Fugacity From Wikipedia, the free encyclopedia

Transcription

1 頁 1 / 5 Fugacity From Wikipedia, the free encyclopedia In chemical thermodynamics, the fugacity (f) of a real gas is an effective pressure which replaces the true mechanical pressure in accurate chemical equilibrium calculations. It is equal to the pressure of an ideal gas which has the same chemical potential as the real gas. For example, nitrogen gas (N 2 ) at 0 C and a pressure of 100 atm has a fugacity of atm. [1] This means that the chemical potential of real nitrogen at a pressure of 100 atm has the value which ideal nitrogen would have at a pressure of atm. Fugacities are determined experimentally or estimated for various models such as a Van der Waals gas that are closer to reality than an ideal gas. The ideal gas pressure and fugacity are related through the dimensionless fugacity coefficient. [2] For nitrogen at 100 atm, the fugacity coefficient is atm / 100 atm = For an ideal gas, fugacity and pressure are equal so is 1. The fugacity is closely related to the thermodynamic activity. For a gas, the activity is simply the fugacity divided by a reference pressure to give a dimensionless quantity. This reference pressure is called the standard state and normally chosen as 1 atmosphere or 1 bar, Again using nitrogen at 100 atm as an example, since the fugacity is atm, the activity is just with no units. Accurate calculations of chemical equilibrium for real gases should use the fugacity rather than the pressure. The thermodynamic condition for chemical equilibrium is that the total chemical potential of reactants is equal to that of products. If the chemical potential of each gas is expressed as a function of fugacity, the equilibrium condition may be transformed into the familiar reaction quotient form (or law of mass action) except that the pressures are replaced by fugacities. For a condensed phase (liquid or solid), the chemical potential is equal to that of the vapor in equilibrium with the condensed phase, and therefore the fugacity is equal to the fugacity of the vapor. This fugacity is approximately equal to the vapor pressure when the vapor pressure is not too high. The word "fugacity" is derived from the Latin for "fleetness", which is often interpreted as the tendency to flee or escape. The concept of fugacity was introduced by American chemist Gilbert N. Lewis. [3] Contents 1 Definition in terms of chemical potential 2 Evaluation of fugacity for a real gas 3See also 4 References Definition in terms of chemical potential

2 頁 2 / 5 The fugacity of a real gas is formally defined by an equation analogous to the relation between the chemical potential and the pressure of an ideal gas. For any pure substance, the chemical potential (μ) is equal to the molar Gibbs free energy, whose variation with temperature (T) and pressure (p) is given by d μ = dg = SdT + VdP. At constant temperature, this expression can be integrated as a function of P. We must also set a reference state. For an ideal gas the reference state depends only on pressure, and we set P = 1 bar so that Now, for an ideal gas Reordering, we get This gives the chemical potential for an ideal gas in an isothermal process, with a reference state is P = 1 bar. For a real gas, we cannot calculate because we do not have a simple expression for a real gas molar volume. Even if using an approximate expression such as the van der Waals equation, the Redlich-Kwong or any other equation of state, it would depend on the substance being studied and would be therefore of very limited utility. We would like the expression for a real gas chemical potential to be similar to the one for an ideal gas. We therefore define a magnitude, called fugacity, so that the chemical potential for a real gas becomes with a given reference state to be discussed later. This is the usual form of the definition, but it may be solved for f to obtain the equivalent explicit form Evaluation of fugacity for a real gas Fugacity is used to better approximate the chemical potential of real gases than estimations made using the ideal gas law. Yet fugacity allows the use of many of the relationships developed for an idealized system.

3 頁 3 / 5 In the real world, gases approach ideal gas behavior at low pressures and high temperatures; under such conditions the value of fugacity approaches the value of pressure. Yet no substance is truly ideal. At moderate pressures real gases have attractive interactions and at high pressures intermolecular repulsions become important. Both interactions result in a deviation from "ideal" behavior for which interactions between gas atoms or molecules are ignored. For a given temperature, the fugacity satisfies the following differential relation: where is the Gibbs free energy, is the gas constant, is the fluid's molar volume, and is a reference fugacity which is generally taken as 1 bar. For an ideal gas, when f = P, this equation reduces to the ideal gas law. Thus, for any two physical states at the same temperature, represented by subscripts 1 and 2, the ratio of the two fugacities is as follows: For an ideal gas, this becomes simply or f = P But for, every gas is an ideal gas. Therefore, fugacity must obey the limit equation We determine f by defining a function We can obtain values for Φ experimentally easily by measuring V, T and P. From the expression above we have We can then write Where

4 頁 4 / 5 Since the expression for an ideal gas was chosen to be,we must have Suppose we choose. Since, we obtain The fugacity coefficient is defined as ϕ = f/p (note that for an ideal gas, ϕ = 1.0), and it will then verify The integral can be evaluated via graphical integration if we measure experimentally values for Φ while varying P. We can then find the fugacity coefficient of a gas at a given pressure P and calculate The reference state for the expression of a real gas chemical potential is taken to be ideal gas, at P = 1 bar and temperature T. Since in the reference state the gas is considered to be ideal (it is an hypothetical reference state), we can write that for the real gas See also Activity (chemistry), the measure of the effective concentration of a species in a mixture Chemical equilibrium Electrochemical potential Excess chemical potential Partial molar property Thermodynamic equilibrium Fugacity capacity

5 頁 5 / 5 References 1. ^ Peter Atkins and Julio de Paula, Atkins' Physical Chemistry (8th edn, W.H. Freeman 2006), p ^ Atkins, Peter; John W. Locke ( ). Atkins' Physical Chemistry (7th ed.). Oxford University Press. ISBN ^ Lewis, Gilbert Newton ( ). "The Osmotic Pressure of Concentrated Solutions, and the Laws of Perfect Solution.". Journal of the American Chemical Society 30 (5): doi: /ja01947a002 ( Retrieved from " Categories: Physical chemistry Chemical thermodynamics Thermodynamic properties State functions This page was last modified on 21 October 2011 at 14:06. Text is available under the Creative Commons Attribution-ShareAlike License; additional terms may apply. See Terms of use for details. Wikipedia is a registered trademark of the Wikimedia Foundation, Inc., a non-profit organization.