Reference number 118. VINI-TAPE, issued by Denka Company Limited on February 1, 2016 (1/5) Issued on August 1, 2004 Revised on February 1, 2016

Transcription

1 Reference number 118. VINI-TAPE, issued by on February 1, 2016 (1/5) Issued on August 1, 2004 Revised on February 1, 2016 Safety Data Sheet (Fourth edition) 1. PRODUCT AND COMPANY IDENTIFICATION Product name: VINI-TAPE Manufacturer: Address: Nihonbashi Mitsui Tower, 1-1, Nihonbashi-Muromachi 2-chome, Chuo-ku, Tokyo, JAPAN Division: Industrial Materials Department Telephone number: Fax number: Emergency contact: Overseas Adhesive Tapes Section, Industrial Materials Department, Telephone: Evening and holiday contact: Chiba Plant, Telephone: Reference number: HAZARDS IDENTIFICATION GHS Classification: GHS label elements: Hazards other than GHS Classification: Not applicable (article) Not applicable If the product is burned, noxious gas (composed mostly of hydrogen chloride and carbon monoxide) may be generated. Therefore, adequate ventilation must be maintained to avoid inhaling the gas. 3. COMPOSITION AND INFORMATION ON INGREDIENTS Substance, mixture or article: article Chemical compositions Composition Polyvinyl Di-isononyl Stabilizing Adhesive agent chloride phthalate agent, etc. Content (wt%) 50 to to to to 15 Chemical properties (CH 2 -CHCl) n C 26 H 42 O CAS No FIRST-AID MEASURES Inhalation: (1) Remove the person exposed to combustion or decomposition gas immediately and provide fresh air. (2) Get medical attention in any case where abnormal conditions are detected.

2 Reference number 118. VINI-TAPE, issued by on February 1, 2016 (2/5) Skin contact: Eye contact: Ingestion: As hypersensitive persons may suffer swelling or irritation after coming into contact with the adhesive agent of the tape, gently remove the tape and rinse off the adhesive agent. There is no chance that this product gets into eyes. However, if a chip or broken piece of the tape gets into eyes, the eye balls may be damaged. In such a case, rinse it off with clean water for 15 minutes or more. Try to induce vomiting as much as possible. If any abnormal conditions are detected, get medical attention. 5. FIRE-FIGHTING MEASURES Extinguishing media: Use water, dry chemicals, foams, etc. Protection for firefighters: In case of a fire, this product will not burn intensely but may be melted by heat. If it burns or it is melted because of the high temperature, noxious gas (composed mostly of hydrogen chloride and carbon monoxide) may be generated. Therefore, it is indispensable to wear respiratory protective equipments, safety glasses and chemical protective gloves, and put out fire from the windward. 6. ACCIDENTAL RELEASE MEASURES Personal precautions: Environmental precautions: Removal method: Immediately sweep and collect the released substances in a paper bag, etc. 7. HANDLING AND STORAGE Handling Technical measures: (1) Do not place fire nearby. (2) As this product is a tape for industrial use, do not affix it to the human body, food or medical products. Precautions: If the product is used in a closed room, the room must be well-ventilated. Precautions for safe handling: Avoid contact with organic solvents in order to prevent dissolution deformation. Storage Storage conditions: (1) To avoid alterations (deformations), store the product in a place at room temperature away from sunlight, water leak, moisture and heat. (2) To prevent a fire, store the product in a place away from fire, heat source and light source. Safe container and package materials: Nothing in particular 8. EXPOSURE CONTROLS AND PERSONAL PROTECTION Protective equipment: Not particularly required Control concentration: No rules or regulations Allowable concentration: No rules or regulations

3 Reference number 118. VINI-TAPE, issued by on February 1, 2016 (3/5) 9. PHYSICAL AND CHEMICAL PROPERTIES Physical state: Form: Solid (Film-type molding product) Color: Multiple colors Odor: Rubber odor (Subtle odor) ph: Specific temperatures/temperature ranges at which changes in physical state occur Boiling point: Melting point: Resolution temperature: There is no data. However, the softening process starts at approx. 60ºC. Flash point: 230ºC Auto-ignition temperature: 425ºC Explosion properties: Density: 1.3 g/cm 3 Solubility: Insoluble in water 10. STABILITY AND REACTIVITY Stability: Stabilized if treated in a normal manner Reactivity: Inappropriate conditions: High temperature, High humidity, Sunshine Reactive chemical hazards: Oxidant, Acid, Base Hazardous decomposition products: If the product is burned, noxious gas (composed mostly of hydrogen chloride and carbon monoxide) may be generated. 11. TOXICOLOGICAL INFORMATION Acute toxicity: Specific symptoms in animal tests: Irritation and Corrosive effects: Touching the surface repeatedly may cause skin roughness. Sensitization: Toxicity after repeated intake (sub-acute, sub chronic, chronic): CMR-effects (carcinogenic, mutagenic and reproductive effects): 12. ECOLOGICAL INFORMATION No information 13. DISPOSAL CONSIDERATIONS Dispose of residues/container in accordance with local/regional/state/national/federal/international regulations. Do not dump residues/container into sewers, on the ground or into any body of water.

4 Reference number 118. VINI-TAPE, issued by on February 1, 2016 (4/5) 14. TRANSPORT INFORMATION International regulation: Not applicable Specific precautionary transport measures and conditions: Avoid direct sunlight, water leak, rapid temperature change, etc. and ensure that the packing and packaging materials are not damaged or the cargo does not collapse. 15. REGULATORY INFORMATION Di-isononyl phthalate is a regulated component. EU (REACH ANNEX ⅩⅦ 52), Canada (Phthalates Regulations), USA (Consumer Product Safety Improvement Act), Japan (notification of the Ministry of Health, Labor, and Welfare No.336), Switzerland (Toy Safety Ordinance) : Toy or child care article that can, in a reasonably foreseeable manner, be placed in the mouth of a child must contain no more than 1,000mg/kg of DINP. USA : Clean Water Act Section 307(a) (1) Toxic Pollutants (40 CFR ) RCRA AppendixⅧ List of Hazardous Constituents (40 CFR 261) CERCLA Hazardous Substances (40 CFR 302.4) California Proposition65 WARNING: This product contains a chemical known to the State of California to cause cancer. 16. OTHER INFORMATION (1) All the data contained herein are protected by copyrights, treaties, laws and regulations effective in each relevant country. The data may not be used (copied, modified, transmitted, distributed, published, diverted, posted etc.) outside the scope of private use or that explicitly permitted under the applicable law without obtaining our prior consent. (2) We are making every effort to maintain the accuracy and usability of the data contained herein. However, no guarantee or warranty is made as to the accuracy and safety. Also, please note that the data and descriptions contained herein are subject to change without notice due to new knowledge and experience. (3) We do not make any guarantee or warranty as to the accuracy or safety of the data contained herein, such as merchantability (quality, performance, etc. which are normally expected), adequateness for certain purposes, and non-infringement of rights of third parties. (4) The data contained herein concerns only the product. If this product is combined or processed with other materials, such data shall be invalid. (5) The product shall be kept out of reach of infants. Also, this product shall not be used for materials within reach of infants. (6) Before use, the product shall be tested internally to check whether it conforms to the intended purpose and assure the safety on your own responsibility. (7) All the materials have unknown hazards. Therefore, they need to be handled with care. This SDS describes specific hazards. However, other hazards also may be presented.

5 Reference number 118. VINI-TAPE, issued by on February 1, 2016 (5/5) Receipt Safety Data Sheet (SDS) Product name: VINI-TAPE <Request> Suppliers including manufacturers are legally obligated to provide users with Safety Data Sheets (SDS) describing hazardous properties, handling methods, storage methods, emergency methods, transportation modes, etc. for the purpose of safe use of the relevant chemical materials. Please understand the intent and purpose of SDS, and fill out and return this receipt to us by mail or fax. Date of receipt: Month Day, Year Corporate name: Department: Address: Phone number: Name: Seal <Address for return> Overseas Adhesive Tape Section, Industrial Materials Department, Life Science & Environment Products 1-1, Nihonbashi-Muromachi 2-chome, Chuo-ku, Tokyo, JAPAN Telephone: Fax: