Revision Date: 26-Mar IDENTIFICATION. Nioxin 3D Styling Bodifying Foam. Finished Product - Consumer (Retail) and Professional Use

Transcription

1 SAFETY DATA SHEET Issuing Date: 26-Mar-2015 Version 1 Product Name Product ID: Product Type: Recommended Use Manufacturer Address Emergency Telephone 1. IDENTIFICATION Nioxin 3D Styling Bodifying Foam _PROF_NG Finished Product - Consumer (Retail) and Professional Use Personal Beauty Care Product The Procter & Gamble Company Sharon Woods Innovation Center Reed Hartman Highway Cincinnati OH pgsds.im@pg.com Transportation (24 HR) CHEMTREC (U.S./ Canada) or Mexico toll free in country: HAZARD IDENTIFICATION This product is classifed under 29CFR (d) and the Canadian Hazardous Products Regulation as follows:. Eye Damage / Irritation Signal Word Category 2B WARNING Hazard Statements Hazard pictograms Causes eye irritation Prevention Response Storage Disposal Hazards not otherwise classified Pressurized container: Do not pierce or burn, even after use Wash hands thoroughly after handling IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing If eye irritation persists: Get medical advice/attention Page 1 / 7

2 (HNOC) 3. COMPOSITION/INFORMATION ON INGREDIENTS Ingredients are listed according to 29CFR Appendix D and the Canadian Hazardous Products Regulation Chemical Name Synonyms Trade Secret CAS-No Weight % Isobutane - No Propane - No Propenoic acid, 2-methyl-, - No (dimethylamino)ethyl ester, polymer with 1-ethenyl-2-pyrrolidinone, compd. with diethyl sulfate Phenoxyethanol - No Poly(oxy-1,2-ethanediyl), - No alpha-dodecyl-omega-hydroxy- Glycine, - No N,N'-1,2-ethanediylbis[N-(carboxymet hyl)-, sodium salt (1:2) 1-Hexadecanaminium, N,N,N-trimethyl-, chloride (1:1) - No First aid measures for different exposure routes 4. FIRST AID MEASURES Eye contact Skin contact Ingestion Inhalation Most important symptoms/effects, acute and delayed IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. under normal use. Not an expected route of exposure. If swallowed:. Clean mouth with water and afterwards drink plenty of water. under normal use. May cause eye irritation. Indication of immediate medical attention and special treatment needed, if necessary Notes to Physician Treat symptomatically. 5. FIRE-FIGHTING MEASURES Suitable extinguishing media Unsuitable Extinguishing Media Special hazard Special protective equipment for fire-fighters Specific hazards arising from the Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.. Containers may explode when heated or if contaminated with water. As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. Containers may explode when heated. Page 2 / 7

3 chemical 6. ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment and emergency procedures Personal precautions Advice for emergency responders under normal use conditions. Use personal protective equipment as required. Methods and materials for containment and cleaning up Methods for containment Methods for cleaning up. Do not puncture or incinerate cans. 7. HANDLING AND STORAGE Precautions for safe handling Advice on safe handling Handle in accordance with good industrial hygiene and safety practice. Conditions for safe storage, including any incompatibilities Storage Conditions Incompatible products Keep containers tightly closed in a dry, cool and well-ventilated place. known. Aerosol Classification Level 1 Control parameters Exposure Guidelines. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Chemical Name CAS-No ACGIH TLV OSHA PEL Mexico PEL Isobutane STEL: 1000 ppm Propane TWA: 1000 ppm TWA: 1000 ppm TWA: 1800 mg/m 3 (vacated) TWA: 1000 ppm (vacated) TWA: 1800 mg/m 3 Chemical Name CAS-No Alberta Quebec Ontario TWAEV British Columbia Isobutane TWA: 800 ppm TWA: TWA: 1000 ppm 1000 ppm Propane TWA: 1000 ppm TWA: 1000 ppm TWA: 1800 mg/m 3 TWA: 1000 ppm TWA: 1000 ppm No relevant exposure guidelines for other ingredients Exposure controls Engineering Measures Personal Protective Equipment Eye Protection Manufacturing Sites: Safety glasses with side-shields Distribution, Workplace and Household Settings: Page 3 / 7

4 Hand Protection Skin and Body Protection Respiratory Protection 9. PHYSICAL AND CHEMICAL PROPERTIES Physical C Appearance Odor Odor threshold Aerosol viscous white Mint-like Property Values Note ph value Melting/freezing point Boiling point/boiling range Flash point Evaporation rate Aerosol - Not Applicable Flammability (solid, gas) Flammability Limits in Air Upper flammability limit Lower Flammability Limit Vapor pressure Vapor density Relative density 0.96 Water solubility Soluble in water Solubility in other solvents Partition coefficient: n-octanol/water Autoignition temperature. Decomposition temperature. Viscosity of Product Oxidizing properties VOC Content (%) Not applicable. Products comply with US state and federal regulations for VOC content in consumer products. 10. STABILITY AND REACTIVITY Reactivity Stability Hazardous polymerization Hazardous Reactions Conditions to Avoid Materials to avoid under normal use conditions. Stable under normal conditions. Hazardous polymerization does not occur. under normal processing. under normal processing. in particular. Hazardous Decomposition Products under normal use. Product Information Information on likely routes of exposure 11. TOXICOLOGICAL INFORMATION Inhalation Skin contact Ingestion Intentional misuse by deliberately concentrating and inhaling contents may be harmful or fatal. Page 4 / 7

5 Eye contact Avoid contact with eyes. Irritating to eyes. Delayed and immediate effects as well as chronic effects from short and long-term exposure Acute toxicity Skin corrosion/irritation Serious eye damage/eye irritation Skin sensitization Respiratory sensitization Germ cell mutagenicity Neurological Effects Reproductive toxicity Developmental toxicity Teratogenicity STOT - single exposure STOT - repeated exposure Target Organ Effects Aspiration hazard Carcinogenicity Irritating to eyes. Component Information Ecotoxicity Chemical Name CAS-No LD50 Oral LD50 Dermal LC50 Inhalation Isobutane ppm (Guideline not indicated; mouse; 2 h) Propane > ppm (Guideline not indicated; rat; 0.25 h) The product is not expected to be hazardous to the environment. 12. ECOLOGICAL INFORMATION Persistence and degradability Bioaccumulative potential Mobility Other adverse effects DISPOSAL CONSIDERATIONS Waste treatment Waste from Residues / Unused Products Contaminated packaging California Hazardous Waste Codes (non-household setting) Aerosol cans, when disposed as waste, are regulated as D003 reactive hazardous waste in some States because of their potential to explode when heated. Check with your State environmental agency for guidance. Pressurized container: Do not pierce or burn, even after use TRANSPORT INFORMATION DOT UN no UN1950 UN Proper shipping name Aerosols Description UN1950, Aerosols, 2.2, Ltd. Qty., Ltd. Qty. Hazard Class 2.2 Page 5 / 7

6 Emergency Response Guide Number 126 IMDG UN Number UN1950 UN Proper shipping name Aerosols, non-flammable Description UN1950, Aerosols, non-flammable, 2.2, Ltd. Qty., Ltd. Qty. Transport hazard class(es) 2.2 EmS-No F-D, S-U IATA UN no UN1950 UN Proper shipping name Aerosols Description UN1950, Aerosols, non-flammable, 2.2, Ltd. Qty., Ltd. Qty. Hazard Class 2.2 ERG Code 2L IATA comment Can also be shipped as ID8000 Consumer Commodity U.S. Federal Regulations 15. REGULATORY INFORMATION SARA 313 Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA). This product does not contain any chemicals which are subject to the reporting requirements of the Act and Title 40 of the Code of Federal Regulations, Part 372 CERCLA This material, as supplied, does not contain any substances regulated as hazardous substances under the Comprehensive Environmental Response Compensation and Liability Act (CERCLA) (40 CFR 302) or the Superfund Amendments and Reauthorization Act (SARA) (40 CFR 355). There may be specific reporting requirements at the local, regional, or state level pertaining to releases of this material Food and Drug Administration (FDA) The product described in this Material Safety Data Sheet is regulated under the Federal Food, Drug, and Cosmetics Act and is safe to use as per directions on container, box or accompanying literature (where applicable) Clean Air Act, Section 112 Hazardous Air Pollutants (HAPs) (see 40 CFR 61) This product contains the following substance(s) which are either listed as hazardous air pollutants (HAPS) or VOC's per the Clean Air Act: Chemical Name CAS-No CAA (Clean Air Act) Hazardous Air Pollutants Phenoxyethanol X Clean Water Act This product does not contain any substances regulated as pollutants pursuant to the Clean Water Act (40 CFR and 40 CFR ) California Proposition 65 This product is not subject to warning labeling under California Proposition 65. U.S. State Regulations (RTK) Chemical Name CAS-No New Jersey Isobutane X Propane X Chemical Name CAS-No Massachusetts Page 6 / 7

7 Isobutane X Propane X Chemical Name CAS-No Pennsylvania Isobutane X Propane X Phenoxyethanol X Butane X International Inventories United States Product is a personal care product and regulated under FDA. Canada This product is in compliance with CEPA for import by P&G. Legend TSCA - United States Toxic Substances Control Act Section 8(b) Inventory CEPA - Canadian Environmental Protection Act Perfumes contained with the products comply with appropriate IFRA guidance. 16. OTHER INFORMATION Issuing Date: Revision Date: Reason for revision 26-Mar Mar-2015 Initial Release. Disclaimer The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text End of SDS Page 7 / 7