MATERIAL SAFETY DATA SHEET Revision: /29/2003 Page: 1 of 6

Similar documents
MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET KEMAMIDE E ULTRA BEAD Version: 1

IRIS SAFETY DATA SHEET 1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING 2. HAZARDS IDENTIFICATION

Material Safety Data Sheet

SUPER WHITE FONOLINE Petrolatum. Sonneborn, Inc. 771 Old Saw Mill River Road Tarrytown, NY , USA

SUNISO 5GS Refrigeration Oil

1. PRODUCT AND COMPANY IDENTIFICATION. : Product Stewardship (770)

2602 FLORIDA PURPLE PEC

PETRONATE HL Sodium Sulfonate

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET Magnesium Ferrite

Material Safety Data Sheet DARAMEND Metals Amendment

Material Safety Data Sheet

1. PRODUCT AND COMPANY IDENTIFICATION

indicates trademark registered in the U.S. Outside the U.S., mark may be registered, pending or a trademark. Mark is or may be used under license.

1. PRODUCT AND COMPANY IDENTIFICATION 2. COMPOSITION/INFORMATION ON REGULATED INGREDIENTS

SAFETY DATA SHEET. Section 1 Chemical Product and Company Identification

Safety Data Sheet. * * * Section 1 - Product and Company Identification * * * * * * Section 2 Hazards Identification * * *

SonneNatural Select Jojoba Oil

SAFETY DATA SHEET Barium Sulfate

PANTONE 365U

Material Safety Data Sheet CHEMICAL PRODUCT & COMPANY IDENTIFICATION

10% Ultramarine Violet 5011

1136 DEXRON VI AUTOMATIC TRANSMISSION FLUID

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET Revision Date:

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET VESTAMID L1700 NATURAL-COLOURED

MATERIAL SAFETY DATA SHEET

Issuing Date Revision Date Revision Number IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING

SAFETY DATA SHEET.

MATERIAL SAFETY DATA SHEET

MGC ADVANCED POLYMERS, INC. SAFETY DATA SHEET Page 1 of 6

Issue Date: 28-Aug-2014 Revision Date: 09-Sep-2014 Version 1 1. IDENTIFICATION. Tapping and drilling metal.

Material Safety Data Sheet

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

TERRACLOR SUPER X Emmulsifiable. Chemtura USA Corporation Chemtura Corporation (Worldwide HQ) 199 Benson Road Middlebury, CT USA

1. IDENTIFICATION. Tapping and drilling metal. 2. HAZARDS IDENTIFICATION

Material Safety Data Sheet

SAFETY DATA SHEET Synthetic Yellow Iron Oxide (2)

SAFETY DATA SHEET Granufin Iron Oxide

SAFETY DATA SHEET Granufin Iron Oxide

Issue date 30-Oct-2014 Revision date 30-Oct-2014 Version Identification of the Substance/Preparation and of the Company/Undertaking

NARRICOT INDUSTRIES, LP MATERIAL SAFETY DATA SHEET

W2388BASE PLASTIC ERASER COMPOUND

MATERIAL SAFETY DATA SHEET Beta Titanium SECTION 1 IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING

SAFETY DATA SHEET

Material Safety Data Sheet

Issue Date: 09-Feb-2009 Revision Date: 24-Nov-2014 Version 1 1. IDENTIFICATION. Radnor 5" X 8" Alcohol Free Respirator Wipes (100 per box)

Safety Data Sheet 1. PRODUCT IDENTIFICATION

LYMAN PRODUCTS SAFETY DATA SHEET

SONO JELL # 9 PETROLATUM

SAFETY DATA SHEET Yellow iron oxide Laguna Clay Company #MIROXY

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

704 MONOLEC GEAR LUBRICANT

Safety Data Sheet. Issue Date: 15-Apr-2015 Revision Date: 01-Oct-2015 Version 1 1. IDENTIFICATION. Scandia Stabilized Zirconia

Conforms to ANSI Z Standard (United States, Canada, Mexico). Material Safety Data Sheet Black Print Cartridge PN: 24B6018

: Silicone Molding Compounds

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET. 1. Identification of the substance/mixture and of the company/undertaking. Microsphere Orange Yellow Pigment MP-OY5512

Safety Data Sheet. * * *Section 1 - PRODUCT AND COMPANY IDENTIFICATION* * *

6405 MONOLEC R&O COMPRESSOR/TURBINE OIL

1232 ALMATEK GENERAL PURPOSE LUBRICANT

SAFETY DATA SHEET. Electrical insulation and heat conduction.

SAFETY DATA SHEET Iron oxide blend

Material Safety Data Sheet

SAFETY DATA SHEET. SECTION 1: Identification of the substance/mixture and of the company/undertaking

Safety Data Sheet (SDS)

Material Safety Data Sheet

Soluble Concentrate (SC)

SAFETY DATA SHEET. SECTION 1: Identification of the substance/mixture and of the company/undertaking

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET SECTION 1

Material Safety Data Sheet

Material Safety Data Sheet

SODIUM CITRATE Page 1 of 7

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet acc. to ISO/DIS 11014

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET. The components are not hazardous or are below required disclosure limits.

Doped Polycrystalline Silicon - Wafers

Material Safety Data Sheet

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

Issue Date: 02-Jan-2012 Revision Date: 24-Mar-2015 Version 2 1. IDENTIFICATION. Industrial cleaning, blasting and coating removal.

Safety Data Sheet. * * *Section 1 - PRODUCT AND COMPANY IDENTIFICATION* * *

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

Varsity Collection Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET Pump Flush

Material Safety Data Sheet

Clear-flex sdx Polyurethane

MATERIAL SAFETY DATA SHEET CARBON DIOXIDE

Issue Date 01-Jan-2009 Revision Date: 28-May-2015 Version 1 1. IDENTIFICATION. PAG OIL 100 with UV DYE. For Mobile Air Conditioning Systems.

Transcription:

Page: 1 of 6 1. PRODUCT AND COMPANY IDENTIFICATION Product name: Chemical name: Supplier: MAGNESIUM STEARATE NF FG D Magnesium stearate Crompton Corporation 199 Benson Road Middlebury, CT 06749, USA Emergency telephone number: CHEMTREC (24 hours) 800-424-9300 Crompton Corporation Emergency Response (24 hours) 800-292-5898 For MSDS, Product Safety, or regulatory inquiries, call: 866-430-2775 Customer Service: 877-948-2660 2. COMPOSITION / INFORMATION ON INGREDIENTS COMPONENT CAS# CONCENTRATION Magnesium stearate 557-04-0 Stearic acid 57-11-4 < 2.0 % Water 7732-18-5 < 3.0 % 3. HAZARDS IDENTIFICATION EMERGENCY OVERVIEW USUAL HAZARDS ASSOCIATED WITH ORGANIC DUSTS. THE POSSIBILITY OF EXPLOSION EXISTS UNDER DUSTY CONDITIONS. AVOID DUSTING WHEN HANDLING AND AVOID ALL POSSIBLE SOURCES OF IGNITION (SPARK AND FLAME). 4. FIRST AID MEASURES Swallowing No emergency care anticipated. Skin Wash skin with soap and water. Inhalation

Remove to fresh air. Page: 2 of 6 Eye contact Flush eyes thoroughly with water for several minutes. Obtain medical attention if discomfort persists. 5. FIRE-FIGHTING MEASURES Flash point: 176 C (350 F) Special fire fighting procedures Do not direct a solid stream of water or foam into burning molten material; this may cause spattering and spread the fire. Special protective equipment for firefighters Firefighters must be equipped to prevent breathing of vapors or products of combustion. Wear an approved selfcontained breathing apparatus and protective clothing. Extinguishing media Suitable: Extinguish with: - dry chemical - water spray - CO2 - foam 6. ACCIDENTAL RELEASE MEASURES Environmental precautions This product is insoluble in water and will float on the surface. Methods for cleaning up Avoid dispersion of dust. Eliminate sources of ignition. Sweep up and collect in a suitable container for disposal. Sweep up using non-sparking equipment. Observe government regulations. 7. HANDLING AND STORAGE HANDLING Handling precautions Avoid dispersion of dust to reduce fire and explosion potential. STORAGE Storage requirements Store at ambient temperature. Keep drums tightly closed to prevent contamination.

Page: 3 of 6 8. EXPOSURE CONTROLS / PERSONAL PROTECTION PERSONAL PROTECTION Respiratory protection Use NIOSH/MSMA certified dust mask and/or respirator where appropriate. Hand protection / protective gloves Neoprene Eye protection Monogoggles Skin protection Rubber or plastic apron ENGINEERING CONTROLS Ventilation Adequate ventilation to keep dust level below TLV. EXPOSURE LIMITS Component Type Value Remark Particulates not TWA, OSHA 15.0 mg/m3 Total dust otherwise regulated TWA, OSHA 5.0 mg/m3 Respirable fraction TWA - ACGIH 10.0 mg/m3 Total inhalable dust TWA - ACGIH 3.0 mg/m3 Respirable fraction 9. PHYSICAL AND CHEMICAL PROPERTIES APPEARANCE Physical state Color Odor Powder White Slight fatty OTHER PROPERTIES Boiling point Melting point Vapor pressure Vapor density (air=1) Solubility in water Flash point Decomposes 145 C (293 F) at STP unless specified below. Negligible Non Volatile Insoluble 176 C (350 F)

Percent volatiles < 3 %(m) Page: 4 of 6 Method: Cleveland open cup ASTM D 92 10. STABILITY AND REACTIVITY Stability: Stable. Stability - Conditions to avoid Stable under normal conditions. Incompatible materials Strong oxidizing agents. Hazardous combustion products Carbon monoxide. Carbon dioxide. Hazardous polymerization: Will not occur. 11. TOXICOLOGICAL INFORMATION GENERAL No information available. SWALLOWING Low acute toxicity. SKIN ABSORPTION Low acute toxicity. INHALATION Dust may cause irritation of the respiratory tract. SKIN CONTACT May cause slight irritation. EYE CONTACT May cause slight irritation.

12. ECOLOGICAL INFORMATION Not expected to be acutely toxic to aquatic organisms. 13. DISPOSAL CONSIDERATIONS Page: 5 of 6 General: It is our opinion this product is not a RCRA hazardous waste. It is the generator s responsibility to make their own determination as to the RCRA status of waste they generate. We have not performed a Toxicity Characteristic Leachate Procedure (TCLP) on this product. Incinerate in a furnace where permitted under appropriate Federal, State, and local regulations. Non-cleaned packages Subject completely emptied paper bags to paper recycling. 14. TRANSPORT INFORMATION DOT Classification This product is not regulated by DOT. IMDG Classification This product is not regulated by IMDG. ICAO Classification This product is not regulated by ICAO. 15. REGULATORY INFORMATION Comprehensive Environmental Response Compensation and Liability Act of 1980 (CERCLA) requires notification of the National Response Center of release of quantities of hazardous substances equal to or greater than the reportable quantities (RQ s) in 40CFR302.4. **** NONE **** Superfund Amendments and Reauthorization Act of 1986 (SARA) Title III requires emergency planning based on Threshold Planning Quantities (TPQ s) and release reporting based on Reportable Quantities (RQ s) in 40CFR355 (used for SARA 302 and 304). None. Superfund Amendments and Reauthorization Act of 1986 (SARA) Title III requires submission of annual reports of release of toxic chemicals that appear in 40CFR372 (for SARA 313). This information must be included in MSDS s that are copied and distributed for this material. None. Pennsylvania Right-To-Know Hazardous Substance List--Hazardous Substances and Special Hazardous Substances on the list must be identified when present in products. None.

Page: 6 of 6 New Jersey Worker and Community Right-To-Know Act (Labeling Requirements) Chemical name CAS# New Jersey TS Number Magnesium stearate 557-04-0 Stearic acid 57-11-4 Water 7732-18-5 EPA Hazard Categories (SARA 311, 312): None CHEMICAL INVENTORY Canada: This product is on the DSL. Europe: United States: Australia: China: Japan: Korea: Philippines: This product is on the EINECS inventory. 209-150-3 This product is on the TSCA inventory. This product is on the AICS inventory. This product is on the IECSC Inventory. This product is on the ENCS inventory. This product is listed on the Existing Chemicals List (ECL). This product is on the PICCS. 16. OTHER INFORMATION HMIS RATING Health: 0 Flammability: 1 Reactivity: 0 PPI: - LEGEND STP Standard temperature and pressure W/W Weight/Weight 0 (HMIS) Minimal hazard 1 (HMIS) Slight hazard 2 (HMIS) Moderate hazard 3 (HMIS) Serious hazard 4 (HMIS) Severe hazard X (HMIS) Personal protection rating to be supplied by user depending on use conditions Copyright 2003 Crompton Corporation The opinions expressed herein are those of qualified experts within Crompton Corporation. We believe that the information contained herein is current as of the date of this Safety Data Sheet. Since the use of this information and of these opinions and the conditions of use of this product are not within the control of Crompton Corporation, it is the user s obligation to determine the conditions of safe use of the products.