MATERIAL SAFETY DATA SHEET A Colourant Page 1

Transcription

1 A Colourant Page 1 MSDS No A Revision Date: 05/15/2015 Version : 1-1 / CDN Replaces: 07/14/2011 WHMIS controlled: Class: yes D 2A Section 01 - Product and company identification Identification of the company: Contact EH&S Manager: CHEMTREC: Domestic North America: International call: Dryvit Systems Canada a division of RPM Canada 129 Ringwood Drive Stouffville, Ontario L4A 8A2 Telephone No.: ehs@dryvit.com (collect calls accepted) Trade name: Chemical family: Primary product use: A Colourant Aqueous dispersion of C.I. Pigment White 6 containing polyglycol Colourant preparation Section 02 - Hazards identification Health effects of exposure: Eye and skin contact may cause irritation. Inhalation of vapours or mists may irritate the respiratory tract. Fatty alcohol ethoxylate: the effects of long term exposure have t been determined. Listed carcigen: IARC: No NTP: No OSHA: No Other: No Section 03 - Composition/information on ingredients Hazardous ingredients: Component CAS number Concentration C.I. Pigment White % Polyethylene glycol mooleyl ether % Section 04 - First aid measures

2 A Colourant Page 2 After inhalation: Get victim to fresh air. Give artificial respiration or oxygen if breathing has stopped or is difficult. Get prompt medical attention. Do t give fluids if victim is unconscious. After contact with skin: Remove contaminated clothing and wash affected areas with soap and plenty of water for at least 15 minutes. If redness or skin irritation occurs, seek medical attention. After contact with eyes: Immediately wash the eyes with flowing water for at least 15 minutes. Insure proper irrigation by occasionally lifting upper and lower eyelids. Thereafter seek prompt medical attention. After ingestion: If ingested, do t induce vomiting. Get immediate medical assistance. Advice to doctor / Treatment: None kwn. Section 05 - Fire fighting measures Flashpoint: Lower explosion limit: Upper explosion limit: Self ignition: Ignition temperature: Extinguishing media: No flash point upto 100 C. water spray jet dry powder carbon dioxide alcohol-resistant foam water jet Special fire fighting procedure: Evacuate endangered area, close off area. Close leakages. Wear protective equipment. Hazardous combustion products: In case of fires, hazardous combustion gases are formed: Carbon moxide (CO) Carbon dioxide (CO2) Nitrogen oxides (NOx) Section 06 - Accidental release measures Steps to be taken in case of spill or leak: Wear suitable protective equipment. Ensure adequate ventilation. Contain spill and pump into proper containers using compatible equipment. Smaller spills may be recovered using inert absorbent material (sand, sawdust) and collected into suitable containers. Wash spill area. Do t allow the product to enter sewers or waterways.

3 A Colourant Page 3 Section 07 - Handling and storage Advice on safe handling: When used and handled appropriately special measures are needed Further info on storage conditions: Keep container tightly closed Keep from freezing. Protect from heat/overheating. Section 08 - Exposure controls / personal protection Occupational exposure limits: Component CAS Regulatory list Type of value Value 1 Value 2 number: Titanium dioxide US ACGIH Threshold Limit Values Threshold Limit Value_Time Weighted Average 10 mg/m3 Respiratory protection: Hand protection: Eye protection: Other protective equipment: Wear an approved respirator if vapours or mists are generated when handling or processing this product. Use appropriate filters. Do t exceed filters limitations. Butyl Rubber, PVC or Neoprene Wear safety glasses with side-shields. Wear clothing suitable to avoid skin contact. Section 09 - Physical and chemical properties Form: Color: Odor: Odor limit: Liquid white t specified ph: Solubility in water: Soluble in... : Density: Melting point : miscible fat 1.92 g/cm3 t applicable Boiling point : > 100 C Vapor pressure:

4 A Colourant Page 4 Bulk density: Relative vapor density: Partitioning coef. octal/water: Viscosity / (dynamic): Viscosity / (kinematic): 1,800 mpa.s (23 C) Section 10 - Stability and reactivity Thermal decomposition: Chemical stability: Hazardous Polymerization: Incompatibility with (Conditions to avoid) : Hazardous decomposition products Stable. Conditions to avoid: Strong oxidizing agents. t kwn When handled and stored appropriately, dangerous decomposition products are kwn Section 11 - Toxicological information Acute oral toxicity: Acute inhalation toxicity: Acute dermal toxicity: Skin irritation: Eye irritation: Sensitization: LD50 > 2,000 mg/kg The product has t been tested. The information is derived from the properties of the individual components. t reasonable n-irritant The product has t been tested. The information is derived from the properties of the individual components. n-irritant The product has t been tested. The information is derived from the properties of the individual components. Section 12 - Ecological information Biodegradation: Fish toxicity: Daphnia toxicity: Algae toxicity:

5 A Colourant Page 5 Bacteria toxicity: Dissolved organic carbon (DOC): Chemical oxygen demand (COD): Biological oxygen demand (BOD): Remarks: Do t allow to enter soil, waterways or waste water The product has t been tested. The information is derived from the properties of the individual components. Section 13 - Disposal considerations Waste disposal information: Wastes may be incinerated or landfilled after solidification in approved sites. Follow local regulations. Section 14 - Transport information TDG t restricted IATA t restricted IMDG t restricted Section 15 - Regulatory information Registration status DSL: NDSL: CEPA Listed as priority substance: Listed as toxic substance: NPRI yes TSCA Status: All components of this product are listed on the TSCA Inventory. FDA: This product is t registered with the FDA. Section 16 - Other information

6 A Colourant Page 6 WHMIS MAY CAUSE CANCER BASED ON ANIMAL DATA MAY BE IRRITATING TO EYES, SKIN OR RESPIRATORY SYSTEM The information contained on this MSDS is to the best of our kwledge an accurate summary of the data available as of the date of preparation. Dryvit Systems Canada is t liable for the application or use of this information in situations beyond its control or outside the rmal and expected use of its product. Dryvit Systems Canada assumes responsibility for damage or injury from the use of the product described herein.