REF PCb NOTE: REF PCb. Recommended Soldering Pattern NOTE: sdda56b2w InGaN Blue White Segment Common Anode

Transcription

1 mechanical dimensions mechanical dimensions 1 specifications Mechanical dimensions sdda56b2w dimension in millimeter (inch), dimension in millimeter (inch), dimension in millimeter (i and tolerance is 0.25 (.0 InTERnaL EQuIvaLEnT CIRCuIT ed tern dimension in millimeter (inch), Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ± 0.25mm (0.01 ) unless otherwise noted.. Specifications are subject to change without notice. 009 Corp E. Lexington Ave., Pomona CA Tel: Version: A Fax: Date: 4/27/ American Opto Plus LED Corp E. Lexington Ave., Pomona CA Tel: Fax: Part Version: Number A Date: 4/27/2009 Chip Material Color of Emission Lens Type Description American Opto Plus LED Corp E. Lexington Ave., Pomona CA Tel: Fax: sdda56b2w InGaN Blue White Segment Common Anode Castleton Street, #88 City of Industry, CA T: F:

2 2 ABSOLUTE MAXIMUM RATINGS (Ta=25 C) Parameter Symbol Value Unit Power Dissipation per Dice Pad 120 mw Derating Liner from 25 C per Dice - 0. ma / c Continuous Forward Current per Dice Iaf 0 ma Peak Current per Dice (duty cycle 1/10, 1kHz) Ipf 100 ma Reverse Voltage per Dice Vr 5 V Operating Temperature Topr -40~+105 c Storage Temperature Tstg -40~+105 c OPTICAL-ELECTRICAL CHARACTERISTICS (Ta=25 C) Characteristic Symbol Condition Value Min. Type. Max. Unit Forward Voltage per Dice Vf If = 5mA V Reverse Current per Dice Ir Vr = 8V µa Peak Wavelength per Dice λp If = 5mA nm Dominant Wavelength per Dice λd If = 5mA nm Luminous Intensity per Dice Iv If = 5mA mcd Spectral Radiation Bandwidth per Dice Δλ If = 5mA nm *Tolerance of viewing angle: -10 / +5 deg Castleton Street, #88 City of Industry, CA T: F:

3 optical characteristic curves Typical Electro-optical Characteristic Curves (25 Free air Temperature Unless Otherwise specified) Castleton Street, #88 City of Industry, CA T: F:

4 4 soldering conditions lamp type led SMT LOW SOLDERING INSTRUCTIONS SMT Soldering Profile Pb free reflow soldering Profile 5 SEC. TEMPERATURE 217 C 200 C 150 C C C/SEC.MAX. C/SEC.MAX. 6 C/SEC.MAX SEC. 100SEC.MAX. SOLDERING IRON TIME Basic spec is 4 sec when 260 C. If temperature is higher, time should be shorter (+10 C 1 sec). Power dissipation of Iron should be smaller than 15W, and temperature should be controllable. Surface temperature of the device should be under 20 C. REWORK Customer must finish rework within 5 sec. under 260. The head of soldering iron cannot touch copper foil Castleton Street, #88 City of Industry, CA T: F:

5 5 Dimensions of Tape (Unit: mm) Packaging specification Castleton Street, #88 City of Industry, CA T: F: