DILLARD S TEST PROTOCOL FOR DILR US DECORATIVE PILLOWS / STUFFED ITEMS (V26)

Transcription

1 Test Date: Reviewed By/Date: SUPPLEMENTAL PROTOCOLS * California Proposition 65 Applicable Section from Protocol CPSD-AN-PTCL US *Law label (bedding tag). DILR-SL-PTCL DILLARD S TEST PROTOCOL FOR 1 The sample should be reviewed against the requirements of California Proposition 65 to determine if additional testing or labeling is required. - The sample should be reviewed against the requirements of Protocol to determine if additional testing is required. USA. Note: Additional cost, sample size & TAT may be required if testing to 1 or more supplemental protocols is necessary. Please refer to the above referenced supplemental protocol(s) for additional information. LABELING One Time Use Products **Fair Packaging and Labeling Act OR All Other Products **Uniform Packaging and Labeling Regulations F.P. & L. Act (16 CFR 500) OR NIST Uniform Laws and Regulations Handbook Manufacturer, Packer, or Distributor s Name & Address (City, State & Zip) Product Identification Net quantity of contents shall be expressed in terms of weight or mass, measure, numerical count, or combination so as to give accurate information to facilitate consumer comparison (U.S. and metric units). **Country of Origin Marking 19 CFR Shall indicate country of origin legibly, permanently, and in comparable size and close proximity to any mention of country other than country in which the article was manufactured or produced. Must be visible at point of purchase. Use Labeling Visual 1 Use/care instructions that are clear and understandable shall be provided in language appropriate to destination countries. Fiber Content FTC 2 Report actual (Textile Fiber Products Identification Act) Country of Origin 19 CFR Report actual Care label 16 CFR Verify present. Mock up label is accepted. RN# (Registered Number) or Mfr. Name WPL# (Wool Product Number) Or Mfr. Name Note: please refer to testing results on Page 1 of report for confirmation of the proper care. If the lab analysis does not match the affixed or proposed label, then the label will fail. FTC 1 Verify presence (Textile Fiber Products Identification Act) FTC 1 Verify presence (Wool Labeling Act) Page 1 of 5

2 Dimensions And / Or Finish Size Standard measure 1 Pass Verify Label Claims Visual All Must comply to claims ANALYTICAL *Total lead content in surface coatings CPSC-CH-E / CPSD-AN MTHD 1 All accessible surface coatings on the product shall not contain lead or lead compounds in which the lead content is in excess of 0.06% (600 mg/kg) of the weight of the total content. * Formaldehyde spot test on textile Qualitative analysis / CPSD-AN MTHD * Formaldehyde release in textile AATCC 112 / CPSD- AN MTHD 1 Fabric, which may come into contact with skin, shall be negative result. Note: - This method cannot be applied on nylon and PU, quantitative analysis should be performed directly if need. 1 Fabric, which may come into contact with skin, shall not have formaldehyde release exceed 75 mg/kg (ppm). PHYSICAL CHARACTERISTICS Note: conduct testing only if formaldehyde spot test shows positive result. Fiber Analysis: Blends AATCC 20A 2 Report actual (3% Tolerance - FTC) Single Fiber AATCC 20A 2 Report actual (0% Tolerance - FTC) Fabric Count ASTM D / D (R2004) Fabric Weight (Oz. / Sq. Yd.) ASTM D ae1 / D (R2004) Yarn Structure ASTM D (R2004) / D Report actual (+5%) 3 Report actual (+5%) 1 As specified Page 2 of 5

3 Fabric defects ASTM D No critical defects (R2016) Dimensions (L x W) Standard measure 1 Report overall dimensions; shall meet label claims (If applicable) (-0% / +5%). DIMENSIONAL STABILITY Shrinkage - Laundering (3 HL or 1DC) PERFORMANCE AATCC 135 / 150 / % x 4% (Length x Width) Page 3 of 5 Fabric Weight (oz/sq yd) < >4.0 Tensile Strength (Warp And Fill) ASTM D R Tearing Strength (Warp And Fill) ASTM D R2013e1 COLORFASTNESS Laundering: Shade Alteration AATCC 61 2A / Grade 4.0 minimum Staining AATCC 61 2A / Grade 3.0 minimum Self-Staining AATCC 61 2A / Grade 4.5 minimum Actual Home Laundering (3x): Actual Home Laundering (1x): Color Change Shade Alteration AATCC 150 modified 1 Grade 4.0 minimum (Mod. = Use of Tide brand detergent) Staining AATCC 150 modified 1 Grade 3.0 minimum (Mod. = Use of Tide brand detergent) Self Staining AATCC 150 modified 1 Grade 4.5 minimum (Mod. = Use of Tide brand detergent) Dry Crocking AATCC 8-16 / Grade 4.0 minimum Wet Crocking AATCC 8-16 / Grade 3.0 minimum Light Report 10 Hours AATCC [Option 3] Grade 4.0 minimum

4 Bleach: Chlorine CPSD-SL MTHD 1 Grade 5.0 minimum Non-Chlorine CPSD-SL MTHD 1 Grade 4.0 minimum DOWN AND FEATHER TESTING (If Applicable) *Content Analysis IDFB Part 3 1 As specified (For labeling, follow the USA Uniform Law labels) for each market. *Species identification IDFB Part 12 Designated Species (Per Client) When designated, the product shall contain a minimum 75% minimum cluster with 95% minimum species for both down and feather *Color separation IDFB Part 16 Tolerance of Grey down for declared, white down (maximum 1%) *Fill Power IDFB Part 10-B 1 [Steam conditioning] As claimed, minimum + / -5% If no claim is made, report value only * Down & feather: turbidity cleanliness IDFB Part 11-A/JIS 6.5/EN 1164 (Original) Less than 10 NTU *Oxygen Number IDFB Part 7 1 Less than 4.8 *Fat & Oil IDFB Part % maximum *Odor BV testing method 1 Acceptable (FD001) *Down Shifting Per Care Label 1 Even distribution after laundering *Down Migration Per Care Label 1 None visible APPEARANCE PROPERTIES Key: * Additional Charge For This Test ** Mandatory Requirement No visual defects Results Key: Rating Key: M Meets NM Does Not Meet Good Good NA Not Applicable NT Not Tested Fail Fail Page 4 of 5

5 C Claimed R Recorded No. Of Required For Complete Testing: 4 No. Of Additional required for Down and 1 Creation Date: October 29, 2001 Feather Filled items No. Of (Fully Packed) Cartons For Transit Testing: 1 (Only Upon Dillard s Request) Editorial Revision Date: MARCH,,26,2018 No. Of Working Days For Complete Testing: 7 Pricing Review Date: June 19, 2008 Technical Review Date: Page 5 of 5