Safety Data Sheet. Section 1 - Chemical Product and Company Identification. Bitumen Adhesive on Polymer Film with Liner

Transcription

1 Safety Data Sheet Section 1 - Chemical Product and Company Identification Product: RA Flashing Chemical Family: Bitumen Adhesive on Polymer Film with Liner Manufacturer Information: Fiberweb, Inc 70 Old Hickory Blvd. Old Hickory, TN Company Contact: Jim Reynolds Telephone Number: (8am-5pm M-F Central Time) Emergency Phone Contact: Chemtrec (24 Hours) Emergency Phone Number: Section 2 Hazards Identification Emergency Overview This product contains a material that is considered hazardous by the Occupational Safety and Health Administration (OSHA) Hazard Communication Standard (29 CFR ). Signal Word- WARNING Route of Exposure-Skin Skin contact with rubberized asphalt can cause irritation. Route of Exposure-Eye Eye contact with rubberized asphalt residue on hands can cause irritation. Route of Exposure -Ingestion Route of Exposure-Inhalation Inhalation from heated product may cause irritation of nose, throat and respiratory system. HMIS Ratings Health: 1 Fire: 0 Reactivity: 0 Personal Protection: A Hazard Scale: 0=Minimal 1=Slight 2=Moderate 3=Serious 4=Severe *=Chronic Hazard Section 3 - Composition CAS # Component Percent Petroleum Bitumen 60% - 100% Section 4 - First Aid Measures First Aid-Skin Wash affected area with soap and water. Get medical attention if symptoms occur First Aid-Eye Check for and remove any contact lenses. In case of contact with eyes, rinse immediately with plenty Page 1 of 6

2 of water. Get medical attention if symptoms occur. First Aid-Ingestion First Aid-Inhalation First Aid-Notes to Physician No specific treatment. Treat symptomatically. Contact poison treatment specialist immediately if large quantities have been ingested or inhaled. Section 5 - Fire Fighting Measures Flash Point: Method Used: Auto Ignition: Flammability Classification: Lower Explosive Limit (%): Upper Explosive Limit (%): General Fire Hazards Solid material may burn upon extended exposure to open flames. Hazardous Combustion Products Upon decomposition this product may emit carbon dioxide, carbon monoxide, sulfur oxides, and/or low molecular weight hydrocarbons. Extinguishing Media Water spray, foam, carbon dioxide, or dry chemical Fire Fighting Equipment/Instructions As in any fire, wear a self-contained breathing apparatus and full protective gear. NFPA Ratings Health: 1 Fire: 0 Reactivity: 0 Hazard Scale: 0=Minimal 1=Slight 2=Moderate 3=Serious 4=Severe Section 6 - Accidental Release Measures Containment Procedures Sweep waste fabric into a pile. Clean -Up Procedures Sweep waste fabric into a waste container and recycle, incinerate or landfill in conformity with local disposal regulations. Evacuation Procedures Special Procedures None Section 7 - Handling and Storage Handling Procedures Put on appropriate personal protective equipment. Eating, drinking and smoking should be prohibited in areas where material is handled, stored and processed. Workers should wash hands and face before eating, drinking and smoking. Do not get in your eyes or on your skin or clothing. Do not ingest. Use only with adequate ventilation. Wear appropriate respirator when ventilation is inadequate. Keep in the original container or an approved alternative made from a compatible material, kept tightly closed when not in use. Empty containers retain product and can be hazardous. Do not reuse containers. Page 2 of 6

3 Storage Procedures Store in accordance with local regulations. Store in original container protected from direct sunlight in a dry cool and well ventilated area away from incompatible materials and food and drink. Keep container tightly closed and sealed until ready to use. Do not store in unlabeled containers. Section 8 - Exposure Controls/Personal Protection Component Exposure Limits Component CAS Exposure Limits Petroleum Bitumen ACGIH TLV ( United States, 1/2008) TWA: 0.5 mg/m3 8 hour(s) Form: Fume NIOSH REL ( United States, 12/2001) CEIL: 5 mg/m3 15 minute(s). Form: Fume Engineering Controls Use only with adequate ventilation. If user operations generate dust, fumes, gas, vapor or mist, use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure to airborne contaminates below any recommended or statutory limits. Hygiene Measures Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking, and using the lavatory and at the end of the working period. Appropriate techniques should be used to remove potentially contaminated clothing. Wash contaminated clothing before reusing. Ensure that eyewash stations and safety showers are close to the work station location. Personal Protective Equipment Personal Protective Equipment-Eyes/Face Safety Glasses Personal Protective Equipment-Skin Overall buttoned at the neck and wrist and chemical resistant gloves. Personal Protective Equipment-Respiratory None usually required Personal Protective Equipment-General Follow individual plant safety rules. Section 9 - Physical & Chemical Properties Appearance: Bitumen Adhesive on Polymer Odor: Asphaltic Film with Liner Physical State: Solid ph: Vapor Pressure: NIL Evaporation Rate: Boiling Point: Melting Point: Solubility (H 2 O): Negligible Specific Gravity: Vapor Density: Percent Volatiles: NIL Packing Density:. Page 3 of 6

4 Section 10 - Chemical Stability & Reactivity Information Chemical Stability Stable under ordinary conditions of use and storage. Conditions to Avoid Combustible when exposed to open flames. Incompatibility Oxidizing materials. Hazardous Decomposition Carbon monoxide, carbon dioxide and/or low molecular weight hydrocarbon may be emitted upon decomposition. Hazardous Polymerization Will not occur. Section 11 - Toxicological Information Acute and Chronic Toxicity This product contains a material that is considered hazardous by the Occupational Safety and Health Administration (OSHA) Hazard Communication Standard (29 CFR ). Component Analysis Component CAS ACGIH IARC Petroleum Bitumen A4 3 Carcinogenicity P This product contains a material that is considered hazardous by the Occupational Safety and Health Administration (OSHA) Hazard Communication Standard (29 CFR ). Epidemiology Neurotoxicity Mutagenicity Teratogenicity Other Toxicological Information Specific toxicity testing has not been performed on this product. Hazard evaluation is based on information from similar products, raw material data, and technical literature. Section 12 - Ecological Information Ecotoxicity General product Information No available information. Environmental Fate No available information. Page 4 of 6

5 Section 13 - Disposal Considerations RA Flashing Waste Disposal The generation of waste should be avoided or minimized wherever possible. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe way. Dispose of surplus and non-recyclable products via a licensed waste disposal contractor. Disposal of this product, solutions and any by-products should at all times comply with the requirements of environmental protection and waste disposal legislation and any regional local authority requirements. Transportation Regulations Product is not regulated for transportation. US Federal Regulations No additional information. Component Analysis-Federal Section 14 - Transportation Information Section 15 - Regulatory Information Component CAS# SARA 302 SARA 313 CERCLA (40 CFR 355 Appx A) (40 CFR ) (40 CFR 302.4) Petroleum Bitumen Yes Yes Yes State Regulations Other state regulations may apply. Check individual state requirements. Component Analysis-State The following components appear on one or more of the following state hazardous substances list: Component CAS# CA FL MA MN NJ PA Petroleum Bitumen No No Yes No Yes Yes Component Analysis-WHMIS IDL No components are identified under the Canadian Hazardous Products Act Ingredient Disclosure List. Page 5 of 6

6 Section 16 Other Information RA Flashing Other Information Material from this SDS was taken from SDSs for raw materials. SDS History New SDS DISCLAIMER OF EXPRESSED AND IMPLIED WARRANTIES The information in this document is believed to be correct as of the date issued. HOWEVER, NO WARRANTY OF MERCHANTABILITY, FITNESS FOR ANY USE, OR ANY OTHER WARRANTY IS EXPRESSED OR IS TO BE IMPLIED REGARDING THE ACCURACY OR COMPLETENESS OF THIS INFORMATION, THE RESULTS TO BE OBTAINED FROM USE OF THIS INFORMATION OR THE PRODUCT, THE SAFETY OF THIS PRODUCT, OR THE HAZARDS RELATED TO ITS USE. This information and the product are furnished on the condition that the person receiving them shall make his or her own determination as to the suitability of the product for his particular purpose and on the condition that they assume the risk of his use thereof. THIS PRODUCT IS CONSIDERED AN ARTICLE AND DOES NOT REQUIRE A SAFETY DATA SHEET (SDS). REVIEWED BY: Dustin Darnall Page 6 of 6