Pre-Feasibility Report

Transcription

1 Pre-Feasibility Report Essentials Pharma 1

2 1. Introduction M/s. Essentials Pharma is an new unit to be located at Plot 19, Survey 10/1, Rajkot-Ahmedabad National Highway 8-B, Village: Hirasar, Tal: Rajkot, District: Rajkot, Gujarat. The unit proposes to manufacture bulk drugs above site location. 2. Cost of Project Total Cost of the proposed project is around Rs. 2.3 crore, out of which 40 lakhs will be used for Environment Management System. 3. Production Capacity Production capacity is prescribe below: List of Products Name of Product (MTPM) (MTPA) 1 Povidone-iodine 2 Carbamazepine 3 Potassium Citrate 4 Metforminhydrochloride Oxyclozanide 6 Sodium Citrate 4. List of Raw Materials List of raw materials is given below: Name of Raw materials Povidone-Iodine- 1 MT/Month (MTPM) 1 Povidone Iodine 0.12 Carbamazepine-1 MT/Month 1 Iminostibene carbonyl chloride Amonium carbonate 0.55 Potassium Citrate-1 MT/Month 1 Potassium Hydroxide flakes 0.55 Essentials Pharma 2

3 2 Citric acid Monohydrate 0.62 Metformin Hydrochloride-1 MT/Month 1 Dimethyl Amino HCl Dicyandiamide 0.53 Oxyclozanide-1 MT/Month 1 2-Amino-4,6-Dichlorophenol ,5,6-trichloro salicylic acid 0.65 Sodium Citrate-1 MT/Month 1 Sodium Hydroxide Citric Acid Monohydrate Manufacturing Process Manufacturing process is given as Annexure-II in application form. 6. Details of manpower Total manpower requirement at all level of plant will be Water Consumption & Waste Water Generation Break up Water Consumption (lit/day) Waste water generation (lit/day) I Domestic II Gardening III Industrial 1 Water treatment Process Boiler Cooling Washing Total Industrial Total (I+II+III) Essentials Pharma 3

4 8. Source of Pollution Details of Air Pollution Main source of air pollution will be from stack attached with Boiler. Agro waste (briquette) will be used as fuel & Cyclone will be provided as APCM. Proper stack height will be provided for proper atmospheric dispersion of pollutants. Stack attached to Fuel Type & rate of consumption Stack Height (m) APC measures Probable emission Flue Gas Stacks 1. Boiler Agrow waste (briquettes): 16 Cyclone PM<150 mg/nm 3 SO 2 <100 ppm 0.6 TPD 3. D.G. Set HSD - 35 Lit/hr NO x <50 ppm (125 KVA) Source and disposal of waste water Source of wastewater generation is mainly from process, washing & utility. Entire qty. of generated industrial effluent will be treated in ETP and finally evaporated in kettle type evaporator to achieve zero discharge. Domestic effluent will be disposed off to soak pit through septic tank. Source and disposal of Hazardous wastes Summary of waste and ultimate disposal are summarized below: Type of Waste Category of Waste Disposal facility 1. ETP sludge Collection, Storage, & Evaporation salt MT/month Transportation & Disposal at TSDF site approved by GPCB. 2. Used Lubricating Oil kl/year Collection, Storage, Transportation & disposal by 3. Discarded drums /containers Liners nos./month 50 kg/month selling to Registered Recyclers. Being used for packing of ETP sludge in case of excess it will be sold to approved recycler or traders. Essentials Pharma 4

5 9. Funds for pollution control measures The management is quite conscious of its responsibility for maintaining clear environment adequate funds can be provided for the pollution control measures as financing part of overall project. 10. Monitoring facilities Air sampling will be done by outside agency for required parameters and analysis report will be sent to concerned authority as part of compliances. 11. Conclusion On the basis of information presented in the pre-feasibility report on pollution control measures and after its implementation, there will be no discharge of effluent and air emission from the plant beyond the norms specified by the Board as per the provisions of Air (Prevention and Control of Pollution) Act, 1981 and Water (Prevention and Control of Pollution) Act, Essentials Pharma 5