Issue Date: 08-Jan-2016 Revision Date: 8- April-2016 Version 2 1. IDENTIFICATION 2. HAZARDS IDENTIFICATION

Size: px
Start display at page:

Download "Issue Date: 08-Jan-2016 Revision Date: 8- April-2016 Version 2 1. IDENTIFICATION 2. HAZARDS IDENTIFICATION"

Transcription

1 Safety Data Sheet Issue Date: 08-Jan-2016 Revision Date: 8- April-2016 Version 2 1. IDENTIFICATION Product Identifier Product Name Other means of identification SDS # Brady Low Foam Laundry JA0150 Recommended use of the chemical and restrictions on use Recommended Use Laundry detergent. Details of the supplier of the safety data sheet Supplier Address Brady Industries 7055 Lindell Road Las Vegas, NV Phone: (702) USA Emergency Telephone Number Company Phone Number Emergency Telephone (24 hr) : ChemTel HAZARDS IDENTIFICATION Appearance Light blue powder Physical State Solid Odor Spearmint Classification Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 1 Hazards Not Otherwise Classified (HNOC) May be harmful if swallowed Signal Word Danger Hazard Statements Causes skin irritation Causes serious eye damage Page 1 / 8

2 Precautionary Statements - Prevention Wash face, hands and any exposed skin thoroughly after handling Wear protective gloves/protective clothing/eye protection/face protection Precautionary Statements - Response IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing Immediately call a poison center or doctor/physician IF ON SKIN: Wash with plenty of soap and water If skin irritation occurs: Get medical advice/attention Take off contaminated clothing and wash it before reuse 3. COMPOSITION/INFORMATION ON INGREDIENTS Chemical Name CAS No Weight-% Nonylphenol Ethoxylate Proprietary Sodium percarbonate Proprietary Sodium metasilicate Proprietary **If Chemical Name/CAS No is "proprietary" and/or Weight-% is listed as a range, the specific chemical identity and/or percentage of composition has been withheld as a trade secret.** First Aid Measures 4. FIRST-AID MEASURES General Advice Eye Contact Skin Contact Inhalation Ingestion Provide this SDS to medical personnel for treatment. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a poison center or doctor/physician. IF ON SKIN: Wash with plenty of soap and water. If skin irritation occurs: Get medical advice/attention. Take off contaminated clothing and wash it before reuse. Remove to fresh air. Clean mouth with water and drink afterwards plenty of water. Most important symptoms and effects Symptoms Causes skin irritation. Causes serious eye damage. May be harmful if swallowed. Indication of any immediate medical attention and special treatment needed Notes to Physician Treat symptomatically. 5. FIRE-FIGHTING MEASURES Suitable Extinguishing Media Page 2 / 8

3 Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Unsuitable Extinguishing Media. Specific Hazards Arising from the Chemical. Protective equipment and precautions for firefighters As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. 6. ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment and emergency procedures Personal Precautions Environmental Precautions Use personal protective equipment as required. See Section 12 for additional Ecological Information. Methods and material for containment and cleaning up Methods for Containment Methods for Clean-Up Prevent further leakage or spillage if safe to do so. Keep in suitable, closed containers for disposal. 7. HANDLING AND STORAGE Precautions for safe handling Advice on Safe Handling Handle in accordance with good industrial hygiene and safety practice. Wear protective gloves/protective clothing and eye/face protection. Wash face, hands, and any exposed skin thoroughly after handling. Conditions for safe storage, including any incompatibilities Storage Conditions Incompatible Materials Keep containers tightly closed in a dry, cool and well-ventilated place. None known based on information supplied. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Exposure Guidelines Chemical Name ACGIH TLV OSHA PEL NIOSH IDLH Sodium metasilicate 2 mg/m 3 2 mg/m Appropriate engineering controls Engineering Controls Apply technical measures to comply with the occupational exposure limits. Individual protection measures, such as personal protective equipment Eye/Face Protection Skin and Body Protection Refer to 29 CFR for eye and face protection regulations. Refer to 29 CFR for appropriate skin and body protection. Page 3 / 8

4 Respiratory Protection Refer to 29 CFR for respiratory protection requirements. General Hygiene Considerations Handle in accordance with good industrial hygiene and safety practice. Information on basic physical and chemical properties 9. PHYSICAL AND CHEMICAL PROPERTIES Physical State Solid Appearance Light blue powder Odor Spearmint Color Light blue Odor Threshold Property Values Remarks Method ph Melting Point/Freezing Point Boiling Point/Boiling Range Flash Point Evaporation Rate Flammability (Solid, Gas) Upper Flammability Limits Lower Flammability Limit Vapor Pressure Vapor Density Specific Gravity Water Solubility Solubility in other solvents Partition Coefficient Auto-ignition Temperature Decomposition Temperature Kinematic Viscosity Dynamic Viscosity Explosive Properties Oxidizing Properties Reactivity Not reactive under normal conditions. 10. STABILITY AND REACTIVITY Chemical Stability Stable under recommended storage conditions. Possibility of Hazardous Reactions None under normal processing. Conditions to Avoid Keep out of reach of children. Incompatible Materials None known based on information supplied. Page 4 / 8

5 Hazardous Decomposition Products None known based on information supplied. Information on likely routes of exposure Product Information 11. TOXICOLOGICAL INFORMATION Eye Contact Skin Contact Inhalation Ingestion Causes serious eye damage. Causes skin irritation. Do not inhale. May be harmful if swallowed. Component Information Chemical Name Oral LD50 Dermal LD50 Inhalation LC50 Sodium Chloride = 3 g/kg ( Rat ) > 10 g/kg ( Rabbit ) > 42 g/m 3 ( Rat ) 1 h Sodium Bicarbonate = 4220 mg/kg ( Rat ) Nonylphenol Ethoxylate = 1310 mg/kg ( Rat ) Sodium percarbonate = 1034 mg/kg ( Rat ) Sodium metasilicate = 600 mg/kg ( Rat ) - - Information on physical, chemical and toxicological effects Symptoms Please see section 4 of this SDS for symptoms. Delayed and immediate effects as well as chronic effects from short and long-term exposure Carcinogenicity Based on the information provided, this product does not contain any carcinogens or potential carcinogens as listed by OSHA, IARC or NTP. Numerical measures of toxicity 12. ECOLOGICAL INFORMATION Ecotoxicity The product is not classified as environmentally hazardous. However, this does not exclude the possibility that large or frequent spills can have a harmful or damaging effect on the environment. Component Information Chemical Name Algae/aquatic plants Fish Toxicity to Crustacea microorganisms Sodium Chloride : 96 h Lepomis 1000: 48 h Daphnia magna Page 5 / 8

6 macrochirus mg/l LC50 flowthrough 12946: 96 h Lepomis macrochirus mg/l LC50 static : 96 h Pimephales promelas mg/l LC50 static 7050: 96 h Pimephales promelas mg/l LC50 semi-static : 96 h Pimephales promelas mg/l LC50 static : 96 h Oncorhynchus mykiss mg/l LC50 flow-through Sodium Bicarbonate Sodium percarbonate Sodium metasilicate : 120 h Nitzschia linearis mg/l EC50 70: 240 h Chlorella emersonii mg/l EC : 96 h Lepomis macrochirus mg/l LC50 static 70.7: 96 h Pimephales promelas mg/l LC50 static 210: 96 h Brachydanio rerio mg/l LC50 semi-static 210: 96 h Brachydanio rerio mg/l LC50 mg/l EC : 48 h Daphnia magna mg/l EC50 Static 2350: 48 h Daphnia magna mg/l EC50 4.9: 48 h Daphnia pulex mg/l EC50 216: 96 h Daphnia magna mg/l EC50 Persistence/Degradability. Bioaccumulation. Mobility Other Adverse Effects 13. DISPOSAL CONSIDERATIONS Waste Treatment Methods Disposal of Wastes Contaminated Packaging Disposal should be in accordance with applicable regional, national and local laws and regulations. Disposal should be in accordance with applicable regional, national and local laws and regulations. California Hazardous Waste Status Chemical Name Sodium percarbonate California Hazardous Waste Status Ignitable 14. TRANSPORT INFORMATION Note DOT Please see current shipping paper for most up to date shipping information, including exemptions and special circumstances. Not regulated Page 6 / 8

7 IATA IMDG Not regulated Not regulated 15. REGULATORY INFORMATION International Inventories Chemical Name TSCA DSL NDSL EINECS ELINCS ENCS IECSC KECL PICCS AICS Nonylphenol Ethoxylate Present X Present X Present X X Sodium percarbonate Present X Present Present X Present X X Sodium metasilicate Present X Present Present X Present X X Legend: TSCA - United States Toxic Substances Control Act Section 8(b) Inventory DSL/NDSL - Canadian Domestic Substances List/Non-Domestic Substances List EINECS/ELINCS - European Inventory of Existing Chemical Substances/European List of Notified Chemical Substances ENCS - Japan Existing and New Chemical Substances IECSC - China Inventory of Existing Chemical Substances KECL - Korean Existing and Evaluated Chemical Substances PICCS - Philippines Inventory of Chemicals and Chemical Substances AICS - Australian Inventory of Chemical Substances US Federal Regulations SARA 313 US State Regulations U.S. State Right-to-Know Regulations Page 7 / 8

8 16. OTHER INFORMATION NFPA HMIS Health Hazards Health Hazards Flammability Flammability Instability Physical Hazards Special Hazards Personal Protection Issue Date: Revision Date: Revision Note: 08-Jan Jan-2016 New format Disclaimer The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text. End of Safety Data Sheet Page 8 / 8