INFRA. ...on a wave of confidence INNOVATION AQUALINE. an ideal solution for modern trenchless technologies and laying in sandless beds.

Transcription

1 INFRA...on a wave of confidence AQUALINE an ideal solution for modern trenchless technologies and laying in sandless beds. INNOVATION

2 Pipelife presents a new product line: AQUALINE RC water pipes

3 Aqualine pipes are made of 100% PE 100RC. PE 100RC materials Delivers Concentrated load resistance Increased resistance to pitting corrosion under tension Extended service life Reduced risk of failure of damaged pipes Quick installation allows the use of almost any material around the pipe - RC and RC2 up to 200 mm, AQUALINE RC Robust without granularity limitation Which means Financial savings Safety Reliability

4 AQUALINE RC series: 1 2 s = thickness determined by EN x,y = thickness of the individual wall layers with a total thickness given by EN , x + y = s (x : y = 90 : 10) t = thickness of the protective coating over the standard dimensions (e.g. AQUALINE RC ROBUST wall thickness = s mm) Note: Pipes intended for pressure sewer systems are colour-coded in brown.

5 Advantages of RC1 a RC2 1 Replaces the superpipe series AQUALINE RC1 (Type 1) - mono layer homogeneous black pipe with blue identification strips (dyed-through strip). The pipe is made of PE 100 RC in its full wall cross-section. It is suitable for open trenches without a sand-bed (possibility of point load) and less demanding trenchless installation methods). Product range: SDR 17 - DN 63-DN 400mm SDR 11 - DN 32-DN 400mm SDR 7,4 - DN 32-DN 400mm Product code starts with RC1-xxxxxx (e.g. RC /100) sandless installation in trenches suitable for delicate trenchless technologies reduced risk of failure of damaged pipes improved weldability without the necessity of protection cable 2 Replaces the Supertwin series AQUALINE RC2 (Type 2) - two-layer coextruded pipe with a black inner layer (90% of the wall thickness of black PE 100 RC) and a blue outer layer (10% of the wall thickness of blue PE 100 RC), which indicates excessive damage to the wall. External damage over 10% is clearly visible and the pipe itself indicates the extent of the damage. It does not have a higher overall thickness than the RC1 type and, except damage detection, it has no other technical advantages compared to type 1. Product range: SDR 11 - DN 32-DN 225mm SDR 17 - DN 50-DN 225mm Product code starts with RC2-xxxxxx (e.g. RC /012)

6 Replaces the ROBUST SUPERpipe series. AQUALINE RC ROBUST (Type 3) Pipe according to EN of PE 100 RC, with additional protective layer / coat with a thickness of approximately 1.6 mm with identification stripes. The coat is made from modified polyethylene (PEpro): its properties fully replace polypropylene it has a very smooth surface with a high resistance to scratching this allows for easier handling, particularly in the coils and in forming the arches on the installation route it is fully recyclable without the necessity of separation, whereby the environmental advantage of Aqualine piping is further improved Benefits of AQUALINE RC ROBUST use in trenches without grain size limitation use for all kinds of trenchless technologies easy to detect Aqualine RC ROBUST is deliverable with an integrated detection wire. Product range: SDR 11 - DN 32 - DN 355mm SDR 17 - DN 50 - DN 355mm SDR 7,4 - DN 90-DN 355mm, identification stripes Product code starts on ROB-xxxxxx (e.g. ROB /100)

7 PE pipes application according to the granulometry PE100 up to DN 200 max. 20 mm from DN 250 max. 40 mm AQUALINE RC1 up to 200 mm AQUALINE RC ROBUST UNLIMITED! AQUALINE RC2 up to 200 mm RC ROBUST 100% suitable for TRENCHLESS LAYING

8 PE pipes application according to the risk of damage Method PE 100 Type of pipes aqualine RC1 aqualine RC2 AQUALINE RC ROBUST Laying in trench sand backfill Laying in trench (max. grain) Laying in trench without limitation grain Relining pipes with smooth internal surface Relining pipes inside unspecified Ploughing Milling work Horizontal drilling * Burstlining * Depends on the quality of soil pipe can be used when laying with low risk pipe can be used, for the installation with medium risk pipe can be used when laying with high risk, it requires an additional protective layer

9 Quality of RC pipes is documented: with certifications according to EN ISO 9001 and EN ISO tests of pipes at the 2016 technical level ISO PENT EN PAS 1075 PAS 1075 GRIS EN PAS For more information, see our website