SAFETY DATA SHEET 1. Identification Product identifier Paraffin Oil Other means of identification SDS number 00580 Part Number 501-439 Recommended use Recommended restrictions ne known. Manufacturer/Importer/Supplier/Distributor information Supplier Company name LECO Corporation Address 3000 Lakeview Avenue St. Joseph, MI 49085 United States Telephone 269-983-5531 Website www.leco.com E-mail info@leco.com Emergency phone number Chemtrec: 800-424-9300 Chemtrec Int'l: 703-527-3887 2. Hazard(s) identification Physical hazards Health hazards Environmental hazards OSHA defined hazards Label elements Aspiration hazard Hazardous to the aquatic environment, long-term hazard Category 1 Category 4 Signal word Hazard statement Precautionary statement Prevention Response Storage Disposal Hazard(s) not otherwise classified (HNOC) Supplemental information Danger May be fatal if swallowed and enters airways. May cause long lasting harmful effects to aquatic life. Avoid release to the environment. If swallowed: Immediately call a poison center/doctor. Do NOT induce vomiting. Store locked up. Dispose of contents/container in accordance with local/regional/national/international regulations. ne known. ne. 3. Composition/information on ingredients Mixtures Chemical name Common name and synonyms CAS number % Oil, Mineral 8012-95-1 60-100 4. First-aid measures Inhalation Move to fresh air. Call a physician if symptoms develop or persist. 1 / 6
Skin contact Eye contact Ingestion Most important symptoms/effects, acute and delayed Indication of immediate medical attention and special treatment needed General information 5. Fire-fighting measures Suitable extinguishing media Unsuitable extinguishing media Specific hazards arising from the chemical Special protective equipment and precautions for firefighters Fire fighting equipment/instructions Specific methods Wash the skin immediately with soap and water. Get medical attention if irritation develops and persists. Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention if irritation develops and persists. Call a physician or poison control center immediately. Rinse mouth. Do not induce vomiting. May cause respiratory irritation. Irritation of eyes. Skin irritation. Provide general supportive measures and treat symptomatically. If you feel unwell, seek medical advice (show the label where possible). Water Spray or Fog. Carbon dioxide (CO2). Dry chemicals. Alcohol resistant foam. Do not use water jet as an extinguisher, as this will spread the fire. During fire, gases hazardous to health may be formed. Self-contained breathing apparatus and full protective clothing must be worn in case of fire. Cool containers exposed to heat with water spray and remove container, if no risk is involved. Use standard firefighting procedures and consider the hazards of other involved materials. 6. Accidental release measures Personal precautions, protective equipment and emergency procedures Methods and materials for containment and cleaning up Environmental precautions Keep unnecessary personnel away. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ventilate closed spaces before entering them. Ensure adequate ventilation. Remove sources of ignition. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Avoid release to the environment. Inform appropriate managerial or supervisory personnel of all environmental releases. 7. Handling and storage Precautions for safe handling Conditions for safe storage, including any incompatibilities Do not handle until all safety precautions have been read and understood. Obtain special instructions before use. Wear appropriate personal protective equipment. Avoid breathing mist or vapor. Avoid contact with eyes, skin, and clothing. Wash hands thoroughly after handling. Observe good industrial hygiene practices. Keep away from heat, sparks and open flame. Keep containers tightly closed in a dry, cool and well-ventilated place. Store away from incompatible materials (see Section 10 of the SDS). 8. Exposure controls/personal protection Occupational exposure limits US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000) Components Type Value Oil, Mineral (CAS 8012-95-1) US. ACGIH Threshold Limit Values Components PEL 5 mg/m3 Mist. Type Value Oil, Mineral (CAS 8012-95-1) US. NIOSH: Pocket Guide to Chemical Hazards Components Type TWA 5 mg/m3 Inhalable fraction. Value Oil, Mineral (CAS 8012-95-1) Biological limit values STEL 10 mg/m3 Mist. TWA 5 mg/m3 Mist. biological exposure limits noted for the ingredient(s). 2 / 6
Appropriate engineering controls Provide adequate ventilation. Individual protection measures, such as personal protective equipment Eye/face protection Wear safety glasses with side shields (or goggles). Skin protection Hand protection Other Respiratory protection Thermal hazards General hygiene considerations Wear protective gloves. Wear suitable protective clothing. In case of insufficient ventilation, wear suitable respiratory equipment. Wear appropriate thermal protective clothing, when necessary. Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. 9. Physical and chemical properties Appearance Odor Physical state Color Odor threshold ph Melting point/freezing point Initial boiling point and boiling range Flash point Evaporation rate Flammability (solid, gas) Liquid. Liquid. Amber Odorless. 500 F (260 C) estimated 275.0 F (135.0 C) estimated Upper/lower flammability or explosive limits Flammability limit - lower (%) Flammability limit - upper (%) Explosive limit - lower (%) Explosive limit - upper (%) Vapor pressure Vapor density Relative density Solubility(ies) Solubility (water) Partition coefficient (n-octanol/water) Auto-ignition temperature Decomposition temperature Viscosity 0.85 (20 C) Insoluble 500 F (260 C) estimated 10. Stability and reactivity Reactivity Chemical stability Possibility of hazardous reactions Conditions to avoid Incompatible materials The product is stable and non-reactive under normal conditions of use, storage and transport. Material is stable under normal conditions. Hazardous polymerization does not occur. Heat, flames and sparks. Strong oxidizing agents. 3 / 6
Hazardous decomposition products Irritating and/or toxic fumes and gases may be emitted upon the product's decomposition. Carbon oxides. 11. Toxicological information Information on likely routes of exposure Inhalation May cause irritation to the respiratory system. Skin contact Eye contact Ingestion Symptoms related to the physical, chemical and toxicological characteristics Information on toxicological effects Acute toxicity Skin corrosion/irritation Serious eye damage/eye irritation Respiratory or skin sensitization Respiratory sensitization Skin sensitization Germ cell mutagenicity Carcinogenicity Irritating to skin. May be irritating to eyes. May be harmful if swallowed and enters airways. May be irritating to the skin. May be irritating to eyes. OSHA Specifically Regulated Substances (29 CFR 1910.1001-1050) Reproductive toxicity Specific target organ toxicity - single exposure Specific target organ toxicity - repeated exposure Aspiration hazard 12. Ecological information Ecotoxicity Persistence and degradability Bioaccumulative potential Mobility in soil Other adverse effects 13. Disposal considerations Disposal instructions Hazardous waste code Waste from residues / unused products Contaminated packaging 14. Transport information DOT t regulated as dangerous goods. IATA t regulated as dangerous goods. IMDG t regulated as dangerous goods. May be fatal if swallowed and enters airways. ecotoxicity data noted for the ingredient(s). data is available on the degradability of this product. data available. data available. other adverse environmental effects (e.g. ozone depletion, photochemical ozone creation potential, endocrine disruption, global warming potential) are expected from this component. Dispose of contents/container in accordance with local/regional/national/international regulations. The waste code should be assigned in discussion between the user, the producer and the waste disposal company. Dispose of in accordance with local regulations. Empty containers should be taken to an approved waste handling site for recycling or disposal. 4 / 6
Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code t established. 15. Regulatory information US federal regulations This product is a "Hazardous Chemical" as defined by the OSHA Hazard Communication Standard, 29 CFR 1910.1200. TSCA Section 12(b) Export tification (40 CFR 707, Subpt. D) CERCLA Hazardous Substance List (40 CFR 302.4) SARA 304 Emergency release notification OSHA Specifically Regulated Substances (29 CFR 1910.1001-1050) Superfund Amendments and Reauthorization Act of 1986 (SARA) Hazard categories Immediate Hazard - Delayed Hazard - Fire Hazard - Pressure Hazard - Reactivity Hazard - SARA 302 Extremely hazardous substance SARA 311/312 Hazardous chemical SARA 313 (TRI reporting) Other federal regulations Clean Air Act (CAA) Section 112 Hazardous Air Pollutants (HAPs) List Clean Air Act (CAA) Section 112(r) Accidental Release Prevention (40 CFR 68.130) Safe Drinking Water Act (SDWA) US state regulations US. California Controlled Substances. CA Department of Justice (California Health and Safety Code Section 11100) US. Massachusetts RTK - Substance List Oil, Mineral (CAS 8012-95-1) US. New Jersey Worker and Community Right-to-Know Act Oil, Mineral (CAS 8012-95-1) US. Pennsylvania Worker and Community Right-to-Know Law Oil, Mineral (CAS 8012-95-1) US. Rhode Island RTK US. California Proposition 65 California Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65): This material is not known to contain any chemicals currently listed as carcinogens or reproductive toxins. International Inventories Country(s) or region Inventory name On inventory (yes/no)* Australia Australian Inventory of Chemical Substances (AICS) Canada Canada China Domestic Substances List (DSL) n-domestic Substances List (NDSL) Inventory of Existing Chemical Substances in China (IECSC) 5 / 6
Country(s) or region Inventory name On inventory (yes/no)* Europe European Inventory of Existing Commercial Chemical Substances (EINECS) Europe Japan Korea New Zealand Philippines United States & Puerto Rico European List of tified Chemical Substances (ELINCS) Inventory of Existing and New Chemical Substances (ENCS) Existing Chemicals List (ECL) New Zealand Inventory Philippine Inventory of Chemicals and Chemical Substances (PICCS) Toxic Substances Control Act (TSCA) Inventory *A "" indicates that all components of this product comply with the inventory requirements administered by the governing country(s) A "" indicates that one or more components of the product are not listed or exempt from listing on the inventory administered by the governing country(s). 16. Other information, including date of preparation or last revision Issue date 11-20-2014 Version # 01 HMIS ratings Health: 0 Flammability: 1 Physical hazard: 0 "*" Represents a chronic hazard. NFPA ratings Health: 0 Flammability: 1 Instability: 0 Disclaimer Supplier cannot anticipate all conditions under which this information and its product, or the products of other manufacturers in combination with its product, may be used. It is the user s responsibility to ensure safe conditions for handling, storage and disposal of the product, and to assume liability for loss, injury, damage or expense due to improper use. The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text. 6 / 6