PROYECTOR KOKOH UNE EN IK10 IP66

Transcription

1 PROYECTOR KOKOH UNE EN IK10 IP66

2 THE DATA SHOWN IN THIS DATA SHEET MAY BE SUBJECT TO CHANGES ACCORDING TO TREND TECHLOGY OUR ENGINEERING DEPARTMENT AND R & D + I UNE EN A C B IP66 IK10 Height (A) 310 mm Widht(B) 260 mm Mounting bracket (C) 220 mm Weight: 7,50 kg. TECHNICAL DATA LUMINAIRE - MAXIMUM AND MINIMUM VALUES K K K OPTICAL GROUP TOTAL POWER LED WORK EFFORT MINAL FLUX (*) PERFORMAN- CE MINAL FLUX (*) PERFORMAN- CE MINAL FLUX (*) PERFORMAN- CE L18 HE 15W 15 W 17,04% lm 146 lm/w lm 153 lm/w lm 153 lm/w L18 HE 70W 70 W 69,17% lm 102 lm/w lm 107 lm/w lm 108 lm/w L24 HE 20W 20 W 11,58% lm 153 lm/w lm 160 lm/w lm 161 lm/w L24 HE 140W 140 W 70,88% lm 104 lm/w lm 110 lm/w lm 110 lm/w L18 HP 15W 15 W 7,13 % lm 165 lm/w lm 176 lm/w lm 180 lm/w L18 HP 175W 175 W 74,77 % lm 115 lm/w lm 123 lm/w lm 124 lm/w L24 HP 70W 70 W 16,07 % lm 149 lm/w 11,164 lm 159 lm/w lm 163 lm/w L24 HP 225W 225 W 49,80 % lm 127 lm/w lm 135 lm/w lm 138 lm/w Led lifetime (**) : Maintenance of luminous flux t q 25 C to 100,000 working hours of 95% for all power (*) Nominal light flux is an indicative light Tj 25 C based on data provided by the LED manufacturer. The actual light flux output of the luminaire depends on the ambient conditions (eg temperature and contamination) and the optical efficiency of the luminaire. (**) Led lifetime according IES LM-80 - TM-21 standards. Standards: Photobiological safety certificate UNE-EN page 2

3 THE DATA SHOWN IN THIS DATA SHEET MAY BE SUBJECT TO CHANGES ACCORDING TO TREND TECHLOGY OUR ENGINEERING DEPARTMENT AND R & D + I KOKOH Technology TABLE WITH AVAIBLE OPTIONS BASE PROGRAMMABLE PREMIUM DRIVERS KOKOH DOUBLE LEVEL CONTROL LINE LUMIUS FLUX REGULATOR PROGRAMMED IN FACTORY SELF PROGRAMMABLE REMOTE MANAGEMENT SOLAR VERSION All options within the same range are combined. Number steps regulation in Base Option: 5 Number steps regulation in Programmable and Premium Option: 8 Electrical Characteristics Power available L18 HE version: From 15 W to 70 W (*) L24 HE version: From 20 W to 140 W(*) L18 HP version: From 15 W to 175 W (*) L24 HP version: From 70 W to 225 W (*) Color temperature 3.300º K, 4.300º K, 5.300º K (*) CRI From 75 to 90 Power regulation Until 60% power for regulated fixtures (*) Voltage 90 to 305 Vac / 47 to 63 Hz / cos α 0,95 Isolation Class I Working temperature -30 to +65º C Standards EN62384, EN , EN , EN EN61547, EN55015, EN and 2-5 (*) Standard parameters. If you require other values contact us, please. The technology developed by KOKOH allows to manufacture luminaires of any power with a variation of one watt in one watt, according to the needs of the client, in both LED chip version HE and HP, being able to adapt to 100% the power required by the surface to be illuminated and the energy consumption of the installation. Do not hesitate to contact us. Constructive Characteristics Structure Flood Light body are made up of LEDs heat sink, made of extruded aluminum tempered according to EN AW6060 T66 and black anodized color over the whole surface. Fasteners, handle, side flaps to control angle fixing and base components made of galvanized steel painted in black. LED Optical Block Optical LED fixed over the structure of the Flood Light directly. Optical block closure made of transparent polycarbonate fireproof, IP66 degree of protection. Fixing Three M-12 Diameter hole on the handle. Angle fixing Through lateral fins perforaded every 5º. page 3

4 THE DATA SHOWN IN THIS DATA SHEET MAY BE SUBJECT TO CHANGES ACCORDING TO TREND TECHLOGY OUR ENGINEERING DEPARTMENT AND R & D + I Option set BASE PROGRAMMABLE PREMIUM OPTICAL LED chip High efficiency, I max : ma High power, I max : ma LED number 12, 24 CCT Warm white (3.300º K) Neutral white (4.300º K) Cold white (5.300º K) Standard CCT. Optionally we can supply in the following CCT: 2.700º K, 3.000º K, K, 4.000º K, 4.500º K, 5.000º K, 5.700º K, 6.500º K The degrees Kelvin have a variation of up to ± 300 depending on the binning of the diode. CRI 75 CRI CRI 80 CRI 90 ELECTRONIC CONTROL Double level control line X X Programmed in factory Light flux variation Self-programmable Luminous flux regulator X X Remote management X Surge suppression protection device 10 KV Additional protection fuse SOLAR VERSION Solar 12 Vdc, 24 Vdc With solar option it is possible to combine any method of light flux variation OTHERS Prewired customizable length IP-67 connector 2P+TT Included Optional X Not available page 4

5 THE DATA SHOWN IN THIS DATA SHEET MAY BE SUBJECT TO CHANGES ACCORDING TO TREND TECHLOGY OUR ENGINEERING DEPARTMENT AND R & D + I Photometry MODEL 1 S-32 MODEL 2 S-57 MODEL 3 S-120 HIGH EFFICIENCY LENS Vision angle: 32º HIGH EFFICIENCY LENS Vision angle: 57º HIGH EFFICIENCY LENS Vision angle: 120º Applications Ornamental light, high altitudes and spot lighting installation located. Applications Ornamental light, pedestrian crossing, large indoor and outdoor areas and pro- Applications Ornamental light, large areas of indoor and outdoor and general lighting without Photometry exposed are the most commonly used for outdoor lighting. In addition to these, we have a wide range of lenses for any specific lighting requirement or space to iluminate. page 5

6 THE DATA SHOWN IN THIS DATA SHEET MAY BE SUBJECT TO CHANGES ACCORDING TO TREND TECHLOGY OUR ENGINEERING DEPARTMENT AND R & D + I Range of luminaire KOKOH The luminaires developed by KOKOH are encompassed in three categories: Base Preprogrammed Premium All ranges share the know-how of KOKOH such as quality of materials luminaires, the use of the latest generation LEDs with high lumen/watt ratio, in combination with high-performance lenses and photometry optimized for any type of lighting, optical block formed by a heat sink that combines high thermal conductivity with high mechanical strength and switching power supply with an efficiency of 92% and low ripple output voltage. The Preprogrammed and Premium range combines quality and technology described in the added value of drivers developed by the R + D + i of KOKOH RESEARCH, which offer additional features such as additional protection against surges and overtemperature in led node, variation the luminous flux, remote management point to point and are fully compatible with technological advances developed by our R + D + i. Drivers KOKOH Our drivers control are the result of years of study of our R+D+i on the operation of LED technology. Offer greater benefit in the overall performance of the luminaire, as in the life of the LED. Drivers developed by KOKOH are constantly evolving according to the latest technological advances in led technology. The advantages of the use of our drivers are as follows 1. Minimize the risk of failure by improper operation of the LED Our optical blocks are designed such that failure of one LED does not affect more than a quarter of the total LED luminaire. The LED module is configured in 4 separate arrays of 6 LEDs (L24 version) or 2 arrays of 6 LEDs (L18 version) connected in series and controlled by the driver KOKOH. With this configuration the LEDs will consume the same power independently without the need of balanced circuits and in case of failure of a LED, the maximum affection will be only 6 LED of all LED that make the fixture. 2. Protection against surges, transients and high voltages In order to offer the highest reliability and safety in our luminaires and lighting equipment, the KOKOH driver has additional protection in addition to the power supply capable of protecting the driver, control electronics and LED modules against possible Anomalies that may appear on the power line such as atmospheric surge, transients and accidental cut of the neutral conductor of the network. This protection is independent of the surge arresters to be installed in the public lighting panel and at no time replaces them. page 6

7 3. Protection against high temperatures In the event of a sudden increase in temperature, the KOKOH driver has temperature sensors that monitor the heat emitted by the luminaire at all times, acting in the event of an abnormality to protect the whole of the equipment from premature failure by a Excess heat. 4. Variation of the luminous flux The driver developed by KOKOH allows the variation of luminous flux of the luminaire and consequently to minimize the energy consumption of the installation to obtain an additional saving in the hours of less use of the installation. Our R & D department has been able to develop various methods of variation of luminous flux depending on the characteristics of the installation where the luminaires will be located. In the case of traditional installations replacing luminaires with discharge lamp technology by LED luminaires, the KOKOH drivers allow you to take advantage of dual level lightning control line or luminous flux regulators with voltage stabilization as used for sodium lamps( No matter the model), to reduce the power consumed by luminaires at night. This last quality perpetuates the life of the luminous flux regulators, which after the entry of LED technology had been relegated to the background because they are incompatible. For installations where there are no luminous flux regulators methods or for new installations, the KOKOH drivers allow selfregulation without the need for an external signal. For this it has a programming capable of assigning up to 8 steps of control so as to vary the power consumed as a function of the time that is in progress. This feature is performed by the programmable version. The self-programmable version has autonomous capacity of auto-adjust regulation according to the time of the year, since the regulation needs are not the same for summer as for winter. Thanks to its complex algorithms of control, the KOKOH driver can discriminate in which time of the year it is and self-adjusting its steps according to the hours of darkness in each moment. 5. Remote management The future of outdoor lighting through integration of this within the Smart City concept. It allows sustainable development of lighting with less consumption of energy resources and greater capacity of infrastructure management. Our R & D has developed drivers that have the ability to be integrated into a Smart City for remote management through a communication module, managing to control all operating parameters of the light (on schedule, variation luminous flux) and know in real time consumption, hours of operation, breakdowns... page 7

8 THE DATA SHOWN IN THIS DATA SHEET MAY BE SUBJECT TO CHANGES ACCORDING TO TREND TECHLOGY OUR ENGINEERING DEPARTMENT AND R & D + I LED thermal management It is known that the lifetime of the LED and the luminous flux emitted is related to this junction temperature reached in normal use. Our R & D has endeavored to reduce the temperature by developing a heat sink to ensure maximum heat dissipation of the LED and turn the sink reaches a minimum surface temperature. The heat sink used in luminaires KOKOH, is designed for maximum heat dissipation thanks to design your fins, dissipation Surface and the thickness of the base in contact with the LED. The heat sink is made of extruded according to DIN EN 12020, the material used is aluminum tempered according to EN AW 6060-T66, topped with a black anodized color over the whole surface. This combination makes our heatsinks one of the most efficient in the market. Heat sink tempered aluminum extrusion profile according to standard DIN EN Applications The Flood Light Proyector KOKOH can be installed horizontally or suspended and even supported directly on the wall. Its mounting height is between 4 to 18 meters, adapting to any lighting need thanks to its optical studied and their ability to orientation in the X, Y. Given the versatility of this Flood Light use it is so varied that it can be used both indoors and outdoors for lighting large areas such as car parks, urban roads, squares, ornamental lighting facades and bell towers, sports facilities, sports centers, industrial buildings, department stores, logistics centers, walking areas and work... Thanks to its careful design, the employed lenses and LEDs use high light output, this Flood Light is ideal for sports lighting, achieving high levels of lighting and high uniformity with lower power consumption in the market. This Flood Light is optimized for use in paddle courts, achieving an illumination according to the requirements of the Spanish Federation of Padel, with a total consumption of less than 1 kw and greater uniformity of Like the other products KOKOH, the reflector is able to take advantage of future technological improvements developed by our R + D + i. page 8