Safety data sheet according to 1907/2006/EC, Article 31

Transcription

1 Page 1/6 SECTION 1: Identification of the substance/mixture and of the company/undertaking 1.1 Product identifier Registration number Mixture 1.2 Relevant identified uses of the substance or mixture and uses advised against Product category PC9a Coatings and paints, thinners, paint removers Application of the substance / the mixture Line marking concentrate Uses advised against Processes involving extreme heat use advised against. 1.3 Details of the supplier of the safety data sheet Manufacturer/Supplier: Maxwell Amenity Ltd Allscott Park Allscott Telford Shropshire TF6 5DY Tel: +44 (0) Further information obtainable from: Product safety department. 1.4 Emergency telephone number: Tel: +44 (0) (not 24 hours) SECTION 2: Hazards identification 2.1 Classification of the substance or mixture Classification according to Regulation (EC) No 1272/2008 The product is not classified according to the CLP regulation. 2.2 Label elements Labelling according to Regulation (EC) No 1272/2008 Void Hazard pictograms Void Signal word Void Hazard statements Void 2.3 Other hazards Results of PBT and vpvb assessment PBT: Not applicable. vpvb: Not applicable. SECTION 3: Composition/information on ingredients 3.2 Chemical characterisation: Mixtures Description: An emulsification of pigments and water-based emulsions. Dangerous components: Void Additional information: For the wording of the listed hazard phrases refer to section 16. SECTION 4: First aid measures 4.1 Description of first aid measures General information: No special measures required. After inhalation: Supply fresh air; consult doctor in case of complaints. After skin contact: Immediately wash with water and soap and rinse thoroughly. After eye contact: Check for and remove any contact lenses. Rinse opened eye for several minutes under running water. Then consult a doctor. After swallowing: Rinse out mouth and then drink plenty of water. Do not induce vomiting; call for medical help immediately. If vomiting occurs spontaneously, keep head below hips to prevent aspiration. (Contd. on page 2)

2 Page 2/6 4.2 Most important symptoms and effects, both acute and delayed No further relevant information available. Information for doctor: Treat symptomatically and supportively. 4.3 Indication of any immediate medical attention and special treatment needed No further relevant information available. (Contd. of page 1) SECTION 5: Firefighting measures 5.1 Extinguishing media Suitable extinguishing agents: CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam. 5.2 Special hazards arising from the substance or mixture No further relevant information available. 5.3 Advice for firefighters Protective equipment: Do not inhale explosion gases or combustion gases. Wear self-contained respiratory protective device. Wear fully protective suit. SECTION 6: Accidental release measures 6.1 Personal precautions, protective equipment and emergency procedures Ensure adequate ventilation 6.2 Environmental precautions: Dilute with plenty of water. Do not allow product to reach sewage system or any water course. 6.3 Methods and material for containment and cleaning up: Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust). Send for recovery or disposal in suitable receptacles. 6.4 Reference to other sections See Section 7 for information on safe handling. See Section 8 for information on personal protection equipment. See Section 13 for disposal information. SECTION 7: Handling and storage 7.1 Precautions for safe handling Ensure good ventilation/exhaustion at the workplace. Information about fire - and explosion protection: No special measures required. 7.2 Conditions for safe storage, including any incompatibilities Storage: Requirements to be met by storerooms and receptacles: No special requirements. Information about storage in one common storage facility: Store away from oxidising agents. Further information about storage conditions: Protect from frost. Store in cool, dry conditions in well sealed receptacles. Protect from heat and direct sunlight. 7.3 Specific end use(s) No further relevant information available. SECTION 8: Exposure controls/personal protection Additional information about design of technical facilities: No further data; see item Control parameters Ingredients with limit values that require monitoring at the workplace: The product does not contain any relevant quantities of materials with critical values that have to be monitored at the workplace. (Contd. on page 3)

3 Page 3/6 Additional information: The lists valid during the making were used as basis. (Contd. of page 2) 8.2 Exposure controls Personal protective equipment: Select PPE appropriate for the operations taking place taking into account the product properties. General protective and hygienic measures: Do not inhale gases / fumes / aerosols. Wash hands before breaks and at the end of work. Avoid contact with the eyes. Avoid close or long term contact with the skin. Do not eat or drink while working. Respiratory protection: Not necessary if room is well-ventilated. Protection of hands: The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation Material of gloves The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. Penetration time of glove material The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed. Eye protection: Safety glasses Body protection: Protective work clothing Body protection must be chosen depending on product properties, activity and possible exposure. SECTION 9: Physical and chemical properties 9.1 Information on basic physical and chemical properties General Information Appearance: Form: Emulsion Colour: According to product specification Odour: Mild Odour threshold: ph-value: Change in condition Melting point/freezing point: Undetermined. Initial boiling point and boiling range: Undetermined. Flash point: >100 C Flammability (solid, gas): Not applicable. Ignition temperature: >250 C Decomposition temperature: Auto-ignition temperature: Product is not self-igniting. Explosive properties: Product does not present an explosion hazard. Explosion limits: Lower: Upper: Vapour pressure at 20 C: 23 hpa Density at 20 C: g/cm³ (Contd. on page 4)

4 Page 4/6 Relative density Vapour density Evaporation rate Solubility in / Miscibility with water: Emulsifiable. Partition coefficient: n-octanol/water: Viscosity: Dynamic: Kinematic: 9.2 Other information No further relevant information available. (Contd. of page 3) SECTION 10: Stability and reactivity 10.1 Reactivity No further relevant information available Chemical stability Thermal decomposition / conditions to be avoided: No decomposition if used and stored according to specifications Possibility of hazardous reactions No dangerous reactions known Conditions to avoid No further relevant information available Incompatible materials: Strong oxidising agents Hazardous decomposition products: Carbon monoxide and carbon dioxide SECTION 11: Toxicological information 11.1 Information on toxicological effects Acute toxicity Based on available data, the classification criteria are not met. Primary irritant effect: Skin corrosion/irritation Based on available data, the classification criteria are not met. Serious eye damage/irritation Based on available data, the classification criteria are not met. Respiratory or skin sensitisation Based on available data, the classification criteria are not met. CMR effects (carcinogenity, mutagenicity and toxicity for reproduction) Germ cell mutagenicity Based on available data, the classification criteria are not met. Carcinogenicity Based on available data, the classification criteria are not met. Reproductive toxicity Based on available data, the classification criteria are not met. STOT-single exposure Based on available data, the classification criteria are not met. STOT-repeated exposure Based on available data, the classification criteria are not met. Aspiration hazard Based on available data, the classification criteria are not met. SECTION 12: Ecological information 12.1 Toxicity Aquatic toxicity: No further relevant information available Persistence and degradability The organic portion of the product is biodegradable Bioaccumulative potential Product is not expected to bioaccumulate Mobility in soil No further relevant information available. Additional ecological information: General notes: Generally not hazardous for water 12.5 Results of PBT and vpvb assessment PBT: Not applicable. vpvb: Not applicable Other adverse effects No further relevant information available. (Contd. on page 5)

5 Page 5/6 (Contd. of page 4) SECTION 13: Disposal considerations 13.1 Waste treatment methods Recommendation Recommended Hierarchy of Controls: - Minimise waste; - Reuse if not contaminated; - Recycle, if possible; or - Safe disposal (if all else fails). Contact waste processors for recycling information. Used, degraded or contaminated product may be classified as hazardous waste. Anyone classifying hazardous waste and determining its fate must be qualified in accordance with state and international legislation. Uncleaned packaging: Recommendation: Disposal must be made according to official regulations. Container remains hazardous when empty. Continue to observe all precuations. Containers, even those that are empty, may contain residues that can develop hazardous gases and vapours upon heating. Do not cut, drill, grind, weld, or perform similar operations on or near empty containers. Recommended cleansing agents: Water, if necessary together with cleansing agents. SECTION 14: Transport information 14.1 UN-Number ADR, ADN, IMDG, IATA Void 14.2 UN proper shipping name ADR, ADN, IMDG, IATA Void 14.3 Transport hazard class(es) ADR, ADN, IMDG, IATA Class Void 14.4 Packing group ADR, IMDG, IATA Void 14.5 Environmental hazards: Not applicable Special precautions for user Not applicable Transport in bulk according to Annex II of Marpol and the IBC Code Not applicable. Transport/Additional information: Not dangerous according to the above specifications. UN "Model Regulation": Void SECTION 15: Regulatory information 15.1 Safety, health and environmental regulations/legislation specific for the substance or mixture Directive 2012/18/EU Named dangerous substances - ANNEX I None of the ingredients is listed Chemical safety assessment: A Chemical Safety Assessment has not been carried out. SECTION 16: Other information This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. (Contd. on page 6)

6 Page 6/6 (Contd. of page 5) Abbreviations and acronyms: ADR: Accord européen sur le transport des marchandises dangereuses par Route (European Agreement concerning the International Carriage of Dangerous Goods by Road) IMDG: International Maritime Code for Dangerous Goods IATA: International Air Transport Association GHS: Globally Harmonised System of Classification and Labelling of Chemicals EINECS: European Inventory of Existing Commercial Chemical Substances ELINCS: European List of Notified Chemical Substances CAS: Chemical Abstracts Service (division of the American Chemical Society) PBT: Persistent, Bioaccumulative and Toxic vpvb: very Persistent and very Bioaccumulative