Page 1 / 7 Safety Data Sheet. Lubricant. Issuing Date Revision Date Version 1. Warning

Transcription

1 Page 1 / 7 Safety Data Sheet SDS # : D-0419 Issuing Date Revision Date Version 1 1. PRODUCT AND COMPANY IDENTIFICATION Active Trade Name Part no. for Xerox Products 070P00043 Color Pure substance/mixture Identified uses Manufactured by Dark gray Mixture Xerox Corporation Rochester, NY Emergency telephone Safety Information US: (800) Chemical Emergency only (Chemtrec) (800) HAZARDS IDENTIFICATION Warning Emergency Overview May cause sensitization by skin contact Causes eye and skin irritation Color Dark gray Appearance Paste Classification of the substance or mixture Physical state Solid Odor Mild Consumers Skin Corrosion/Irritation Category 2 Serious Eye Damage/Eye Irritation Category 2 Skin Sensitization Sub-category 1B GHS Label elements, including precautionary statements Symbol(s) Signal Word Warning

2 SDS # : D-0419 Page 2 / 7 Hazard Statements Precautionary Statements Potential Health Effects Principle Routes of Exposure Acute Toxicity Eyes Skin Inhalation Ingestion Chronic effects Main symptoms Environmental hazard H315 - Causes skin irritation H319 - Causes serious eye irritation H317 - May cause an allergic skin reaction P202 - Do not handle until all safety precautions have been read and understood P261 - Avoid breathing dust/fume/gas/mist/vapors/spray P264 - Wash hands thoroughly after handling P272 - Contaminated work clothing should not be allowed out of the workplace P280 - Wear protective gloves/protective clothing/eye protection/face protection P302 + P352 - IF ON SKIN: Wash with plenty of soap and water P305 + P351 + P338 - IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing P333 + P313 - If skin irritation or rash occurs: Get medical advice/attention P337 + P313 - If eye irritation persists: Get medical advice/attention P501 - Dispose of contents/container to an appropriate disposal facility in accordance with all local, regional, national, and international regulations. Skin contact Irritating to eyes Irritating to skin, May cause sensitization by skin contact No known effect May be harmful if swallowed Prolonged or repeated skin contact may cause dermatitis and sensitization See Section 12 for additional Ecological Information 3. COMPOSITION/INFORMATION ON INGREDIENTS Product Description Varies = may contain one or more of the following , , , , , , , , , , , , , , , , , , , , , , , , , , , Chemical Name CAS No. Weight % Base oil - highly refined VARIES Molybdenum disulfide <3 Calcium carbonate <3 1,3,4-Thiadiazole-2(3H)-thione, 5,5'-dithiobis <3 Phosphoric acid esters, amine salt PROPRIETARY <1 Calcium bis(dinonylnaphthalenesulphonate) <1 Amines, C12-14-alkyl, reaction products with <1 hexanol, phosphorus oxide (P2O5), phosphorus sulfide (P2S5) and propylene oxide Alkenyl amine PROPRIETARY <1 2,5-Bis(octyldithio)-1,3,4-thiadiazole <1 4. FIRST AID MEASURES General advice Eye contact When symptoms persist or in all cases of doubt seek medical advice. Show this material safety data sheet to the doctor in attendance. Immediately flush with plenty of water. After initial flushing, remove any contact lenses and

3 SDS # : D-0419 Page 3 / 7 continue flushing for at least 15 minutes, Get medical attention Skin contact Inhalation Ingestion Notes to physician Protection of first-aiders Wash off immediately with soap and plenty of water for at least 15 minutes, Remove and wash contaminated clothing before re-use, Get medical attention Move to fresh air in case of accidental inhalation of vapors or decomposition products, Get medical attention immediately if symptoms occur Do not induce vomiting without medical advice, Get medical attention if symptoms occur, Rinse mouth, Drink plenty of water May cause sensitization by skin contact 5. FIRE-FIGHTING MEASURES Flammable properties Not flammable Flash point 260 C / 500 F Method Cleveland Open Cup (COC) Suitable extinguishing media Unsuitable extinguishing media Water fog, Alcohol-resistant foam, Dry chemical, Carbon dioxide Do not use a solid water stream as it may scatter and spread fire Specific hazards arising from the chemical Closed containers may expand and subsequently burst when exposed to extreme heat. Hazardous combustion products Explosion Data Sensitivity to Mechanical Impact Sensitivity to Static Discharge Carbon dioxide (CO2), Carbon monoxide, Nitrogen oxides (NOx), Sulfur oxides, Metal oxides Not impact sensitive Not sensitive Protective Equipment and Precautions for Firefighters As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. 6. ACCIDENTAL RELEASE MEASURES Personal Precautions Ensure adequate ventilation, For personal protection see section 8 Methods for containment Methods for cleaning up Other information Prevent further leakage or spillage if safe to do so Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). The environmental impact of this product has not been fully investigated. However, this preparation is not expected to present significant adverse environmental effects. 7. HANDLING AND STORAGE Advice on safe handling Handle in accordance with good industrial hygiene and safety practice, Avoid inhalation of vapors/mist and contact with skin and eyes

4 SDS # : D-0419 Page 4 / 7 Technical measures and storage conditions Hygiene measures Store in original container/properly labeled. Keep tighly closed, protect from sunlight, store in cool dry well ventilated place. Do not store with incompatible materials in section 10 None under normal use conditions 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Exposure guidelines Product Information Xerox Exposure Limit None established. Chemical Name ACGIH TLV OSHA PEL Molybdenum disulfide TWA: 10 mg/m 3 TWA: 3 mg/m 3 Occupational exposure controls Engineering measures None under normal use conditions. Personal Protective Equipment Consumer use Respiratory protection Eye/Face protection Skin and body protection Hand protection These recommendations apply to the product as supplied None required under normal usage 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance Paste Odor Mild Odor threshold Physical state Solid ph Color Dark gray Flash point 260 C / 500 F Boiling N.D. Autoignition temperature point/range Flammability Limits in Air Not applicable Vapor pressure Vapor density Density <1000 kg/m 3 (<1 g/cm3) at 25 C Water solubility Insoluble Viscosity Partition coefficient Evaporation rate Melting point/range

5 SDS # : D-0419 Page 5 / 7 Freezing point Decomposition temperature Specific gravity 10. STABILITY AND REACTIVITY Reactivity Stability Incompatible products Conditions to Avoid No specific test data available for this product. Refer to Conditions to avoid and incompatible materials for additional information Stable Oxidizing agents No specific data Hazardous Decomposition Products None under normal use conditions Hazardous polymerization Hazardous reactions Hazardous polymerization does not occur None under normal processing 11. TOXICOLOGICAL INFORMATION Acute Toxicity Product Information Chemical Name Oral LD50 Dermal LD50 LC50 Inhalation Base oil - highly refined 5000 mg/kg ( Rat ) 2000 mg/kg ( Rabbit ) 2.18 mg/l ( Rat ) 4 h Molybdenum disulfide 2820 mg/m 3 ( Rat ) 4 h Calcium carbonate 6450 mg/kg ( Rat ) Chronic toxicity Main symptoms Carcinogenicity Other toxic effects Product Information Skin/Eye Irritation Sensitization Mutagenic effects Teratogenicity Target organ effects Aspiration Hazard Other adverse effects Prolonged or repeated skin contact may cause dermatitis and sensitization Contains no ingredient listed as a carcinogen Causes eye and skin irritation May cause sensitization by skin contact Not determined Not applicable 12. ECOLOGICAL INFORMATION Ecotoxicity The environmental impact of this product has not been fully investigated. Chemical Name Toxicity to algae Toxicity to fish Toxicity to microorganisms Base oil - highly refined LC50> 5000 mg/l Toxicity to daphnia and other aquatic invertebrates EC50 > 1000 mg/l 48 h

6 SDS # : D-0419 Page 6 / 7 Oncorhynchus mykiss 96 h Persistence and degradability Bioaccumulation Mobility No component data available Other adverse effects 13. DISPOSAL CONSIDERATIONS Waste Disposal Methods This material, as supplied, is not a hazardous waste according to Federal regulations (40 CFR 261). This material could become a hazardous waste if it is mixed with or otherwise comes in contact with a hazardous waste, if chemical additions are made to this material, or if the material is processed or otherwise altered. Consult 40 CFR 261 to determine whether the altered material is a hazardous waste. Consult the appropriate state, regional, or local regulations for additional requirements. Contaminated packaging Dispose of in accordance with local regulations. 14. TRANSPORT INFORMATION Note This material is not subject to regulation as a hazardous material for shipping 15. REGULATORY INFORMATION International Inventories TSCA Complies U.S. Federal Regulations SARA 313 Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA). This product does not contain any chemicals which are subject to the reporting requirements of the Act and Title 40 of the Code of Federal Regulations, Part 372 Clean Water Act This product does not contain any substances regulated as pollutants pursuant to the Clean Water Act (40 CFR and 40 CFR ) Clean Air Act, Section 112 Hazardous Air Pollutants (HAPs) (see 40 CFR 61) This product does not contain any substances regulated as hazardous air pollutants (HAPS) under Section 112 of the Clean Air Act Amendments of CERCLA This material, as supplied, does not contain any substances regulated as hazardous substances under the Comprehensive Environmental Response Compensation and Liability Act (CERCLA) (40 CFR 302) or the Superfund Amendments and Reauthorization Act (SARA) (40 CFR 355). There may be specific reporting requirements at the local, regional, or state level pertaining to releases of this material TSCA This product complies with TSCA12(b) US State Regulations

7 SDS # : D-0419 Page 7 / 7 California Proposition 65 This product does not contain any Proposition 65 chemicals U.S. State Right-to-Know Regulations This product is subject to U.S. State Right-to-know regulations as noted below. Chemical Name Massachusetts New Jersey Pennsylvania Illinois Minnesota Molybdenum disulfide X X Canada This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations (CPR) and the SDS contains all the information required by the CPR. 16. OTHER INFORMATION Issuing Date Revision Date Revision Note (M)SDS sections updated:, 3 Disclaimer The information provided on this SDS is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guide for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered as a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other material or in any process, unless specified in the text. end