INTRODUCTION. The wood heater was sealed after completion oftesting in compliance with the EPA regulation as follows:

Transcription

1 Model:2100 Wolf Steel td. - Barrie, ON 4M 4Y8 't NTRODUCTON Wolf Steel td. retained OMN to peforrn U.S. Environmental Protection Agency (EPA) certification testing on the 2100 wood stove. The 2100 wood stove is a non-atalltic, freestanding, radiant-type room heater. The firebox is constructed of mild steel. Usable firebox volume was measuled to be 1.5 cubic feet and the stove is vented through a 6-inch diameter flue collar located at the top ofthe unit. laboratory is 30 feet above sea level. The unit was received in good condition and logged in on November 10, 2008, then assigned and labeled with OMN D #1318. OMN representative Ken EPA was notified of the testing dates in a letter dated December 11, A testing contract, including provisions for Random Compliance Audit (RCA) testing, has been signed by Cliff - illey of Wolf Steel td. and is on file at OMN s testing faciliry. The 2100 wood stove was tested in accordance with the U.S. EPA 40 CFR Part 60. Suboart AAA Standard of Performance for Residential Wood Heaters (Appendix A, Methods 28 and 5G). Particulatemissions were measured using a Method 5G sampling train consisting of two filters (front and back). The weighted averag emissions ofthe four test runs included in the results --\-, indicate a particulat emission leve1 of 3.9 grams per hour. #5, a fari confirmation test run, was performed and was not used in the weighted averagemission results. Test runs were conducted in each of three bum rate categories ( kgftr, kglhr, and maximum). Emissions for each of their individual test runs did not exceed the cao. The 2100 results are within the emission limit of 7.5 grams per hour for non-catalytic affeited facilities manufactured on or after July 1, 1990, or sold at retail on or after luly l,1992. The wood heater was sealed after completion oftesting in compliance with the EPA regulation as follows: o "DO NOT TAMPER" labels were placed on the door and on all other openings. o Plastic material sealed with "DO NOT TAMPER" labels and tape was wrapped around the unit.. The unit was sealed in a wood box constructed for the unit and secured with steel banding. o "DO NOT TAMPER" labels were placed on all outer surfaces of the box. This report is organized in accordance with the EPA-recommended outline and is summarized in the Table of Contents immediately preceding this reporl. The results in this report are limited to the item submitted. OMN-Test aboratories, nc. C.rti/icaiio, f6t Repo datcdjdn tr^ 20A9: \to" isht.6.rs\ sdtgtvotl Steet.! tj\-0t-3 Wotl Steet 1.6:.u j-s-o r,3 i-) nf i-r

2 Model:2100 Wolf Steel td. Baftie, ON 4M 4Y8,.1 Table Particulate Emissions :,_ Burn Rate (kq/hr dry) Method 5G Emissions (q/hr) O J tl Weiqhted particulat emission averaqe of four test runs: 3.9 grams per hour. Table Test Facility Conditions Room Temperature ("F) Barometric Pressure (Hq) Air Velocity (ft/min) Before After Before After Before After 1 oaj <50 < , <50 <50 J oo <50 < <50 <50 O [N]-Te s t aborut or i e s, nc. Cqti icanan rest Rcpo.t dokd Jatidr, 2A09: \\Otntkn\6.rs\Test,E\.W'YSteel\41j-S-q1-3lvofstecl t.6\jlt * of 5-8

3 Model: 2100 WolJSeel td Napoleon Koo.l Baftie, ON 4M 4Y8,.i t Table ' Fuel Measurement and Crib Description Summary - PRETEST Pretest Fuel Weight (Startinq weiqht in lbs) Pretest Moisture (Drv basis - %) Goal Bed Weight (lbs) z.j o.z 21.1 z.z O Table Fuel Measurement and Crib Description Summary - TEST i- \!- Test Fuel Wet Basis (lbs) Firebox Volume (ft1 Fuel oading Density Wel Basis (lbs/ft") Fuel Moisture Content Dry (%) Piece ength (in) 2x4s Used A o.l x4s Used OMN-Test aborutaies, nc. CeftJication Test R.pdt.laba Jahndry 2AO9: \\Oni'ifl\tsers\TettihewalJ Skel\11i-S-0 t -J W.f Steel l.6t t 15 S 0 t! 5-4 of5-8

4 Mode!:2ta0 Wolf Steel td. g Napoleon Road.l Ba ie, ON 4M 4Y8 Table Dilution Tunnel Gas Measurements and Sampling Data Summary ength of Test (min) Velocity (fusec) Averaqe Dilution Tunnel Gas Measurements Flow Rate (dscf/min) Temperature ("F) J 70 J-JZ Table 1.5- Heater Operation Data (Average Temperature Data) Beginning Surface Temperature Averaqe" Ending Surface Temperature Average" Surface Delta TD a. All temperatures are in degrees F. b. Represents the difference between beginning and ending average surface temperatures. OMN-Test aboratories, lnc. Catitatia" est Repot aated Jat ary 2aa9: \\Oh itflr,setr,t.nntt\tynf SittAl l5-*a B WoA 9cel t. a\.tj t-9a of5-8

5 Model:2100 Warsteel td. Barrie, ON 4M 4Y8 Table Pretest Gonfiguration Combustion Air (in) Fuel Added Fuel Removed Time (min) 1 Open " 2 Open 0.375" Fully Open A Open 0.78" 8.2 lbs at start; no addition; coal bed 2.3 lbs 8.2 lbs at start; no addition; coal bed 2.2 lbs 17.3 lbs at start; no addition; coal bed 2.0 lbs f 3.9 lbs at start; no addition; coal bed 2.3 lbs Table Data Average Dry Burn Rate (kq/hr) nitial (lnduced) Draft (H,O) Primary Air Setting (in) Time (min) Average Draft (HrO) open " O7 0 Open 0.375" Fullv Open Open 0.78" OMN-Test aborataries, nc. Cerkldtid Test R.pofl ddted Jatnury 20a9: \\A,tisn\us.rs\rcstihgvo( Sk.l1 i S 0l 3 lfolj Steel 6\l i-ya of5-8

6 Modet: 2100 WofS,eel td. Ba ie, ON lm 4Y8 Table.8 - Test Gonfigurations Five-Minute Startup Fuel oadinq: oaded by 55 seconds. Door: Closed at 60 seconds. Primary Air: Fully open for 5.0 minutes, then closed to test setting. Secondary: Fixed. Tertiary: None. Fan: Off for first 30 minutes, on high for remainder of test. Fuel oadinq: oaded by 55 seconds. Door: Closed at 60 seconds. Primary Air; Fully open for 5.0 minutes, then closed to test setting. Secondarv: Fixed. Tertiarv: None. Fan: Off for first 30 minutes, on hiqh for remainder of test. Fuel oadinq: oaded by 45 seconds. Door: Closed at 50 seconds. Primarv Air: Fully open for duration of test. Secondary: Fixed. Tertiary: None. Fan. On hiqh for duration of test. Fuel oadinq: oaded by 45 seconds. Door: Closed at 50 seconds. Primarv Air: Fully open for 5.0 minutes, then closed to test setting. Secondary: Fixed. Tertiarv: None. Fan: On high for duration of test. Gombustion Air Open " Open 0.375" Fully Open Open 0.78" OMN-Test aborctoies,nc. 5-7 of 5-8 Ceiifcatioi $t Rep*t date.l Jatuary 20a9: \\Ohhj@\users\fesnBwolJ Steel\ 1t-S-A/ -3 WalJ St.el t.6\1t 5,Sa t,3

7 Model: 2100 wofsbel td. gttopoleghroad Barrie, ON 4M 4Y8 t- 1ANADA t TEST RESTJTS AF{D DSCUSSON ',1 A total of five test runs were performed on the 2100 wood stove. Four test runs were conducted in the following categories and included in the weighted average emission level results: two in the 0.80 to 1.25 kgllu dry category; one in the 1.25 to 1.90 kg,4r dry category; and one at maximum. The weighted particulate emission level was measured to be 3,9 g/hr. tl- The proportionality results for all four test runs were acceptable. Quality check results for each test run axe presented in Section 2 ofthis report. '._ - '\ l- 1 l- OMN-Test aboralories, nc. c.nf@i Te! R.put.bt d Jdtuary 2009: \\onnttun44s\t*tin8\worstee^115+0t-3 wotfst.t t.6\4r5" of5-8