6 7 8 10 OUTSIDE CORNER 19 20 4 5 11 21 22 15 16 13 12 OPENING 14 SOFFIT 18 END WALL 17 INSIDE CORNER 9 6 7 8 ELEVATION FOR DETAIL REFERENCE ONLY CCV-01 CCV-02 CCV-03 CCV-04 CCV-05 CCV-06 CCV-07 CCV-08 CCV-09 CCV-10 CCV-11 CCV-12 CCV-13 CCV-14 CCV-15 CCV-16 CCV-17 INDEX STANDARD PANEL OFFERING STANDARD PANEL OFFERING SIDE LAP DETAILS SIDE LAP DETAILS WALL SECTIONS WALL SECTIONS WALL SECTIONS BASE DETAILS PARAPET DETAIL STACK JOINT DETAIL HEAD OPENING DETAIL JAMB OPENING DETAIL SILL OPENING DETAIL HEAD, JAMB, SILL INTERSECTION FIX POINT DETAIL END WALL DETAIL CCV-18 SOFFIT DETAILS CCV-19 OUTSIDE CORNER DETAIL CCV-20 INSIDE CORNER DETAIL CCV-21 PENETRATION (1 of 2) CCV-22 PENETRATION (2 of 2) INDEX NOTE: DETAILS ARE FOR PROMOTIONAL USE ONLY. FOR COMPLETE DETAILS, REFER TO CENTRIA'S WEB SITE AT www.centria.com CCV-01
16" [406] 16" [406] 5.25" [133] CC-624 5.25" [133] 5.25" [133] CC-662 16" [406] 16" [406] 5.25" [133] CC-663 CC-664 5.25" [133] 12" [305] 12" [305] (TYP.) 4.00" [102] CC-260 1.25" [32] 5.25" [133] CC-262 12" [305] CC-263 5.25" [133] CASCADE Panel Options Horizontal With Attachment Clips Vertical With Attachment Clips and a Fixing Point Fastener CASCADE LOW CELL PANELS CCV-02
16" [406] 16" [406] 8.25" [210] CC-610 1.25 [32] 2.75 [70] CC-612 4.25 [108] 16" [406] 16" [406] 4.25" [108] CC-613 4.25" [108] CC-620 4.25" [108] 16" [406] 16" [406] 4.25" [108] 4.00" [102] CC-623 8.25" [210] CC-630 12" [305] 12" [305] 8.25" [210] CC-200 CC-210 4.25" [108] 12" [305] 4.25" [108] CC-220 CASCADE Panel Options Horizontal With Attachment Clips Vertical With Attachment Clips and a Fixing Point Fastener CASCADE HIGH CELL PANELS CCV-03
CC-624 16" [406] NOMINAL COVERAGE CC-662 16" [406] NOMINAL COVERAGE CC-663 16" [406] NOMINAL COVERAGE CC-664 16" [406] NOMINAL COVERAGE CC-260 12" [305] NOMINAL COVERAGE CC-262 12" [305] NOMINAL COVERAGE SIDE LAPS CC-263 12" [305] NOMINAL COVERAGE CASCADE LOW CELL PANELS CCV-04
CC-610 16" [406] NOMINAL COVERAGE CC-612 16" [406] NOMINAL COVERAGE CC-613 16" [406] NOMINAL COVERAGE CC-620 16" [406] NOMINAL COVERAGE CC-623 16" [406] NOMINAL COVERAGE CC-630 16" [406] NOMINAL COVERAGE CC-200 12" [305] NOMINAL COVERAGE CC-210 12" [305] NOMINAL COVERAGE SIDE LAPS CC-220 12" [305] NOMINAL COVERAGE CASCADE HIGH CELL PANELS CCV-05
DRAINED & VENTED CAVITY CASCADE PANEL CSC-3 PANEL CLIP (TOPS OF ALL PANELS SHALL BE THRU FASTENED TO PROVIDE A FIXING POINT FOR THE WALL PANELS.) INTERIOR SHEATHING STUD INSULATION EXTERIOR SHEATHING BARRIER HORIZONTAL 3/4" [19] DEEP 16 GA. SUBGIRT PANELS ON PROTECTED EXTERIOR SHEATHING WITH CAVITY INSULATION VAPOR RETARDER LOCATION THE LOCATION OF THE VAPOR (DIFFUSION) RETARDER IS NOT IDENTIFIED IN THIS DETAIL BECAUSE IT IS A REQUIREMENT THAT VARIES BY CODE JURISDICTION, CLIMATE AND INTERIOR CONDITIONS. THEREFORE THE BUILDING DESIGNER MUST MAKE THIS DETERMINATION. = NOT BY CENTRIA DRAINED & VENTED CAVITY CASCADE PANEL HORIZONTAL 1/2" [13] DEEP 16 GA. SUBGIRT CSC-3 PANEL CLIP (TOPS OF ALL PANELS SHALL BE THRU FASTENED TO PROVIDE A FIXING POINT FOR THE WALL PANELS.) HORIZONTAL GIRTS BARRIER (PROVIDED BY FACE PANEL) VERTICAL LINER PANEL WITH FACTORY APPLIED SEALANT AIR BARRIER (LINER PANEL) FIELD-APPLIED (1.65 PCF) INSULATION IN LINER CAVITY PANELS WITH INSULATION IN VERTICAL LINER = NOT BY CENTRIA CCV-06
CASCADE PANEL METALWRAP INSULATED BACK-UP PANEL CSC-3 PANEL CLIP (TOPS OF ALL PANELS SHALL BE THRU FASTENED TO PROVIDE A FIXING POINT FOR THE WALL PANELS.) "A" "A" METALWRAP CONT. ZEE AT EACH PANEL SIDE JOINT (36" O.C.) METALWRAP INSULATED BACK-UP PANEL SECTION A-A PANEL CLIP CASCADE PANEL 3 4 " DRAINED & VENTED CAVITY PANELS WITH METALWRAP INSULATED BACK-UP PANEL = NOT BY CENTRIA DRAINED & VENTED CAVITY CASCADE PANEL CSC-3 PANEL CLIP (TOPS OF ALL PANELS SHALL BE THRU FASTENED TO PROVIDE A FIXING POINT FOR THE WALL PANELS.) CON'T. HORIZONTAL ZEE 16 [1.52] GA. MIN. (SPACING TO BE DETERMINED BY CLADDING ENGINEER) INTERIOR SHEATHING STUD EXTERIOR SHEATHING BARRIER INSULATION SUITABLE FOR MOISTURE EXPOSURE PANELS WITH INSULATION OUTBOARD OF STUD CAVITY VAPOR RETARDER LOCATION THE LOCATION OF THE VAPOR (DIFFUSION) RETARDER IS NOT IDENTIFIED IN THIS DETAIL BECAUSE IT IS A REQUIREMENT THAT VARIES BY CODE JURISDICTION, CLIMATE AND INTERIOR CONDITIONS. THEREFORE THE BUILDING DESIGNER MUST MAKE THIS DETERMINATION. = NOT BY CENTRIA CCV-07
MASONRY FASTENER (*) CONTINUOUS HORIZONTAL ZEE SHAPED SUBGIRT (SHIM AS REQUIRED) (*) SUBGIRTS SHALL BE 1.) 16 GA. MINIMUM. 2.) 3/4" [19] MINIMUM DEPTH. 3.) SPACED AT 24" [610] OR 48"O.C. [1219] BASED ON DESIGN LOADS AND INSULATION SIZE. CSC-3 PANEL CLIP (TOPS OF ALL PANELS SHALL BE THRU FASTENED TO PROVIDE A FIXING POINT FOR THE WALL PANELS.) MASONRY INSULATION SUITABLE FOR MOISTURE EXPOSURE AIR BARRIER & WATER RESISTANT COATING OR MEMBRANE CASCADE PANEL DRAINED & VENTED CAVITY PANELS WITH INSULATION OVER MASONRY WALL VAPOR RETARDER LOCATION THE LOCATION OF THE VAPOR (DIFFUSION) RETARDER IS NOT IDENTIFIED IN THIS DETAIL BECAUSE IT IS A REQUIREMENT THAT VARIES BY CODE JURISDICTION, CLIMATE AND INTERIOR CONDITIONS. THEREFORE THE BUILDING DESIGNER MUST MAKE THIS DETERMINATION. = NOT BY CENTRIA CASCADE PANEL CSC-3 PANEL CLIP (TOPS OF ALL PANELS SHALL BE THRU FASTENED TO PROVIDE A FIXING POINT FOR THE WALL PANELS.) HORIZONTAL GIRTS FINISH IS REQUIRED ON BOTH SIDES OF THE PANEL SINCE BOTH SIDES ARE EXPOSED TO THE WEATHER PANELS USED AS A SCREEN WALL = NOT BY CENTRIA CCV-08
STUDS EXTERIOR SHEATHING BARRIER SELF ADHERING TAPE 3/4"[19] DEEP SUBGIRT SEALANT BASE DETAIL () (CC-7003) DESIGN OF BASE MUST VARY TO SUIT CONCRETE PLACEMENT AND FORMING TOLERANCES STUDS 3/4"[19] DEEP SUBGIRT EXTERIOR SHEATHING BARRIER SELF ADHERING TAPE SEALANT BASE DETAIL () (CC-7001) = NOT BY CENTRIA CCV-09
PARAPET 3/4"[19] SUBGIRT METAL CLOSURE (*) THROUGH FASTEN TO FIX @ LOW CELL STUDS BARRIER EXTERIOR SHEATHING PARAPET (CC-7010) = NOT BY CENTRIA CCV-10
EXTERIOR SHEATHING SELF ADHERING TAPE BARRIER STUDS 3/4"[19] DEEP SUBGIRT METAL CLOSURE (*) THROUGH FASTEN TO FIX @ LOW CELL STACK JOINT (CS-7004) = NOT BY CENTRIA CCV-11
EXTERIOR SHEATHING BARRIER SELF ADHERING TAPE 3/4"[19] DEEP SUBGIRT STUDS CURING BUTYL EXTEND BARRIER & AIR BARRIER WEATHER SEAL HEAD OPENING ( ) (CC-7000) PRIMARY AIR SEAL DOOR, WINDOW OR LOUVER = NOT BY CENTRIA CCV-12
EXTERIOR SHEATHING BARRIER STUDS PRIMARY AIR SEAL EXTEND BARRIER & AIR BARRIER CURING BUTYL DOOR, WINDOW OR LOUVER WEATHER SEAL 3/4"[19] DEEP SUBGIRT NON-CURING BUTYL EXTERIOR SHEATHING BARRIER JAMB OPENING (CC-7002B) STUDS PRIMARY AIR SEAL EXTEND BARRIER & AIR BARRIER CURING BUTYL DOOR, WINDOW OR LOUVER WEATHER SEAL 3/4"[19] DEEP SUBGIRT FIELD CUT LEG AS REQUIRED @ LOW CELL APPLICATIONS NON-CURING BUTYL JAMB OPENING (CC-7002) NON-CURING BUTYL = NOT BY CENTRIA CCV-13
EXTEND BARRIER & AIR BARRIER WINDOW OR LOUVER PRIMARY AIR SEAL METAL CLOSURE (*) THROUGH FASTEN TO FIX @ LOW CELL CURING BUTYL 3/4"[19] DEEP SUBGIRT STUDS EXTERIOR SHEATHING BARRIER SILL OPENING () (CC-7005) = NOT BY CENTRIA CCV-14
INTERSECTION OF HEAD, JAMB & SILL (CC-7013) = NOT BY CENTRIA CCV-15
FIX POINT DETAIL @ OPENING (CC-7022) = NOT BY CENTRIA CCV-16
STUD EXTERIOR SHEATHING 3/4"[19] SUBGIRT BARRIER AND AIR BARRIER SELF ADHERING TAPE SUPPORT FLASH EXTEND BARRIER & AIR BARRIER ONTO ABUTTING WALL & BED W/ CURING BUTYL POLYURETHANE END WALL () (CC-7006B) STUD EXTERIOR SHEATHING 3/4"[19] SUBGIRT BARRIER AND AIR BARRIER SELF ADHERING TAPE SUPPORT FLASH EXTEND BARRIER & AIR BARRIER ONTO ABUTTING WALL & BED W/ CURING BUTYL POLYURETHANE END WALL () (CC-7006A) = NOT BY CENTRIA CCV-17
EXTERIOR SHEATHING BARRIER AND AIR BARRIER STUDS SELF ADHERING TAPE 3/4"[19] SUBGIRT METAL AND COMPOSITION CLOSURES SOFFIT - FRONT () (CC-7016) 3/4"[19] SUBGIRT STUDS METAL AND COMPOSITION CLOSURES METAL CLOSURE (*) THROUGH FASTEN TO FIX @ LOW CELL EXTERIOR SHEATHING BARRIER AND AIR BARRIER SOFFIT - BACK () (CC-7017) = NOT BY CENTRIA CCV-18
DESIGN MAY VARY DUE TO PANEL MODULE LAYOUT STUDS 3/4" [19] SUBGIRT EXTERIOR SHEATHING BARRIER NON-CURING BUTYL SUPPORT FLASH NON-CURING BUTYL OUT SIDE CORNER ( ) (CC-7007B) = NOT BY CENTRIA CCV-19
DESIGN MAY VARY DUE TO PANEL MODULE LAYOUT STUDS 3/4" DEEP SUBGIRT BARRIER EXTERIOR SHEATHING SUPPORT FLASH HIGH CELL DETAIL (CC-7009A) INSIDE CORNER (CC-7009B) LOW CELL DETAIL (CC-7009) = NOT BY CENTRIA CCV-20
NOTE:- REF. PAGE CCV-20 FOR SECTS. A-A & B-B PENETRATION DETAIL (CC-7012) = NOT BY CENTRIA CCV-21
BARRIER SELF ADHERING TAPE 3/4"[19] SUBGIRT ANGLE SUPPORT FLAT EXTERIOR SHEATHING BARRIER SECTION A-A (CC-7012A) STUDS SELF ADHERING TAPE SELF ADHERING TAPE ANGLE SUPPORT BARRIER FLAT FLASH PENETRATION DETAIL SECTION B-B (CC-7012B) POLYURETHANE SEALANT (TYPICAL ALL AROUND) PANEL CLIP CSC-3 EXTERIOR SHEATHING = NOT BY CENTRIA CCV-22