WARNING! Safety Data Sheet Deep Fat Fryer Cleaner. JEM MFG LLC 1901 Parrish Drive SE Rome, GA (706) CHEMTREC :...

Transcription

1 SECTION I - IDENTIFICATION JEM MFG LLC 1901 Parrish Drive SE Rome, GA (706) CHEMTREC :... (800) Product Number Product Name Chemical Family CAS Number Date Prepared Revision Number F /1/2015 SECTION II - HAZARDOUS IDENTIFICATION GHS CLASSIFICATION: Classification Skin Corrosion/Irritation Category 2 WARNING! GHS LABEL: Hazard Statements H315 Causes skin irritation Page 1 of 7

2 Precautionary Statements P264 Wash hands thoroughly after handling. P280 P P P362 Wear protective gloves/protective clothing/eye protection/face protection. IF ON SKIN: Wash with soap and water. If skin irritation occurs: get medical advice/attention. Take off contaminated clothing and wash before reuse. SECTION III - COMPOSITION/INFORMATION ON INGREDIENTS The precise composition of this product is proprietary information. In the event of a medical emergency, a complete disclosure will be provided to medical personnel. Component Name CAS # Component% OSHA PEL ACGIH TLV Sodium Hydroxide mg/m³, Ceiling 2 mg/m³, Ceiling SECTION IV - FIRST AID MEASURES Contact with eyes: Flush with water for 15 minutes. Seek immediate medical attention. Skin contact: Inhalation: Wash exposed areas with water and mild soap. Remove contaminated clothing immediately and launder before reuse. If irritations persist, seek immediate medical attention. Remove victim to fresh air. Administer oxygen or artificial respiration if breathing is affected or stopped. Seek immediate medical attention. Ingestion: If swallowed. Do not induce vomiting. Seek immediate medical attetntion. Give large quantities of milk or acidic beverages. SECTION V - FIREFIGHTING MEASURES Suitable Extinguishing Media: Water fog, foam, CO2, dry chemical. Special Fire Fighting Procedures Use self-contained breathing apparatus and full bunker gear in fire areas. Evacuate all unprotected personnel from area. Keep containers cool with water fog to minimize swelling taking care not to spread flames with water used for cooling. Unusual Fire Fighting Hazards: Product is water reactive due to content of Sodium Hydroxide. Page 2 of 7

3 SECTION VI - ACCIDENTAL RELEASE MEASURES Personal Precautions: Environmental Precautions: Use appropriate personal protective equipment (i.e. -gloves, goggles, apron, etc.) to minimize risk of exposure to skin and eyes. Prevent liquid from entering drains, sewers or waterways. Methods for Cleaning Up: Small spill: Sweep dry powder if possible and dispose of in a closed container. Small amounts may be flushed to drain with large quantities of water. Large spills: Sweep or scrape and containerize dry material in an appropriate closed container. Dike or wet vacuum liquid spills. Clean up residual material by washing area with water. SECTION VII - HANDLING AND STORAGE Handling and Storage: Avoid prolonged breathing of mist or vapor. Wash thoroughly after handling. Avoid contact with eyes. Avoid prolonged skin contact with product concentrate and solutions. EXPOSURE LIMITS: SECTION VIII - PRECAUTIONS TO CONTROL EXPOSURE / PERSONAL PROTECTION Component Name CAS # OSHA PEL ACGIH TLV Sodium Hydroxide mg/m³, Ceiling 2 mg/m³, Ceiling Engineering Controls: Monitoring: Adequate local or mechanical to reduce vapor or mist to below the PEL or TLV. Follow accepted work practices for handling a corrosive material. Personal Protective Equipment (PPE) Eye Protection: Goggles or approved OSHA device with side shields; do not wear contact lenses when handling this product. Skin Protection: Impervious solvent resistent gloves. Impervious solvent resistent gloves. Impervious apron and work boots recommend where splashing may occur. Respiratory Protection: Use the proper respirator in areas where the chemical exposure is unknown or above the OSHA PEL or ACGIH TLV. Page 3 of 7

4 Appearance Odor C 12.5 Melting/Freezing Point Flashpoint Specific Gravity Soluability Auto-Ignition Temperature Decomposition Temperature VOC Content Odor Threshold Boiling Range Evaporation Point Flammable Limits - Upper Flammable Limits - Lower Vapor Pressure Vapor Density (Air=1) Viscosity Safety Data Sheet SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES White, granular powder Complete n/a n/a SECTION X - STABILITY AND REACTIVITY Stability: Conditions to Avoid: Stable until mixed with water. Generates considerable heat when mixed with water. Strong acidic liquids, aluminum, zinc, tin, brass and bronze. Hazardous Decomposition/Byproducts: Reaction with various sugars may form carbon monoxide. Hazardous Polymerization: Will not occur. Polymerization Conditions to Avoid: Incompatibilities: Strong acids and oxidizers Page 4 of 7

5 SECTION XI - TOXICOLOGICAL INFORMATION Likely Route of Exposure: Contact and inhalation; ingestion possible. Inhalation: No test data for product. Eye Contact: Very irritating. Skin Contact: Very irritating. Ingestion: No test data for product. Toxicity: Component Name LD50 LC50 Sodium Hydroxide Not Established Not Established Reproductive Effects Teratogenicity Mutagenicity Embryotoxicity Sensitization to Product Synergistic Products SECTION XII - ECOLOGICAL INFORMATION Ecotoxicity: Mobility: Degradability: BioAccumulation: SECTION XIII - WASTE DISPOSAL CONSIDERATIONS DOT SHIPPING INFORMATION SECTION XIV - TRANSPORT INFORMATION Proper Shipping Name: Corrosive solid, basic, inorganic, n.o.s., (containing sodium hydroxid Page 5 of 7

6 Contains: Hazard Class and Label: 8, UN3262 Identification Number: Packaging Group: III Safety Data Sheet SECTION XV - REGULATORY INFORMATION TSCA STATUS:... SARA TITLE III SECTION 302/304 EXTREMELY HAZARDOUS SUBSTANCE: No chemicals in this material are subject to the reporting requirements. SARA TITLE III SECTION 311/312 HAZARD CATEGORIZATION: Acute X Chronic Fire Pressure Reactive X SARA TITLE III SECTION 313 SUPPLIER INFORMATION: No chemicals in this material are subject to the reporting requirements. CERCLA SECTION 102(a) HAZARDOUS SUBSTANCE: Component Name CAS # % by wt. RQ (lbs.) Sodium Hydroxide ,000 CALIFORNIA PROPOSITION 65: No chemicals in this material are subject to the reporting requirements. SECTION XVI - OTHER INFORMATION HMIS Health:... 2 HMIS Flammability:... 0 HMIS Reactivity:... 0 Additional: Disclaimer -The information in this SDS is given in good faith, but no warranty expressed or implied is made. JEM MFG LLC assumes no responsibility for personal injury or property damage to vendees, users, or third parties caused by the material. As potential misuse of the material cannot be controlled by the manufacturer, vendees or end users assume all risks associated with the use of the material. Page 6 of 7

7 Page 7 of 7