SPECIALTY PRODUCTS AQUACHECKTM ASPHALT PRODUCTS - SPECIALTY PRODUCTS

Transcription

1 ASPHALT S - SPECIALTY S SPECIALTY S

2 LN-1 LN-1 MINERAL SPIRITS & GENERAL CLEANER LN-1 Products high quality mineral spirit is a a multi-purpose cleaner and thinner. LN-1 can be used as a thinner with paints, enamels, and varnishes. It is used as a clean-up solvent for brushes, rollers, trays. It is used to clean wood, porcelain, metal furniture, and most types of flooring. It can even be used as a charcoal lighter fluid. DO NOT USE on asphalt, rubber tile, or around plugged-in electric motors or gas fired heaters. LN-1 when being used as a thinner can be introduced directly into the product to increase volume or reduce solids percentage. LN-1 when being used as a cleaner should not over saturate item being cleaned. LN-1 when being used as a charcoal lighter fluid should again not oversaturate the charcoal. Make sure container is closed and a safe distance from burner before ignition. Also allow sufficient time for fluid to burn off before using. LN-1 should be stored in a cool area and keep away from heat and open flames.

3 LN-12 LN-12 QUICK DRYING ASPHALT GILSONITE PAINT LN-12 Gilsonite Paint is a superior quick drying asphalt paint formulated to meet Federal Specification TTC-494 Types I, II, and III. LN-12 Gilsonite Paint is used as a tough and weather resistant coating on all types of steel, piping, industrial equipment chassis, radiators, burial vaults, etc. LN-12 Gilsonite Paint may be brushed or sprayed onto a clean and dry surface. This material dries in one hour and cures in approximately five hours. LN-12 Gilsonite Paint should be kept in a warm area before usage during cold seasons, but this material can be used year round and the only protection would be from weathering on the container. Gilsonite CAS

4 LN-52 LN-52 BLACK ASPHALT FENCE PAINT LN-52 Black Fence Paint is a high quality asphalt cutback fence paint. LN-52 Black Fence Paint is used as a protective coating and moisture barrier on all types of wood and steel structures. LN-52 Black Fence Paint must be applied to a surface that is dry and clean from all foreign matter. This material can be applied with roller, brush or spray equipment and should yield a coverage rate with gallons of 400 linear feet on three board fences. LN-52 Black Fence Paint can be used year round and the only protection would be from weathering on the container. HydrocarbonResin CAS

5 LN-3100 LN-3100 BLACK NET SET LN-3100 Black Net Set is an asphalt cutback formulated as a protective coating. LN-3100 Black Net Set is used as a protective coating that penetrates nets and coats crabpots. LN-3100 Black Net Set should be applied to nets and crabpots, which are dry and oil free. The item should be dipped for approximately twenty minutes and taken out and allowed to dry. LN-3100 Black Net Set can be used year round and the only protection would be from weathering on the container. HydrocarbonResin CAS

6 MP-33 MP-33 HEAVY DUTY INDUSTRIAL MASTIC MP-33 Heavy Duty Industrial Mastic meets TT-C-520 specifications and is 100% ASBESTOS-FREE. This material is a self-healing type asphalt cutback fortified with fibres and fillers. MP-33 Heavy Duty Industrial Mastic is a multi-purpose protective coating used as a moisture barrier on felt and metal roofs, siding, and masonry surfaces above and below grade. MP-33 Heavy Duty Industrial Mastic must be applied to a surface that is dry and clean of all foreign matter. This material should be kept in a warm area and stirred before use. This material can be applied by brush or trowel at a rate of 40 square feet per gallon. MP-33 Heavy Duty Industrial Mastic can be used year round and the only protection would be from weathering on the container. Fibre Amino Salt Clay CAS CAS CAS

7 MP-48 MP-48 WOOD BLOCK MASTIC MP-48 Wood Block Mastic is an asphalt cutback with fibres and additives to perform as a floor block mastic binder and is 100% ASBESTOS-FREE. MP-48 Wood Block Mastic is used for adhering wood block flooring and wooden subflooring in gymnasiums to concrete or wood base. This material also can be used in conjunction with a dampproofing membrane. MP-48 Wood Block Mastic must be applied to surface free of all foreign matter. This material should be applied with a notched trowel and should yield a coverage rate of square feet per gallon or use wood block manufacturers recommendation. MP-48 Wood Block Mastic can be used year round and the only protection would be from weathering on the container. Fibre Amine Salt Clay CAS CAS CAS CAS

8 MP-49 MP-49 BRICK BLOCK MASTIC MP-49 Brick Block Mastic is an asphalt cutback with fibres and latex additives to perform as a brick block mastic binder and is 100% ASBESTOS-FREE. MP-49 Brick Block Mastic is used for adhering brick or block in a paving application. This material also can be used in conjunction with a dampproofing membrane. MP-49 Brick Block Mastic must be applied to surface free of all foreign matter. This material should be applied with a notched trowel and should yield a coverage rate of square feet per gallon or use block or brick pavers manufacturers recommendation. MP-49 Brick Block Mastic can be used year round and the only protection would be from weathering on the container. Fibre Mineral Filler Amine Salt Clay Latex CAS CAS CAS CAS CAS

9 MP-52 MP-52 BITUMINOUS JOINT COMPOUND MP-52 Bituminous Joint Compound is a trowel mastic asphaltic compound for joint sealing and is 100% ASBESTOS-FREE. MP-52 Bituminous Joint Compound is used as a joint sealant for concrete pipe, foundations, and all other masonry and steel joint sealing. MP-52 Bituminous Joint Compound can be applied by trowel in a liberal fashion to fill the joint completely. MP-52 Bituminous Joint Compound can be used year round and the only protection would be from weathering on the container. Fibre Amine Salt Clay CAS CAS CAS CAS

10 SL-5 SL-5 SILICONE CLEAR GUARD SL-5 Silicone Clear Guard meets Federal Specification SS-W-00110C specifications. This material is formulated to be a clear silicone mixture with solvent. SL-5 Silicone Clear Guard is used to produce a moisture barrier on brick and masonry surfaces, but also allows for the structure to breathe and evaporate moisture. SL-5 Silicone Clear Guard must be applied to a surface that is dry and free of all foreign matter. This material may be applied by brush or spray equipment and should yield a coverage rate of 150 square feet per gallon on concrete or hard brick. SL-5 Silicone Clear Guard can be used year round and the only protection would be from weathering on the container. Silicone Resin Trade Secret

11 EM-12 EM-12 ASPHALT EMULSION METAL DUCTAL PIPE COAT EM-12 Pipe Coat is a single component non-flammable highly rubberized asphalt emulsion modified with polymers and plasticizers. EM-12 Pipe Coat is a sprayable coating designed to protect from corrosion, waterproofing, environmental elements and achieves excellent durability and flexibility. DO NOT ALLOW material to freeze. DO NOT THIN material. EM-12 Pipe Coat must be applied to a surface that is free from all foreign matter. This material should remain dry until it has cured. This material should be mixed before using and yields a coverage of square feet per gallon. EM-12 Pipe Coat must be kept from freezing. MATERIAL Weight per 770F, ASTM-D-1010, (lbs) SPECIFICATIONS: Nonvolatile %, ASTM-D F, ASTM-D-562 (Kreb's Stormer Unit) KU Softening Point (00F), ASTM-D Penetration (0.1 mm), ASTM-D Std. Spec. for Emulsified AASHTO Designation M ASTM Designation D Resistance to water, ASTM-D-2939 no blistering, no loss of adhesion, no re-emulsification meets spec. meets spec. Dry Time (hrs.) ASTM-D-2939 less than 1 Shelf Life (yrs.) 1-2

12 SC-700 SC-700 CAR INDUSTRIAL UNDERCOAT SC-700 Heavy Duty Industrial Undercoat meets TT-C-520 specifications and is 100% ASBESTOS-FREE. This material is a self-healing type asphalt cutback fortified with fibres and fillers. SC-700 Heavy Duty Industrial Undercoat is a multi-purpose protective coating used as a protective undercoat on cars and trailers. SC-700 Heavy Duty Industrial Undercoat must be applied to a surface that is dry and clean of all foreign matter. This material should be kept in a warm area and stirred before use. This material can be applied by brush or trowel at a rate of 40 square feet per gallon. SC-700 Heavy Duty Industrial Undercoat can be used year round and the only protection would be from weathering on the container. Fibre Amino Salt Clay CAS CAS CAS