Material Safety Data Sheet

Similar documents
Material Safety Data Sheet

MSDS Report Report in electronic version is only for client's preview and reference. For confirmative content, formal test report shall prevail.

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

Minmax Energy Technology Co.,Ltd Add: WeiHong Building, SanDong Avenue, East, HuaDu, Guangzhou, China Tel: Fax:

MATERIAL SAFETY DATA SHEET

DATE: EDITION AMENDMENT DATE OF ISSUE. A0 Initial Publish A1 Changing the Company Name A2 Updating version A3 Updating version

Material Safety Data Sheet Lithium Primary Cells and Batteries (LI Series)

Material Safety Data Sheet Lithium Primary Cells and Batteries (LI Series)

Material Safety Data Sheet

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET Lithium Polymer Rechargeable Battery

MATERIAL SAFETY DATA SHEET BAT/48071

Material Safety Data Sheet

MSDS Report. Description : Rechargeable Li-ion Battery. GS Testing. Shenzhen Data Power Technology Ltd

Material Safety Data Sheet

TOPA BATTERY MATERIAL SAFETY DATA SHEET

TOPA BATTERY MATERIAL SAFETY DATA SHEET

SECTION 1: PRODUCT AND COMPANY IDENTIFICATION

Material Safety Data Sheet

Material Safety Data Sheet Effective Page 1 of 6. Section I Chemical Product and Company Identification

Safety Data Sheets (SDSs) Emergency Tel (Within USA and Canada): CHEMTREC

Material Safety Data Sheet

Material Safety Data Sheet

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

SHENZHEN LC HI-TECH CO., LTD MATERIAL SAFETY DATA SHEET (MSDS) Date: Feb 2012 VER 1.0

Material Safety Data Sheet Lithium Primary Cells and Batteries (LFS Series)

NUMATIC LIPO BATTERY PACK 36V

MSDS. Report No.:PTC C-EN01V01 Date:Aug. 10, 2018 Page 1 of 9

Print Date: 07/10/2008 Version: 1.0 Page: 1/

MANUFACTURER: BYD(HUIZHOU) BATTERY CO., LTD. Material Safety Data Sheet. Date Prepared:

Safety Data Sheet. Models: LTC-3PN, LTC-7PN, LTC-7P, LTC-7PMP, LTC-7PMS, LTC-16M, PT-2150, PT-2175, PT-2100, PT-2200, PT-2300, HP-5134, HP-5135.

Material Safety Data Sheet

SECTION 1 IDENTIFICATION SECTION 2 HAZARD(S) SECTION 3 COMPOSITION. Ascent Battery Supply, LLC 1325 Walnut Ridge Drive Hartland, WI 53029

SAFETY DATA SHEET. Q-Pearl Solder Spheres - LF (Sn96.5/Ag3.0/Cu0.5)

SAFETY DATA SHEET. Q-Pearl Solder Spheres - LF (Sn96.5/Ag3.0/Cu0.5)

Safety Data Sheets (SDSs) Product Name: ER14250/ER14505/ER14335/ER26650 / ER34615 / ER Lithium Thionyl Chloride(Li-SOCI2, non-rechargeable)

Shenzhen Anbotek Compliance Laboratory Limited MSDS REPORT

XenoEnergy Lithium Battery

XenoEnergy Lithium Battery

XenoEnergy Lithium Battery

Document Number:TCL-098 Revision:01 page 1 of 4. Emergency Telephone Number Telephone Number for information

1. Identification. 2. Hazards Identification. Precautionary Statements Contact with molten wax may cause thermal burns. Hazard Statements None

SAFETY DATA SHEET. Beeswax. 1. Identification

LIVINGSTONE INTERNATIONAL PTY LTD 100% PROUDLY AUSTRALIAN OWNED SINCE 1984 ABN:

VIPER INTERNATIONAL Ph (269) th Ave. Gobles, MI Material Safety Data Sheet VIPER S VENOM

XenoEnergy Lithium Battery

MATERIAL SAFETY DATA SHEET

MSDS MATERIAL SAFETY DATA SHEET

1. Identification. 2. Hazards Identification. Precautionary Statements Contact with molten wax may cause thermal burns. Hazard Statements None

SAFETY DATA SHEET (SDS)

SAFETY DATA SHEET. DATE OF PREPARATION: INFORMATION TELEPHONE NUMBER: January 26, 2015 EMERGENCY TELEPHONE NUMBERS:

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEETS

Safety Data Sheet. NFPA/HMIS Rating Severe = 4; Serious = 3; Moderate = 2; Slight = 1; Minimal = 0 1. PRODUCT AND COMPANY IDENTIFICATION

MATERIAL SAFETY DATA SHEET

Safety Data Sheet Candelilla Wax (SKU: WAX02) August 2016

Material Safety Data Sheet

Revision date Identification of the Substance/Preparation and of the Company/Undertaking

MATERIAL SAFETY DATA SHEET. 1. Identification of the substance/preparation and of the company/undertaking

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET. DATE OF PREPARATION: INFORMATION TELEPHONE NUMBER: January 15, 2015 EMERGENCY TELEPHONE NUMBERS:

Safety Data Sheet Monopole, Inc.

Materials Safety Data Sheet

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Version /27/2006

MATERIAL SAFETY DATA SHEET

MSDS MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

EverGuard TPO. Material Safety Data Sheet. Updated: 12/08. Quality You Can Trust Since From North America s Largest Roofing Manufacturer

MATERIAL SAFETY DATA SHEET

H648 Page 1 Material Data Safety Sheet. Heartland Adhesives & Coatings Inc. Preparation Date:

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET MARBALEASE IMR-1 Internal Mold Release

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET

Section 2: Composition / Information on Ingredients Principle Component(s) (chemical and common name(s)) (Cas. No) % OSHA PEL mg/m3

COMPONENTS PERCENT OSHA ACGIH OTHER LIMITS CAS NUMBER Hazardous Components PEL TLV 1% or greater Carcinogens 0.01 % or greater

SHENZHEN GREPOW BATTERY CO.,LTD.

Scott s Liquid Gold Wood Cleaner & Preservative (Aerosol) or consult local poison control center immediately

Gold ( ) 70 ND ND No No No Toluene ( ) NE 100 ppm 100 ppm No No No Arcosolve PM ( ) NE 100 ppm 100 ppm No No No.

SAFETY DATA SHEET. #358NVOC Liquid Flux. MANUFACTURER 24 HR. EMERGENCY TELEPHONE NUMBERS Qualitek International, Inc.

Issue Date Revision date Revision Number Identification of the Substance/Preparation and of the Company/Undertaking

Sodium Silicate, 42 Be'

SAFETY DATA SHEET. Chemical Family : Mixture Synonyms: LFP Battery, Lithium Iron Phosphate Battery 24-Hour Emergency: Chemtrec:

Issue Date Revision date Revision Number Identification of the Substance/Preparation and of the Company/Undertaking

Safety Data Sheet Monopole, Inc.

1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING

1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING

Transcription:

Section 1. Product Identification PRODUCT NAME: 3.6V Lithium Battery PRODUCT CODE: LIR2450 Section 2 Composition/Information on Ingredient Section 3 - Hazards Identification Health Hazards (Acute and Chronic) These chemicals are contained in a sealed can. Risk of exposure occurs only if the battery is mechanically or electrically abused. Contact of electrolyte and extruded lithium with skin and eyes should be avoided. Sign/Symptoms of Exposure A shorted lithium battery can cause thermal and chemical burns upon contact with the skin. May be a reproductive hazard. Note If lithium hexafluorophosphate leaked in the industrial condition, it may cause skin burns. MSDS-044.doc 1 of 7 NA = Not Applicable NE = Not Established UN =

Section 4 - First Aid Measures Eye Flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid. Skin Remove contaminated clothes and rinse skin with plenty of water or shower for 15 minutes. Get medical aid. Inhalation Remove from exposure and move to fresh air immediately. Use oxygen if available. Ingestion Give at least 2 glasses of milk or water. Induce vomiting unless patient is unconscious. Call a physician. Section 5 - Fire Fighting Measures Flash Point: N/A. Auto-Ignition Temperature: N/A. Extinguishing Media Dry chemical, CO2. Special Fire-Fighting Procedures Self-contained breathing apparatus. Unusual Fire and Explosion Hazards Cell may vent when subjected to excessive heat-exposing battery contents. Hazardous Combustion Products Carbon monoxide, carbon dioxide, lithium oxide fumes. MSDS-044.doc 2 of 7 NA = Not Applicable NE = Not Established UN =

Section 6 - Accidental Release Measures Steps to be Taken in case Material is Released or Spilled If the battery material is released, remove personnel from area until fumes dissipate. Provide maximum ventilation to clear out hazardous gases. Wipe it up with a cloth, and dispose of it in a plastic bag and put into a steel can. The preferred response is to leave the area and allow the batteries to cool and vapors to dissipate. Provide maximum ventilation. Avoid skin and eye contact or inhalation of vapors. Remove spilled liquid with absorbent and incinerate. Waste Disposal Method It is recommended to discharge the battery to the end, handing in the abandoned batteries to related department unified, dispose of the batteries in accordance with approved local, state, and federal requirements. Consult state environmental protection agency and/or federal EPA. Section 7 - Handling and Storage The batteries should not be opened, destroyed or incinerate, since they may leak or rupture and release to the environment the ingredients that they contain in the hermetically sealed container. Do not short circuit terminals, or over charge the battery, forced over-discharge, throw to fire. Do not crush or puncture the battery, or immerse in liquids. Precautions to be taken in handling and storing Avoid mechanical or electrical abuse. Storage preferably in cool, dry and ventilated area, which is subject to little temperature change. Storage at high temperatures should be avoided. Do not place the battery near heating equipment, nor expose to direct sunlight for long periods. Other Precautions Batteries may explode or cause burns, if disassembled, crushed or exposed to fire or high temperatures. Do not short or install with incorrect polarity. MSDS-044.doc 3 of 7 NA = Not Applicable NE = Not Established UN =

Section 8 - Exposure Controls, Personal Protection Respiratory Protection In case of battery venting, provide as much ventilation as possible. Avoid confined areas with venting batteries. Respiratory Protection is not necessary under conditions of normal use. Ventilation Not necessary under conditions of normal use. Protective Gloves Not necessary under conditions of normal use. Other Protective Clothing or Equipment Not necessary under conditions of normal use. Personal Protection is recommended for venting batteries: Respiratory Protection, Protective Gloves, Protective Clothing and safety glass with side shields. Section 9 - Physical and Chemical Properties Nominal Voltage: 3.6V. Rated Capacity:110mAh. Appearance Characters: Silver, circular, with odorless solid battery. Section 10 - Stability and Reactivity Stability Stable Conditions to Avoid Heating, mechanical abuse and electrical abuse. Hazardous Decomposition Products N/A. Hazardous Polymerization MSDS-044.doc 4 of 7 NA = Not Applicable NE = Not Established UN =

N/A. If leaked, forbidden to contact with strong oxidizers, mineral acids, strong alkalis, halogenated hydrocarbons. Section 11 - Toxicological Information Inhalation, skin contact and eye contact are possible when the battery is opened. Exposure to internal contents, the corrosive fumes will be very irritation to skin, eyes and mucous membranes. Overexposure can cause symptoms of non-fibrotic lung injury and membrane irritation. Section 12 - Ecological Information When promptly used or disposed the battery does not present environmental hazard. When disposed, keep away from water, rain and snow. Section 13 - Disposal Considerations APPROPRIATE METHOD OF DISPOSAL OF SUBSTANCE OR PREPARATION If batteries are still fully charged or only partially discharged, they can be considered a reactive hazardous waste because of significant amount of uncreated, or unconsumed lithium remaining in the spent battery. The batteries must be neutralized through an approved secondary treatment facility prior to disposal as a hazardous waste. Recycling of battery can be done in authorized facility, through licensed waste carrier. MSDS-044.doc 5 of 7 NA = Not Applicable NE = Not Established UN =

Section 14 - Transport Information According to PACKING INSTRUCTION 965 ~ 967 of IATA DGR 53 rd Edition for transportation, or the special provision 188 of IMDG, or the Recommendations on the Transport of Dangerous Goods Model Regulations. More information concerning shipping, testing, marking and packaging can be obtained from Label master at http://www.labelmaster.com. Separate Lithium-ion batteries when shipping to prevent short-circuiting. They should be packed in strong packaging for support during transport. Take in a cargo of them without falling, dropping, and breakage. Prevent collapse of cargo piles and wet by rain. Transport Fashion: By air, by sea, by road. Section 15 - Regulatory Information Law Information Dangerous Goods Regulation Recommendations on the Transport of Dangerous Goods Model Regulations International Maritime Dangerous Goods Technical Instructions for the Safe Transport of Dangerous Goods Classification and code of dangerous goods Occupational Safety and Health Act (OSHA) Toxic Substances Control Act (TSCA) Consumer Product Safety Act (CPSA) Federal Environmental Pollution Control Act (FEPCA) The Oil Pollution Act (OPA) Superfund Amendments and Reauthorization Act Title III (302/311/312/313) (SARA) MSDS-044.doc 6 of 7 NA = Not Applicable NE = Not Established UN =

Resource Conservation and Recovery Act (RCRA) Safety Drinking Water Act (CWA) California Proposition 65 Code of Federal Regulations (CFR) In accordance with all Federal, State and Local laws. Section 16 - Additional Information MANUFACTURER DISCLAIMER: The information contained herein is based upon data considered to be accurate and is offered solely for information, customer consideration and investigation. The manufacturer extends no warranties, makes no representations and assumes no responsibility as to the accuracy, completeness or suitability of this data for any purchaser's use. The content of this relates only to this product as sold and does not relate to use with any other material or in any process. All chemical products should be used only by, or under, the direction of technically qualified personnel, who are aware of the hazards involved and of the necessity for reasonable care in handling. Hazard communication, United States Occupational Safety and Health (OSHA) and Canadian Workplace Hazardous Materials Information System (WHMIS) regulations require that employees must be trained in the use of s as a source of hazards information and response. MSDS-044.doc 7 of 7 NA = Not Applicable NE = Not Established UN =