SAFETY DATA SHEET. SECTION 1: Identification of the substance/mixture and of the company/undertaking

Transcription

1 SAFETY DATA SHEET SECTION 1: Identification of the substance/mixture and of the company/undertaking 1.1. Product identifier Trade name or designation of the mixture Registration number Synonyms Product code Issue date Version number Revision date Trade Club C3 5W-30 - UKTOFL05 UKTOTW05 UKTOBA05 17-June June Relevant identified uses of the substance or mixture and uses advised against Automotive lubricant Identified uses Uses advised against None known Details of the supplier of the safety data sheet Vauxhall Trade Club Griffin House UK Osborne Road Luton Bedfordshire LU1 3YT 1.4 Emergency telephone SECTION 2: Hazards identification 2.1. Classification of the substance or mixture The mixture has been assessed and/or tested for its physical, health and environmental hazards and the following classification applies. Classification according to Regulation (EC) No 1272/2008 as amended This mixture does not meet the criteria for classification according to Regulation (EC) 1272/2008 as amended. Hazard summary 2.2. Label elements Label according to Regulation (EC) No. 1272/2008 as amended Hazard pictograms Signal word Hazard statements Precautionary statements Prevention Response Storage Disposal Supplemental label information 2.3. Other hazards The mixture does not meet the criteria for classification. Observe good industrial hygiene practices. Wash hands after handling. Store away from incompatible materials. Dispose of waste and residues in accordance with local authority requirements. Not a PBT or vpvb substance or mixture. SECTION 3: Composition/information on ingredients 3.2. Mixtures The components are not hazardous or are below required disclosure limits. List of abbreviations and symbols that may be used above #: This substance has been assigned Union workplace exposure limit(s). M: M-factor PBT: persistent, bioaccumulative and toxic substance. vpvb: very persistent and very bioaccumulative substance. All concentrations are in percent by weight unless ingredient is a gas. Gas concentrations are in percent by volume. UKTOFL05 UKTOTW05 UKTOBA05 Version #: 04 Revision date: 17-June-2017 Issue date: 17-June / 6

2 Composition comments SECTION 4: First aid measures General information The full text for all H-statements is displayed in section 16. Ensure that medical personnel are aware of the material(s) involved, and take precautions to protect themselves Description of first aid measures Move to fresh air. Call a physician if symptoms develop or persist. Inhalation Skin contact Eye contact Ingestion 4.2. Most important symptoms and effects, both acute and delayed 4.3. Indication of any immediate medical attention and special treatment needed SECTION 5: Firefighting measures General fire hazards 5.1. Extinguishing media Suitable extinguishing media Unsuitable extinguishing media 5.2. Special hazards arising from the substance or mixture 5.3. Advice for firefighters Special protective equipment for firefighters Special fire fighting procedures Specific methods Wash off with soap and water. Get medical attention if irritation develops and persists. Rinse with water. Get medical attention if irritation develops and persists. Rinse mouth. Get medical attention if symptoms occur. Exposure may cause temporary irritation, redness, or discomfort. Treat symptomatically. SECTION 6: Accidental release measures No unusual fire or explosion hazards noted. Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Do not use water jet as an extinguisher, as this will spread the fire. During fire, gases hazardous to health may be formed. Self-contained breathing apparatus and full protective clothing must be worn in case of fire. Move containers from fire area if you can do so without risk. Use standard firefighting procedures and consider the hazards of other involved materials Personal precautions, protective equipment and emergency procedures For non-emergency Keep unnecessary personnel away. For personal protection, see section 8 of the SDS. personnel For emergency responders 6.2. Environmental precautions 6.3. Methods and material for containment and cleaning up 6.4. Reference to other sections SECTION 7: Handling and storage 7.1. Precautions for safe handling 7.2. Conditions for safe storage, including any incompatibilities 7.3. Specific end use(s) Keep unnecessary personnel away. Use personal protection recommended in Section 8 of the SDS. Avoid discharge into drains, water courses or onto the ground. Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination. Never return spills to original containers for re-use. For personal protection, see section 8 of the SDS. For waste disposal, see section 13 of the SDS. Avoid prolonged exposure. Observe good industrial hygiene practices. Store in original tightly closed container. Store away from incompatible materials (see Section 10 of the SDS). Automotive lubricant SECTION 8: Exposure controls/personal protection 8.1. Control parameters Occupational exposure limits Biological limit values No exposure limits noted for ingredient(s). No biological exposure limits noted for the ingredient(s). UKTOFL05 UKTOTW05 UKTOBA05 Version #: 04 Revision date: 17-June-2017 Issue date: 17-June / 6

3 Recommended monitoring procedures Derived no effect levels (DNELs) Predicted no effect concentrations (PNECs) Follow standard monitoring procedures Exposure controls Appropriate engineering controls Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Individual protection measures, such as personal protective equipment General information Personal protection equipment should be chosen according to the CEN standards and in discussion with the supplier of the personal protective equipment. Eye/face protection Skin protection - Hand protection - Other Respiratory protection Thermal hazards Hygiene measures Environmental exposure controls Wear safety glasses with side shields (or goggles). Wear appropriate chemical resistant gloves. Suitable gloves can be recommended by the glove supplier. Wear suitable protective clothing. SECTION 9: Physical and chemical properties 9.1. Information on basic physical and chemical properties Appearance Odour Physical state Form Colour Odour threshold ph Melting point/freezing point Initial boiling point and boiling range In case of insufficient ventilation, wear suitable respiratory equipment. Wear appropriate thermal protective clothing, when necessary. Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. Environmental manager must be informed of all major releases. Liquid. Liquid. Gold. Brown. Slight. 300 C (572 F) estimated Flash point > > C (> F) Evaporation rate Flammability (solid, gas) Not applicable. Upper/lower flammability or explosive limits Flammability limit - lower (%) Flammability limit - upper (%) Vapour pressure Vapour density Relative density Solubility(ies) Solubility (water) Partition coefficient (n-octanol/water) Auto-ignition temperature Decomposition temperature 0.1 hpa estimated UKTOFL05 UKTOTW05 UKTOBA05 Version #: 04 Revision date: 17-June-2017 Issue date: 17-June / 6

4 Viscosity Viscosity temperature Explosive properties Oxidising properties 9.2. Other information Density Kinematic viscosity Percent volatile Specific gravity VOC 75 mm²/s 40 C (104 F) Not explosive. Not oxidising g/cm3 estimated 75 mm²/s (40 C (104 F)) 0.07 % estimated 1.05 estimated 0.07 % estimated SECTION 10: Stability and reactivity Reactivity Chemical stability Possibility of hazardous reactions Conditions to avoid Incompatible materials Hazardous decomposition products The product is stable and non-reactive under normal conditions of use, storage and transport. Material is stable under normal conditions. No dangerous reaction known under conditions of normal use. Contact with incompatible materials. Strong oxidising agents. SECTION 11: Toxicological information General information No hazardous decomposition products are known. Occupational exposure to the substance or mixture may cause adverse effects. Information on likely routes of exposure Inhalation Prolonged inhalation may be harmful. Skin contact Eye contact Ingestion Symptoms Information on toxicological effects Acute toxicity Skin corrosion/irritation Serious eye damage/eye irritation Respiratory sensitisation Skin sensitisation Germ cell mutagenicity Carcinogenicity Reproductive toxicity Specific target organ toxicity - single exposure Specific target organ toxicity - repeated exposure Aspiration hazard Mixture versus substance information Other information No adverse effects due to skin contact are expected. Direct contact with eyes may cause temporary irritation. May cause discomfort if swallowed. However, ingestion is not likely to be a primary route of occupational exposure. Exposure may cause temporary irritation, redness, or discomfort. No data available. No information available. SECTION 12: Ecological information Toxicity Based on available data, the classification criteria are not met for hazardous to the aquatic environment Persistence and degradability Bioaccumulative potential Partition coefficient n-octanol/water (log Kow) No data is available on the degradability of this product. No data available. UKTOFL05 UKTOTW05 UKTOBA05 Version #: 04 Revision date: 17-June-2017 Issue date: 17-June / 6

5 Bioconcentration factor (BCF) Mobility in soil Results of PBT and vpvb assessment No data available. Not a PBT or vpvb substance or mixture Other adverse effects No other adverse environmental effects (e.g. ozone depletion, photochemical ozone creation potential, endocrine disruption, global warming potential) are expected from this component. SECTION 13: Disposal considerations Waste treatment methods Residual waste Contaminated packaging EU waste code Disposal methods/information Special precautions SECTION 14: Transport information ADR RID ADN IATA IMDG Transport in bulk according to Annex II of Marpol and the IBC Code Dispose of in accordance with local regulations. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe manner (see: Disposal instructions). Since emptied containers may retain product residue, follow label warnings even after container is emptied. Empty containers should be taken to an approved waste handling site for recycling or disposal. The Waste code should be assigned in discussion between the user, the producer and the waste disposal company. Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Dispose in accordance with all applicable regulations. Not established. SECTION 15: Regulatory information Safety, health and environmental regulations/legislation specific for the substance or mixture EU regulations Regulation (EC) No. 1005/2009 on substances that deplete the ozone layer, Annex I and II, as amended Regulation (EC) No. 850/2004 On persistent organic pollutants, Annex I as amended Regulation (EU) No. 649/2012 concerning the export and import of dangerous chemicals, Annex I, Part 1 as amended Regulation (EU) No. 649/2012 concerning the export and import of dangerous chemicals, Annex I, Part 2 as amended Regulation (EU) No. 649/2012 concerning the export and import of dangerous chemicals, Annex I, Part 3 as amended Regulation (EU) No. 649/2012 concerning the export and import of dangerous chemicals, Annex V as amended Regulation (EC) No. 166/2006 Annex II Pollutant Release and Transfer Registry, as amended Regulation (EC) No. 1907/2006, REACH Article 59(10) Candidate List as currently published by ECHA Authorisations Regulation (EC) No. 1907/2006, REACH Annex XIV Substances subject to authorization, as amended Restrictions on use Regulation (EC) No. 1907/2006, REACH Annex XVII Substances subject to restriction on marketing and use as amended UKTOFL05 UKTOTW05 UKTOBA05 Version #: 04 Revision date: 17-June-2017 Issue date: 17-June / 6

6 Directive 2004/37/EC: on the protection of workers from the risks related to exposure to carcinogens and mutagens at work, as amended. Other EU regulations Directive 2012/18/EU on major accident hazards involving dangerous substances, as amended Other regulations National regulations Chemical safety assessment SECTION 16: Other information List of abbreviations References Information on evaluation method leading to the classification of mixture Full text of any H-statements not written out in full under Sections 2 to 15 Revision information Training information Disclaimer The product is classified and labelled in accordance with EC directives or respective national laws. Pregnant women should not work with the product, if there is the least risk of exposure. This Safety Data Sheet complies with the requirements of Regulation (EC) No 1907/2006, as amended. Follow national regulation for work with chemical agents. Young people under 18 years old are not allowed to work with this product according to EU Directive 94/33/EC on the protection of young people at work, as amended. No Chemical Safety Assessment has been carried out. The classification for health and environmental hazards is derived by a combination of calculation methods and test data, if available. Product and Company Identification: Alternate Trade Names Physical & Chemical Properties: Multiple Properties Follow training instructions when handling this material. Vauxhall Trade Club cannot anticipate all conditions under which this information and its product, or the products of other manufacturers in combination with its product, may be used. It is the user s responsibility to ensure safe conditions for handling, storage and disposal of the product, and to assume liability for loss, injury, damage or expense due to improper use. The information in the sheet was written based on the best knowledge and experience currently available. UKTOFL05 UKTOTW05 UKTOBA05 Version #: 04 Revision date: 17-June-2017 Issue date: 17-June / 6