Issue Date 05-Jun-2016 Revision Date 13-Jun-2016 Version 1 1. IDENTIFICATION

Transcription

1 SAFETY DATA SHEET Issue Date 05-Jun-2016 Revision Date 13-Jun-2016 Version 1 SPD PROTECTOR A SPD Protector Part A 1. IDENTIFICATION Product identifier Product Name Other means of identification Product Code SPD Protector Part A SPD PROTECTOR A Recommended use of the chemical and restrictions on use Recommended Use Restricted to professional users. Uses advised against Consumer use Details of the supplier of the safety data sheet Supplier Address Manufacturer Address Solomon Colors, Inc. Solomon Colors, Inc Color Plant Road 4050 Color Plant Road Springfield, IL Springfield, IL Company Phone Number (US & Canada); (Outside rth America) 24 Hour Emergency Phone Number Classification 2. HAZARDS IDENTIFICATION OSHA Regulatory Status This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR ) Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2 Skin sensitization Category 1 Germ cell mutagenicity Category 2 Label elements Warning Emergency Overview Hazard statements Causes skin irritation Causes serious eye irritation May cause an allergic skin reaction SPD PROTECTOR A 1 / 8 SPD Protector Part A

2 Suspected of causing genetic defects Appearance Physical state Liquid Odor Precautionary Statements - Prevention Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Wash face, hands and any exposed skin thoroughly after handling Avoid breathing dust/fume/gas/mist/vapors/spray Contaminated work clothing should not be allowed out of the workplace Wear protective gloves/protective clothing/eye protection/face protection Precautionary Statements - Response IF exposed or concerned: Get medical advice/attention IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing If eye irritation persists: Get medical advice/attention IF ON SKIN: Wash with plenty of soap and water Take off contaminated clothing and wash before reuse If skin irritation or rash occurs: Get medical advice/attention Precautionary Statements - Storage Store locked up Precautionary Statements - Disposal Dispose of contents/container to an approved waste disposal plant Hazards not otherwise classified (HNOC) Other Information Toxictoaquaticlifewithlonglastingefects 3. COMPOSITION/INFORMATION ON INGREDIENTS Chemical Name CAS. Weight-% Trade Secret Bisphenol A - Epichlorohydrin polymer * Oxirane, [(2-methylphenoxy)methyl] * *The exact percentage (concentration) of composition has been withheld as a trade secret. Description of first aid measures 4. FIRST AID MEASURES Eye contact Rinse thoroughly with plenty of water for at least 15 minutes, lifting lower and upper eyelids. Consult a physician. Skin Contact Wash skin with soap and water. SPD PROTECTOR A 2 / 8 SPD Protector Part A

3 Inhalation Ingestion Remove to fresh air. Clean mouth with water and drink afterwards plenty of water. Most important symptoms and effects, both acute and delayed Symptoms. Indication of any immediate medical attention and special treatment needed te to physicians Treat symptomatically. 5. FIRE-FIGHTING MEASURES Suitable extinguishing media Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Unsuitable extinguishing media Caution: Use of water spray when fighting fire may be inefficient. Specific hazards arising from the chemical. Explosion data Sensitivity to Mechanical Impact ne. Sensitivity to Static Discharge ne. Protective equipment and precautions for firefighters As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. 6. ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment and emergency procedures Personal precautions Ensure adequate ventilation, especially in confined areas. Environmental precautions Environmental precautions See Section 12 for additional ecological information. Methods and material for containment and cleaning up Methods for containment Methods for cleaning up Prevent further leakage or spillage if safe to do so. Pick up and transfer to properly labeled containers. 7. HANDLING AND STORAGE Precautions for safe handling Advice on safe handling Handle in accordance with good industrial hygiene and safety practice. Conditions for safe storage, including any incompatibilities Storage Conditions Incompatible materials Keep containers tightly closed in a dry, cool and well-ventilated place. Strong oxidizing agents. Strong acids. Strong bases. Aliphatic Amines. SPD PROTECTOR A 3 / 8 SPD Protector Part A

4 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Control parameters Exposure Guidelines. Appropriate engineering controls Engineering Controls Showers Eyewash stations Ventilation systems. Individual protection measures, such as personal protective equipment Eye/face protection Skin and body protection Respiratory protection General Hygiene Considerations special technical protective measures are necessary. special technical protective measures are necessary. If exposure limits are exceeded or irritation is experienced, NIOSH/MSHA approved respiratory protection should be worn. Positive-pressure supplied air respirators may be required for high airborne contaminant concentrations. Respiratory protection must be provided in accordance with current local regulations. Handle in accordance with good industrial hygiene and safety practice. Information on basic physical and chemical properties 9. PHYSICAL AND CHEMICAL PROPERTIES Physical state Liquid Appearance Odor Color yellow Odor threshold Property Values Remarks Method ph Melting point/freezing point Boiling point / boiling range Flash point Evaporation rate Flammability (solid, gas) Flammability Limit in Air Upper flammability limit: Lower flammability limit: Vapor pressure Vapor density Specific Gravity 1.14 Water solubility Solubility in other solvents Partition coefficient Autoignition temperature Decomposition temperature Kinematic viscosity Dynamic viscosity Explosive properties Oxidizing properties Other Information Softening point Molecular weight VOC Content (%) Density Bulk density SPD PROTECTOR A 4 / 8 SPD Protector Part A

5 10. STABILITY AND REACTIVITY Reactivity data available Chemical stability Stable under recommended storage conditions. Possibility of Hazardous Reactions ne under normal processing. Conditions to avoid Extremes of temperature and direct sunlight. Incompatible materials Strong oxidizing agents. Strong acids. Strong bases. Aliphatic Amines. Hazardous Decomposition Products ne known based on information supplied. Information on likely routes of exposure 11. TOXICOLOGICAL INFORMATION Product Information Inhalation Eye contact Skin Contact Ingestion data available data available. data available. data available. data available. Chemical Name Oral LD50 Dermal LD50 Inhalation LC50 Bisphenol A - Epichlorohydrin = mg/kg ( Rat ) - - polymer Oxirane, [(2-methylphenoxy)methyl] = 4 g/kg ( Rat ) - = 6090 mg/m 3 ( Rat ) 4 h Information on toxicological effects Symptoms. Delayed and immediate effects as well as chronic effects from short and long-term exposure Sensitization Germ cell mutagenicity Carcinogenicity Reproductive toxicity STOT - single exposure STOT - repeated exposure Aspiration hazard Numerical measures of toxicity - Product Information The following values are calculated based on chapter 3.1 of the GHS document. ATEmix (oral) 7795 mg/kg ATEmix (inhalation-gas) mg/l ATEmix (inhalation-dust/mist) mg/l SPD PROTECTOR A 5 / 8 SPD Protector Part A

6 12. ECOLOGICAL INFORMATION Ecotoxicity Toxic to aquatic life with long lasting effects Persistence and degradability. Bioaccumulation. Other adverse effects 13. DISPOSAL CONSIDERATIONS Waste treatment methods Disposal of wastes Contaminated packaging Disposal should be in accordance with applicable regional, national and local laws and regulations. Do not reuse container. 14. TRANSPORT INFORMATION DOT t regulated SPD PROTECTOR A 6 / 8 SPD Protector Part A

7 15. REGULATORY INFORMATION International Inventories TSCA DSL/NDSL EINECS/ELINCS ENCS IECSC KECL PICCS AICS Legend: TSCA - United States Toxic Substances Control Act Section 8(b) Inventory DSL/NDSL - Canadian Domestic Substances List/n-Domestic Substances List EINECS/ELINCS - European Inventory of Existing Chemical Substances/European List of tified Chemical Substances ENCS - Japan Existing and New Chemical Substances IECSC - China Inventory of Existing Chemical Substances KECL - Korean Existing and Evaluated Chemical Substances PICCS - Philippines Inventory of Chemicals and Chemical Substances AICS - Australian Inventory of Chemical Substances US Federal Regulations SARA 313 Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA). This product does not contain any chemicals which are subject to the reporting requirements of the Act and Title 40 of the Code of Federal Regulations, Part 372 SARA 311/312 Hazard Categories Acute health hazard Chronic Health Hazard Fire hazard Sudden release of pressure hazard Reactive Hazard CWA (Clean Water Act) This product does not contain any substances regulated as pollutants pursuant to the Clean Water Act (40 CFR and 40 CFR ) CERCLA This material, as supplied, does not contain any substances regulated as hazardous substances under the Comprehensive Environmental Response Compensation and Liability Act (CERCLA) (40 CFR 302) or the Superfund Amendments and Reauthorization Act (SARA) (40 CFR 355). There may be specific reporting requirements at the local, regional, or state level pertaining to releases of this material US State Regulations California Proposition 65 This product does not contain any Proposition 65 chemicals U.S. State Right-to-Know Regulations SPD PROTECTOR A 7 / 8 SPD Protector Part A

8 16. OTHER INFORMATION, INCLUDING DATE OF PREPARATION OF THE LAST REVISION NFPA Reactivity 0 Physical and Chemical Properties - Flammability 0 Physical hazards 0 Personal protection X HMIS Health hazards 0 Issue Date Revision Date Revision te 05-Jun Jun-2016 The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text. End of Safety Data Sheet SPD PROTECTOR A 8 / 8 SPD Protector Part A