Asset management Management systems Requirements

Similar documents
Asset management Overview, principles and terminology

Technical Specification

AS/NZS ISO 9004:2011 Managing for the sustained success of an organization A quality management approach

Waters Examination for Legionella spp. including Legionella pneumophila

Australian Standard. Guidelines for the selection of quality management system consultants and use of their services AS ISO ISO 10019:2005

Societal security Business continuity management systems Guidance

Australian/New Zealand Standard

AS/NZS ISO 9001:2016. Quality management systems Requirements AS/NZS ISO 9001:2016. Australian/New Zealand Standard. Superseding AS/NZS ISO 9001:2008

Australian Standard. Sampling procedures for inspection by attributes

Australian/New Zealand Standard

AS/NZS ISO 9000:2000 Quality management systems Fundamentals and vocabulary

Controlled environments

AS/NZS :2016. High-strength steel fastener assemblies for structural engineering Bolts, nuts and washers AS/NZS :2016

Australian Standard. Atmospheric corrosivity zones in Australia AS AS

This is a free 15 page sample. Access the full version online. HB 90.1:2012 The Small Business Handbook Guide to ISO 9001:2008

AS Residential timber-framed construction Part 2: Non-Cyclonic Areas

AS/NZS 10002:2014. Australian/New Zealand Standard. Guidelines for complaint management in organizations AS/NZS 10002:2014

Risk management Principles and guidelines

Australian Standard. Meters for water supply. Part 4: In-service compliance testing AS AS

Australian/New Zealand Standard

Australian Standard. Design and installation of sheet roof and wall cladding. Part 3: Plastic AS AS

AS/NZS 4505:1998 AS/NZS

Australian Standard. Power transformers. Part 1.2: Minimum Energy Performance Standard (MEPS) requirements for distribution transformers

Australian Standard. Pipelines Gas and liquid petroleum. Part 0: General requirements AS AS

HB Executive Guide to Business Continuity Management. This is a free 6 page sample. Access the full version online.

Australian Standard. Metal castings. Part 1: Ferrous sand moulded AS (Incorporating Amendment No. 1) AS

Australian/New Zealand Standard

AS AS Australian Standard. Metal finishing Thermoset powder coatings

Information technology Security techniques Information security management systems Requirements

AS/NZS :2016. High-strength steel fastener assemblies for structural engineering Bolts, nuts and washers AS/NZS :2016

AS/NZS 4804:2001. Occupational health and safety management systems. General guidelines on principles, systems and supporting techniques

Australian Standard. Qualification of welders for fusion welding of steels AS AS

Australian Standard. Non-destructive testing Determination of thickness. Part 3: Use of ultrasonic testing AS AS 2452.

AS/NZS :2015

AS/NZS :2015. Scaffolding AS/NZS :2015. Part 3: Prefabricated and tube-and-coupler scaffolding. Australian/New Zealand Standard

AS/NZS 2589:2007 AS/NZS

Australian Standard. Metal finishing Thermoset powder coatings for architectural applications of aluminium and aluminium alloys AS AS 3715

Australian/New Zealand Standard

AS AS Australian Standard. Wear-resistant white cast iron. This is a free 6 page sample. Access the full version online.

AS/NZS :2014. Guide to the protection of structural steel against atmospheric corrosion by the use of protective coatings AS/NZS 2312.

Australian/New Zealand Standard

AS/NZS :2003. Structural design actions AS/NZS :2003. Part 3: Snow and ice actions. Australian/New Zealand Standard

AS/NZS 5131:2016. Australian/New Zealand Standard. Structural steelwork Fabrication and erection AS/NZS 5131:2016

Australian/New Zealand Standard

AS/NZS 3010:2005 AS/NZS

Australian/New Zealand Standard

Australian/New Zealand Standard

Australian Standard. Interchange of client information AS (Incorporating Amendment No. 1) AS

Electrical installations Marinas and boats

Australian Standard. Guide to the investigation and sampling of sites with potentially contaminated soil

Australian/New Zealand Standard

Australian/New Zealand Standard

Australian/New Zealand Standard

Australian Standard. Cement mortar lining of steel pipes and fittings AS AS 1281

Australian Standard. Certification of welders and welding supervisors. AS (Incorporating Amendment No. 1) AS 1796

INTERNATIONAL STANDARD

AS/NZS 1477:2017. Australian/New Zealand Standard. PVC pipes and fittings for pressure applications. Superseding AS/NZS 1477:2006 AS/NZS 1477:2017

Australian/New Zealand Standard

Australian Standard. Electroplated coatings of rhodium for general engineering applications AS AS 2429

Australian/New Zealand Standard

Australian/New Zealand Standard

AS/NZS 3012:2003 AS/NZS

AS AS Australian Standard. Installation of nailplated timber roof trusses

Australian/New Zealand Standard

AS/NZS 2280:2012 AS/NZS

Australian/New Zealand Standard

Australian/New Zealand Standard

RISK MANAGEMENT GUIDELINES

Australian Standard. Equipment for the pasteurization of milk and other liquid dairy products Continuous-flow systems AS AS 3993

Australian Standard. Sampling procedures and charts for inspection by variables for percent nonconforming AS ISO 3951:1989

Australian/New Zealand Standard

AS/NZS :2003. Plumbing and drainage AS/NZS :2003. Australian/New Zealand Standard. Part 3: Stormwater drainage

Australian/New Zealand Standard

Australian Standard. Specification for general purpose corrugated fibreboard boxes and blanks AS

Australian/New Zealand Standard

ISO INTERNATIONAL STANDARD. Risk management Principles and guidelines. This is a free 6 page sample. Access the full version online.

AS AS Australian Standard. Chain-link fabric security fences and gates. This is a free 7 page sample. Access the full version online.

Australian/New Zealand Standard

Australian Standard. Pressure equipment Examination and testing AS Reconfirmed 2016

Standards Australia LICENCE

ISO/IEC INTERNATIONAL STANDARD. Information technology Security techniques Information security management systems Requirements

Australian Standard. Pressure vessels. AS (Incorporating Amendment Nos. 1, 2 and 3) AS 1210

LICENCE. for WEB LINKS. Check if this document is current Find similar documents StandardsWatch (info and login) Visit our website

ISO INTERNATIONAL STANDARD. Clinical investigation of medical devices for human subjects Good clinical practice

AS This is a free 6 page sample. Access the full version online. Australian Standard. Headstones and cemetery monuments

HB This is a free 12 page sample. Access the full version online. The Food Processing Industry

HB This is a free 9 page sample. Access the full version online. The Service Industry Handbook

AS/NZS :2015. Plumbing and drainage AS/NZS :2015. Part 2: Sanitary plumbing and drainage. Australian/New Zealand Standard

Information technology Security techniques Information security management systems Requirements

Australian Standard. Guide to the sampling of particulate materials. Part 1: Sampling procedures AS

Australian/New Zealand Standard

Australian Standard. Explosives Storage, transport and use. Part 1: Storage AS

ISO/TS TECHNICAL SPECIFICATION

AS Australian Standard. Piling Design and installation. This is a free 8 page sample. Access the full version online.

Australian Standard. Part 3 SEAT INDEX POINT AS /ISO EARTH-MOVING MACHINERY HUMAN DIMENSIONS

Guidelines for auditing management systems (ISO 19011:2011)

ISO/IEC TR TECHNICAL REPORT

Australian Standard. Non-destructive testing Radiography of welded butt joints in metal. Part 1: Methods of test AS

ISO/IEC INTERNATIONAL STANDARD. Conformity assessment General requirements for proficiency testing

ISO Information and documentation Management systems for records Fundamentals and vocabulary

Transcription:

ISO 55001:2014 AS ISO 55001:2014 Asset management Management systems Requirements

This Australian Standard was prepared by Committee MB-019, Asset Management. It was approved on behalf of the Council of Standards Australia on 20 October 2014. This Standard was published on 11 November 2014. The following are represented on Committee MB-019: Asset Management Council Austroads Cooperative Research Centre for Infrastructure and Engineering Asset Management CRC Mining Defence Materiel Organisation (Australian Government) Energy Networks Association Institute of Public Works Engineering Australasia National Offshore Petroleum Safety and Environmental Management Authority Professionals Australia University of Western Australia Water Services Association of Australia This Standard was issued in draft form for comment as DR AS ISO 55001:2014. Standards Australia wishes to acknowledge the participation of the expert individuals that contributed to the development of this Standard through their representation on the Committee and through the public comment period. Keeping Standards up-to-date Australian Standards are living documents that reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued. Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments that may have been published since the Standard was published. Detailed information about Australian Standards, drafts, amendments and new projects can be found by visiting www.standards.org.au Standards Australia welcomes suggestions for improvements, and encourages readers to notify us immediately of any apparent inaccuracies or ambiguities. Contact us via email at mail@standards.org.au, or write to Standards Australia, GPO Box 476, Sydney, NSW 2001.

Australian Standard Asset management Management systems Requirements First published as AS ISO 55001:2014. COPYRIGHT Standards Australia Limited All rights are reserved. No part of this work may be reproduced or copied in any form or by any means, electronic or mechanical, including photocopying, without the written permission of the publisher, unless otherwise permitted under the Copyright Act 1968. Published by SAI Global Limited under licence from Standards Australia Limited, GPO Box 476, Sydney, NSW 2001, Australia ISBN 978 1 74342 873 3

ii PREFACE This Standard was prepared by the Standards Australia Committee MB-019, Asset Management. The objective of this Standard is to specify requirements for the establishment, implementation, maintenance and improvement of a management system for asset management. This Standard should be read in conjunction with AS ISO 55000 and AS ISO 55002. This Standard is identical with, and has been reproduced from, ISO 55001:2014, Asset management Management systems Requirements. As this Standard is reproduced from an International Standard, the following applies: (a) In the source text this International Standard should read this Australian Standard. (b) A full point substitutes for a comma when referring to a decimal marker. References to International Standards should be replaced by references to Australian or Australian/New Zealand Standards, as follows: Reference to International Standard ISO 55000 Asset management Overview, principles and terminology Australian Standard AS ISO 55000 Asset management Overview, principles and terminology The term informative has been used in this Standard to define the application of the annex to which it applies. An informative annex is only for information and guidance.

AS ISO 55001:2014 Contents CONTENTS Foreword...iv Introduction v iii 1 Scope... 1 2 Normative reference... 1 3 Terms and definitions... 1 4 Context of the organization... 1 4.1 Understanding the organization and its context... 1 4.2 Understanding the needs and expectations of stakeholders... 1 4.3 Determining the scope of the asset management system... 2 4.4 Asset management system... 2 5 Leadership... 2 5.1 Leadership and commitment... 2 5.2 Policy... 3 5.3 Organizational roles, responsibilities and authorities... 3 6 Planning... 3 6.1 Actions to address risks and opportunities for the asset management system... 3 6.2 Asset management objectives and planning to achieve them... 4 7 Support... 5 7.1 Resources... 5 7.2 Competence... 5 7.3 Awareness... 6 7.4 Communication... 6 7.5 Information requirements... 6 7.6 Documented information... 7 8 Operation... 8 8.1 Operational planning and control... 8 8.2 Management of change... 8 8.3 Outsourcing... 8 9 Performance evaluation... 8 9.1 Monitoring, measurement, analysis and evaluation... 8 9.2 Internal audit... 9 9.3 Management review... 9 10 Improvement...10 10.1 Nonconformity and corrective action...10 10.2 Preventive action...10 10.3 Continual improvement...11 Annex A (informative) Information on asset management activities...12 Bibliography...13 Page iii

iv ISO 55001:2014(E) Introduction INTRODUCTION This International Standard specifies the requirements for the establishment, implementation, maintenance and improvement of a management system for asset management, referred to as an asset management system. This International Standard can be used by any organization. The organization determines to which of its assets this International Standard applies. This International Standard is primarily intended for use by: those involved in the establishment, implementation, maintenance and improvement of an asset management system; those involved in delivering asset management activities and service providers; internal and external parties to assess the organization s ability to meet legal, regulatory and contractual requirements and the organization s own requirements. The order in which requirements are presented in this International Standard does not reflect their importance or imply the order in which they are to be implemented. Further guidance regarding the application of the requirements within this International Standard is provided in ISO 55002. General information on asset management, and information on the terminology applicable to this International Standard, is provided in ISO 55000. Organizations can find that consideration of the principles will assist the development of asset management in their organization. This International Standard applies the definition of risk given in ISO 31000:2009 and ISO Guide 73:2009. In addition, it uses the term stakeholder rather than interested party. This International Standard is designed to enable an organization to align and integrate its asset management system with related management system requirements. Annex A provides additional information on areas related to asset management activities. ISO 2014 All rights reserved v

This is a free preview. Purchase the entire publication at the link below: AS ISO 55001:2014 - PDF his is a free 6 page sample. Access the full version online. Looking for additional Standards? Visit SAI Global Infostore Learn about LexConnect, All Jurisdictions, Standards referenced in Australian legislation Need to speak with a Customer Service Representative - Contact Us