MATERIAL SAFETY DATA SHEET. Revision Number: 0 1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND THE COMPANY/UNDERTAKING

Transcription

1 SRO-150 MATERIAL SAFETY DATA SHEET Print date: 20-Aug-2012 Revision Number: 0 Revision date: 1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND THE COMPANY/UNDERTAKING SRO-150 Product Name: Article Code: Synonyms: Chemical characterisation: No data is available on the product itself. Supplier: Summit Industrial Products 9010 County Road 2120 Tyler, Texas Phone: (903) Fax: (903) Emergency telephone number CHEMTREC: , International: (703) COMPOSITION/INFORMATION ON INGREDIENTS Components CAS-No ACGIH (TWA mg/m 3 ): OSHA (TWA mg/m 3 ): Synthetic Hydrocarbon 5 mg/m3(oil mist) 5 mg/m3(oil mist) Note for Non-Hazardous Components Components not precisely identified above are non-hazardous as defined by applicable laws. 3. HAZARDS IDENTIFICATION Properties affecting health: Principle routes of exposure: Skin contact: Eye contact: Inhalation: Ingestion: None. Skin. Respiratory system. Substance may cause slight skin irritation. Avoid contact with eyes. May cause slight irritation. Avoid breathing vapors or mists. Vapors and/or aerosols which may be formed at elevated temperatures may be irritating to eyes and respiratory tract. Ingestion may cause gastrointestinal irritation, nausea, vomiting and diarrhoea 4. FIRST AID MEASURES General advice: Skin contact: If symptoms persist, call a physician. Wash off immediately with soap and plenty of water. If skin irritation persists, call a physician. Remove and wash contaminated clothing before re-use. Product name: SRO of 5

2 Eye contact: Inhalation: Ingestion: Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. If eye irritation persists, consult a specialist. In the case of inhalation of aerosol/mist consult a physician if necessary. Move to fresh air. Do not induce vomiting. Never give anything by mouth to an unconscious person. Drink 1 or 2 glasses of water. If symptoms persist, call a physician. Suitable extinguishing media: Dry chemical, Carbon dioxide (CO2), Foam 5. FIRE-FIGHTING MEASURES Extinguishing media which must not be used for safety reasons:. Special protective equipment for firefighters: Standard procedure for chemical fires. As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. Specific hazards: Unusual hazards: Specific methods: Flash point: Autoignition temperature: Flammability Limits in Air: Lower Upper Not applicable. No hazards to be especially mentioned In the event of fire, cool tanks with water spray 545 ( F). 6. ACCIDENTAL RELEASE MEASURES Personal precautions: Environmental precautions: Methods for cleaning up: Wear personal protective equipment. Contaminated surfaces will be extremely slippery. Prevent further leakage or spillage if safe to do so. Do not let product enter drains. Do not flush into surface water or sanitary sewer system. Should not be released into the environment. Absorb spill with inert material (e.g. dry sand or earth), then place in a chemical waste container. 7. HANDLING AND STORAGE Handling Technical measures/precautions: Safe handling advice: Storage Technical measures/storage conditions: Incompatible products: No special technical protective measures required. Spilling onto the container`s outside will make container slippery. Keep containers dry and tightly closed to avoid moisture absorption and contamination. No special restrictions on storage with other products. 8. EXPOSURE CONTROLS / PERSONAL PROTECTION Engineering measures to reduce exposure: Ensure adequate ventilation, especially in confined areas. 2 of 5

3 Personal Protective Equipment Respiratory protection: Hand protection: Skin and body protection: Eye protection: Hygiene measures: In case of mist, spray or aerosol exposure wear suitable personal respiratory protection and protective suit. Nitrile rubber. Usual safety precautions while handling the product will provide adequate protection against this potential effect. Safety glasses Wash hands before breaks and immediately after handling the product.. Keep away from food, drink and animal feeding stuffs.. 9. PHYSICAL AND CHEMICAL PROPERTIES Physical State: Liquid Color: Light yellow Specific gravity: <1.0 Evaporation rate: Vapor pressure: Appearance: Odor: Boiling point/range Vapor density: Solubility: Liquid Mild Insoluble. 10. STABILITY AND REACTIVITY Stability: Polymerization: Hazardous decomposition products: Materials to avoid: Conditions to avoid: Stable under recommended storage conditions. Hazardous polymerisation does not occur. None under normal use Strong oxidising agents. Stable at normal conditions 11. TOXICOLOGICAL INFORMATION Acute toxicity: No data available 12. ECOLOGICAL INFORMATION Mobility: Bioaccumulative potential: Not applicable. Ecotoxicity effects: Aquatic toxicity: No data available. 13. DISPOSAL CONSIDERATIONS Waste from residues / unused products: Contaminated packaging: In accordance with local and national regulations. Empty containers should be taken for local recycling, recovery or waste disposal DOT 14. TRANSPORT INFORMATION TDG (Canada) 3 of 5

4 14. TRANSPORT INFORMATION IMO / IMDG ICAO IATA 15. REGULATORY INFORMATION International Inventories PICCS: This product complies w ith phil: TSCA: Listed in TSCA DSL: All of the components in this product are listed in DSL ENCS: This product does not comply w ith JPENCS CHINA: This product complies w ith china: AICS: All the constituents of this material are listed on the Australian Inventory of Chemical Substances (AICS). KECL: This product complies w ith korea: EINECS/ELINCS This product complies w ith EINECS/ELINCS U.S. Regulations: Sara (311, 312) hazard class: Canada WHMIS hazard class: 16. OTHER INFORMATION NFPA Health: 1 Flammability: 1 Instability: 0 HMIG Health: 1 Flammability: 1 Reactivity: 0 NFPA symbol: Reason for revision: Prepared by: Not applicable Health & Safety 4 of 5

5 The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text. 5 of 5