. Electrical and Lighting System Specifications Complete internal electrical system, including 3-phase distribution panel, quick connect lighting, quick connect outlets, and commercial-military adaptor cable with plugs. Distribution panel is rain tight 125 Amp, 208V, 60Hz, 3-phase with a 60 amp main breaker. Lighting government verified to provide 30 foot candles of light 48 from ground. Includes Eight (8) weatherproof duplex receptacles with covers evenly distributed throughout shelter and One (1) weatherproof 30 amp receptacle. Commercial-Military hook-up adaptor cable with military cannon plug (Part No. MS9055C32412P) and 60 amp commercial plug included with system. Breakers are GFI rated and spare slots are available for additional breakers. Electrical cord is arctic rated. Plugs are twist lock for security. Anchoring and Tools Complete anchoring kit for anchoring to earth, asphalt, or concrete. Tested and compatible with AM-2 matting. All tools necessary for erection/strike are included with the CAMSS30 Shelter System (This includes necessary ladders). Spares/Repair Kit (P/N MSS-HIT-RK) Spares/repair kit includes patch materials for cover, liner, and floor. Patch materials are air transportable without special hazmat requirement. CAMSS30 Insulcam Insulating Liner (P/N CAMSS-30-HLLE) CAMSS30 Solarfly (P/N CAMSS30Q-SF-T) Tan (P/N CAMSS30Q-SF-G) Green Instruction Manual Verified T.O. manual included with each California Medium Shelter System (CAMSS30) at time of shipment. Manual includes photo reproducible drawings of erection sequence, all parts with DOD part numbers, electrical diagram, and container drawing. Download the above specifications at

6 CAMSS Shelters P.O. Box 2459 Kirkland, WA CAGE Code: 1M7W1 Business Size: Small Bay Ismoyo/US Marines of Regiment Combat Team 1/Getty Images PLCAMSS305201