Material Safety Data Sheet

Similar documents
MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

Material Safety Data Sheet

Material Safety Data Sheet

Material Safety Data Sheet

Material Safety Data Sheet

Material Safety Data Sheet

Material Safety Data Sheet

Material Safety Data Sheet

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

Material Safety Data Sheet

TRISOTECH G ROOF INSULATION 1.0" Version 2. Print Date 10/16/2008 REVISION DATE: 10/15/2008

: NON-SLIP AGGREGATE - 50 LB BAG

M A T E R I A L S A F E T Y D A T A S H E E T PHONE: CHEMTREC 24-HOUR PHONE: COMPOSITION/INFORMATION ON INGREDIENTS

Aggravated Medical Conditions Pre-existing eye, skin and respiratory disorders may be aggravated by exposure.

: HORIZON PANEL 2 3/8" 4X8

MATERIAL SAFETY DATA SHEET MIST-N-SHINE PROFESSIONAL DETAILER MSDS DATE: 1/4/2006

Inhalation. Irritant Moderate irritant Could cause nausea, vomiting or diarreah. Moderate Irritant N/A N/A N/A N/A None known

MATERIAL SAFETY DATA SHEET

TopCoat CRT White. Material Safety Data Sheet. Updated: 12/08. Quality You Can Trust Since From North America s Largest Roofing Manufacturer

MATERIAL SAFETY DATA SHEET

HEY'DI POWDER X Version 1. Print Date 07/13/2007 REVISION DATE: 09/12/2006

The Valspar Corporation Material Safety Data Sheet

Version /27/2006

: POLYESTER MAT CP. (40"X 324') 40" RL

TPO 45 MIL FLEECE BACK 76" X 90' Version 1. Print Date 01/29/2009 REVISION DATE: 01/31/2008

1. Chemical Product and Company Identification. 2. Hazardous Ingredients. 3. Hazards Identification

1. Chemical Product and Company Identification. 2. Hazardous Ingredients. 3. Hazards Identification

MATERIAL SAFETY DATA SHEET

MATERIAL SAFTEY DATA SHEET

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET MSDS DATE: 7/5/11

MATERIAL SAFETY DATA SHEET FILE NO.: 640 NAME OF PRODUCT MSDS DATE: 2/24/12

: TPA WALKWAY ROLL-GRAY 3' x 60' 72 mil

M A T E R I A L S A F E T Y D A T A S H E E T

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET 16 Sections

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET FILE NO.: 682 FOAMING INSTANT HAND SANITIZER, ALCOHOL FREE MSDS DATE: 12/3/12

Version 4.0 Print Date 07/09/2012 REVISION DATE: 07/08/2012

Version 3.0 Print Date 12/19/2013 REVISION DATE: 07/08/2012

Safety Data Sheet Revision Date: 05/28/2015

1. COMPANY AND PRODUCT IDENTIFICATION 2. HAZARDS IDENTIFICATION

: EUCON LR - BULK GALLONS

MATERIAL SAFETY DATA SHEET FILE NO.: 679 NAME OF PRODUCT MSDS DATE: 7/2/12

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

1770 Joyce Avenue (614) Columbus, OH MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET SHINE MASTER POLISH & SEALANT MSDS DATE: 01/04/2006

SAFETY DATA SHEET. Chemical Name Wt.% CAS Dimethyl siloxane, hydroxy-terminated Silicon dioxide

: MULSEAL 52 GAL DRUM

Item No: Item Desc: Shared MSDS s (Item No): MSDS Origin

: CONCRETE BLASTER - 55 GAL DRUM

MATERIAL SAFETY DATA SHEET MSDS DATE: 1/5/10

MATERIAL SAFETY DATA SHEET

1. COMPANY AND PRODUCT IDENTIFICATION 2. HAZARDS IDENTIFICATION

SAFETY DATA SHEET. ERSystems Fabric Faced Butyl Tape. MANUFACTURER 24 HR. EMERGENCY TELEPHONE NUMBERS ITW Polymers Sealants North America

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet HOCUT 797-HM

txt PRODUCT IDENTIFIER: DRICON(R*) FIRE RETARDANT TREATED WOOD AND LUMBER

*MATERIAL SAFETY DATA SHEET*

MATERIAL SAFETY DATA SHEET

The Valspar Corporation Material Safety Data Sheet

Product Description. Hazard Identification. First Aid Measures. Firefighting Procedures. Spill or Leak Procedures. Handling and Storage

Version /28/2006

MATERIAL SAFETY DATA SHEET

Safety Data Sheet. Section 1 - Product and Company Identification

SAFETY DATA SHEET. identifiers. Description of necessary measures, subdivided according to the different routes of exposure, i.e.

Material Safety Data Sheet February 13, 2015

: POWERPLY SA FIRE RATED SQ ROLL

VIPER INTERNATIONAL Ph (269) th Ave. Gobles, MI Material Safety Data Sheet VIPER S VENOM

SAFETY DATA SHEET. Chemical Name Wt.% CAS Dimethyl siloxane, hydroxy-terminated Silicon dioxide

SAFETY DATA SHEET Product #: F000352

SAFETY DATA SHEET Page 1 of 6 All-Clean

ADDENDUM TO SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET MSDS DATE: 7/31/2010 POWER CLEAN ALL-PURPOSE CLEANER

SAFETY DATA SHEET. identifiers

SECTION 1: PRODUCT AND COMPANY IDENTIFICATION

1. COMPANY AND PRODUCT IDENTIFICATION 2. HAZARDS IDENTIFICATION

Safety Data Sheet. Section 1 - Product and Company Identification

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

1. PRODUCT AND COMPANY IDENTIFICATION 2. HAZARDS IDENTIFICATION 3. COMPOSITION/INFORMATION ON INGREDIENTS Product Identifier:

SAFETY DATA SHEET 100X EDTA Solution

Transcription:

Material Safety Data Sheet Section 1 General Information Manufacturer: HMIS Rating William Zinsser and Company, Inc. HEALTH: 1 173 Belmont Drive FLAMMABILITY: 0 Somerset, NJ 08875 REACTIVITY: 0 (732) 469-8100 Emergency Telephone: Chemtrec (800) 424-9300 Date: 5/16/01 Product Name: Bondex Skid-Tex ST-30 Product Codes: 22242 Section 2 Hazardous Ingredients OSHA ACGIH Hazardous Component CAS# PEL TLV Pumice 1332-09-8 15 mg/m 3 * 5 mg/m 3 ** 3 mg/m 3 Quartz 14808-60-7 0.1 mg/m 3 ** 0.1 mg/m 3 ** * Total Dust ** Respirable Dust Fraction Section 3 Hazard Identification Primary Routes of Exposure: Inhalation Skin Contact Eye Contact Potential Acute Health Effects: Eye: Skin: Ingestion: Inhalation: tract. Dust may cause eye irritation. Prolonged exposure may cause skin irritation. May cause gastrointestinal distress and nausea. Avoid breathing dust. Dust may be irritating to the nose, throat, and respiratory Potential Chronic Health Effects: None known. Page 1 of 6 pages.

(See also Sections 4, 8, and 11 for related information) Section 4 First Aid Measures Eye contact: Skin contact: Ingestion: Flush eyes with water for at least 15 minutes. Wash with soap and water. Call a physician or poison control center. Inhalation: No specific treatment is necessary since this material is not likely to be hazardous by inhalation. If exposed to excessive levels of dust remove to fresh air and get medical attention if cough or other symptoms develop. Note to Physician: Treat symptomatically. This material is basically non-toxic. Ingestion of a small quantity (approx. one tablespoon) is unlikely to cause harm. Section 5 Flash Point (method): Fire Fighting Measures N/A Extinguishing Media: Use alcohol foam, carbon dioxide, or water spray when fighting fires involving this material. Protection of Firefighters: As in any fire, wear NIOSH approved self-contained breathing apparatus pressure-demand and full protective gear. Section 6 Personal Precautions: Accidental Release Measures Avoid breathing dust. Clean Up Methods: Transfer into recovery drums. Dispose of in accordance with federal, state, local, regulations. (See also Section 8 for information on Exposure Controls and Personal Protective Equipment) Section 7 Handling and Storage Handling: Use with adequate ventilation. Avoid prolonged or repeated contact with eyes, skin, and clothing. Storage: Protect container against physical damage. Page 2 of 6 pages.

Section 8 Exposure Controls / Personal Protection Engineering Controls: Good general ventilation should be sufficient to control airborne levels. Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne dust levels below recommended exposure limits. Personal Protective Equipment (PPE): Eye Protection: Skin Protection: Safety glasses or goggles. Wear gloves to prevent prolonged skin contact. Respiratory Protection: None needed under normally anticipated use conditions. If dust levels exceed allowable exposure limits, wear a NIOSH approved respirator with P-100 filters. General Hygiene Practices: hands before eating and drinking. Avoid eye and skin contact. Avoid breathing dust. Wash Section 9 Physical Data Appearance: White granular solid Odor: None. Physical State: solid ph: N/A Boiling Point: N/A Melting Point: N/A Odor Threshold: N/D Viscosity: N/A Solubility in Water: N/D Specific Gravity (water = 1): N/D Section 10 Stability and Reactivity Stability: Stable, non-reactive. Hazardous Polymerization: Will not occur. Hazardous Decomposition Products: None known. Section 11 Toxicological Information Carcinocenicity: This material is not considered a carcinogen by IARC or NTP and is not regulated as a carcinogen by OSHA. (See also Section 15 for related information) Page 3 of 6 pages.

Section 12 Ecological Information Chemical Fate and Effects: No data available. Section 13 Disposal Considerations Recommended Waste Disposal Method: This material is not considered hazardous waste under Federal Hazardous Waste Regulations (40CFR 261). However, state and local requirements for waste disposal may be more restrictive or otherwise differ from federal regulations. Chemical additions, processing or otherwise altering this material may render the waste management information presented in this MSDS incomplete, inaccurate or otherwise inappropriate. Consult all applicable federal, state, and local regulations regarding the proper disposal of this material. Section 14 Transportation Information Regulated by the US DOT: No. This product is not considered a hazardous material by DOT. Freight Classification: Section 15 Paint Additive Regulatory Information CERCLA: The Comprehensive Environmental Response Compensation and Liability Act of 1980 (CERCLA) requires notification to the National Response Center for releases of quantities of Hazardous Substances equal to or greater than the reportable quantities (RQs) in 40 CFR 302.4 (for CERCLA 102). Components present in this product at a level which could require reporting under the statute are: Chemical Name CAS# Maximum Concentration (Wt. %) None N/A N/A SARA Title III, section 311/312: The Superfund Amendments and Reauthorization Act of 1986 (SARA) Title III requires emergency planning based on Threshold Planning Quantities (TPQs) and release reporting based on Reportable Quantities (RQs) in 40 CFR 355 (used for SARA 302, 304, 311 and 312). Components present in this product at a level which could require reporting under the statute are: Chemical Name CAS# Maximum Concentration (Wt. %) None N/A N/A SARA Title III, section 313: Page 4 of 6 pages.

The Superfund Amendments and Reauthorization Act of 1986 (SARA) Title III requires submission of annual reports of release of toxic chemicals that appear in 40 CFR 372 (for SARA 313). Components present in this product at a level which could require reporting under the statute are: Chemical Name CAS# Maximum Concentration (Wt. %) None N/A N/A TSCA: The components of this mixture are listed in the Toxic Substance Control Act Inventory of Chemical Substances. This product does not contain any chemicals that require export notification under Section 12(b) of the TSCA regulation. Section 16 Other Information Legend: N/A: Not Applicable N/D: Not Determined N/E: Not Established N/R: Not Required STEL: Short Term Exposure Limit C: OSHA Ceiling Value cps: Centipoise mg/m 3 : milligrams per cubic meter mppcf: million particles per cubic foot of air. PPM: Parts Per Million PPB: Parts Per Billion PEL: Permissible Exposure Limit TLV: Threshold Limit Value TWA: Time Weighted Average ACGIH: American Conference of Governmental Industrial Hygienists CPSC: Consumer Product Safety Commission DOT: US Department of Transportation FHSA: Federal Hazardous Substance Act OSHA: Occupational Safety and Health Administration (US Dept. of Labor) RCRA: Resource Conservation and Recovery Act SARA: Superfund Amendment and Reauthorization Act Skin: This substance has the potential to be absorbed systemically through the skin. TSCA: Toxic Substance Control Act HMIS Key 4 = Severe Hazard 3 = Serious Hazard 2 = Moderate Hazard 1 = Slight Hazard 0 = Minimal Hazard Prepared By: Zinsser Health and Safety Manager, Regulatory Compliance Dept. Page 5 of 6 pages.

173 Belmont Drive Somerset, NJ 08875 (732) 469-8100 Disclaimer: William Zinsser Company, Inc. believes, to the best of its knowledge, information and belief, the information contained herein to be accurate and reliable as of the date of this material safety data sheet. However, because the conditions of handling, use, and storage of these materials are beyond our control, we assume no responsibility or liability for personal injury or property damage incurred by the use of these materials and make no warranty, expressed or implied, regarding the accuracy or reliability of the data or results obtained from their use. All materials may present unknown hazards and should be used with caution. The information and recommendations in this material safety data sheet are offered for the users consideration and examination. It is the responsibility of the user to determine the final suitability of this information and data and to comply with all applicable international, federal, state, and local laws and regulations. Page 6 of 6 pages.