Garrett Stone, BBR&S Chairman September 2013

Transcription

1 Garrett Stone, BBR&S Chairman September 2013

2 The Importance of Energy Codes States and local jurisdictions adopt energy efficient codes to establish the minimum legal standards for building construction including fenestration Energy codes generally establish requirements for new buildings, additions & remodeling and replacement windows Jurisdictions typically adopt model codes, occasionally with local amendments

3 For almost two decades, federal law has required jurisdictions to consider and/or adopt model energy codes Two primary national model energy codes Residential construction = IECC Non-residential construction = ASHRAE 90.1 and IECC

4 There has been much emphasis at the national policymaker level for using energy codes to provide energy efficiency for national security, economic and environmental reasons Example: DOE target for 2012 was 30% improvement over 2006 IECC

5 Future model codes expected to require even more efficient windows. NFRC ratings are key to code compliance for fenestration.

6 Modern model energy codes incorporate NFRC procedures as the exclusive method for determining fenestration energy performance for both residential and non-residential construction (U-factor and SHGC) The only alternative is an extremely limited default table Virtually all state codes currently incorporate these requirements

7

8 2012 IECC contains separate, stand-alone residential & commercial energy codes 2012 IRC Chapter 11 duplicates IECC residential energy provisions

9 ICC revised the intent of the IECC: regulate the design and construction of buildings for the effective use and conservation of energy over the useful life of each building. (excerpt)

10 The Department of Energy s positive determination of the 2012 IECC for residential construction was published May 17 th 2012 States have two years to certify they have reviewed their energy codes and determined whether to update requirements

11 U-factors and SHGCs: Same approach as 2006 and 2009 IECC All fenestration ratings must be determined in accordance with NFRC or limited default table (no other options) VT: NFRC VT recognized by IECC for first time VTs for fenestration (if required by the code) must be determined in accordance with NFRC or limited default table

12 U-Factor Same values for both residential and commercial fenestration Products lacking labeled and certified NFRC ratings are assigned a default value Frame Type Single Pane Double Pane Skylight Single Skylight Double Metal Metal with Thermal Break Nonmetal or Metal Clad Glazed Block 0.60

13 SHGC & VT Same values for both residential and commercial fenestration Products lacking labeled and certified NFRC ratings are assigned a default value SINGLE GLAZED DOUBLE GLAZED GLAZED BLOCK Clear Tinted Clear Tinted SHGC VT

14 More efficient fenestration in virtually all climate zones Overall increase in code stringency over 2006 IECC estimated by some observers to achieve 30% target (considerable savings from windows) DOE study concluded 2012 IECC saves between 25-38% in relevant energy costs over the 2006 IECC, depending on climate zone DOE study concluded that 2009 and 2012 improvements were cost effective

15 Lower Maximum Window U-Factor in Most Climate Zones 2006 Code 2009 Code 2012 Code Zone Zone Zone Marine 4 and Zones

16 Lower Maximum Window SHGC in Certain Climate Zones Climate Zones 1 through 3 Climate Zone 4 ExceptMarine 2006 Code 2009 Code 2012 Code NR NR 0.40

17

18 Energy Efficiency Part 1 Substantially simplified and material neutral -- new prescriptive vertical fenestration U-factors using three categories: Fixed, Operable and Entrance Door (skylights are addressed separately) Weighted average approach for U-factor Prescriptive table allows: 30% window to wall ratio Up to 40% window to wall ratio permitted if new daylighting provisions are satisfied

19 Energy Efficiency Part 2 More stringent air leakage requirements for commercial windows Minimum requirements for skylights in certain buildings As an alternative to the prescriptive path, compliance may also be achieved through use of performance analysis or ASHRAE

20 Lower U-Factors for Most Zones Along With Changes to Classification Zone 1 Zone 2 Zone 3 Zone 4 Except Marine Zone 5 & Marine 4 Zone 6 Zone 7 Zone 8 Fixed Fenestration U-Factor Operable Fenestration U-Factor Entrance Door U-Factor Skylights U-Factor

21 Modified Approach to SHGC Single set of SHGC values by product type (with adjustment provisions for projection factor): Zone 1 Zone 2 Zone 3 Zone 4 Except Marine Zone 5 & Marine 4 Zone 6 Zone 7 Zone 8 Vertical Fenestration SHGC Skylights SHGC NR NR

22 Over 550 proposals submitted to change the residential and commercial codes Committee Action Hearings took place in April 2013 Public Comment Hearing (formerly Final Action Hearing ) will take place this October to decide the 2015 IECC

23 US DOE has issued a positive determination on ASHRAE (an improvement over 2007) States must certify that commercial energy codes meet or exceed ASHRAE by Oct. 18, Because IECC incorporates ASHRAE 90.1 as compliance alternative, states commonly adopt IECC for both residential and commercial construction ASHRAE has retained material differences (metal vs. non-metal frames) in fenestration requirements

24

25 Majority of states have already adopted the 2009 IECC and/or ASHRAE and many more are still in the process States are moving ahead with consideration of and/or adoption of the 2012 IECC and/or ASHRAE DOE and the states are working towards improved compliance rates

26 Improved Residential Performance Standards Improved NonResidential Performance Standards BOTH Effective January 1, 2014 Substantial improvements and increased stringency in fenestration requirements for both residential and nonresidential buildings

27 Improved Residential Performance Standards: More stringent prescriptive criteria Maximum 0.32 U-factor for all of California Maximum 0.25 SHGC for all of California (except climate zones 1, 3 and 5) The prescriptive path is also the baseline for the performance method

28 Improved Nonresidential Performance Standards: Improved fenestration prescriptive criteria New -- Minimum VT requirement More stringent U-factor and RSHGC values New Same values across entire state Material-neutral vertical fenestration requirements The prescriptive path is also the baseline for the nonresidential performance method

29 Improved Nonresidential Performance Standards: Vertical Fenestration (Max 40% WWR) Fixed Window Operable Window Curtainwall / Storefront Glazed Doors Max U-Factor Max SHGC Min VT Skylights (Max 5% SRR) Glass, Curb Mounted Glass, Deck Mounted Plastic, Curb Mounted Max U-Factor Max SHGC NR Min VT

30 Improved Nonresidential Performance Standards: New -- Reduced site-built NFRC exception: Under the old standards, 10,000 square feet of sitebuilt fenestration was exempt from NFRC certification and labeling The exemption has been reduced to 1,000 square feet of site-built fenestration in the new standards This change should result in considerably more NFRC certification

31 Note that the presentation above is not intended as legal advice and no guarantee is offered as to its accuracy. The user uses this information at his or her own risk.