ADDENDUM NO. 01 PROJECT Colby Glass E.S. Window Upgrades and ADA Work PROJECT NO. 16043 DATE February 07, 2018 TO: All Prime Contract Bidders and all others to whom Drawings and Specifications have been issued by the Architect/Engineer. This Addendum forms a part of the Contract Documents. This addendum modifies and supplements the Contract Documents as follows for the above-mentioned project and includes two (2) pages, three (3) attachments, and no revised drawing sheets. All other provisions of the Documents remain the same. CLARIFICATIONS None CHANGES TO THE SPECIFICATIONS ITEM NO. 1. ITEM NO. 2. ITEM NO. 3. ITEM NO. 4. ITEM NO. 5. ITEM NO. 6. ITEM NO. 7. TABLE OF CONTENTS: A. Remove Table of Contents and insert new attached Table of Contents. Add new SECTION NO. 01 2100, ALLOWANCES to the Specifications. SECTION NO. 01 2200, UNIT PRICES: A. At subparagraph 1.8.A.1, add allow for brick toothing. to the end of the description. SECTION NO. 01 5813, TEMPORARY PROJECT SIGNAGE: A. Added attached edited drawing SECTION NO. 06 4100, ARCHITECTURAL WOOD CASEWORK: A. At Paragraphs 2.2.1 B. 1 and 2, revise wood species to read Select White Birch or Select White Maple. B. At Paragraph 2.2.1 C.: Delete paragraph in its entirety. All cabinets are to be wood veneer. C. At Paragraph 2.2.4 A, revise to read Plastic Laminate Countertops: ¾ inch plywood substrate covered with HPDL, conventionally fabricated, post formed and self-edge banded. SECTION NO. 08 7100, DOOR HARDWARE: A. Hardware Schedule: 1) Eliminate HWS #101 and add Door E105B to Hardware Set #104. 2) Hardware Set #103: Revise label from Privacy to Passage. SECTION No. 10 2800, TOILET, BATH, AND LAUNDRY ACCESSORIES: A. Add subparagraph 2.2.4.B.1: Product: Kimberly-Clark In-Sight Lev-R-Matic II Roll Paper Towel Dispenser #KIM09736.
ADDENDUM NO. 01 16043 February 07, 2018 Page 2 of 2 CHANGES TO THE DRAWINGS ITEM NO. 8. DRAWING SHEET NO. A201, SCHEDULES & DETAILS: A. TOILET ACCESSORY SCHEDULE, Change TA-3 to read Kimberly-Clark In-Sight Lev-R-Matic II Roll Paper Towel Dispenser #KIM09736. ITEM NO. 9. DRAWING SHEET NO. A402, ENLARGED PLANS & ELEV.: A. C3/A402 Provide one TA-8 Sanitary Napkin Disposal Unit. Install top at 2-0 a.f.f. o 0 o T:\16043\15-0_Bidding\Addenda\Addendum No. 1.docx
T-16043 NISD Colby Glass ES Window Upgrades and ADA Work (slew512) TOC - 1 of 3 TABLE OF CONTENTS DIVISION 00 - PROCUREMENT AND CONTRACTING REQUIREMENTS PROCUREMENT AND CONTRACTING REQUIREMENTS PROVIDED BY THE OWNER (See Table of Contents for included documents) 00 3100 AVAILABLE PROJECT INFORMATION STC Asbestos Survey Report Dated January 26, 2018 00 7330 ADDITIONAL SUPPLEMENTARY CONDITIONS DIVISION 01 GENERAL REQUIREMENTS 01 0070 PROVISIONS FOR ACCESSIBILITY 01 1000 SUMMARY Roof Membrane Guarantee No. TXSADF 003439 by U.S. Ply, Inc. Roof Membrane Guarantee No. 25365 by Siplast, Inc. (for areas A,E, and F) 01 2000 PRICE AND PAYMENT PROCEDURES 01 2100 ALLOWANCES (Addendum No. 1) 01 2200 UNIT PRICES 01 2300 ALTERNATES 01 3000 ADMINISTRATIVE REQUIREMENTS Substitution Request form (Pre-Bid) Substitution Request form (Post-Bid & after execution of Contract) Release of Liability and Indemnification for Use of Electronic Files Notice to Comply (NTC) Form RFI Form AIA Document G716 01 3216 CONSTRUCTION PROGRESS SCHEDULE 01 4000 QUALITY REQUIREMENTS 01 4100 REGULATORY REQUIREMENTS 01 5000 TEMPORARY FACILITIES AND CONTROLS 01 5813 TEMPORARY PROJECT SIGNAGE S1 Temporary Project Sign 01 6000 PRODUCT REQUIREMENTS 01 6116 VOLATILE ORGANIC COMPOUND (VOC) CONTENT RESTRICTIONS 01 7000 EXECUTION AND CLOSEOUT REQUIREMENTS 01 7800 CLOSEOUT SUBMITTALS DIVISION 02 EXISTING CONDITIONS 02 4100 DEMOLITION 02 8333.13 LEAD-BASED PAINT REMOVAL AND DISPOSAL DIVISION 03 CONCRETE - NOT USED T:\16043\13-0_Specs\XXX No Input\Cover & TOC\TOC-MF2004-FULL--RED.doc TABLE OF CONTENTS TOC - 1
T-16043 NISD Colby Glass ES Window Upgrades and ADA Work (slew512) TOC - 2 of 3 DIVISION 04 MASONRY 04 2000 UNIT MASONRY 04 7200 CAST STONE MASONRY DIVISION 05 METALS 05 4000 COLD-FORMED METAL FRAMING 05 5000 METAL FABRICATIONS 05 5213 PIPE AND TUBE RAILINGS DIVISION 06 WOOD, PLASTIC, & COMPOSITES 06 1000 ROUGH CARPENTRY 06 1050 ROOF CARPENTRY (RC) 06 4100 ARCHITECTURAL WOOD CASEWORK DIVISION 07 THERMAL AND MOISTURE PROTECTION 07 2100 THERMAL INSULATION 07 2720 MEMBRANE FLASHING 07 2728 FLUID-APPLIED AIR BARRIER ASSEMBLY 07 5220 ROOF INSTALLER S WARRANTY (RC) 07 5550 ROOF SYSTEM REPAIRS (RC) 07 9200 JOINT SEALANTS 07 9513 EXPANSION JOINT COVER ASSEMBLIES DIVISION 08 OPENINGS 08 1213 HOLLOW METAL FRAMES 08 1416 FLUSH WOOD DOORS 08 4313 ALUMINUM-FRAMED STOREFRONTS 08 7100 DOOR HARDWARE 08 8000 GLAZING 08 8859 METAL COMPOSITE WINDOW INFILL PANELS DIVISION 09 FINISHES 09 2116 GYPSUM BOARD ASSEMBLIES 09 2400 CEMENT PLASTERING 09 3000 TILING 09 5100 ACOUSTICAL CEILINGS 09 6500 RESILIENT FLOORING 09 9113 EXTERIOR PAINTING 09 9123 INTERIOR PAINTING DIVISION 10 Through 20 NOT USED DIVISION 21 FIRE SUPPRESSION T:\16043\13-0_Specs\XXX No Input\Cover & TOC\TOC-MF2004-FULL--RED.doc TABLE OF CONTENTS TOC - 2
T-16043 NISD Colby Glass ES Window Upgrades and ADA Work (slew512) TOC - 3 of 3 DIVISION 22 PLUMBING 22 1005 (15410) PLUMBING PIPING 22 4000 (15440) PLUMBING FIXTURES DIVISION 23 HEATING, VENTILATING, & AIR CONDITIONING - MEP 23 0513 (15010) GENERAL REQUIREMENT FOR MECHANICAL AND ELECTRICAL 23 0550 (15050) BASIC MECHANICAL MATERIALS AND METHODS 23 3000 (15890) AIR DISTRIBUTION DIVISION 24 and 25 NOT USED DIVISION 26 ELECTRICAL 26 0100 (16010) BASIC ELECTRICAL REQUIREMENTS 26 0126 (16950) TESTING 26 0500 (16050) BASIC ELECTRICAL MATERIALS AND METHODS 26 5100 (16500) LIGHTING DIVISION 27 - COMMUNICATIONS ATTACHMENTS CONSULTANT KEY. Key Discipline Company Telephone MEP Mechanical, Electrical and Wallis Engineering Group (210)805-9001 Plumbing Engineers 8031 Broadway San Antonio, TX 78209 RC Roofing Consultant Hollon + Cannon (512)705-7299 128858 Research Blvd. Austin, TX 78750 SE Structural Engineer RSCR 1950 La Manda Blvd. San Antonio, TX 78201 (210) 340-7973 END OF TABLE OF CONTENTS (TOC) T:\16043\13-0_Specs\XXX No Input\Cover & TOC\TOC-MF2004-FULL--RED.doc TABLE OF CONTENTS TOC - 3
T-16043 NISD Colby Glass ES - Window Upgrades & ADA Work (slew512) 01 2100-1 of 2 PART 1 GENERAL SECTION 01 2100 ALLOWANCES 1.1 SECTION INCLUDES A. Cash allowances. B. Contingency allowance. C. Payment and modification procedures relating to allowances. 1.2 RELATED REQUIREMENTS A. Section 01 2000 - Price and Payment Procedures: Additional payment and modification procedures. 1.3 CASH ALLOWANCES A. Costs Included in Cash Allowances: Cost of product for purchase, delivery, and installation to Contractor or subcontractor, less applicable trade discounts. B. Architect Responsibilities: 1. Consult with Contractor for consideration and selection of products, suppliers, and installers. 2. Select products in consultation with Owner and transmit decision to Contractor. 3. Prepare Change Order. C. Contractor Responsibilities: 1. Assist Architect in selection of products, suppliers, and installers. 2. Obtain proposals from suppliers and installers and offer recommendations. 3. On notification of which products have been selected, execute purchase agreement with designated supplier and installer. 4. Arrange for and process shop drawings, product data, and samples. Arrange for delivery. 5. Promptly inspect products upon delivery for completeness, damage, and defects. Submit claims for transportation damage. D. Differences in costs will be adjusted by Change Order. 1.4 CONTINGENCY ALLOWANCE A. Contractor's costs for products, delivery, installation, labor, insurance, payroll, taxes, bonding, equipment rental, overhead and profit will be included in Change Orders authorizing expenditure of funds from this Contingency Allowance. B. Funds will be drawn from the Contingency Allowance only by Change Order. C. At closeout of Contract, funds remaining in Contingency Allowance will be credited to Owner by Change Order. 1.5 ALLOWANCES SCHEDULE A. Section 04 2000 - Unit Masonry: Include a stipulated sum for purchase, delivery, and installation of 500 sf of brick veneer at the Unit Price determined in Section 01 2200 - Unit Prices. B. Contingency Allowance: Include the stipulated sum/price of $25,000 for use upon Owner's instructions. PART 2 PRODUCTS - NOT USED PART 3 EXECUTION - NOT USED END OF SECTION Addendum No. 01 ALLOWANCES 01 2100-1.
T-16043 NISD Colby Glass ES - Window Upgrades & ADA Work (slew512) 01 2100-2 of 2 Addendum No. 01 ALLOWANCES 01 2100-2.