SAFETY DATA SHEET. StemFit Basic02

Transcription

1 The information is provided as a service to our customers and is intended only for their use. This information is based on technical information believed to be reliable and will be revised as new knowledge or experience is gained. 1. PRODUCT AND COMPANY IDENTIFICATION Product Name: (Medium for Stem Cell) Product Code: Not Available General Use: Culture for Stem Cell Product Description: Solution MSDS Number: Not Available MANUFACTURER Company Name: AJINOMOTO CO., INC. Address: , Kyobashi, Chuo-ku, Tokyo , Japan Telephone No.: +81-(0) Mr. Kazunori Mawatari 2. HAZARDS IDENTIFICATION GHS classification: Not classified PHYSICAL HAZARDS: Not classified HEALTH HAZARDS: Not classified ENVIRONMENTAL HAZARDS: Not classified Signal word: None Hazard statements: Not applicable Precautionary statements: Not applicable 3. COMPOSITION/INFORMATION ON INGREDIENTS Ingredient: Water, Glucose, Amino acids, Vitamin, Mineral, Growth factors and Protein CAS Registry Number: Not Available Page 1 of 5

2 4. FIRST-AID MEASURES INHALATION: If breathed in, move person into fresh air. If not breathing give artificial respiration. Consult a physician. EYE : Rinse thoroughly with plenty of water for at least 15 minutes. Consult a physician. SKIN : Wash off with soap and plenty of water for at least 15 minutes. Consult a physician. INGESTION: Do not induce vomiting without medical advice. Never give anything by mouth to an unconscious person. Rinse mouth with water. Consult a physician. PROTECTION TO FIRST-AIDERS: Consult a physician. Show this safety data sheet to the doctor in attendance. Move out of dangerous area. NOTE TO PHYSICIAN: This product is containing various ingredients to culture the Stem Cell. The ingredients are, water, glucose, amino acids, vitamin, minerals, growth factors and proteins. These ingredients are almost similar one with the sold mediums used for the culture for ES cell or ips cell in US, EU or Asian countries. 5. FIRE-FIGHTING MEASURES FLAMMABLE PROPERTIES: Data of flash point or ignition temperature are not available. EXTINGUISHING MEDIA: Use carbon dioxide, dry chemical powder, appropriate foam or water spray. 6. ACCIDENTAL RELEARSE MEASURES LAND SPILL: Use personal protective equipment. Wash spill site with water after material pickup is complete. Keep in suitable, closed containers for disposal. WATER SPILL: Do not let product enter drains. 7. HANDLING AND STORAGE HANDLING: Avoid contact with skin and eyes. STRORAGE: Keep container tightly in the freezer of refrigerator. Page 2 of 5

3 8. EXPOSURE CONTROLS/PERSONAL PROTECTION EXPOSURE LIMIT VALUES: Not Available EXPOSURE CONTROLS: Not Available Occupational Exposure Controls Engineering controls: Not Available Personal Protection Respiratory Protection: NIOSH or MSHA-approved respirator. Mechanical exhaust is required. Hand Protection: Handle with chemical-resistant gloves. Eye Protection: Put on safety glasses. Skin Protection: Choose body protection according to the amount and concentration of the dangerous substance at the work place. Hygiene measures: Handle in accordance with good industrial hygiene and safety practice. Wash hands before breaks and at the end of workday. 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance: Solution Odour: Non-odour. ph: Around ph7 Boiling Point/Boiling Range: Not Available Melting Point/Melting Range: Almost 0 Decomposition Temperature: Not Available Flash Point: Not Available Auto Ingestion Temperature: Not Available Flammability: Not Available Explosive Properties: Not Available Oxidizing Properties: Not Available Vapor Pressure: Not Available Relative Density: Not Available Solubility: Solution Partition Coefficient (n-octanol/water): Insoluble in non-polar solvents. Viscosity: Not Available Vapour Density: Not Available Evaporation Rate: Not Available 10. STABILITY AND REACTIVITY CONDITIONS TO AVOID: Storage in the freezer (Sol. A&B) STABILITY: Stable for 2years in the freezer (Sol. A&B) Page 3 of 5

4 MATERIALS TO AVOID: Room temperature HAZARDOUS REACTIONS/DECOMPOSITION PRODUCTS: Not Available 11. TOXICOLOGICAL INFORMATION Acute Toxicity: Not Available Eye Irritation: Not Available Skin Irritation: Not Available Sensitization: Not Available Repeated Dose Toxicity: Not Available Chronic Toxicity: Not Available Mutagenicity: Not Available Carcinogenicity: Not Available Reproductive and Developmental Toxicity: Not Available 12. ECOLOGICAL INFORMATION ECOTOXICITY: Not Available MOBILITY: Not Available PRESISTENCE AND BIODEGRADABILITY: Not Available BIOACCUMIRATIVE POTENTIAL: Not Available OTHER ADVERSE EFFECTS: Not Available 13. DISPOSAL CONSIDERATION Comply with all federal, state and local regulations. Do not dump this product into sewers, on the ground or into any body of water. 14. TRANSPORT INFORMATION US DEPARTMENT OF TRANSPORTATIONS (DOT) Hazardous Materials: Not regulated. Hazardous Materials Description and Proper Shipping Name: Not regulated. Hazardous Class or Division: Not regulated. Identification Number: Not regulated. Packing Group (PG) : Not regulated. Label(s) Required: Not regulated. SEA TRANSPORT IMDG: Not regulated. Class: Not regulated. Packing Group (PG) : Not regulated. Page 4o f 5

5 UN Number: Not regulated. Proper Shipping Name: Not regulated. Marine Pollutant: Not regulated. AIR TRANSPORT ICAO/IATA: Not regulated. Class: Not regulated. Packaging Group (PG) : Not regulated. UN Number: Not regulated. Proper Shipping Name: Not regulated. 15. REAGULATORY INFORMATION OSHA STATUS: Not applicable TSCA STATUS: Not applicable CERCLA REPORTABLE QUANTITY (40 CFR 117,302) : Not applicable SARA TITLEⅢ: Not applicable SECTION 302 (40 CFR 355) SECTION 311/312 (40 CFR 370) SECTION 313 (40 CFR 372) Please refer to any other federal, state and local regulations. 16. OTHER INFORMATION This information is furnished without warranty, express or implied, except that it is accurate to the best knowledge of AJINOMOTO CO., INC. It relates only to the specific product designated herein, and dose not related to use in combination with any other material or in any process. AJINOMOTO CO., INC. assumes no legal responsibility for use of or reliance upon this information. Page 5 of 5 Date of issue MSDS Jan 24, 2017