Safety Data Sheet LS Identification

Transcription

1 1. Identification 1.1. Product identifier Product Identity Alternate Names (CP-116) CP-116, 1.2. Relevant identified uses of the substance or mixture and uses advised against Intended use Application Method See Technical Data Sheet. See Technical Data Sheet Details of the supplier of the safety data sheet Company Name Lone Star Lubricants 2232 Moneda St. Fort Worth, TX Emergency 24 hour Emergency Telephone No. (817) Customer Service: Lone Star Lubricants (817) Hazard(s) identification 2.1. Classification of the substance or mixture No applicable GHS categories Label elements Using the Toxicity Data listed in section 11 and 12 the product is labeled as follows. No applicable GHS categories. [Prevention]: No GHS prevention statements [Response]: No GHS response statements [Storage]: No GHS storage statements [Disposal]: No GHS disposal statements Page 1 of 9

2 3. Composition/information on ingredients This product contains the following substances that present a hazard within the meaning of the relevant State and Federal Hazardous Substances regulations. Ingredient/Chemical Designations Weight % GHS Classification Notes Molybdenum sulfide CAS Number: Petrolatum CAS Number: Not Classified [1] Not Classified [1] In accordance with paragraph (i) of , the specific chemical identity and/or exact percentage (concentration) of composition has been withheld as a trade secret. [1] Substance classified with a health or environmental hazard. [2] Substance with a workplace exposure limit. [3] PBT-substance or vpvb-substance. *The full texts of the phrases are shown in Section First aid measures 4.1. Description of first aid measures General Inhalation Eyes Skin Ingestion In all cases of doubt, or when symptoms persist, seek medical attention. Never give anything by mouth to an unconscious person. Remove to fresh air, keep patient warm and at rest. If breathing is irregular or stopped, give artificial respiration. If unconscious place in the recovery position and obtain immediate medical attention. Give nothing by mouth. Irrigate copiously with clean water for at least 15 minutes, holding the eyelids apart and seek medical attention. Remove contaminated clothing. Wash skin thoroughly with soap and water or use a recognized skin cleanser. If swallowed obtain immediate medical attention. Keep at rest. Do NOT induce vomiting Most important symptoms and effects, both acute and delayed Overview Eyes - can cause irritation, redness, blurred vision. Skin - prolonged contact can cause irritation and dermatitis. Ingestion - can cause gastrointestinal irritation, nausea, vomiting, and diarrhea. See section 2 for further details. 5. Fire-fighting measures 5.1. Extinguishing media Recommended extinguishing media; alcohol resistant foam, CO2, powder, halon. Do not use: water. Page 2 of 9

3 5.2. Special hazards arising from the substance or mixture Hazardous decomposition: Irritating and/or toxic fumes including oxides of carbon, sulfur and nitrogen may be released Advice for fire-fighters Wear self-contained breathing apparatus. Do not extinguish with water. ERG Guide No Accidental release measures 6.1. Personal precautions, protective equipment and emergency procedures Put on appropriate personal protective equipment (see section 8) Environmental precautions Do not allow spills to enter drains or waterways. Use good personal hygiene practices. Wash hands before eating, drinking, smoking or using toilet. Promptly remove soiled clothing and wash thoroughly before reuse Methods and material for containment and cleaning up Clean spill with absorbent material. Eliminate ignition sources. Do not store oily materials in enclosed containers for long periods of time. Wear gloves, goggles and gas mask if TWA s are exceeded. Dispose of waste in a chemical landfill as approved by current local, state and federal laws and regulations. 7. Handling and storage 7.1. Precautions for safe handling Handle containers carefully to prevent damage and spillage 7.2. Conditions for safe storage, including any incompatibilities Incompatible materials:. Protect from physical damage. Store in a cool, dry, ventilated area away from acids, alkalis, and open flames Specific end use(s). Page 3 of 9

4 8. Exposure controls and personal protection 8.1. Control parameters Exposure CAS No. Ingredient Source Value Molybdenum sulfide OSHA No Established Limit ACGIH No Established Limit NIOSH No Established Limit Supplier No Established Limit Petrolatum OSHA No Established Limit ACGIH No Established Limit NIOSH No Established Limit Supplier No Established Limit Carcinogen Data CAS No. Ingredient Source Value Molybdenum sulfide OSHA Select Carcinogen: No NTP Known: No; Suspected: No IARC Group 1: No; Group 2a: No; Group 2b: No; Group 3: No; Group 4: No; Petrolatum OSHA Select Carcinogen: No NTP Known: No; Suspected: No IARC Group 1: No; Group 2a: No; Group 2b: No; Group 3: No; Group 4: No; 8.2. Exposure controls Respiratory Eyes Skin Engineering Controls Use NIOSH approved organic respirator if TWA/TLV limits are exceeded. Wear chemical safety glasses or goggles. Chemical resistant gloves. Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction. Other Work Practices See section 2 for further details. - [Prevention]: If mechanical, use non sparking equipment. Use good personal hygiene practices. Wash hands before eating, drinking, smoking or using toilet. Promptly remove soiled clothing and wash thoroughly before reuse. 9. Physical and chemical properties Appearance Odor Odor threshold Black Liquid Slight Page 4 of 9

5 ph Melting point / freezing point Initial boiling point and boiling range Flash Point Evaporation rate (Ether = 1) Flammability (solid, gas) Upper/lower flammability or explosive limits Vapor pressure (Pa) Vapor Density Specific Gravity Solubility in Water Partition coefficient n-octanol/water (Log Kow) Auto-ignition temperature Decomposition temperature Viscosity (cst) Density 9.2. Other information No other relevant information. >300F (C.0.C.) Not Applicable Lower Explosive Limit: Upper Explosive Limit: 12.0 (lb/gal) 10. Stability and reactivity Reactivity Hazardous Polymerization will not occur Chemical stability Stable under normal circumstances Possibility of hazardous reactions Conditions to avoid Incompatible materials Hazardous decomposition products Irritating and/or toxic fumes including oxides of carbon, sulfur and nitrogen may be released. Page 5 of 9

6 11. Toxicological information Acute toxicity Ingredient Oral LD50, mg/kg Skin LD50, mg/kg Inhalation Vapor LC50, mg/l/4hr Inhalation Dust/Mist LC50, mg/l/4hr Inhalation Gas LC50, ppm Molybdenum sulfide - ( ) 2.82, Rat - Category: 4 Petrolatum - ( ) > 5,000.00, Rat - Category: NA > 5,000.00, Rabbit - Category: NA Note: When no route specific LD50 data is for an acute toxin, the converted acute toxicity point estimate was used in the calculation of the product's ATE (Acute Toxicity Estimate). Classification Category Hazard Description Acute toxicity (oral) --- Not Applicable Acute toxicity (dermal) --- Not Applicable Acute toxicity (inhalation) --- Not Applicable Skin corrosion/irritation --- Not Applicable Serious eye damage/irritation --- Not Applicable Respiratory sensitization --- Not Applicable Skin sensitization --- Not Applicable Germ cell mutagenicity --- Not Applicable Carcinogenicity --- Not Applicable Reproductive toxicity --- Not Applicable STOT-single exposure --- Not Applicable STOT-repeated exposure --- Not Applicable Aspiration hazard --- Not Applicable 12. Ecological information Toxicity No additional information provided for this product. See Section 3 for chemical specific data. Aquatic Ecotoxicity Ingredient 96 hr LC50 fish, mg/l 48 hr EC50 crustacea, mg/l ErC50 algae, mg/l Molybdenum sulfide - ( ) Not Available Not Available Not Available Petrolatum - ( ) Not Available Not Available Not Available Page 6 of 9

7 This product is covered by EPA s Comprehensive Environmental Response, Compensation and Liability Act (CERCLA) Petroleum Exclusion. Therefore releases to air, land, or water are not reportable under CERCLA ( Superfund ). However, under Section 311 of EPA s Clean Air Water Act (CWA). This product is considered an oil. As such, spills into or leading to surface waters that cause a sheen must be reported to the national response center, This product is an oil under 49 CFR (DOT) part 130. If shipped by rail or highway in a tank with a capacity of 3,500 gallons or more, it is subject to the requirements of part 130. Mixture solutions in which this product is present at 10% or more may also be subject to this rule Persistence and degradability There is no data on the preparation itself Bioaccumulative potential Mobility in soil Results of PBT and vpvb assessment This product contains no PBT/vPvB chemicals Other adverse effects. 13. Disposal considerations Waste treatment methods Observe all federal, state and local regulations when disposing of this substance. Hazard characteristic and regulatory waste stream classification can change with product use. Accordingly, it is the responsibility of the user to determine the proper storage, transportation, treatment and/or disposal methodologies for spent material and residues at the time of disposition. Conditions of use may cause this material to become a hazardous waste, as defined by federal or state regulations. It is the responsibility of the user to determine if the material is a hazardous waste at the time of disposal. Transportation, treatment, storage, and disposal of waste material must be conducted in accordance with RCRA regulations (see 40 CFR 260 through 40 CFR 271). State and/or local regulations may be more restrictive. Contact your regional US EPA office for guidance concerning case specific disposal issues. Empty drums and pails retain residue. DO NOT pressurize, cut, weld, braze solder, drill or expose this products empty container to heat, flame or other ignition sources. DO NOT attempt to clean it. Empty drums and pails should be drained completely, properly bunged or sealed, and promptly sent to a reconditioner. 14. Transport information DOT (Domestic Surface Transportation) IMO / IMDG (Ocean Transportation) ICAO/IATA UN number Not Applicable Not Regulated Not Regulated UN proper shipping Not Regulated Not Regulated Not Regulated name Page 7 of 9

8 14.3. Transport hazard class(es) DOT Hazard Class: Not Applicable IMDG: Not Applicable Sub Class: Not Applicable Air Class: Not Applicable Packing group Not Applicable Not Applicable Not Applicable Environmental hazards IMDG Marine Pollutant: No Special precautions for user No further information 15. Regulatory information Regulatory Overview Toxic Substance Control Act ( TSCA) WHMIS Classification The regulatory data in Section 15 is not intended to be all-inclusive, only selected regulations are represented. All components of this material are either listed or exempt from listing on the TSCA Inventory. Not Regulated US EPA Tier II Hazards Fire: No Sudden Release of Pressure: No Reactive: No Immediate (Acute): No Delayed (Chronic): No EPCRA 311/312 Chemicals and RQs: EPCRA 302 Extremely Hazardous: EPCRA 313 Toxic Chemicals: Proposition 65 - Carcinogens (>0.0%): Proposition 65 - Developmental Toxins (>0.0%): Proposition 65 - Female Repro Toxins (>0.0%): Proposition 65 - Male Repro Toxins (>0.0%): New Jersey RTK Substances (>1%) : Pennsylvania RTK Substances (>1%) : Page 8 of 9

9 16. Other information The information and recommendations contained herein are based upon data believed to be correct. However, no guarantee or warranty of any kind, expressed or implied, is made with respect to the information contained herein. We accept no responsibility and disclaim all liability for any harmful effects which may be caused by exposure to our products. Customers/users of this product must comply with all applicable health and safety laws, regulations, and orders. The full text of the phrases appearing in section 3 is: Not applicable This is the first version in the GHS SDS format. Listings of changes from previous versions in other formats are not applicable. THE INFORMATION IN THIS MSDS WAS OBTAINED FROM SOURCES WHICH WE BELIEVE ARE RELIABLE. HOWEVER, THE INFORMATION IS PROVIDED WITHOUT ANY WARRANTY, EXPRESSED OR IMPLIED REGARDING ITS CORRECTNESS. SOME INFORMATION PRESENTED AND CONCLUSIONS DRAWN HEREIN ARE FROM SOURCES OTHER THAN DIRECT TEST DATA ON THE SUBSTANCE ITSELF. THIS MSDS WAS PREPARED AND IS TO BE USED ONLY FOR THIS PRODUCT. IF THE PRODUCT IS USED AS A COMPONENT IN ANOUTHER PRODUCT, THIS MSDS INFORMATION MAY NOT BE APPLICABLE. USERS SHOULD MAKE THEIR OWN INVESTIGATIONS TO DETERMINE THE SUITABILITY OF THE INFORMATION OR PRODUCTS FOR THEIR PARTICULAR PURPOSE. THE CONDITIONS OR METHODS OF HANDLING, STORAGE, USE, AND DISPOSAL OF THE PRODUCT ARE BEYOND OUR CONTROL AND MAY BE BEYOND OUR KNOWLEDGE. FOR THIS AND OTHER REASONS, WE DO NOT ASSUME RESPONSIBILITY AND EXPRESSLY DISCLAIM LIABILITY FOR LOSS, DAMAGE OR EXPENSE ARISING OUT OF OR IN ANY WAY CONNECTED WITH HANDLING, STORAGE, USE OR DISPOSAL OF THE PRODUCT. End of Document Page 9 of 9