Technical Guide. Adhesive Tapes

Similar documents
K-FLEX. K-FLEX Tapes. for HVAC and industrial application

Pressure Sensitive Adhesives for HVAC/R, Mechanical and Metal Building Insulation. Tapes, Fasteners & Sealants Product Catalog

Mechanical Insulation for Refrigeration Systems

DSC BUILDING 1200 ALTERATIONS OCTOBER 2011 SECTION DUCT INSULATION

SECTION HVAC INSULATION

3 Adhesive Transfer Tapes with Adhesive PC

Extreme Sealing Tape

High Performance Adhesive Transfer Tapes with Adhesive 200MP

High Performance Adhesive Transfer Tapes with 3M Adhesive 200MP

TOPCOAT Restoration Specifications Fiberglass & MB Granulated Cap Sheets

SECTION EPOXY TERRAZZO

Spandrel Glass Types and Recommendations

S OZ. WOVEN POLYETHYLENE F. R. S-3 KLEAR SPAN FR S-6 18 OZ. VINYL COATED POLYESTER (VCP) INNOVATIVE SOLUTIONS PRECISION RELIABILITY

K-FLEX K-FLEX ST 74 A NEW GENERATION OF INSULATION MATERIALS

High Performance Adhesive Transfer Tapes 467MP 468MP 467MPF 468MPF 7952MP 7955MP 7962MP 7965MP 9172MP 9185MP 9667MP 9668MP

Sheet Metal Connectors, Inc.

HVAC INSULATION. A. General Requirements for Flexible Elastomeric Insulation: 3. Use pre-molded roll on pipe sizes 3.5" and below.

For More Information Visit the 3M Adhesive Transfer Tape Web Pages

Air and Vapor Barrier 3015

TEKTON Flashings and TEKTON Construction Tape

LAMINATE. Laminate Panel Systems. ABS Laminating Skins Mat: ABS Plastic Total Thickness: 1mm /.04 Wt: 3.21kg / 7.08lbs

This Design guideline contained herein includes the requirements for mechanical insulation at The University of Texas at Austin

Weatherproofing & Sealing Systems

Military Specifications

Military Specifications

Thermal Management Catalog

Silica Slit Gasket & Thermal Insulating Tape 1800 F / 982 C: InSilMax Extreme High Temperature, Heat, Flame, Molten Metal & Weld Splatter Resistant

Specialty Industrial Tapes. adhesive tape solutions...beyond the roll

Thermal Management Catalog

Scotch-Weld Metal Bonder Acrylic Adhesive DP8407NS Gray

Acrylic adhesive Non-woven fabric* Acrylic adhesive Release liner

May 8, 2017 ADDENDUM #1. IFB Resin Floor System For Highway Department Central District Building

SECTION PIPING INSULATION

ROOFS ROOFS WALLS FLOORS. Energy efficiency for constructions... Always environment-friendly...

3M Electrically Conductive Adhesive Transfer Tape 9707

BuildingName The Description of the Project P DOCUMENTS

MECHANICAL AND PHYSICAL PROPRIETIES

DATA SHEET CARBON FABRIC

SECTION HVAC DUCTS AND CASINGS

OptiLiner Banded Liner System, Thermal, Metal Building

3M Cold Shrink Silicone Rubber Connector Insulators 8440 Series

Design & Construction Standards, Revised January

FireShield System Specifications Mineral Surface Cap, Mop Granule and Torch Granule APP Cap Sheets

4411N 4411G 4412N 4412G

Application Specification:

SPECIA LT Y SEA LANT S

Trusted ICC ES DIVISION: ATLANTA, CGF PRO, ENERGYS. Look. Conformity! Evaluation. ICC-ES Evaluation

3 Scotchmate TM. Nylon Reclosable Fasteners. Technical Data December, Plainbacked Products. Products

Roofing. Carrier Membrane SA. Self-adhesive Carrier Membrane. Product Description. Tests. Product Data. Form. Storage

MAKE ROOFS LAST LONGER

LOCTITE HC AERO

AQUATITE. Also designed as: Crack/gap filler for masonry and unglazed ceramics Sealants against leaks Repairer for roof cracks and gutters

SLAB ON GRADE Insul-Joint or Expansion Joint Material as Required by A/E Specifications AquaCheck Liquid Coating 400 (Waterproofing Membrane) with Aqu

10 Steps to Save Energy in Your House

RPR Insul-Mate Sheet and Roll Jacketing

Adhesive Transfer Tapes with

Adhesive Transfer Tapes with Adhesive 200MP 467MP 468MP 467MPF 468MPF 7952MP 7955MP 7962MP 7965MP 9172MP 9185MP 9667MP 9668MP

TECH SOLUTIONS Hot Box Testing of Four Different Metal Building Roof Assemblies Determines Insulation Efficiency

DATA SHEET FLASH TAPE 1

DIVISION: THERMAL AND MOISTURE PROTECTION SECTION: THERMAL INSULATION SECTION: AIR BARRIERS REPORT HOLDER:

STANDARD FOR EXTRUDED INSULATION POWER CABLES RATED ABOVE 46 THROUGH 345 KV. Approved by AMERICAN NATIONAL STANDARDS INSTITUTE.

About VentureClad Jacketing...

TOPCOAT Restoration Specifications Structural Concrete

SPECIFICATION GUIDELINES FOR THE USE OF CRYOGEL Z ON COLD PIPING AND EQUIPMENT

AESTUVER fire-protection mastic For the AESTUVER expansion joint M

Total Window. U-Factor. Total Window U Value. Duralite can improve. Warmer window. comfortable.

1.2 Reference Standard: NOFMA - National Oak Flooring Manufacturers Association Grading Standards.

REPORT HOLDER: THE DOW CHEMICAL COMPANY 1501 LARKIN CENTER DRIVE MIDLAND, MICHIGAN EVALUATION SUBJECT:

Electrical Insulating Tapes

3 Scotchmate TM. Nylon Reclosable Fasteners. Product Selection Guide April, M Scotchmate Nylon Reclosable Fastener.

Typical Properties Specification Writers: These values are not intended for use in preparing specifications.

Typical Properties. THERMATTACH Dielectric Thickness Thermal Material Strength Carrier Color inches (mm) Impedance Features/Typical Applications (Vac)

PERM-FLEX ASSEMBLY DIRECT APPLICATION TO CEMENTITIOUS SUBSTRATES MANUFACTURERS SPECIFICATION / SECTION 09960

SECTION WINDOW FILM. Display hidden notes to specifier. (Don't know how? Click Here) Copyright ARCAT, Inc. - All rights reserved

SECTION MANUFACTURED ROOF EXPANSION JOINTS

INSTALLATION GUIDELINES for ISO-C1 POLYISOCYANURATE MECHANICAL INSULATION for LIQUEFIED NATURAL GAS (LNG) CRYOGENIC REFRIGERATION CHILLED WATER

1 of 22. SSE Industries Sdn. Bhd. PP/PET Battery Strapping Tool. Pillow Type Biscuit Packaging Machine

SECTION SLOPED TRANSLUCENT METAL SKYLIGHT SYSTEM

SECTION HVAC GRAVITY VENTILATORS

SECTION PANEL AND POST AND PYLON SIGNAGE. 1. Non-illuminated Panel and Post signs. 2. Internal illumination Pylon (Cabinet and Post) signs.

TOPCOAT System Specifications Corrugated Transite Panels

FP30112WHITE100 Heat Shrink TW Tubing 100' Spool

Section BUILDINGS, SHELTERS, ENCLOSURES

G SPECIFICATION: EXTRUDED POLYOLEFIN COATING ON STEEL GAS PIPE VOLUME: 6. REVISION: (See ) 6/17/14 5 Years

WATERPROOFING CONSTRUCTION JOINTS

Construction. S-Vap 5000E SA Self-adhesive Vapour Barrier. Product Description

***********************************************************************************

NOMEX TYPE 410 TECHNICAL DATA SHEET. Electrical properties. Please note: PERFORM WHEN THE HEAT S ON TYPICAL ELECTRICAL PROPERTIES

3 Thermally Conductive Tapes

Protech Regular 870 Radon Resisting Membrane

Originally Issued: 05/03/2013 Revised: 06/06/2016 Valid Through: 05/31/2017

1. Rubberized asphalt waterproofing membrane, reinforced. 2. Molded sheet drainage panels. 3. Insulation. 4. Plaza deck pavers.

1. Division 23 Section "Hangers and Supports for HVAC Piping and Equipment" for pipe insulation shields and protection saddles.

Double Coated Urethane Foam Tapes

Adhesive Transfer Tapes with Adhesive EK PC

SECTION Solar Control Film WINDOW FILM. Copyright ARCAT, Inc. - All rights reserved

SECTION JOINT SEALANTS PART 1 - GENERAL 1.01 RELATED DOCUMENTS

ENGINEERING COMMITTEE Interface Practices Subcommittee AMERICAN NATIONAL STANDARD. ANSI/SCTE (Formerly IPS SP 100)

SECTION COLD APPLIED RUBBER MODIFIED ASPHALT WATERPROOFING

PIPEWORK INSULATION. 14/ Page 1 of 10 Pipework Insulation Rev D

Transcription:

Technical Guide Adhesive Tapes

TECHNICAL GUIDE ADHESIVE TAPES Thank you for choosing our products Note: Technical information contained in this catalog may be changed or updated by the manufacturer without notice for the benefit of the excellence, service or presentation of the products. No liability is assumed for the use of this information.

ADHESIVE TAPES ADHESIVE TAPES The use of adhesive tapes in the air conditioning, refrigeration, heating and ventilation industries is very extensive, reason why offers the best solution with a wide selection of high quality tapes, whose application ensures satisfactory results. NOMENCLATURE KAT-(X)-(Y)-(ZZ)-(C) (C) = Color: B : Black G : Gray S : Silver (ZZ) = Length in Yards (Y) = Width in Inches (X) = Type: D : Duct Tape A : Aluminum R : Reinforced Aluminum (AT) = Product: Adhesive Tape (K) = Manufacturer : I. GREY DUCT TAPE gray adhesive tape for multiuse ducts, also known as the secret weapon of installers, is manufactured using polyethylene-laminated fabric, sensitive to pressure, and of high adhesive power. It can be used as a moisture barrier avoiding humidity entering pipes, rigid or flexible ducts, and as insulating material in general. Although there are many makes using different materials and adhesives, our product is heat resistant (up to 93 C) to be applied on steam pipes. FEATURES Appropriate for jobs requiring a strong, flexible, waterproof tape of high adhesive power Individually packed in plastic to prevent contact with dust and other pollutants Normally available in dark gray and also in black Thickness: 0.254 mm Adhesion: 62 oz/inch Tension: 32 lb/inch Feasible elongation: 16% Maximum operating temperature: 93 C T h a n k y o u f o r c h o o s i n g o u r p r o d u c t s Rev. 00 05-14

ADHESIVE TAPES I. GREY DUCT TAPE (Cont.) Width Length MODEL Metric British/American Metric British/American KAT-D225G 0,051m 2" KAT-D250G 45,72m 50 yds. Standard Color Grey (G) II. SMOOTH ALUMINUM TAPE The smooth aluminum tape is widely used: In thermal insulation works because of its reflection characteristics and heat blocking properties In cable coating as a barrier and electricity conductor In air conditioning and multiuse ducts It is an insulating tape thicker than 25 µm (1 mil) and it is impermeable to oxygen and water FEATURES Appropriate for air conditioning ducts (flexible and rigid), for insulation of cold rooms and water heaters, as ceiling joint sealant or for steam applications, among other uses Individually packed in plastic to prevent contact with dust and other pollutants Aluminum foil of 40 microns (1.7 mil) Acrylic sealing layer for higher resistance to steam and moisture Adhesion: 80 oz/inch Tension: 18 lb/inch Feasible elongation: 5% Maximum operating temperature range: -20 C to +120 C Application temperature range: +10 C to +40 C Width Length MODEL Metric British/American Metric British/American KAT-A225S 0,051m 2" KAT-A250S 45,72m 50 yds. KAT-A325S 0,076m 3" KAT-A350S 45,72m 50 yds. Standard Color T h a n k y o u f o r c h o o s i n g o u r p r o d u c t s Rev. 00 05-14

ADHESIVE TAPES III. REINFOCED ALUMINUM TAPE The aluminum-reinforced auto-adhesive tape is manufactured with an aluminum foil reinforced with a fiberglass mesh of 2x3 per square inch pattern for a higher tensile strength of the material. It can be used: In thermal insulation jobs because of its reflection characteristics and heat blocking properties In cable coating as a barrier and electricity conductor In air conditioning and multiuse ducts FEATURES Suitable for air conditioner ducts (flexible and rigid), for insulation of cold rooms and water heaters, as ceiling joint sealant or for steam applications, among other uses Individually packed in plastic to prevent contact with dust and other pollutants Aluminum foil of 35 microns (1.5 mil) Acrylic sealant layer for higher resistance to steam and moisture Adhesion: 90 oz/inch Tension: 18 lb/inch Feasible elongation: 2% Maximum operating temperature range: -30 C to +125 C Application temperature range: from +10 C to +40 C Width Length MODEL Metric British/American Metric British/American KAT-R225S 0,051m 2" KAT-R250S 45,72m 50 yds. KAT-R325S 0,076m 3" KAT-R350S 45,72m 50 yds. Standard Color INSTALLATION For a long-term effectiveness, it is recommended to use it on a clean, dry surface free of debris, dust or grease. T h a n k y o u f o r c h o o s i n g o u r p r o d u c t s Rev. 00 05-14

Notes: ADHESIVE TAPES

TECHNICAL GUIDE Thank you for choosing our products