SAFETY DATA SHEET. 1. Identification. 2. Hazard(s) identification. 3. Composition/information on ingredients

Transcription

1 SAFETY DATA SHEET 1. Identification Product identifier Other means of identification Product code Recommended use Recommended restrictions DREWMULSE GMC Surfactant For industrial use only. Manufacturer/Importer/Supplier/Distributor information Manufacturer Company name Stepan Company Address 22 West Frontage Road Northfield, IL Telephone USA General Emergency phone number Medical Chemtrec Chemtrec Int'l Hazard(s) identification Physical hazards Health hazards Environmental hazards OSHA defined hazards Label elements Not classified. Serious eye damage/eye irritation Not classified. Not classified. Category 2A Signal word Hazard statement Precautionary statement Prevention Response Storage Disposal Hazard(s) not otherwise classified (HNOC) Supplemental information Warning Causes serious eye irritation. Wash thoroughly after handling. Wear eye protection/face protection. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Store away from incompatible materials. Dispose of waste and residues in accordance with local authority requirements. None known. None. 3. Composition/information on ingredients Mixtures Chemical name _Glycerides, C8-10 mono-, di- and tri- (Alt CAS / ) Common name and synonyms CAS number % Glycerin / 6

2 4. First-aid measures Inhalation Skin contact Eye contact Ingestion Most important symptoms/effects, acute and delayed Indication of immediate medical attention and special treatment needed General information 5. Fire-fighting measures Suitable extinguishing media Unsuitable extinguishing media Specific hazards arising from the chemical Special protective equipment and precautions for firefighters Fire fighting equipment/instructions Specific methods General fire hazards 6. Accidental release measures Personal precautions, protective equipment and emergency procedures Methods and materials for containment and cleaning up Environmental precautions 7. Handling and storage Precautions for safe handling Conditions for safe storage, including any incompatibilities 8. Exposure controls/personal protection Move to fresh air. Call a physician if symptoms develop or persist. Wash off with soap and water. Get medical attention if irritation develops and persists. Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Rinse mouth. Get medical attention if symptoms occur. Severe eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred vision. Provide general supportive measures and treat symptomatically. Keep victim under observation. Symptoms may be delayed. Ensure that medical personnel are aware of the material(s) involved, and take precautions to protect themselves. Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Do not use water jet as an extinguisher, as this will spread the fire. During fire, gases hazardous to health may be formed. Self-contained breathing apparatus and full protective clothing must be worn in case of fire. Move containers from fire area if you can do so without risk. Use standard firefighting procedures and consider the hazards of other involved materials. No unusual fire or explosion hazards noted. Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear appropriate protective equipment and clothing during clean-up. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ensure adequate ventilation. Local authorities should be advised if significant spillages cannot be contained. For personal protection, see section 8 of the SDS. Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination. Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS. Avoid discharge into drains, water courses or onto the ground. Avoid contact with eyes. Avoid prolonged exposure. Provide adequate ventilation. Wear appropriate personal protective equipment. Observe good industrial hygiene practices. Store in tightly closed container. Store away from incompatible materials (see Section 10 of the SDS). Occupational exposure limits The following constituents are the only constituents of the product which have a PEL, TLV or other recommended exposure limit. At this time, the other constituents have no known exposure limits. US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR ) Components Type Value Form Glycerin (CAS ) Biological limit values PEL 5 mg/m3 Respirable fraction. No biological exposure limits noted for the ingredient(s). 15 mg/m3 Total dust. 2 / 6

3 Appropriate engineering controls Good general ventilation should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Provide eyewash station. Individual protection measures, such as personal protective equipment Wear safety glasses with side shields (or goggles). Eye/face protection Skin protection Hand protection Other Respiratory protection Thermal hazards General hygiene considerations 9. Physical and chemical properties Appearance Odor Physical state Form Color Odor threshold ph Melting point/freezing point Initial boiling point and boiling range Flash point Evaporation rate Flammability (solid, gas) Wear appropriate chemical resistant gloves. Wear suitable protective clothing. In case of insufficient ventilation, wear suitable respiratory equipment. Wear appropriate thermal protective clothing, when necessary. Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. Liquid. Liquid. Paste F (24-30 C) > F (> C) Pensky-Martens Closed Cup Not applicable. Upper/lower flammability or explosive limits Flammability limit - lower (%) Flammability limit - upper (%) Explosive limit - lower (%) Explosive limit - upper (%) Vapor pressure Vapor density Relative density Solubility(ies) Solubility (water) Auto-ignition temperature Decomposition temperature Viscosity Other information Explosive properties Oxidizing properties Specific gravity 10. Stability and reactivity Reactivity Chemical stability Dispersible F Not explosive. Not oxidizing. 25 C The product is stable and non-reactive under normal conditions of use, storage and transport. Material is stable under normal conditions. 3 / 6

4 Possibility of hazardous reactions Conditions to avoid Incompatible materials Hazardous decomposition products 11. Toxicological information No dangerous reaction known under conditions of normal use. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. Contact with incompatible materials. Strong oxidizing agents. This product may react with strong alkalies. No hazardous decomposition products are known. Information on likely routes of exposure Inhalation No adverse effects due to inhalation are expected. Skin contact Eye contact Ingestion Symptoms related to the physical, chemical and toxicological characteristics Information on toxicological effects Acute toxicity Skin corrosion/irritation Serious eye damage/eye irritation Respiratory or skin sensitization Respiratory sensitization Skin sensitization Germ cell mutagenicity Carcinogenicity No adverse effects due to skin contact are expected. Causes serious eye irritation. Expected to be a low ingestion hazard. Severe eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred vision. Prolonged skin contact may cause temporary irritation. Causes serious eye irritation. Not a respiratory sensitizer. This product is not expected to cause skin sensitization. No data available to indicate product or any components present at greater than 0.1% are mutagenic or genotoxic. Not classifiable as to carcinogenicity to humans. IARC Monographs. Overall Evaluation of Carcinogenicity OSHA Specifically Regulated Substances (29 CFR ) US. National Toxicology Program (NTP) Report on Carcinogens Reproductive toxicity Specific target organ toxicity - single exposure Specific target organ toxicity - repeated exposure Aspiration hazard 12. Ecological information Ecotoxicity Persistence and degradability Bioaccumulative potential Mobility in soil Other adverse effects 13. Disposal considerations Disposal instructions Local disposal regulations Hazardous waste code This product is not expected to cause reproductive or developmental effects. Not applicable. Not applicable. Not likely, due to the form of the product. The product is not classified as environmentally hazardous. However, this does not exclude the possibility that large or frequent spills can have a harmful or damaging effect on the environment. Readily biodegradable. No data available. No other adverse environmental effects (e.g. ozone depletion, photochemical ozone creation potential, endocrine disruption, global warming potential) are expected from this component. Dispose of contents/container in accordance with local/regional/national/international regulations. Dispose in accordance with all applicable regulations. The waste code should be assigned in discussion between the user, the producer and the waste disposal company. 4 / 6

5 Waste from residues / unused products Contaminated packaging 14. Transport information DOT Not regulated as dangerous goods. IATA Not regulated as dangerous goods. IMDG Not regulated as dangerous goods. Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code 15. Regulatory information US federal regulations Dispose of in accordance with local regulations. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe manner (see: Disposal instructions). Since emptied containers may retain product residue, follow label warnings even after container is emptied. Empty containers should be taken to an approved waste handling site for recycling or disposal. Not established. Toxic Substances Control Act (TSCA) This product is regulated by the Food and Drug Administration (FDA) and therefore is not subject to the provisions of the Toxic Substances Control Act (TSCA). Use of this product in an application outside of those areas regulated by the Food and Drug Administration is prohibited within the United States of America. This product is exempt from the Toxic Substances Control Act (TSCA) Inventory when used solely as a Cosmetic Ingredient. This product is approved for use in Canada in personal care and cosmetic applications only. TSCA Section 12(b) Export Notification (40 CFR 707, Subpt. D) CERCLA Hazardous Substance List (40 CFR 302.4) SARA 304 Emergency release notification OSHA Specifically Regulated Substances (29 CFR ) Superfund Amendments and Reauthorization Act of 1986 (SARA) SARA 302 Extremely hazardous substance SARA 311/312 Hazardous chemical Classified hazard categories SARA 313 (TRI reporting) Other federal regulations Serious eye damage or eye irritation Clean Air Act (CAA) Section 112 Hazardous Air Pollutants (HAPs) List Clean Air Act (CAA) Section 112(r) Accidental Release Prevention (40 CFR ) Safe Drinking Water Act (SDWA) FEMA Priority Substances Respiratory Health and Safety in the Flavor Manufacturing Workplace TRADE SECRET (CAS Proprietary) Other Flavoring Substances with OSHA PEL's 5 / 6

6 International Inventories Country(s) or region Inventory name On inventory (yes/no)* Australia Australian Inventory of Chemical Substances (AICS) Canada Canada China Japan Korea New Zealand Philippines Taiwan Domestic Substances List (DSL) Non-Domestic Substances List (NDSL) Inventory of Existing Chemical Substances in China (IECSC) Inventory of Existing and New Chemical Substances (ENCS) Existing Chemicals List (ECL) New Zealand Inventory (NZIoC) Philippine Inventory of Chemicals and Chemical Substances (PICCS) Taiwan Inventory (TCSI) United States & Puerto Rico Toxic Substances Control Act (TSCA) Inventory *A "" indicates that all components of this product comply with the inventory requirements administered by the governing country(s) A "No" indicates that one or more components of the product are not listed or exempt from listing on the inventory administered by the governing country(s). 16. Other information, including date of preparation or last revision Issue date Revision date Version # 05 Disclaimer Revision information Terms and Conditions. This SDS is designed only as guidance for the products to which it applies. To the greatest extent permitted by applicable law, nothing contained herein creates any legal obligation including contractual obligations, expressed or implied warranties, including any warranties of merchantibility or fitness for particular purpose; or confers any intellectual property rights, including rights to use trademarks or a license to use patents, issued or pending. The information contained herein is based on the manufacturer's own study and the work of others, and is subject to change at any time without further notice. There is no warranty, expressed or implied, as to the accuracy, completeness or adequacy of the information contained herein, and neither the provider nor the manufacturer (nor the agents, directors, officers, contractors or employees of either) are liable to any party for any damages of any nature, including direct, special or consequential damages arising out of or in connection with the accuracy, completeness, adequacy or furnishing of any information in this SDS, or in any other way related (directly or indirectly) to this SDS. The receipt and use of this information constitutes consent to these terms and conditions. This document has undergone significant changes and should be reviewed in its entirety. No No No 6 / 6