CERTIFICATE OF ACCREDITATION

Size: px
Start display at page:

Download "CERTIFICATE OF ACCREDITATION"

Transcription

1 CERTIFICATE OF ACCREDITATION ANSI-ASQ National Accreditation Board 500 Montgomery Street, Suite 625, Alexandria, VA 22314, This is to certify that Clark Dynamic Testing Laboratory, Inc Route 51 South Jefferson Hills, PA has been assessed by ANAB and meets the requirements of international standard ISO/IEC 17025:2005 while demonstrating technical competence in the field of TESTING Refer to the accompanying Scope of Accreditation for information regarding the types of tests to which this accreditation applies. AT-2508 Certificate Number Certificate Valid: 09/14/ /03/2020 Version No. 004 Issued: 09/14/2018 This laboratory is accredited in accordance with the recognized International Standard ISO/IEC 17025:2005. This accreditation demonstrates technical competence for a defined scope and the operation of a laboratory quality management system (refer to joint ISO-ILAC-IAF Communiqué dated April 2017).

2 SCOPE OF ACCREDITATION TO ISO/IEC 17025:2005 Clark Dynamic Testing Laboratory, Inc Route 51 South Jefferson Hills, PA Michelle Felicetti TESTING Valid to: October 3, 2020 Certificate Number: AT-2508 Testing performed in support of FCC DoC and certification approval procedures Type of Device Examples Scope of Accreditation Supporting FCC Guidance Unintentional Radiators (FCC ANSI C Part 15, Subpart B) Industrial, Scientific, and Medical Equipment (FCC Part 18) Consumer ISM equipment FCC MP-5, (February 1986) Compatibility Test Method Test Specification(s) Range Conducted Emissions Conducted Susceptibility Radiated Emissions MIL-STD-461E, CE101 MIL-STD-461F, CE Hz 10 khz MIL-STD-461E, CE102 MIL-STD-461F, CE102 Power Leads 10 khz 10 MHz MIL-STD-461E, CS101 MIL-STD-461F, CS Hz 150 khz MIL-STD-461E, CS101 MIL-STD-461F, CS Hz 150 khz Power Leads, Bulk Cable MIL-STD-461E, CS114 Injections MIL-STD-461F, CS khz 200 MHz MIL-STD-461E, RE101 MIL-STD-461F, RE101 Magnetic Field 30 Hz 100 khz Page 1 of 8

3 Compatibility Test Method Test Specification(s) Range Radiated Susceptibility Radiated Susceptibility Compatibility Emissions MIL-STD-461E, RE102 MIL-STD-461F, RE khz 18 GHz MIL-STD-461E, RS101 MIL-STD-461F, RS Hz 100 khz (Excluding sec ) MIL-STD-461E, RS103 MIL-STD-461F, RS103 2 MHz 18 GHz to 50 V/m at 3 m Distance (Excluding sec ) EN (2001) EN (2007) + A1 (2011) EN (2001) EN (2006) EN (2009) + A1 (2010) CISPR 11: CFR Part 15, Subpart B using ANSI C63.4 (2009, 2014) 47 CFR Part 15, Subpart B using ANSI C63.4 (2009, 2014) IEC/EN (2007) Electric Field Magnetic Field Electric Field Residential, Commercial, and Light Industrial Environments Emission Standard for Industrial Environments Railway Applications Emission and of the Signaling and Telecommunications Apparatus Industrial, Scientific, and Medical Radio Frequency Equipment ISM Radio frequency disturbance characteristics Limits and Methods of measurement Unintentional Radiators ISM Equipment Compatibility Part 6-1: Generic Standards for residential, Commercial, and Light Industrial Environments Page 2 of 8

4 Compatibility Test Method Test Specification(s) Range IEC/EN (2005) IEC/EN ( ) 4 kv IEC/EN (2009) 150 khz 80 MHz (140 dbµv) IEC/EN (2006) + A1 (2008) + A2 (2010) 2 MHz 18 GHz (50 V/m at 3 m Distance) IEC/EN (2006) 4 kv IEC/EN (2004) + A1 (2010) 4 kv IEC/EN (2010) 100 A/m Compatibility Part 6-2: Generic Standards for residential, Commercial, and Light Industrial Environments Compatibility Part 4-4: Testing and Measurement Techniques Electrostatic Discharge Test Compatibility Part 4-6: Testing and Measurement Techniques to Conduct Disturbances, Induced by Radio-Frequency Fields Compatibility Part 4-6: Testing and Measurement Techniques Radiated Radio - Frequency, Field Test Compatibility Testing and Surge Test Compatibility Testing and Electrical Fast Transient/Burst Test Compatibility Testing and Power Frequency Magnetic Field Test Page 3 of 8

5 Compatibility Test Method Test Specification(s) Range IEC/EN (2010) 1000 A/m IEC/EN (2004) IEC/EN (2009) IEC/EN (2000) Compatibility Testing and Pulse Magnetic Field Test Compatibility (EMC) Part 4-11: Testing and Voltage Dips, Short Interruptions and Voltage Variations Tests Compatibility (EMC) Part 4-29: Testing and Voltage Dips, Short Interruptions and Voltage Variations on D.C. Input Power Port Tests Compatibility (EMC) Part 4-13Testing and Harmonics and Interharmonics Including Mains Signaling at A.C. Power Port, Low Frequency Tests Page 4 of 8

6 Mechanical Specific Tests and/or Properties Measured Seismic Temperature and Humidity Specification, Standard, Method, or Test Technique IEEE 323, IEEE 344, IEEE 693, AC 156, CBC 2013, IBC 2012 GR-63-CORE (NEBS) RTCA / DO 160 Section 4 RTCA / DO 160 Section 5 RTCA / DO 160 Section 6 IEEE 323 G 501,502,503 G % 95% RH MIL-STD-202:103 MIL-STD-202:106 MIL-STD-202: C C MIL-STD-202:108 GR-63 CORE IEC IEC IEC C C MIL-STD-833G/H -70 C C Items, Materials or Product Tested Earthquake (Electrical: Instrumentation and Controls) Earthquake (Network Building Equipment) (Airborne Equipment) (Electrical: Instrumentation and Controls) (Environmental (Test Method (Network Building Equipment) (Equipment Transportation) (Programmable Controllers) Test Method Standard (Micro Circuits) Page 5 of 8

7 Mechanical Specific Tests and/or Properties Measured Temperature and Humidity Mechanical Shock Specification, Standard, Method, or Test Technique MIL-STD-833G/H RTCA / DO 160 Section 7 G 516 Items, Materials or Product Tested Test Method Standard (Micro Circuits) (Airborne Equipment) (Environmental Vibration MIL-STD-202:207 MIL-STD-202:213 RTCA / DO 160 Section 8 MIL-STD-202:201 MIL-STD-202:204 MIL-STD-202:214 G 514 MIL-STD-167-1/1A GR-63 CORE (Test Method (Airborne Equipment) (Test Method (Environmental Mechanical Vibrations of Shipboard Equipment (Type I Environmental and Type II Internally Excited) (Network Building Equipment) Page 6 of 8

8 Mechanical Specific Tests and/or Properties Measured Vibration High Impact Shock Salt Spray/Fog Immersion Specification, Standard, Method, or Test Technique IEC /2010 ASTM D4169, ASTM D4718, EN 61373, ISO AREMA C&S Part MIL-S-901D/IC#1/IC#2 Medium Weight Shock Per Test Unit RTCA / DO 160 Section 14 G 509 Per Unit test ISO 9227 IEC ASTM B117 MIL-STD-202:101 G 512 Items, Materials or Product Tested (Rolling Stock Equipment) (Shipping Containers) (Railway Signals) (Military Shipboard Equipment) (Airborne Equipment) (Environmental (General Equipment) (Sheet Metals for Shunts and Precision Resistors) (Test Method (Environmental Page 7 of 8

9 Mechanical Note: Specific Tests and/or Properties Measured Immersion Altitude Water Ingress Specification, Standard, Method, or Test Technique MIL-STD-202:104 G ft 50,000 ft MIL-STD-202:105 IEC b 1Px1-8 NEMA 250 MIL-STD-202:203 Items, Materials or Product Tested (Test Method (Environmental (Test Method (Enclosure Testing) Enclosures for Electrical Equipment (1000V Max) (Test Method 1. This scope is formatted as part of a single document including Certificate of Accreditation No. AT Page 8 of 8