1. COMPANY AND PRODUCT IDENTIFICATION. Glue / Eyelash Glue / Body Glue 2. HAZARDS IDENTIFICATION

Transcription

1 Safety Data Sheet 1. COMPANY AND PRODUCT IDENTIFICATION ilovetocreate A Duncan Enterprises Company 5673 East Shields Avenue Fresno, CA (Fax) EMERGENCY TELEPHONE NUMBERS Health Emergencies: :00 am 3:30 pm Pacific Std. Time Spill and Off-Hour Health Emergencies: U.S. and Canada Outside U.S. and Canada (Collect) Product Name: Product Description: TULIP BODY GLUE Glue / Eyelash Glue / Body Glue 2. HAZARDS IDENTIFICATION HMIS Hazard Ratings for Product Health 1 Flammability 0 Reactivity 0 Personal Protection See Section 8 Rating Scale: 0 = Minimal 1 = Slight 2 = Moderate 3 = Serious 4 = Severe * = Chronic Effects 3. COMPOSITION / INGREDIENT INFORMATION Chemical Name CAS Composition (% by weight) Acrylic Polymer Water FIRST AID MEASURES Eye Contact: Skin Contact: Inhalation: Ingestion: Immediately flush eyes with large amounts of warm water for 15 minutes. Assure adequate flushing of the eyes by separating the eyelids with fingers. Consult a physician. For minor skin contact, avoid spreading material on unaffected skin. Wash affected skin areas thoroughly with soap and warm water. Remove and isolate contaminated clothing and shoes. If irritation persists, seek medical attention. Move subject to fresh air. If breathing is difficult, provide oxygen. If not breathing, provide artificial respiration. Do not induce vomiting without medical advice. If vomiting occurs naturally, lean victim forward to reduce risk of aspiration. Loosen tight clothing. Do not use mouth-to-mouth respiration methods. Seek immediate medical attention. Page 1 of 5

2 5. FIRE FIGHTING MEASURES Autoignition Temperature: Flash Point: Upper Explosive Limit (%): Lower Explosive Limit (%): Extinguisher Media: Special Firefighting Procedures: Fire & Explosion Hazards: NFPA Flammability Hazard Class: Unknown CO2, Dry Chemical, Sand, Water-Spray or Regular Foam As in any fire, use a self-contained breathing apparatus. Wear full-protective clothing and face mask. 0 = Will not burn Spill or Leak Procedures: 6. ACCIDENTAL RELEASE MEASURES Ensure adequate ventilation. Do not touch damaged containers or spilled materials unless wearing protective clothing. Ventilate closed areas before entering. Keep unnecessary personnel away. Dispose fire-control water and other extinguishing agents after spill or leak has been corrected. For safety and environmental precautions, please review entire Safety Data Sheet for necessary information. 7. HANDLING AND STORAGE Storage Temperature: Handling / Storage: Ventilation Requirements: Keep in a cool, dry, and well-ventilated area. Keep away from ignition sources and high heat. Keep out of reach of children and keep closed until used. Store away from incompatable substances such as oxidating agents. Ensure closed areas are well ventilated. 8. EXPOSURE CONTROL AND PERSONAL PROTECTION Conditions Under Which Personal Protective Equipment Required: Eye Protection Requirements: Glove Requirements: Clothing Requirements: Change / Removal of Clothing: Wash Requirements: Respirator Requirements: Ventilation Requirements: Normal work conditions, maintenance / repair. Wear safety glasses with side shields or safety goggles. Use chemical-resistant gloves. Wear protective body covering to minimize exposure to clothing and skin. required. When workers are exposed to greater than the exposure limit, they must use certified respirators. Local exhaust ventilation is recommended to maintain vapor limits below the TLV. Page 2 of 5

3 9. PHYSICAL AND CHEMICAL PROPERTIES Pure Material or Mixture: Mixture Physical Form: Liquid Appearance / Physical Description: White Emulsion; slight odor ph: ~6.0 Boiling Point: 100 C Melting / Freezing Point: 0 C Odor Threshold: Solubility in Water: Soluble and miscible Partition Coefficient (n-octanol/water): Specific Gravity (Water = 1): 1.07 Bulk Density: Volatiles: Vapor Pressure: Evaporation Rate (Water = 1): Vapor Density (Air = 1): Volatile Organic Compounds: Autoignition Temperature: Flash Point: Oxidizing Properties: 10. STABILITY AND REACTIVITY Stability: Incompatibilities: NFPA Reactivity Hazard Class: Hazardous Decomposition Products: Hazardous Polymerization: Stable Avoid contact with strong oxidizers 0 = Insignificant Carbon Monoxide, Carbon Dioxide, small amounts of hydrocarbons Will not occur 11. TOXICOLOGICAL INFORMATION Route of Entry Eye: Skin: Inhalation: Ingestion: Acute (Short-Term) Effects of Exposure Mildly irritating to eyes. 11. TOXICOLOGICAL INFORMATION (Continued) Chronic (Long-Term) Effects of Exposure Effect of Chronic Exposure: This product should be considered non hazardous and has no known chronic effects. Target Organs: Not applicable Carcinogenicity: 12. ECOLOGICAL INFORMATION No data. Page 3 of 5

4 13. DISPOSAL CONSIDERATIONS Waste Disposal Methods: Empty Container Warnings: Waste disposal should be in accordance with existing Federal, State, and Local environmental regulations. Empty containers may contain product residue; follow SDS and label warnings even after they have been emptied. 14. TRANSPORT INFORMATION U.S. Department of Transportation Information DOT Shipping Name: Adhesive Glues, NOI 4620 Sub. 5 DOT Hazard Class: Non-hazardous DOT Reportable Quantity: United Nations Information U.N. Number: U.N. Class: The information provided herein may not include the impact of additional regulatory requirements (e.g., for materials meeting the definition of a hazardous waste under RCRA, hazardous substances under CERCLA, and/or marine pollutants under CWA or other similar federal, state or local laws) or any associated exceptions or exemptions under regulations applicable to the transport of this material. 15. REGULATORY INFORMATION TSCA: FDA: SARA/Title III: All components are on the TSCA Inventory 21CFR This product contains no substances at or above the reported threshold under Section 313, based on available data. Products bearing the Nontoxic Product Seal are certified in a program of toxicological evaluation by a nationally recognized toxicologist to contain no materials in sufficient quantities to be toxic or injurious to humans or to cause acute or chronic health problems. These products are certified to be labeled in accordance with the voluntary chronic hazard labeling standard ASTM D In addition, there is no physical hazard as defined within 29 CFR Part (c). 16. OTHER INFORMATION ACGIH ANSI ASTM C CAS CERCLA CFR CPR DOT EPA F FDA Table of Abbreviations American Conference of Governmental Industrial Hygienists American National Standards Institute American Society for Testing Materials Degrees Centigrade Chemical Abstract Service Comprehensive Environmental Response, Compensation and Liability Act Code of Federal Regulations Controlled Products Regulations Department of Transportation Environmental Protection Agency Degrees Fahrenheit Food & Drug Administration Page 4 of 5

5 16. OTHER INFORMATION (Continued) Table of Abbreviations (Continued) g / l Grams per liter DOT Department of Transportation EPA Environmental Protection Agency F Degrees Fahrenheit FDA Food & Drug Administration g / l Grams per liter Hg Mercury HMIS Hazardous Materials Identification System IARC International Agency for Research on Cancer LD Lethal Dose mg / kg Milligram per kilogram mm Millimeter SDS Safety Data Sheet MSHA Mine Safety and Health Administration N / A NFPA National Fire Protection Association NIOSH National Institute for Occupational Safety and Health NTP National Toxicology Program OSHA Occupational Safety and Health Administration ppm Parts per million SARA Superfund Amendment and Reauthorization Act STEL Short-Term Exposure Limit TSCA Toxic Substances Control Act TWA Time - Weighted Average U.N. United Nations WHMIS Workplace Hazardous Materials Information System > Greater Than < Less Than Creation Date: 05/04/11 Revision Date: 01/22/13 Technical Contact: Frank Peters Research & Development Manager ilovetocreate A Duncan Enterprises Company 5673 East Shields Avenue Fresno, CA (Fax) Disclaimer The information given and the recommendations made herein apply to our product(s) alone and not combined with any other product(s). Such are based on our research and on data from other reliable sources and are believed to be accurate. No guarantee of accuracy is made. It is the purchaser s responsibility before using any product to verify this data under their own operating conditions and to determine whether the product is suitable for their purposes. Page 5 of 5