HMIS RATING: Health- 1 Flammability- 1 Reactivity- 0

Transcription

1 Title: FLUOROGLIDE FB SPRAY Page: 1 Of 5 SECTION I- Identification of Product PRODUCT NAME: Fluoroglide FB Spray OTHER/GENERIC NAMES: N/A FORM: Aerosol Spray HMIS RATING: Health- 1 Flammability- 1 Reactivity- 0 PRODUCT USE: Film bonding grade dry film lubricant and anti-stick agent. MANUFACTURERS NAME/ADDRESS: Saint-Gobain Performance Plastics Corp. 150 Dey Road, Wayne, NJ USA EMERGENCY TELEPHONE NO.: CHEM-TEL Inc. US: Worldwide TECHNICAL ASSISTANCE TELEPHONE NO.: SECTION II- Composition/Information on Ingredients Ingredient Name CAS Number Weight % Isopropanol % Poly-TFE % 1,1,1,2-Tetrafluoroethane % Acetone % SECTION III- Hazards Identification EMERGENCY OVERVIEW: Contents under pressure. Prolonged exposure to sunlight or heat may cause bursting of can. Potential Health Hazards: SKIN: Not anticipated under recommended usage. Contact with skin may cause irritation. EYES: Not anticipated under recommended usage. Contact with eyes may cause irritation. INHALATION: Not anticipated under recommended usage. Overexposure by inhalation may cause dizziness and loss of concentration. INGESTION: Not anticipated under recommended usage. DELAYED EFFECTS: Prolonged overexposure may contribute to drying or flaking of skin. Ingredients found on one of the OSHA designated carcinogen lists are listed below: None known. Section IV- First Aid Measures SKIN: Wash affected area with soap and water. EYES: Flush thoroughly with water for at least 15 minutes. INHALATION: Move to fresh air. Give oxygen to exposed person, if necessary. INGESTION: Do not induce vomiting. Drink two glasses of water and contact physician, hospital, or poison control center. ADVICE TO PHYSICIAN: Never give adrenaline following overexposure.

2 Title: FLUOROGLIDE FB SPRAY Page: 2 Of 5 SECTION V- Fire Fighting Measures Flammable Properties FLASH POINT ( o F): N/A FLASH POINT METHOD: N/A AUTO IGNITION TEMPERATURE: N/A UPPER FLAME LIMIT (volume % in Air): N/A LOWER FLAME LIMIT (volume % in Air) N/A OXYGEN INDEX: N/A Flammability Classification: (NFPA) Level 1 Aerosol EXTINGUISHING MEDIA: Carbon dioxide, dry chemical, foam, and water fog. UNUSUAL FIRE AND EXPLOSIVE HAZARDS: Aerosol cans are under pressure, exposure in excess of 120 F may cause bursting of can. SPECIAL FIRE FIGHTING PRECAUTIONS/INSTRUCTIONS: Self-contained respiratory protection should be provided for firemen fighting in buildings or confined areas. SECTION VI- Accidental Release Measures IN CASE OF SPILLS OR OTHER RELEASE: Use absorbent sweeping compound to soak up material. Put into closed DOT approved containers for disposal. SECTION VII- Handling and Storage NORMAL HANDLING: Shake well before using. Keep away from heat, sparks, open flame, or direct sunlight. Do not puncture or incinerate can. STORAGE RECOMMENDATIONS: Keep away from heat, sparks, open flame, or direct sunlight. SECTION VIII- Exposure Controls/Personal Protection VENTILATION: General Ventilation should be provided. PERSONAL PROTECTIVE EQUIPMENT: None required if material is used within specified processing parameters. Normal safety equipment should always be used in an industrial environment. Eye protection must be worn during any machining operations. ADDITIONAL RECOMMENDATIONS: Wash hands after use. EXPOSURE GUIDELINES/LIMITS: Not applicable. OTHER EXPOSURE LIMITS FOR POTENTIAL DECOMPOSITION PRODUCTS: N/A

3 Title: FLUOROGLIDE FB SPRAY Page: 3 Of 5 SECTION IX- Physical and Chemical Properties APPEARANCE: Clear colorless liquid. PHYSICAL STATE: Liquid, gaseous. ODOR: Mild ethereal odor. SPECIFIC GRAVITY (H 2 O = 1):1.20 SOLUBILITY IN WATER (weight %): Very slight. ph: N/A BOILING POINT: (concentrate, o F) MELTING POINT: N/A VAPOR F: 70 psi VAPOR DENSITY (Air=1): 4.1 EVAPORATION RATE (Butyl Acetate=1): >1 % VOLATILES: N/A IGNITION TEMPERATURE: N/A FLASH POINT ( o F): N/A THERMAL DECOMPOSITION: See Section X. SECTION X- Stability and Reactivity CHEMICAL STABILITY: Stable. CONDITIONS TO AVOID: Avoid open flames and high temperatures. INCOMPATIBILITIES (Specific Materials to Avoid): Strong oxidizing agents and alkalies. HAZARDOUS DECOMPOSITION PRODUCTS: At high temperature it decomposes to CO, CO 2, HF, and possibly other carbonyl halides. HAZARDOUS POLYMERIZATION: Will not occur. SECTION XI- Toxicological Information GENERAL: LC50 for rats is ppm, Cardiac Sensitization Threshold is ppm. IMMEDIATE (ACUTE) EFFECTS: See section VII. DELAYED (SUBCHRONIC AND CHRONIC) EFFECTS: N/A TOXICITY OF PRODUCT: N/A OTHER DATA: N/A SECTION XII- Ecological Information N/A

4 Title: FLUOROGLIDE FB SPRAY Page: 4 Of 5 SECTION XIII- Disposal Considerations Always use up product according to label directions before disposal. Offer empty container for recycling where facilities exist. If recycling is not available, wrap empty container in newspaper and discard in trash. DO NOT PUNCTURE OR INCINERATE CONTAINER. SECTION XIV- Transport Information Domestic International SHIPPING NAME: Aerosols, Nonflammable, n.o.s. Aerosols, Nonflammable, n.o.s. HAZARD CLASS: UN No.: UN1950 UN1950 HAZARD LABEL: Class 2 - NONFLAMMABLE Class 2 - NONFLAMMABLE SECTION XV- Regulatory Information Toxic Substances Control Act (TSCA) TSCA INVENTORY STATUS: All chemical components are listed in the TSCA inventory. OTHER TSCA ISSUES: None SARA Title III/CERCLA Reportable Quantities (RQ s) and/or Threshold Planning Quantities (TPQ s) exist for the following ingredients. Ingredient Name None SARA/CERCLA RQ (lb) SARA EHS TPQ (lb) SECTION 311 HAZARD CLASS: None The following ingredients are SARA 313 Toxic Chemicals, CAS Numbers and weight percents are found in Section II. Ingredient Name Isopropyl Alcohol STATE RIGHT-TO-KNOW Comment In addition to the ingredients found in Section II, the following are listed for state right-to-know purposes. Ingredient Name Weight % Comment Acrylic Resin (CAS # n/a) NJ State Right to Know ADDITIONAL REGULATORY INFORMATION: N/A WHMIS CLASSIFICATION (CANADA): N/A FOREIGN INVENTORY STATUS: N/A

5 Title: FLUOROGLIDE FB SPRAY Page: 5 Of 5 SECTION XVI- Other Information This material safety data sheet was prepared in compliance with US OSHA Hazard Communication Standard 29CFR and the European Council Directive 91/155/EEC, 67/548 and 88/379/EEC as well as their relevant amendments, on the approximation of laws, regulations and administrative provisions relative to the classification, packaging and labeling of dangerous substances and preparations. The information and recommendations set forth above are taken from sources believed to be accurate as of the date hereof; however, Saint-Gobain Performance Plastics Corporation makes no warranty with respect to the accuracy of the information or the suitability of the recommendations, and assumes no liability to any user thereof. The information contained in this sheet does not constitute a hazard assessment and should not be used in place of the user s own assessment of workplace risks as required by other health and safety legislation.