SECTION 1 IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING. 129 Lockwood St CHEM-TEL (24 hour)

Transcription

1 Page 1 of 5 MATERIAL SAFETY DATA SHEET SECTION 1 IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING LUBRIPLATE Lubricants Co. Emergency Telephone Number: 129 Lockwood St CHEM-TEL (24 hour) Newark, NJ Telephone Number for information: SUBSTANCE: LUBRIPLATE APG-90 MSDS No TRADE NAMES/SYNONYMS: PRODUCT USE: Petroleum lubricating oil CREATION DATE: 02/14/2008 REVISION DATE: 01/21/2010 SECTION 2 COMPOSITION/INFORMATION ON INGREDIENTS COMPONENT: Solvent dewaxed heavy paraffinic distillates CAS NUMBER: EC NUMBER (EINECS): PERCENTAGE: COMPONENT: Residual oils (petroleum), solvent dewaxed CAS NUMBER: EC NUMBER (EINECS): PERCENTAGE: COMPONENT: Olefin sulfide mixture CAS NUMBER: NA EC NUMBER (EINECS): NA PERCENTAGE: 5-10 COMPONENT: Methacrylate copolymer CAS NUMBER: NA EC NUMBER (EINECS): NA COMPONENT: Kerosene CAS NUMBER: EC NUMBER (EINECS): COMPONENT: Acrylate copolymer CAS NUMBER:

2 EC NUMBER (EINECS): not assigned Page 2 of 5 NOTE: The IP 346 value of the mineral oil is less than 3% SECTION 3 HAZARDS IDENTIFICATION POTENTIAL HEALTH EFFECTS: INHALATION: LONG TERM EXPOSURE: Lung damage SKIN CONTACT: LONG TERM EXPOSURE: Irritation, skin disorders EYE CONTACT: LONG TERM EXPOSURE: No information available INGESTION: SHORT TERM EXPOSURE: Diarrhea, difficulty breathing LONG TERM EXPOSURE: no information on significant adverse effects HAZARDOUS MATERIAL IDENTIFICATION SYSTEM (HMIS): Health 1 Flammability 1 Reactivity 0 Not a Controlled Product under (WHMIS) Canada Special Protection: See Section 8 SECTION 4 FIRST AID MEASURES INHALATION: Vapor pressure is very low and inhalation at room temperature is not a problem. If overcome by vapor from hot product, immediately remove from exposure and call a physician. SKIN CONTACT: Remove any contaminated clothing and wash with soap and warm water. If injected by high pressure under skin, regardless of the appearance or its size, contact a physician IMMEDIATELY. Delay may cause loss of affected part of body. EYE CONTACT: Flush eyes with clear water for at least 15 minutes or until irritation subsides. If irritation persists, consult a physician. INGESTION: If ingested, call a physician immediately. Do not induce vomiting. SECTION 5 FIRE FIGHTING MEASURES FIRE AND EXPLOSION HAZARDS: Slight fire hazard EXTINGUISHING MEDIA: Carbon dioxide, regular dry chemical, regular foam, water

3 Page 3 of 5 FIRE FIGHTING: Move container from fire area if it can be done without risk. Avoid inhalation of material or combustion by products. Stay upwind and keep out of low areas. HAZARDOUS COMBUSTION PRODUCTS: Thermal decomposition products or combustion: oxides of carbon, oxides of sulphur UNUSUAL FIRE AND EXPLOSION HAZARDS: Do not store or mix with strong oxidants. Empty containers retain residue. Do not cut, drill, grind, or weld, as they may explode. SECTION 6 ACCIDENTAL RELEASE MEASURES OCCUPATIONAL RELEASE: Stop leak if possible without personal risk. Small spills: Absorb with sand or other non-combustible material. Collect spilled material in appropriate container for disposal. SECTION 7 HANDLING AND STORAGE STORAGE: Store and handle in accordance with all current regulations and standards. Keep container tightly closed. Keep away from heat, sparks, and flame. See original container for storage recommendations. Keep separated from incompatible substances. SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION EXPOSURE LIMITS: White mineral oil: MINERAL OIL MIST: 5 mg/m 3 UK OES TWA 10mg/m 3 UK OES STEL VENTILATION: Provide local exhaust ventilation system. Ensure compliance with applicable exposure limits. EYE PROTECTION: Wear splash resistant safety goggles. Provide an emergency eye wash fountain and quick drench shower in the immediate work area. CLOTHING: Wear appropriate chemical resistant clothing. GLOVES: Wear appropriate chemical resistant (nitrile) gloves. RESPIRATOR: Consider the need for appropriate protective equipment, such as self-contained breathing apparatus, adequate masks and filters. SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES PHYSICAL STATE: liquid APPEARANCE: transparent COLOUR: amber PHYSICAL FORM: oil ODOR: additive odor

4 Page 4 of 5 BOILING POINT: >288 C FREEZING POINT: Not available FLASH POINT: 202 C (COC) LOWER FLAMMABLE LIMIT: 0.9% by volume UPPER FLAMMABLE LIMIT: 7.0% by volume AUTO IGNITION: 227 C (COC) VAPOUR PRESSURE: <0.01 mm Hg VAPOR DENSITY (air=1): >5 SPECIFIC GRAVITY (water=1): 0.90 DENSITY: not available WATER SOLUBILITY: negligible ph: not available VOLATILITY: not available ODOR THRESHOLD: not available EVAPORATION RATE: <0.01 (Butyl acetate=1) VISCOSITY: 16 mm C COEFFICIENT OF WATER/OIL DISTRIBUTION: not available SECTION 10 STABILITY AND REACTIVITY REACTIVITY: Stable at normal temperatures and pressures CONDITIONS TO AVOID: Avoid heat, flames, sparks and other sources of ignition. Avoid contact with incompatible materials. INCOMPATIBLES: Oxidising materials, chlorine HAZARDOUS DECOMPOSITION: Thermal decomposition products or combustion: oxides of carbon, oxides of sulphur POLYMERISATION: Will not polymerise. SECTION 11 TOXICOLOGICAL INFORMATION Solvent dewaxed heavy paraffinic distillates: Residual oils (petroleum), solvent dewaxed: Olefin sulfide mixture: Greater than 5,000 mg/kg oral-rat LD50 Methacrylate copolymer:

5 Page 5 of 5 Kerosene: Acrylate copolymer: Greater than 7,940 mg/kg oral-rat LD50 SECTION 12 ECOLOGICAL INFORMATION Not available SECTION 13 DISPOSAL CONSIDERATIONS Dispose in accordance with all applicable regulations SECTION 14 TRANSPORT INFORMATION LAND TRANSPORT ADR: No classification assigned. LAND TRANSPORT RID: No classification assigned. AIR TRANSPORT IATA: No classification assigned. AIR TRANSPORT ICAO: No classification assigned. MARITIME TRANSPORT IMDG: No classification assigned. SECTION 15 REGULATORY INFORMATION EUROPEAN REGULATIONS: EC CLASSIFICATION (CALCULATED): Not classified as dangerous. SECTION 16 OTHER INFORMATION The above information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of LUBRIPLATE Lubricants Company. The data on these sheets relates only to the specific material designated herein. LUBRIPLATE Lubricants Company assumes no legal responsibility for use or reliance upon this data.