NATURAL CERTIFICATION Product: Mafco Magnasweet 100 (MM100) This is to certify that all Flavoring Components of Mafco Magnasweet 100 (MM100) are derived entirely from Natural Sources as defined in CFR21 Part 101 Section 22 (a) (3) of the United States Food and Drug Administration Code of Federal Regulations. In addition, the term Natural Flavoring as applied to this product is both true and correct to the best of our knowledge. representatives. Individual requirements vary and each purchaser is urged to perform their own test, experiments and investigations in the use of Mafco Worldwide Corporation product and for purposes of determining compliance of applicable Federal, State and local laws and regulations.
NUTRITIONAL INFORMATION Product: Mafco Magnasweet 100 (MM100) All data is per 100 grams of product. Parameter MM100 Total calories (cal) 380 Total fat (g) 0 Saturated fat (g) 0 Trans fatty acids (g) 0 Cholesterol (mg) 0 Sodium (mg) 10 Total carbohydrates (g) 94 Dietary fiber (g) 0 Sugars, (g) 0 Protein (g) 0 Vitamin A (IU) 0 Vitamin C (mg) 0 Calcium (mg) 0 Iron (mg) 0 Note: Zero implies trace or no presence. representatives. Individual requirements vary and each purchaser is urged to perform their own test, experiments and investigations in the use of Mafco Worldwide Corporation product and for purposes of determining compliance of applicable Federal, State and local laws and regulations.
ALLERGEN STATEMENT Product: Mafco Magnasweet 100 (MM100) The product listed above does not contain the foods listed in the Allergen List which may cause serious allergic reactions: Allergen List: Peanuts Soybeans Milk Eggs Fish Crustacea Tree nuts Wheat representatives. Individual requirements vary and each purchaser is urged to perform their own test, experiments and investigations in the use of Mafco Worldwide Corporation product and for purposes of determining compliance of applicable Federal, State and local laws and regulations.
BSE/TSE STATEMENT Product: Mafco Magnasweet 100 (MM100) The product Mafco Magnasweet 100 (MM100) is not derived from animal origin and is free from Bovine Spongiform Encephalopathy (BSE) and Transmissible Spongiform Encephalopathy (TSE). representatives. Individual requirements vary and each purchaser is urged to perform their own test, experiments and investigations in the use of Mafco Worldwide Corporation product and for purposes of determining compliance of applicable Federal, State and local laws and regulations.
CONTINUING PRODUCT GUARANTEE Product: Mafco Magnasweet 100 (MM100) Each article comprising every shipment of or other delivery of product made by Mafco Worldwide Corporation, Camden, New Jersey, is hereby guaranteed as of the date of such shipment or delivery to be, on such date, not adulterated or misbranded within the meaning of the U.S. Food, Drug and Cosmetic Act, as amended, and not an article which may not, under the provisions of said Act, be introduced into interstate or intrastate commerce, provided, however, that we do not guarantee against such goods becoming adulterated or misbranded within the meaning of said Act after shipment by reason of causes beyond our control. This is a general, continuing and nonassignable guarantee, subject to revocation on written notice thereof, issued pursuant to said Act, as amended (including the Food Additive Amendment of 1958 and subsequent amendments), and terminates and supercedes like guarantees that may have been previously distributed. representatives. Individual requirements vary and each purchaser is urged to perform their own test, experiments and investigations in the use of Mafco Worldwide Corporation product and for purposes of determining compliance of applicable Federal, State and local laws and regulations.
GMO STATEMENT Product: Mafco Magnasweet 100 (MM100) The product Mafco Magnasweet 100 (MM100) does not contain genetically modified organisms in accordance with the EC regulations 1829/2003 and 1830/2003 as well as the Directive 2001/18/EC. In accordance with the EC regulations 1829/2003 and 1830/2003 as well as the Directive 2001/18/EC, the MM100 does not require additional marking in relation to the presence or use of GMO. representatives. Individual requirements vary and each purchaser is urged to perform their own test, experiments and investigations in the use of Mafco Worldwide Corporation product and for purposes of determining compliance of applicable Federal, State and local laws and regulations.
IRRADIATION STATEMENT Product: Mafco Magnasweet 100 (MM100) The product Mafco Magnasweet 100 (MM100) is not treated with irradiation during the production, storage or shipping process. representatives. Individual requirements vary and each purchaser is urged to perform their own test, experiments and investigations in the use of Mafco Worldwide Corporation product and for purposes of determining compliance of applicable Federal, State and local laws and regulations.
MATERIAL SAFETY DATA SHEET PRODUCT NAME: MONOAMMONIUM GLYCYRRHIZINATE (MM100) (MAFCO MAGNASWEET 100) EFFECTIVE DATE: 3/03/09 1. PRODUCT IDENTIFICATION Synonyms: Monoammonium Glycyrrhizinate CAS No.: 53956-04-0 2. COMPOSITION/INFORMATION ON INGREDIENTS INGREDIENT CAS NO. PERCENT HAZARDOUS ------------------------------------ ----------- ------------- ------------------- Monoammonium Glycyrrhizinate 53956-04-0 100 No 3. HAZARDS IDENTIFICATION EMERGENCY OVERVIEW ------------------------------------ CAUTION! May cause irritation to skin, eyes and respiratory tract -------------------------------------------------------------------------------------------------------------------------------- HEALTH RATING: 0 None FLAMMABILITY RATING: 1 Slight REACTIVITY RATING: 0 None --------------------------------------------------------------------------------------------------------------------------------- POTENTIAL HEALTH EFFECTS ------------------------------------------ INHALATION: Overexposure to dust may produce irritation of the respiratory system INGESTION: Ingestion of large amounts may produce gastrointestinal disturbances. SKIN CONTACT: None. EYE CONTACT: Contact may produce mechanical irritation. CHRONIC EXPOSURE: No information found. AGGRAVATION OF PRE-EXISTING CONDITIONS: No information found. = 4. FIRST AID MEASURES INHALATION: If respiratory irritation occurs upon inhalation, remove to fresh air. Seek medical attention if symptoms persist. INGESTION: If large amounts were swallowed, get medical advice. Do not induce vomiting unless directed to do so by medical personnel. SKIN CONTACT: For skin contact, wash with soap and water. EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes, lifting upper and lower eyelids occasionally. Get medical attention if irritation persists. msmm100.docpage 1 of 4
5. FIREFIGHTING MEASURES FLASH POINT: Not applicable UPPER FLAMMABLE LIMIT: Not applicable LOWER FLAMMABLE LIMIT: Not applicable AUTOIGNITION TEMPERATURE: Not available FLAMMABILITY CLASS: Not applicable RATE OF BURNING: Not applicable GENERAL FIRE HAZARDS: Accumulation of airborne dusts may present an explosion or fire hazard in the presence of an ignition source. HAZARDOUS COMBUSTION PRODUCTS: None EXTINGUISHING MEDIA: Dry chemical, foam, carbon dioxide, water fog FIRE FIGHTING EQUIPMENT/INSTRUCTIONS: Firefighters should wear full protective clothing, including self-contained breathing apparatus. 6. ACCIDENTAL RELEASE MEASURES CONTAINMENT PROCEDURES: Contain the discharged material. If sweeping of a contaminated are is necessary, use a dust suppressant. CLEAN-UP PROCEDURES: Wear protective equipment and clothing during clean-up. Sweep or vacuum spilled material. Use of moist absorbent is recommended. EVACUATION PROCEDURES: Not necessary. SPECIAL PROCEDURES: None. 7. HANDLING AND STORAGE HANDLING PROCEDURES: Avoid getting this material into contact with your eyes. Wash thoroughly after handling. Avoid the formation of airborne dusts. STORAGE PROCEDURES: Keep container tightly closed and store at room temperature. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION EXPOSURE GUIDELINES A. General Product Information Exposures should be minimized in accordance with good industrial hygiene practices. B. Component Exposure Limits OSHA: 15 mg/cu. m; ACGIH: 10/mg/cu.m. ENGINEERING CONTROLS: Ventilation should be sufficient to effectively remove and prevent buildup of airborne dusts. PERSONAL PROTECTIVE EQUIPMENT: Personal Protective Equipment: Eyes/Face Wear appropriate eye protection. Personal Protective Equipment: Skin Wear impervious gloves for prolonged contact. Personal Protective Equipment: Respiratory If ventilation is not sufficient to effectively remove and prevent buildup of dusts, appropriate NIOSH/MSHA approved respiratory protection should be provided. Personal Protective Equipment: General Use good industrial hygiene practices in handling this material. msmm100.docpage 2 of 4
9. PHYSICAL AND CHEMICAL PROPERTIES APPEARANCE: White crystalline powder PHYSICAL STATE: Solid VAPOR PRESSURE: Not applicable BOILING POINT: Not applicable FREEZING POINT: Not applicable SOFTENING POINT: Not available VISCOSITY: Not applicable PERCENT VOLATILE: 3% (moisture) ODOR: Practically odorless ph: Not applicable VAPOR DENSITY: Not applicable SPECIFIC GRAVITY: Not available PARTICLE SIZE: Not available EVAPORATION RATE: Not applicable BULK DENSITY: Not available MOLECULAR WEIGHT: Not available 10. STABILITY AND REACTIVITY CHEMICAL STABILITY: Stable CHEMICAL STABILITY: Conditions to avoid: Avoid accumulation of airborne dusts. HAZARDOUS DECOMPOSITION PRODUCTS: None HAZARDOUS POLYMERIZATION: Will not occur INCOMPATABILITIES: None = 11. TOXICOLOGICAL INFORMATION LD 50 P.O. (mice): 12700 mg/kg LD 50 (mice): 1070 mg/kg = 12. ECOLOGICAL INFORMATION ECOTOXICITY: No data available for this product. ENVIRONMENTAL FATE: No data available for this product. = 13. DISPOSAL CONSIDERATIONS US EPA Waste Number & Descriptions A. General Product Information Empty container retains product residue. Do not distribute, make available, furnish or reuse empty container except for storage and shipment of original product. Empty container, remove all product residue. Puncture or otherwise destroy empty container before disposal. B. Component Waste Numbers: No EPA Waste Numbers are applicable for this product components. DISPOSAL INSTRUCTIONS All wastes must be handled in accordance with local, state and federal regulations. = 14. TRANSPORT INFORMATION US DOT INFORMATION Not regulated INTERNATIONAL TRANSPORTATION REGULATIONS Not regulated as dangerous goods. = msmm100.docpage 3 of 4
15. REGULATORY INFORMATION US FEDERAL REGULATIONS A. General Product Information No information available B. Component Analysis None of this products components are listed under SARA Section 302 (40CFR 355 Appendix A), SARA Section 313 (40CFR 372.6) or CERCLA (40CFR302.4) = 16. OTHER INFORMATION ------------------------------------------FOR ADDITIONAL INFORMATION--------------------------------------- CONTACT: MAFCO WORLDWIDE CORPORATION 856-964-8840 ------------------------------------------------------NOTICE-------------------------------------------------------------- Mafco Worldwide Corporation ( Mafco ) expressly disclaims all express or implied warranties of merchantability and fitness for a particular purpose, with respect to the product or information provided herein, and shall under no circumstances be liable for incidental or consequential damages. Do not use ingredient information and/or ingredient percentages in this MSDS as a product specification. For product specification information, refer to a product specification sheet and/or a certificate of analysis. These can be obtained from Mafco sales office. All information appearing herein is based upon data obtained from the manufacturer and/or recognized technical sources. While the information is believed to be accurate, Mafco makes no representations as to its accuracy or sufficiency. Conditions of use are beyond Mafco. Control and therefore users are responsible to verify this data under their own operating conditions to determine whether the product is suitable for their particular purposes and they assume all risks of their use, handling and disposal of the product, or from the publication or use of, or reliance upon, information contained herein. This information relates only to the product designated herein, and does not relate to its use in combination with any other material or in any other process. msmm100.docpage 4 of 4