SAFETY DATA SHEET. Creation Date 26-Feb-2014 Revision Date 18-Jan-2018 Revision Number 3

Size: px
Start display at page:

Download "SAFETY DATA SHEET. Creation Date 26-Feb-2014 Revision Date 18-Jan-2018 Revision Number 3"

Transcription

1 SAFETY DATA SHEET Creation Date 26-Feb-2014 Revision Number 3 Product Name Cat No. : Synonyms Recommended Use Uses advised against 1. Identification BP ; BP Antilysine; Basic Pancreatic Trypsin Inhibitor; Trypsin Inhibitor. Laboratory chemicals. Not for food, drug, pesticide or biocidal product use Details of the supplier of the safety data sheet Company Fisher Scientific One Reagent Lane Fair Lawn, NJ Tel: (201) Emergency Telephone Number CHEMTRECÒ, Inside the USA: CHEMTRECÒ, Outside the USA: Hazard(s) identification Classification Classification under 2012 OSHA Hazard Communication Standard (29 CFR ) Based on available data, the classification criteria are not met Label Elements None required Hazards not otherwise classified (HNOC) None identified 3. Composition/Information on Ingredients Component CAS-No Weight % Water >98 Sodium chloride <1 Benzyl alcohol <1 Trypsin inhibitor, pancreatic basic <1 4. First-aid measures Page 1 / 6

2 Eye Contact Skin Contact Inhalation Ingestion Most important symptoms and effects Notes to Physician Unsuitable Extinguishing Media Flash Point Method - Autoignition Temperature Explosion Limits Upper Lower Oxidizing Properties Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get medical attention. Wash off immediately with plenty of water for at least 15 minutes. Get medical attention immediately if symptoms occur. Move to fresh air. Get medical attention immediately if symptoms occur. Clean mouth with water and drink afterwards plenty of water. Get medical attention if symptoms occur. None reasonably foreseeable. Treat symptomatically 5. Fire-fighting measures Not oxidising Sensitivity to Mechanical Impact Sensitivity to Static Discharge Specific Hazards Arising from the Chemical None known. None reasonably foreseeable. Hazardous Combustion Products None under normal use conditions Protective Equipment and Precautions for Firefighters As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. NFPA Health 1 Flammability 0 Instability 0 Physical hazards N/A Personal Precautions Environmental Precautions 6. Accidental release measures Use personal protective equipment. Ensure adequate ventilation. Should not be released into the environment. Methods for Containment and Clean Sweep up or vacuum up spillage and collect in suitable container for disposal. Up Handling Storage 7. Handling and storage Wear personal protective equipment. Ensure adequate ventilation. Avoid ingestion and inhalation. Avoid contact with skin, eyes and clothing. Keep container tightly closed. 8. Exposure controls / personal protection Page 2 / 6

3 Exposure Guidelines This product does not contain any hazardous materials with occupational exposure limitsestablished by the region specific regulatory bodies. Engineering Measures None under normal use conditions. Personal Protective Equipment Eye/face Protection Skin and body protection Respiratory Protection Hygiene Measures Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR or European Standard EN166. Wear appropriate protective gloves and clothing to prevent skin exposure. No protective equipment is needed under normal use conditions. Handle in accordance with good industrial hygiene and safety practice. 9. Physical and chemical properties Physical State Liquid Appearance Colorless Odor Odorless Odor Threshold ph 7 Melting Point/Range 0 C / 32 F Boiling Point/Range 100 C / 212 F Flash Point Evaporation Rate Flammability (solid,gas) Flammability or explosive limits Upper Lower Vapor Pressure Vapor Density Specific Gravity Solubility miscible Partition coefficient; n-octanol/water Autoignition Temperature Decomposition Temperature Viscosity 10. Stability and reactivity Reactive Hazard Stability Conditions to Avoid Incompatible Materials None known, based on information available Stable. Excess heat. None known Hazardous Decomposition Products None under normal use conditions Hazardous Polymerization Hazardous Reactions Hazardous polymerization does not occur. None under normal processing. Page 3 / 6

4 Acute Toxicity 11. Toxicological information Product Information Oral LD50 Based on ATE data, the classification criteria are not met. ATE > 2000 mg/kg. Dermal LD50 Based on ATE data, the classification criteria are not met. ATE > 2000 mg/kg. Vapor LC50 Based on ATE data, the classification criteria are not met. ATE > 20 mg/l. Component Information Component LD50 Oral LD50 Dermal LC50 Inhalation Water - Not listed Not listed Sodium chloride LD50 = 3 g/kg ( Rat ) LD50 > 10 g/kg ( Rabbit ) LC50 > 42 g/m 3 ( Rat ) 1 h Benzyl alcohol LD50 = 1230 mg/kg ( Rat ) LD50 = 2 g/kg ( Rabbit ) LC50 = 8.8 mg/l ( Rat ) 4 h Toxicologically Synergistic Products Delayed and immediate effects as well as chronic effects from short and long-term exposure Irritation Sensitization Carcinogenicity The table below indicates whether each agency has listed any ingredient as a carcinogen. Component CAS-No IARC NTP ACGIH OSHA Mexico Water Not listed Not listed Not listed Not listed Not listed Sodium chloride Not listed Not listed Not listed Not listed Not listed Benzyl alcohol Not listed Not listed Not listed Not listed Not listed Trypsin inhibitor, pancreatic basic Not listed Not listed Not listed Not listed Not listed Mutagenic Effects Reproductive Effects Developmental Effects Teratogenicity STOT - single exposure STOT - repeated exposure Aspiration hazard Symptoms / effects,both acute and delayed Endocrine Disruptor Information Other Adverse Effects Ecotoxicity Do not empty into drains.... None known None known The toxicological properties have not been fully investigated. 12. Ecological information Component Freshwater Algae Freshwater Fish Microtox Water Flea Sodium chloride Not listed Pimephals prome: LC50: Not listed EC50: 1000 mg/l/48h 7650 mg/l/96h Benzyl alcohol EC50 = 35 mg/l 3h Lepomis macrochirus: LC50 = 10 mg/l 96h Photobacterium phosphoreum: EC50 = 50mg/L 5 min Photobacterium EC50 = 23 mg/l 48h Page 4 / 6

5 Persistence and Degradability Bioaccumulation/ Accumulation Mobility.. phosphoreum: EC50 = 63.7 mg/l 15 min Photobacterium phosphoreum: EC50 = 71.4 mg/l 30 min Component log Pow Benzyl alcohol 1.1 Waste Disposal Methods DOT TDG IATA IMDG/IMO 13. Disposal considerations Chemical waste generators must determine whether a discarded chemical is classified as a hazardous waste. Chemical waste generators must also consult local, regional, and national hazardous waste regulations to ensure complete and accurate classification. 14. Transport information 15. Regulatory information All of the components in the product are on the following Inventory lists: X = listed International Inventories Component TSCA DSL NDSL EINECS ELINCS NLP PICCS ENCS AICS IECSC KECL Water X X X - X X X Sodium chloride X X X X X X X Benzyl alcohol X X X X X X X Trypsin inhibitor, pancreatic X X basic Legend: X - Listed E - Indicates a substance that is the subject of a Section 5(e) Consent order under TSCA. F - Indicates a substance that is the subject of a Section 5(f) Rule under TSCA. N - Indicates a polymeric substance containing no free-radical initiator in its inventory name but is considered to cover the designated polymer made with any free-radical initiator regardless of the amount used. P - Indicates a commenced PMN substance R - Indicates a substance that is the subject of a Section 6 risk management rule under TSCA. S - Indicates a substance that is identified in a proposed or final Significant New Use Rule T - Indicates a substance that is the subject of a Section 4 test rule under TSCA. XU - Indicates a substance exempt from reporting under the Inventory Update Rule, i.e. Partial Updating of the TSCA Inventory Data Base Production and Site Reports (40 CFR 710(B). Y1 - Indicates an exempt polymer that has a number-average molecular weight of 1,000 or greater. Y2 - Indicates an exempt polymer that is a polyester and is made only from reactants included in a specified list of low concern reactants that comprises one of the eligibility criteria for the exemption rule. U.S. Federal Regulations TSCA 12(b) SARA 313 SARA 311/312 Hazard Categories See section 2 for more information Page 5 / 6

6 CWA (Clean Water Act) Clean Air Act OSHA Occupational Safety and Health Administration CERCLA California Proposition 65 This product does not contain any Proposition 65 chemicals U.S. State Right-to-Know Regulations Component Massachusetts New Jersey Pennsylvania Illinois Rhode Island Water - - X - - Benzyl alcohol X - X - - U.S. Department of Transportation Reportable Quantity (RQ): DOT Marine Pollutant DOT Severe Marine Pollutant N N N U.S. Department of Homeland Security This product does not contain any DHS chemicals. Other International Regulations Mexico - Grade Prepared By Creation Date Revision Date Print Date Revision Summary 16. Other information Regulatory Affairs Thermo Fisher Scientific EMSDS.RA@thermofisher.com 26-Feb Jan Jan-2018 Change to physical properties. Disclaimer The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text End of SDS Page 6 / 6