Material Safety Data Sheet Zinc Plus Hazards identified or described in this document only apply in case of exposure to dust, fumes or particles of the composing chemical or chemicals of this product generated through specific treatments or manipulations such as polishing, welding, heat treatment etc. Section 1. Chemical product and company identification Common name Material uses IPDS Code Validation date Zinc Plus Industrial applications Sheets for building applications. 831739 6 / 2 / 25 United States In case of emergency Emergency telephone number North America 185677455 Emergency telephone number IPDS Umicore 11 32 2 227726 Supplier Umicore Building Products USA Inc. Magnolia Bldg Ste 11 312 Highwoods Boulevard 2764 Raleigh, NC US USA Phone +1 9198747171 Section 2. Composition, Information on Ingredients Name CAS # % by weight Exposure limits Zinc 744666 >99 OSHA PEL (United States). TWA 15 mg/m 3 8 hour(s). Form Total dust ACGIH TLV (United States, 1/25). TWA 1 mg/m 3 8 hour(s). Form Particulates (Insoluble) Not Otherwise Specified (PNOS) Section 3. Hazards identification Remarks Hazards identified or described in this document only apply in case of exposure to dust, fumes or particles of the composing chemical or chemicals of this product generated through specific treatments or manipulations such as polishing, welding, heat treatment etc. Physical State Solid. and Appearance Emergency overview No specific hazard. Routes of entry Potential acute health effects Eyes No known significant effects or critical hazards. Skin No known significant effects or critical hazards. Inhalation No known significant effects or critical hazards. Ingestion No known significant effects or critical hazards. Date of issue 2/6/25. BP Version 1 commercial Page 1/7
Zinc Plus IPDS Code 831739 Potential chronic health effects CARCINOGENIC EFFECTS MUTAGENIC EFFECTS TERATOGENIC EFFECTS See toxicological Information (section 11) Section 4. First aid measures If risk of exposure to dust or fumes exists Eye Contact Skin Contact Inhalation In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention if irritation occurs. In case of contact, immediately flush skin with plenty of water. Remove contaminated clothing and shoes. Wash clothing before reuse. Thoroughly clean shoes before reuse. Get medical attention. If inhaled, remove to fresh air. If breathing is difficult, give oxygen. If not breathing, give artificial respiration. Get medical attention. Ingestion Do NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. Get medical attention if symptoms appear. Section 5. Fire fighting measures Flammability of the product Autoignition Temperature Flash Points Flammable limits Products of combustion Fire hazards in presence of various substances Explosion hazards in presence of various substances Fire fighting media and instructions Special protective equipment for firefighters on fire hazards on explosion hazards Nonflammable. Not considered as a product presenting risks of explosion. Use an extinguishing agent suitable for surrounding fires. No specific hazard. See section 11 for more detailed information on health effects and symptoms. Fire fighters should wear appropriate protective equipment and selfcontained breathing apparatus (SCBA) with a full facepiece operated in positive pressure mode. Date of issue 2/6/25. BP Version 1 commercial Page 2/7
Zinc Plus IPDS Code 831739 Section 6. Accidental release measures Personal precautions Environmental precautions Methods for cleaning up Immediately contact emergency personnel. Keep unnecessary personnel away. Use suitable protective equipment (Section 8). Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. If emergency personnel are unavailable vacuum or carefully scoop up spilled materials and place in an appropriate container for disposal. Avoid creating dusty conditions and prevent wind dispersal. Section 7. Handling and storage Handling Avoid exposure. Use suitable protective equipment (Section 8). Avoid generation of dust. Storage This material is delivered without packaging as solid material. No packaging requirements applicable. Section 8. Exposure Controls, Personal Protection Engineering controls Personal protection Eyes Skin protection / Hand protection Respiratory Personal protective equipment (Pictograms) Use process enclosures, local exhaust ventilation, or other engineering controls to keep airborne levels below recommended exposure limits. If user operations generate dust, fume or mist, use ventilation to keep exposure to airborne contaminants below the exposure limit. Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists or dusts. Chemicalresistant, impervious gloves or gauntlets complying with an approved standard should be worn at all times when handling chemical products if a risk assessment indicates this is necessary. Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Body Recommended Gloves Use cotton or leather gloves. Use a properly fitted, particulate filter respirator complying with an approved standard if a risk assessment indicates this is necessary.respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. Personal Splash goggles. Full suit. Boots. Gloves. Suggested protective clothing might not be protection in sufficient; consult a specialist BEFORE handling this product. case of a large spill Product Name Exposure limits Zinc OSHA PEL (United States). Notes Applicable to dust without specific effect. TWA 15 mg/m 3 8 hour(s). Form Total dust ACGIH TLV (United States, 1/25). TWA 1 mg/m 3 8 hour(s). Form Particulates (Insoluble) Not Otherwise Specified (PNOS) Consult local authorities for acceptable exposure limits. Hygiene measures Date of issue 2/6/25. BP Version 1 commercial Page 3/7
Zinc Plus IPDS Code 831739 General information Section 9. Physical and chemical properties Physical State and Appearance Color Odor Taste Molecular Weight Molecular formula ph Boiling/condensation point Melting/freezing point Critical temperature Specific Gravity Vapor pressure Vapor density Volatility Odor threshold Evaporation rate VOC Viscosity LogKow Ionicity (in water) Dispersion properties Solubility Physical chemical comments Solid. Grey. Odorless. 96 C (1662.8 F) 42 C (788 F) 7.14 (Water = 1) Insoluble in cold water. Section 1. Stability and reactivity Stability and Reactivity Conditions of instability Incompatibility with various substances The product is stable. Date of issue 2/6/25. BP Version 1 commercial Page 4/7
Zinc Plus IPDS Code 831739 Section 11. Toxicological information Toxicity data Ingredient name Zinc on chronic effects on humans Specific effects Carcinogenic effects Mutagenic effects Reproduction toxicity Test Result Route Species LD5 >2 mg/kg Oral Rat LDLo 388 mg/kg Oral Duck No known significant effects or critical hazards. No known significant effects or critical hazards. No known significant effects or critical hazards. Section 12. Ecological information Ecotoxicity data Ingredient name Zinc BOD and COD Biodegradable/OECD Mobility Products of degradation on the products of biodegradation Species Period Result Daphnia magna (EC5) Pimephales promelas (LC5) Oncorhynchus mykiss (LC5) Oncorhynchus mykiss (LC5) Oncorhynchus mykiss (LC5) Daphnia magna (LC5) 48 hour(s) 2.8 mg/l.238 mg/l.24 mg/l.41 mg/l.56 mg/l.57 mg/l Some metallic oxides. Section 13. Disposal considerations Waste disposal Waste stream The generation of waste should be avoided or minimized wherever possible. Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. Disposal of this product, solutions and any byproducts should at all times comply with the requirements of environmental protection and waste disposal legislation and any regional local authority requirements. This product is recyclable. Consideration of disposal via this route should be given. Consult your local or regional authorities. Date of issue 2/6/25. BP Version 1 commercial Page 5/7
Zinc Plus IPDS Code 831739 Section 14. Transport information Regulatory Information DOT Classification TDG Classification UN number Not Not Proper shipping name Class Packing group Label ADR/RID Class Not IMDG Class Not IATADGR Class Not Section 15. Regulatory information Additional information HCS Classification U.S. Federal regulations State regulations International regulations DSCL (EEC) International lists Not TSCA 8(b) inventory titanium; Copper; Zinc SARA 32/34/311/312 extremely hazardous substances No products were found. SARA 32/34 emergency planning and notification No products were found. SARA 32/34/311/312 hazardous chemicals No products were found. SARA 311/312 MSDS distribution chemical inventory hazard identification No products were found. Clean Water Act (CWA) 37 Copper Clean Water Act (CWA) 311 No products were found. Clean air act (CAA) 112 accidental release prevention No products were found. Clean air act (CAA) 112 regulated flammable substances No products were found. Clean air act (CAA) 112 regulated toxic substances No products were found. Pennsylvania RTK Copper (environmental hazard, generic environmental hazard) Massachusetts RTK Copper New Jersey titanium; Copper WARNING This product contains chemical(s) known to the State of California to cause reproductive harm (female) No products were found. This product is not classified according to the EU regulations. Australia (NICNAS) titanium; Copper; Zinc China titanium; Copper; Zinc Germany water class titanium; Zinc Korea (TCCL) titanium; Copper; Zinc WHMIS (Canada) Philippines (RA6969) titanium; Copper; Zinc CEPA DSL titanium; Copper; Zinc Not controlled under WHMIS (Canada). Date of issue 2/6/25. BP Version 1 commercial Page 6/7
Zinc Plus IPDS Code 831739 Section 16. Other information Hazardous Material Information System (U.S.A.) References Date of issue Date of previous issue Version C 6 / 2 / 25 No Previous Validation National Fire Protection Association (U.S.A.) Health Fire hazard Reactivity Personal protection 1 Health Flammability Instability Special Notice to reader To the best of our knowledge, the information contained in this Material Safety Data Sheet is accurate and reliable on presently available resources. However, neither the seller nor any of its subsidiaries assumes any responsibility or liability whatsoever for the accuracy or completeness of the information contained herein. This Material Safety Data Sheet shall not constitute a guarantee for any specific product features. Final determination of suitability of this material is the sole responsibility of the user. All materials may present unknown hazards and should be used and handled with caution and following reasonable safety procedures. Consequently the buyer assumes all risks in connection with the use and handling of this material.