APPENDIX F MECHANICAL DATA

Transcription

1 APPENDIX F MECHANICAL DATA

2 Engineering Detail NTL Model No. Flow Rate (scfm) Wheel Diameter D (inches) Wheel Depth E (inches) Cassette Height/Width A (inches) Cassette Depth B (inches) Hub Diameter H (inches) Approx. Total Wt. (pounds) Drive Motor (Hp) ECW / 00 ECW / 00 ECW / 3 ECW / 3 ECW / 2 ECW / 2 ECW / ECW / 2 ECW / ECW / ECW ECW / ECW ECW ECW ECW ECW ECW ECW /2 ECW /2 ECW /2 ECW ECW ECW ECW ECW The information contained in this brochure is believed to be accurate by NovelAire Technologies, but is not warranted. 032 Mammoth Avenue Baton Rouge, LA Phone: (800) or (225) Fax: (225) Website: Revision //0

3 Depth Depth Effectiveness (%) Effectiveness (%) Sensible Total Latent Sensible Total Latent A.R.= A.R.= Flow Rate (scfm) Flow Rate (scfm) ECW78 ECW ECW20 ECW0 ECW08 ECW5 ECW9 ECW8 ECW2 ECW8 ECW72 ECW3 ECW0 ECW32 ECW8. Pressure Drop (Inches of water). Pressure Drop (Inches of water) Face Velocity (sfpm) Face Velocity (sfpm) LEAKAGE AND EXHAUST AIR TRANSFER Exhaust Air Transfer Ratio (All Models) Pressure Differential EATR.0% 0.% 0.0% Leakage-Outdoor Air Correction Factor (OACF) ECW ECW ECW ECW ECW ECW ECW ECW LEAKAGE AND EXHAUST AIR TRANSFER Exhaust Air Transfer Ratio (All Models) Pressure Differential EATR.0% 0.% 0.0% Leakage-Outdoor Air Correction Factor (OACF) ECW ECW ECW ECW ECW ECW ECW

4 Enthalpy Wheel Cost Analysis for AHU-3 Nehal M. Youssef Lord Stirling Community School APPENDIX F: Mechanical Data

5 Enthalpy Wheel Cost Analysis for AHU- Nehal M. Youssef Lord Stirling Community School APPENDIX F: Mechanical Data

6 UVC for HVAC TM Double-Ended, Very High Output Germicidal Light Source for HVAC Systems Model DE Series UVC Emitters power needed to maintain microbial control. The UVC Emitter, by contrast, has a 2-month service life and even after a full year, it has 2-/2 times greater output than competitive devices deliver on Day! As a result, only Steril- Aire can ensure the germicidal performance you need, with no return of microbial growth, for 3- times longer than the competition. Applications Steril-Aire Double-Ended (DE Series) fixtures are used for internal installation in medium to large air handling systems in commercial, industrial, health care and institutional buildings. They may be mounted singly, in built-up banks or in parallel configurations in a variety of locations, including coils, drain pans, ductwork, mixed air plenums and exhaust systems. The DE Series is available in five lengths (8, 2, 30, 3 and 2 ) and four voltage options (5, 208, 230 or 277 Vac), providing installation flexibility to accommodate virtually any system. UVC Output vs. Temperature Benefits Kills or inactivates surface and airborne microorganisms that contribute to poor IAQ and/or the spread of infectious disease, including: mold and mold spores, bacteria (including TB, Legionella, E. coli, Listeria, salmonella, and whooping cough); and viruses (including colds, flu, measles). Delivers an average of 5 times the output of competitive UVC products at HVAC operating temperatures, for 3- times longer life and more reliable germicidal control. Uses patented state-of-the-art solid-state electronic power supply for enhanced reliability and performance. Continuously cleans coils, drain pans, plenums and ducts, eliminating costly cleaning programs and the use of harmful chemicals and disinfectants. Steril-Aire s multi-patented UVC Emitter provides the best and longest-lasting UVC performance available. As shown in the comparison graph (above), it has been independently tested to deliver an average of 5 times the output of other ultraviolet devices under HVAC operating conditions (5 o 550 fpm air velocity). Competitive UVC lights must be changed every 3- months because they quickly lose the output or killing Lowers HVAC energy costs by restoring heat transfer and net cooling capacity. Produces no ozone or other secondary contaminants will not harm building occupants, equipment or furnishings. Offers lowest life-cycle cost of any UVC product. Return on investment is often less than one year. The most widely used product for commercial UVC for HVAC the industry standard!

7 Model DE Specifications The UVC Emitter TM and fixture shall be factory assembled and tested. They shall consist of a housing, power source, reflector, Emitter sockets and Emitter. The housing shall be constructed of 30 stainless steel to withstand HVAC environments. The reflector shall be constructed of heavy gauge, specular finished aluminum alloy with approximately 85% reflectance at 25 nm wavelength. The housing shall be equipped with /2" electrical conduit openings on each end to facilitate coupling and wiring fixture-to-fixture and to power. All components shall be in one integral assembly to maximize serviceability. The power source shall be a Class P2, electronic, rapid start type with a power factor greater than 0.95 and a power conversion of greater than 75%. The power supply design shall include RF and EMI suppression. The power supply shall be designed to maximize photon production, irradiance and reliability in cold or moving airstreams of F, 00% RH and up to 2000 fpm velocity. The fixture shall be available in 5-208/230 or 277 Vac, 50/0 Hertz, and single phase. The Emitter sockets are medium bi-pin, double click safety, twist lock type. They shall be constructed of UVC-resistant polycarbonate. The Emitter tube shall be a very high output, hot cathode, T5 diameter, medium bi-pin type that produces broadband UVC of nm. Each tube shall produce the specified output at 2000 fpm velocity and air temperatures of F. It shall produce no ozone or other secondary contaminants. Independent testing: The unit shall be tested by an independent test laboratory in accordance with the general provisions of IES Lighting Handbook, 98 Application Volume, and shall be verified through independent testing to provide output per " arc length of not less than 0 µw/cm2 at meter in a 00 fpm airstream of 5 F. Unit shall comply with UL Standard 995 for use in HVAC equipment and shall carry the "UL" and "ULC" labels DIA MOUNTING HOLE, REQD FIXTURE MAY BE INSTALLED ON ANY ANGLE.00 END VIEW /2" CONDUIT INLET, BOTH ENDS This product may be covered by one or more of the following patents, others pending: 5,33,37/ 5,8,07/ 5,87,27/,372,8/,33,70/,25,293/,27,92/,280,8/,23,882. Ordering Information Model No. Part No. Description Length Electrical Weight DE 8 VO Double-Ended Fixture 8" 5, 208, 230V: watts 2.3 lb. DE 8 VO Double-Ended Fixture 8" 277V: watts 2.3 lb. DE 2 VO Double-Ended Fixture 2" 5, 208, 230V: watts 2.7 lb. DE 2 VO Double-Ended Fixture 2" 277V: watts 2.7 lb. DE 30 VO Double-Ended Fixture 30" 5, 208, 230V: watts 3.3 lb. DE 30 VO Double-Ended Fixture 30" 277V: watts 3.3 lb. DE 3 VO Double-Ended Fixture 3" 5, 208, 230V: watts 3.7 lb. DE 3 VO Double-Ended Fixture 3" 277V: watts 3.7 lb. DE 2 VO Double-Ended Fixture 2" 5, 208, 230V: watts. lb. DE 2 VO Double-Ended Fixture 2" 277V: watts. lb. GTD VO Replacement Emitter DE 8 " N/A 0.5 lb. GTD 22 VO Replacement Emitter DE 2 22" N/A 0.5 lb. GTD 28 VO Replacement Emitter DE 30 28" N/A 0.20 lb. GTD 3 VO Replacement Emitter DE 3 3" N/A 0.25 lb. GTD 0 VO Replacement Emitter DE 2 0" N/A 0.25 lb. Steril-Aire USA, Inc. Corporate Office: 00 E. Artesia Blvd., # D Cerritos, CA Telephone: Fax: Website: sales@steril-aire-usa.com Represented By: Complies with current U.S. and Canadian UL Standards for use in HVAC equipment Steril-Aire 0/03 00B

8 Steril-Aire: Fan Coil UVC Kit Page of /8/2005 Steril-Aire Rated "First and Best" in Marketing Surveys Two independent surveys have confirmed Steril-Aire's leadership in UVC. (details) Fan Coil UVC Kit Wins Awards The Steril-Aire Fan Coil Kit is a Plant Engineering Product of the Year finalist and a Buildings Magazine Top 00 Products pick (product details) School Reduces Absenteeism with UVC Lights Health of students and staff improves with installation of UVC lights in air handling system. (details) Products: Fan Coil UVC Kit The Fan Coil UVC Kit packages Steril-Aire's proven technology into a convenient kit designed specially for fan coils, packaged split systems and similar room unit systems. Fan coils have long presented an IAQ challenge because many are equipped with low efficiency filters that do not effectively capture infectious disease contaminants or mold. Due to space and airflow limitations, these units cannot be retrofitted with high efficiency filtration. The Fan Coil UVC Kit provides a practical and effective solution using UVC technology. Emitters are installed across the cooling coil, emitting high output UVC energy, to eliminate surface contaminants and reduce airborne microbial contaminants. The kit brings improved IAQ to hotel/motel rooms, dormitories, office, patient rooms and classrooms. Emitter tubes come in six lengths: ", 20", 2" 30", 3" & 2"

9 Lighting ecatalog - Print LSB Page Page of /3/2005 Lighting Specification Bulletin Germicidal Product Code: 587 Description: G3T5 Specification: Firm Name : Job Name : General Product Code 587 Description G3T5 Subcategory Germicidal Physical Bulb Type T5 Base Type Single Pin (Fa8) Nominal 3.00 Length (In.) Nominal 95 Length (mm) Bulb Nominal.25 Diameter in inches Electrical Average 9000 Rated Life Watts 39 Miscellaneous Additional Information Footnotes Clear, Preheat, For Use With Starters, UVC source WARNING: Risk Group 3 (High Risk): UV emitted from this lamp. Avoid exposure of eyes and skin to unshielded lamp. Skin or eye injury will result. Life rating is based on UV maintenance curve and is measured at 80% of initial (00hr) UVC output. All values are design values or typical values when measured under laboratory conditions.information provided is subject to change w notice. Where applicable, values are based on guidelines published in ANSI. For more information see Terms and Conditions in the lin

10 Electrical Specifications Brand Name CENTIUM T5 Ballast Type Electronic Starting Method Programmed Start Lamp Connection Series Input Voltage 277 Input Frequency 50/0 HZ Status Active Lamp Type Num. of Lamp s Rated Lamp Watts Min. Start Temp ( F/C) Input Current (Amps) Input Power (ANSI Watts) Ballast Factor MAX THD % Power Factor MAX Lamp Current Crest Factor () FC9T5 & () 2 2 0/ FC2T5 F2T5/HO 0 0/ F2T5/HO 2 0 0/ * F39T5/HO 39 0/ F39T5/HO / FC2T5 0 0/ FC2T / FC9T5 22 0/ FC9T / FT2W/2G 2 0/ FT2W/2G 2 2 0/ FT3W/2G 3 0/ FT3W/2G 2 3 0/ FT0W/2G/RS 0 0/ Wiring Diagram B.E.F. For lamp operation, do not use yellow leads The wiring diagram that appears above is for the lamp type denoted by the asterisk (*) Standard Lead Length (inches) in. cm. Black 0 0 White 0 0 Blue 0 0 Red 0 0 Yellow 0 0 Revised 09/0/200 Data is based upon tests performed by Advance Transformer in a controlled environment and representative of relative performance. Actual performance can vary depending on operating conditions. Specifications are subject to change without notice. All specifications are nominal unless otherwise noted. ADVANCE TRANSFORMER CO. O'HARE INTERNATIONAL CENTER 0275 WEST HIGGINS ROAD ROSEMONT, IL 008 Customer Support/Technical Service: Phone: Fax: Corporate Offices: Phone: