SOLEC-Solar Energy Corporation Material Safety Data Sheet

Transcription

1 SOLEC-Solar Energy Corporation Material Safety Data Sheet LO/MIT-II Radiant Barrier Coating (IRCC) Rev. 11/12/13 1. Product and Company Identification SOLEC-Solar Energy Corporation General MSDS Assistance: (609) Walters Avenue 24 Hour Emergency (Chemtrec): (800) Ewing, NJ , USA International Assistance (Chemtrec): (703) Commercial Product Name: LO/MIT-II Chemical Name: Not Applicable Chemical Family: Not Applicable Hazard Class: Not Applicable (non-flammable) Physical Form: Liquid Color: Silver Odor: Ethereal Alcohol NFPA Profile: Health 1, Flammability 0, Instability/Reactivity 0 2. Hazards Identification Classification: Water-based radiant barrier coating (non-hazardous) Eye Contact: Direct contact may cause severe irritation. Skin Contact: A single relatively short exposure will not cause irritation. Prolonged or repeated contact may cause mild irritation. Inhalation: Prolonged or repeated exposure may cause drowsiness and irritate the nose and throat. Ingestion: Small amounts transferred to the mouth by the fingers may cause nausea. Swallowing large amounts may cause gastrointestinal irritation, nausea, vomiting & diarrhea. Aspiration of material into the lungs may cause pulmonary injury. DO NOT INGEST 3. Composition/Information on Ingredients CAS Number Component Name % Weight % Volume DI Water >70 >75 * Proprietary Pigment 0 > Stoddard Solvent <3 < Propylene Glycol Nitroethane Glycol Ether * Mixture Surfactant Aqueous Resin Mixture Acrylic Polymer > Sodium Dioctyl <2 * The specific chemical identity has been withheld as a trade secret

2 4. First Aid Measures Eye Contact: Flush eyes with plenty of water while holding eyelids open. Skin Contact: Remove contaminated clothing/shoes. Launder before reuse. Clean exposed area with isopropyl alcohol, then wash with soap & water and apply a good hand cream. If irritation occurs, get medical attention. Inhalation: Remove to fresh air. If breathing is irregular, administer oxygen. Ingestion: DO NOT INDUCE VOMITING. Get medical attention. 5. Firefighting Measures Flash Point: Greater than 240 degrees F, 116C Flammable Limits (% volume in air): None, LO/MIT-II is non-flammable Extinguishing Media: None, LO/MIT-II is non-flammable Special Firefighting Procedures: Use water to keep containers cool. Wear self-contained positive pressure breathing apparatus and full firefighting protective clothing. 6. Accidental Release Measures Containment/Cleanup: Small Spill: Cover spill with an inert absorbing material, sweep up and place in a waste disposal container. Large Spill: Dike area of spill to prevent spreading. Pump liquid to salvage tank. Remaining liquid may be taken up with sand, clay, earth, floor absorbent or other absorbent material. Waste Disposal Method: Wash area with mild detergent & water and dispose. SOLEC suggests that all local, state & federal regulations concerning health & pollution be reviewed to determine approved disposal procedures. Dried LO/MIT-II residue is NOT flammable. LO/MIT-II in any form will not support combustion If LO/MIT-II in liquid form becomes a waste material, it would NOT be a Hazardous Waste 7. Handling and Storage Handling: Use with adequate ventilation. Avoid spillage. Avoid eye exposure. Avoid prolonged skin contact. Wash with soap and water before eating, drinking or smoking. Minimize breathing of vapors. Keep container closed. Do not take internally. Launder contaminated clothes before re-use. Storage: Do not store near oxidizers, acids or caustics. Keep containers closed when not in use Evaporation of water and solvent may cause gelation. Empty Containers: Empty containers may contain a residue of LO/MIT-II and should not be re-used. Empty containers should be disposed of by a permitted waste disposal company in accordance with local, state and federal law.

3 Component Exposure Limits: 8. Exposure Controls/Personal Protection CAS Number Component Name Exposure Limits Stoddard Solvent Propylene Glycol Nitroethane Glycol Ether Sodium Dioctyl Obs. Stod.Solv. Limits. OSHA PEL (final rule) & ACGIH TLV: TWA 100 ppm, STEL 300 ppm Obs. Prop Glyc. Limits. OSHA PEL (final rule) & ACGIH TLV: TWA 150 ppm, STEL 150 ppm Observe Nit.Eth. limits. OSHA PEL (final rule) & ACGIH TLV: TWA 100 ppm, PEL: 100 ppm Observe Gly.Eth. Limits. OSHA PEL (final rule) & ACGIH TLV: TWA 25 ppm, STEL 35 ppm ACGIH, OSHA, NIOSH: None Listed Engineering Controls: Local Ventilation: Recommended General Ventilation: Recommended Personal Protection Equipment: Respiratory Protection: Avoid prolonged or repeated breathing of vapors. If exposure may exceed permissible exposure limits, use a NIOSH approved respirator to prevent overexposure. Protective Clothing: Avoid contact with the eyes. Wear chemical splash goggles if there is a likelihood of contact with eyes. Avoid prolonged or repeated contact with the skin. Wear chemical resistant gloves and impervious clothing and boots. Physical Form: Liquid Color: Silver Odor: Ethereal Alcohol 9. Physical and Chemical Properties Vapor Density (Air = 1): Specific Gravity (H20 = 1): Odor Threshold: 100 ppm % Volatile by Volume: <6% ph: Neutral % Solids by Weight: <25% VOC Content: Reg g/l, Act g/l Viscosity: <5cP, 29 Sec #1 Zahn's Cup Flash Point: Greater than 240F, 116C Melting Point/Freezing Point: Not Determined Boiling Point: Greater than 160F, 71C Solubility in Water: 100% soluble Autoignition Temperature: Not Determined Flammability Limits in Air: Not Applicable 10. Stability and Reactivity Chemical Stability: Stable Hazardous Polymerization: Will not occur Conditions to Avoid: Soucres of ignition, heat Materials to Avoid: Strong Oxidizing Agents, Acids, Caustics Hazardous Decomposition Products: Carbon Dioxide, Carbon Monoxide, Aluminum Oxide, Nitrogen Oxides, Oxides of Sulfur, Ammonia, Smoke

4 11. Toxicological Information Toxicity Data: CAS Number Component Name % Weight Effects from Acute Exposure Stoddard Solvent < Propylene Glycol Nitroethane Glycol Ether Sodium Dioctyl >5,000 mg/kg (Rat),400 ppm for 4 hrs (Rat) >3,000 ul/kg (Rabbit) 20,000mg/kg (Rat) 15,000 ppm for 4 hrs (Rat) 20,800 mg/kg (Rabbit) 1,100 mg/kg (Rat) 2,000 ppm for 4 hrs (Rat) 2,200 mg/kg (Rabbit) 470 mg/kg (Rat) 450 ppm for 4 hrs (Rat) 220 mg/kg (Rabbit) 3,100 mg/kg (Rat) None Listed 10,000 mg/kg (Rabbit) Ecotoxicity: This mixture contains components that are potentially toxic to freshwater and saltwater ecosystems. Environmental Biodegradability: Readily biodegradable in aerobic conditions. Partition Coefficient (log kow): Stoddard Solvent, 2 to 3 (based on similar materials) Bioaccumulative Potential Assessment: Polymer component - Bioaccumulation is not expected to occur Stability in Water: The product is completely soluble in water Distribution: Principally to air. 12. Ecological Information

5 SOLEC suggests that all local, state and federal regulations concerning health & pollution be reviewed to determine approved disposal procedures. If LO/MIT-II in liquid form becomes a waste material, it would NOT be a Hazardous Waste Empty Containers: Empty containers may contain a residue of LO/MIT-II and should not be re-used. Empty containers should be disposed of by a permitted waste disposal company in accordance with local, state and federal law. DOT Road Shipment Information: Proper Shipping Name: Water-based Radiant Barrier Coating (non-hazardous) Hazard Technical Name: N/A Hazard Class: N/A UN/NA Number: N/A Packing Group: N/A Hazard Labels: N/A Shipping Class: 55 NMFC Number: Emergency Contact: Chemtrec (800) Ocean Shipment Information (IMDG): Proper Shipping Name: Water-based Radiant Barrier Coating (non-hazardous) Hazard Technical Name: N/A Hazard Class: N/A UN/NA Number: N/A Packing Group: N/A Flash Point: N/A Hazard Labels: N/A Emergency Contact: Chemtrec (703) Air Shipment Information (IATA): 13. Disposal Considerations 14. Transportation Information Proper Shipping Name: Water-based Radiant Barrier Coating (non-hazardous) Hazard Technical Name: N/A Hazard Class: N/A UN/NA Number: N/A Packing Group: N/A Packing Inst.: N/A Hazard Labels: N/A Emergency Contact: Chemtrec (703) Emergency Response Guide Number: N/A

6 15. Regulatory Information Components of this product are listed in the EPA/TSCA Inventory of Chemical Substances EPA SARA Title III Chemical Listings Section 302 Extremely Hazardous Substances (40 CFR 355): None Section 304 CERCLA Hazardous Substances (40 CFR 302): CAS Number Component Name % Weight % Volume Stoddard Solvent <3 < Propylene Glycol Nitroethane Glycol Ether Sodium Dioctyl <2 Section 311/312 Hazard Class (40 CFR 370): Acute: None Fire: None Reactive: No Chronic: None Pressure: None Section 313 Toxic Chemicals (40 CFR 372): None NFPA Profile: Health 1, Flammability 0, Instability/Reactivity 0 Prepared By: SOLEC-Solar Energy Corporation 16. Other Information The information contained herein is based on the data available to us and is believed to be correct. However, SOLEC makes no warranty, expressed or implied regarding the accuracy of this data and the results to be obtained from the use thereof.