Material Safety Data Sheet

Transcription

1 Page 1 of 6 Material Safety Data Sheet Taubmans Pure Performance Interior Low Sheen Infosafe No. PPA36 Issue Date May 2008 Status ISSUED by TAUBMANS Not classified as hazardous according to criteria of NOHSC BS: IDENTIFICATION OF THE MATERIAL AND SUPPLIER Product Name Taubmans Pure Performance Interior Low Sheen Company Name PPG Architectural Coatings (ABN ) Address 9 Birmingham Ave. Villawood NSW 2163 Emergency Tel Telephone/Fax Number Tel: Fax: (02) Recommended Use ARCHITECTURAL COATINGS. COMMONLY APPLIED BY BRUSH OR ROLLER. Other Names Name Product Code Taubmans Pure Performance range Taubmans Pure Performance Interior Matt Taubmans Pure Performance Ceiling Paint Taubmans Pure Performance Exterior Low Sheen Taubmans Pure Performance Trim Gloss Taubmans Pure Performance Interior Semi Gloss Taubmans Pure Performance Prepcoat Taubmans Pure Performance Trim Semi Gloss Taubmans Pure Performance Exterior Gloss Other Note: Users should verify currency of this data sheet if more than 5 years old. The information contained in this material safety data sheet is believed to be accurate on the date of issue and in accordance with the information available to us. Persons dealing with products referred to in the material safety data sheet do so at

2 Page 2 of 6 their own risk. We accept no liability whatsoever for damage or injury however caused arising from use of this information or of suggestions contained herein. 2. HAZARDS IDENTIFICATION Hazard Classification NON-HAZARDOUS SUBSTANCE. NON-DANGEROUS GOODS. Hazard classification according to the criteria of NOHSC. Dangerous goods classification according to the Australia Dangerous Goods Code. 3. COMPOSITION/INFORMATION ON INGREDIENTS Ingredients Name CAS Proportion Propylene glycol % PAINT ADDITIVE N/AV 2-10 % TITANIUM DIOXIDE % Water N/AV % Calcite % Acrylic emulsion N/A 0-35 % Flatting Agent N/A 0-30 % 4. FIRST AID MEASURES Inhalation Ingestion Skin Eye Advice to Doctor Other Remove to fresh air if any effects apparent. If swallowed give a glass of water. Induce vomiting using Ipecac syrup APF or finger down throat. Seek medical attention. Wash affected areas with soap and water or an industrial skin cleanser Irrigate copiously with clean fresh water for 15 minutes, holding the eyelids apart. Seek medical attention if irritation persists. Treat symptomatically. Nil. 5. FIRE FIGHTING MEASURES

3 Page 3 of 6 Suitable Extinguishing Media Hazchem Code Properties on Heating & in case of Fire Not required. Material not combustible. Material is non flammable. 6. ACCIDENTAL RELEASE MEASURES Spills & Ventilate area. Scrape up and drum off. Dispose of in accordance with relevant State regulations as non hazardous liquid waste. Do not allow into drains or watercources. Contact points for disposal advise: N.S.W. (02) ENVIRONMENT PROTECTION AUTHORITY VIC. (03) ENVIRONMENT PROTECTION AUTHORITY S.A. (08) ENVIRONMENT PROTECTION AUTHORITY TAS. (002) DEPT. OF ENVIRONMENT AND LAND MAN. W.A. (09) OFFICE OF WASTE MANAGEMENT A.C.T. (06) DEPT. OF URBAN SERVICES (WASTE) N.T. (089) WORK HEALTH AUTHORITY QLD. CONTACT - LOCAL GOVERNMENT AUTHORITY 7. HANDLING AND STORAGE Conditions for Safe Storage Store in cool place and out of direct sunlight. Keep containers sealed when not in use. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION National Exposure Standards Engineering Controls Respiratory Protection WATER N/AV TITANIUM DIOXIDE 10mg/m3 CALCITE 10mg/m3(C) PAINT ADDITIVE N/AV PROPYLENE GLYCOL 10mg/m3 ACRYLIC EMULSION N/Av FLATTING AGENT 10mg/m3 Suppliers recommendation - maximum exposure for an 8 hour working day 5 days a week. Good general ventilation is recommended. No special respiratory protection is necessary. Eye Protection Eye protection to prevent splashing in the eyes, eg. safety glasses with side shields or chemical goggles. Personal

4 Page 4 of 6 Protective Equipment No special skin protection is necessary. 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance Boiling Point Solubility in Water WHITE OR COLOURED LIQUID 100C MISCIBLE Specific Gravity ph Value 8-9 Vapour Pressure N/AV Volatile Component 45 Flash Point Flammability Auto-Ignition Temperature N/A Material is non flammable. N/A Flammable Limits - Lower N/A Flammable Limits - Upper N/A 10. STABILITY AND REACTIVITY Stability and Reactivity Hazardous Reactions Stable. Stable. 11. TOXICOLOGICAL INFORMATION Inhalation Ingestion Skin Eye No toxic effects anticipated. No toxic effects anticipated. Prolonged skin contact may cause mild irritation. Expected to cause no more than minor eye irritation. Chronic Effects No long term effects anticipated.

5 Page 5 of 6 Nil. 12. ECOLOGICAL INFORMATION Ecological No data available. Avoid release to drains and waterways. 13. DISPOSAL CONSIDERATIONS Considerations Product Container Dispose of according to local, state and commonwealth regulations. Do not pour leftover paint down the drain. Unwanted paint should be brushed out on newspaper, allowed to dry and then disposed of via domestic waste collections. Empty containers are acceptable for domestic and industrial waste collections. Empty steel cans are recyclable via steel recycling programs. 14. TRANSPORT INFORMATION Transport Sub.Risk Hazchem Code Packing Group Road and Rail Transport (ACTDG): Class IATA Classification: Class Packaging Group IMDG Reference: Class Flash Point N/A Emergency Procedure Guide: AS1678 Method N/A Not defined as Dangerous Goods by The Australian Code for the Transport of Dangerous Goods by Road and Rail. No special requirements apply. 15. REGULATORY INFORMATION Poisons Schedule AICS (Australia) Not Scheduled All components are listed in the AICS. 16. OTHER INFORMATION

6 Page 6 of 6 Contact Person/Point Other PPG Architectural Coatings Customer Service Technical Officer Phone Toll Free: Emergency Contact: , in NZ Version No.: 008 Nil. Abbreviations: N/A - Not Applicable N/AV - Not Available End of MSDS (C) Copyright ACOHS Pty Ltd Copyright in the source code of the HTML, PDF, XML, XFO and any other electronic files rendered by an Infosafe system for Infosafe MSDS displayed is the intellectual property of Acohs Pty Ltd. Copyright in the layout, presentation and appearance of each Infosafe MSDS displayed is the intellectual property of Acohs Pty Ltd. The compilation of MSDS's displayed is the intellectual property of Acohs Pty Ltd. Copying of any MSDS displayed is permitted for personal use only and otherwise is not permitted. In particular the MSDS's displayed cannot be copied for the purpose of sale or licence or for inclusion as part of a collection of MSDS without the express written consent of Acohs Pty Ltd. Print Date: 20/08/2010 BS: