EESTI STANDARD EVS-EN 12373-1:2002 Aluminium and aluminium alloys - Anodizing - Part 1: Method for specifying decorative and protective anodic oxidation coatings on aluminium Aluminium and aluminium alloys - Anodizing - Part 1: Method for specifying decorative and protective anodic oxidation coatings on aluminium EESTI STANDARDIKESKUS
EESTI STANDARDI EESSÕNA NATIONAL FOREWORD Käesolev Eesti standard EVS-EN 12373-1:2002 sisaldab Euroopa standardi EN 12373-1:2001 ingliskeelset teksti. Käesolev dokument on jõustatud 16.01.2002 ja selle kohta on avaldatud teade Eesti standardiorganisatsiooni ametlikus väljaandes. Standard on kättesaadav Eesti standardiorganisatsioonist. This Estonian standard EVS-EN 12373-1:2002 consists of the English text of the European standard EN 12373-1:2001. This document is endorsed on 16.01.2002 with the notification being published in the official publication of the Estonian national standardisation organisation. The standard is available from Estonian standardisation organisation. Käsitlusala: This part of this European Standard describes a method for specifying decorative and protective anodic oxidation coatings on aluminium. Scope: This part of this European Standard describes a method for specifying decorative and protective anodic oxidation coatings on aluminium. ICS 25.220.20, 77.120.10 Võtmesõnad: area, definitions, electrical, inspection, materials testing, measurement, measuring techniques, metal coatings, metals, non ferrous alloys, non-ferrous metals, non-metallic coatings, oxide coatings, protective coat, specification, surfaces, test equipment, testing
EN 12373-1 ICS 25.220.20; 77.120.10 May 2001 English version Aluminium and aluminium alloys Anodizing Part 1: Method for specifying decorative and protective anodic oxidation coatings on aluminium Aluminium et alliages d aluminium Anodisation Partie 1: Méthode de spécification des caractéristiques des revêtements décoratifs et protecteurs obtenus par oxydation anodique sur aluminium Aluminium und Aluminiumlegierungen Anodisieren Teil 1: Methode zur Spezifizierung dekorativer und schützender anodisch erzeugter Oxidschichten auf Aluminium This European Standard was approved by CEN on 2001-04-20. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Management Centre or to any CEN member. The European Standards exist in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, the Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, the Netherlands, Norway, Portugal, Spain, Sweden, Switzerland, and the United Kingdom. ÈÉË European Committee for Standardization Comité Européen de Normalisation Europäisches Komitee für Normung Management Centre: rue de Stassart 36, B-1050 Brussels 2001. CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national members. Ref. No. E
Page 2
Page 3
Page 4
Page 5
Page 6