DILLARD'S INC TEST PROTOCOL FOR DILL USA- (V13) DOPP KIT (LEATHER AND FABRIC HANGING AND NON HANGING)

Transcription

1 DILLAD'S INC TEST POTOCOL FO DOPP KIT (LEATHE AND FABIC HANGING AND NON HANGING) By/Date: Page 1 of 5 Evaluation Citation / ethod No. of Criteria Notes esult ating SCOPE: This protocol is applicable for testing of dopp kit (leather and fabric hanging and non hanging). SUPPLEENTAY POTOCOL Note: Additional cost, sample size & TAT may be required if testing to 1 or more supplemental protocols is necessary. Please refer to the below referenced supplemental protocol(s) for additional information. A California Proposition 65 DILL-AN-PTCL USA 1 The sample should be reviewed against the requirements of California Proposition 65. LABELING US Packaging labeling Country of origin marking Use labeling Labeling review: leather ANALYTICAL A Total lead in surface coating PHYSICAL CHAACTEISTICS F.P. and L. Act (16 CF 500) O NIST Uniform Laws and egulations Handbook Packaging shall be labelled with the following, Product Identification Net quantity of contents shall be expressed in terms of weight or mass, measure, numerical count, or combination so as to give accurate information to facilitate consumer comparison (U.S. and metric units) anufacturer, packer, or distributor s name & address (City, State & Zip Code) 19 CF Shall indicate country of origin legibly, permanently, and in comparable size and close proximity to any mention of country other than country in which the article was manufactured or produced. ust be visible at point of purchase. 1 Use/care instructions shall be clear, concise and understandable, provide stepby-step method of use and be provided in language appropriate to destination countries. Provide a copy of the instructions in the report. 16 CF 24 1 ust conform to guidelines for leather content / general fiber content labeling If all or part of a product is made of non-leather material that appears to be leather, the non-leather material must be disclosed on the retail packaging. The disclosure must be of such conspicuousness and clarity as to be noted by consumers casually inspecting the product. The disclosure must be in close proximity to the product identification. NOTE: A material that contains ground, pulverized, shredded, reconstituted or bonded leather cannot be represented as being wholly leather. Adequate disclosure of these leather types must be present. CPSC-CH-E / CPSD-AN accessible surface coatings in the as received state on items outside of the scope of 16 CF 1303 shall not contain lead or lead components in which the lead content is in excess of 0.009% (90 ppm) of the weight of the total content. eport actual results or include data table within report. Component testing is allowed. Compositing up to 3 colors is allowed. Client requirement

2 DILLAD'S INC TEST POTOCOL FO DOPP KIT (LEATHE AND FABIC HANGING AND NON HANGING) By/Date: Page 2 of 5 Evaluation Citation / ethod No. of Criteria Notes esult ating 1 eport overall height. Shall meet label claims. height width 1 eport overall width; shall meet label claims depth Dimensions Dimensions thickness Weight Parts inventory Number of main compartments Number of internal pouches or pockets or openings Number of external pouches or pockets or openings Other features Fabric weight Fabric count of woven fabric Yarn construction AST D (2011) WOKANSHIP 1 eport overall depth; shall meet label claims. 1 [Handle drop] eport overall dimensions; shall meet label claims. 1 [Circumference - shoulder strap drop] eport maximum and minimum;shall meet label claims. 1 [aterial thickness] eport overall thickness; shall meet label claims (If applicable) (-0% / +5%). 1 eport overall weight; shall meet label claims. 1 Shall meet label claims. listed hardware must be provided. AST D a 1 Shall be as claimed (-0% +5%) AST D Shall be as claimed (± 3.0%). 1 Shall be as claimed (± 3.0%).

3 DILLAD'S INC TEST POTOCOL FO DOPP KIT (LEATHE AND FABIC HANGING AND NON HANGING) By/Date: Page 3 of 5 Evaluation Citation / ethod No. of Hazardous sharp 16 CF point and sharp & 49 (od) edge Defects and workmanship Fabric defects AST D (2016) PEFOANCE Actual use - CPSD-GB functionality Seam strength AST D e1 (od) Handle 45 degree AST D e1 (od) Handle strength AST D e1 (od) Breaking strength of textile fabrics: grab test Holding strength of snap fasteners esistance to snapping and unsnapping of snap fasteners Button/small parts attachment strength Button impact resistance AST D (2017) AST D (2016) CPSD-SL CPSD-SL CPSD-SL Criteria Notes esult ating Shall have no sharp points / edges, other than those required for function. odification: Expanded scope to other products. Shall have no discernible surface degradation, including crazing, shivering, denting, bubbles, cracks, stains, deformations, chips, fractures, heavy lines, waves, shear marks, scratches, scuff marks, indentations, or blisters. Shall have no components missing, malformed, and/or fractured. 1 No critical defects. Shall function as intended as received. eport details of evaluation (features tested / methods used / materials used / etc.) eport any features not evaluated. 2 Side seam: 15 lb minimum. Bottom seam: 15 lb minimum. Zipper seam: 15 lb minimum. einforced stress points: 15 lb minimum. odification: Expanded the scope to other than apparel lb minimum. odification: Expanded scope to other products lb minimum. odification: Expanded scope to other products. 2 Shell: minimum 20 lbf Lining: minimum 10 lbf Note: Pass / fail base on result of overall fabric break lb for 10 seconds 2 inimum 2 lb aximum 8 lb 2 17 lb minimum for 10 seconds. 2 No fractures of button. Operability of AST D aximum 10 lb.

4 DILLAD'S INC TEST POTOCOL FO DOPP KIT (LEATHE AND FABIC HANGING AND NON HANGING) By/Date: Page 4 of 5 Evaluation Citation / ethod No. of Criteria Notes esult ating zippers 2014 Strength tests for zippers AST D Cross widthwise strength: 50 lb. minimum. Scoop pull: 10 lb. minimum. Top stop: 20 lb. minimum. Bottom stop: 20 lb. minimum. Slider torque: 2 lb-in minimum. Abrasion resistance of fabric - inflated diaphragm apparatus Flexing test AST D (2015) CPSD-SL Slider pull: 5 lb. minimum. 1 [Edge] No removal of upper surface. 1 No cracking after 10,000 cycles No. Of equired for Complete Testing No. Of (Fully Packed) Cartons For Transit Testing: No. Of Working Days For Complete Testing: 3 1 (Only upon Dillard s request) 7 Client Approval: Creation Date: Last evision Date: Pricing eview Date Lucy Feng 05/Sep/ /Oct/ /Aug/2018 Technical eview Date: 13/Feb/2015 Key A Additional Charge For This Test andatory egulatory esult Key

5 DILLAD'S INC TEST POTOCOL FO DOPP KIT (LEATHE AND FABIC HANGING AND NON HANGING) By/Date: Page 5 of 5 esult Key C N NA NT Claimed ecorded eets Does Not eet Not Applicable Not Tested ating Key PASS FAIL N Pass Fail Not equested