Section. Chemical product and company identification Common name ROYCO 363 MSDS# EH4 MILSPEC# Mil-PRF-787 Material use Lubricant. Supplier/Manufacturer Anderol Inc., 25 Merry Lane, East Hanover, NJ 7936 Tel (973) 887-74 Fax (973) 887-8422 In case of emergency CHEMTREC 8-424-93 () Section 2. Hazards identification Physical state Liquid (Clear.) Emergency overview No specific hazard. USE WITH CARE. Follow good industrial hygiene practice. Routes of entry Skin contact. Eye contact.. Potential acute health effects Eyes Skin Potential chronic health effects Medical conditions aggravated by overexposure See toxicological information (section ) Material Safety Data Sheet ROYCO 363 Slightly irritating to the eyes. Slightly irritating to the skin. No known significant effects or critical hazards. No known significant effects or critical hazards. Carcinogenic effects Classified A4 (Not classifiable for humans or animals.) by ACGIH, 3 (Not classifiable for humans.) by IARC [2,6-Ditert-butyl-p-cresol]. Mutagenic effects Not available. Teratogenic effects Not available. Repeated or prolonged exposure is not known to aggravate any medical condition. Section 3. Composition, Information on Ingredients CAS number % by weight 64742-53-6 7-64742-53-6 7 - Brazil 64742-53-6 7 - Classification UN number IDLH H F R Special Distillates (petroleum), hydrotreated Not regulated. - 64742-53-6 7 - light This material is classified as not hazardous under OSHA regulations in the, the WHMIS in, the NOM-8-STPS-2 in and Brazil NBR 47252. See Chapters 8, and 4 for details. Date of issue 9/3/25 Page /5
Section 4. First aid measures Eye contact Skin contact Notes to physician Section 5. Fire fighting measures Flammability of the product Flash point Products of combustion Fire-fighting media and instructions Special protective equipment for fire-fighters Special remarks on fire hazards Check for and remove any contact lenses. In case of contact, immediately flush skin with plenty of water for at least 2 minutes while removing contaminated clothing and shoes. Get medical attention if irritation occurs. Wash with soap and water. Get medical attention if irritation occurs. If inhaled, remove to fresh air. If not breathing, give artificial respiration. Get medical attention if symptoms appear. Do not induce vomiting. Never give anything by mouth to an unconscious person. Get medical attention if symptoms appear. Not available. May be combustible at high temperature. Open cup 63 C (325 F) (Cleveland.). The final products of combustion are carbon oxides and water. Nitrogen, sulfur and metal oxides may also be produced in some cases. Use an extinguishing agent suitable for the surrounding fire. No specific hazard. Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode. Container explosion may occur under fire conditions or when heated. Cool closed containers exposed to fire with water. Section 6. Accidental release measures Personal precautions Immediately contact emergency personnel. Keep unnecessary personnel away. Use suitable protective equipment. Environmental precautions Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. Methods for cleaning up If emergency personnel are unavailable, contain spilled material. For small spills, add absorbent (soil may be used in the absence of other suitable materials), scoop up material and place in a sealable, liquid-proof container for disposal. For large spills, dike spilled material or otherwise contain material to ensure runoff does not reach a waterway. Place spilled material in an appropriate container for disposal. Section 7. Handling and storage Handling Storage Wash thoroughly after handling. Keep container tightly closed. Keep container in a cool, well-ventilated area. Section 8. Exposure controls, personal protection Engineering controls Personal protection Eye protection Good general ventilation should be sufficient to control airborne levels. Ensure that eyewash stations and safety showers are close to the workstation location. Safety glasses with side shields. Respiratory protection Hand protection. Natural rubber (latex). Date of issue 9/3/25 Page 2/5
Skin protection/body Personal protection in case of a large spill Product name Brazil Consult local authorities for acceptable exposure limits. Safety glasses, goggles or face shield. Impervious gloves. Full suit. Boots. Wear MSHA/NIOSH-approved self-contained breathing apparatus or equivalent and full protective gear. Exposure limits Liquid (Clear.) Yellow (Light.) Petroleum (Strong.).88 (Water = ) TWA 5 mg/m 3 8 hour/hours. TWA 5 mg/m 3 8 hour/hours. TWA 5 mg/m 3 8 hour/hours. TWA 5 mg/m 3 8 hour/hours. Section 9. Physical and chemical properties Physical state Color Odor Specific gravity Section. Stability and reactivity Stability and reactivity Incompatibility with various substances Hazardous polymerization The product is stable. Reactive with oxidizing materials. Will not occur. Section. Toxicological information Acute Effects Eyes Skin Potential chronic health effects Slightly irritating to the eyes. Slightly irritating to the skin. No known significant effects or critical hazards. No known significant effects or critical hazards. Carcinogenic effects Classified A4 (Not classifiable for humans or animals.) by ACGIH, 3 (Not classifiable for humans.) by IARC [2,6-Ditert-butyl-p-cresol]. Mutagenic effects Not available. Teratogenic effects Not available. Date of issue 9/3/25 Page 3/5
Section 2. Ecological information Products of degradation Section 3. Disposal considerations Waste disposal Consult your local or regional authorities. Section 4. Transport information Classification Brazil/ / TDG/ DOT/ IMDG/ IATA Not regulated. Label Additional information The final products of biodegradation are carbon oxides and water. Nitrogen and sulfur oxides and metal salts may also be produced in some cases. The generation of waste should be avoided or minimized wherever possible. Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. Disposal of this product, solutions and any by-products should at all times comply with the requirements of environmental protection and waste disposal legislation and any regional local authority requirements. Section 5. Regulatory information U.S. Federal regulations State regulations WHMIS () Classification TSCA 8(b) inventory All components listed. SARA 32/34/3/32 extremely hazardous substances No products were found. SARA 32/34 emergency planning and notification No products were found. SARA 32/34/3/32 hazardous chemicals No products were found. SARA 3/32 MSDS distribution - chemical inventory - hazard identification No products were found. Clean Water Act (CWA) 37 No products were found. Clean Water Act (CWA) 3 No products were found. Clean Air Act (CAA) 2 accidental release prevention No products were found. Clean Air Act (CAA) 2 regulated flammable substances No products were found. Clean Air Act (CAA) 2 regulated toxic substances No products were found. Pennsylvania RTK 2,6-Ditert-butyl-p-cresol (generic environmental hazard) Massachusetts RTK ; 2,6-Ditertbutyl-p-cresol New Jersey 2,6-Ditert-butyl-p-cresol Not controlled under WHMIS (). DSL All components listed. Flammability Reactivity Special International regulations International lists Australia (NICNAS); CHINA INVENTORY (IECS); JAPAN INVENTORY (ENCS); KOREA INVENTORY (ECL); PHILIPPINE INVENTORY (PICCS) All components listed. Date of issue 9/3/25 Page 4/5
Section 6. Other information Hazardous Material Information System (U.S.A.) National Fire Protection Association (U.S.A.) Fire hazard Reactivity Personal protection B Flammability Instability Special References ANSI Z4., MSDS Standard, 24. - Manufacturer's Material Safety Data Sheet. - 29CFR Part9.2 OSHA MSDS Requirements. - 49CFR Table List of Hazardous Materials, UN#, Proper Shipping Names, PG. - Gazette Part II, Vol. 22, No. 2. Registration SOR/88-64, 3 December 987. Hazardous Products Act "Ingredient Disclosure List" - Canadian Transport of Dangerous Goods, Regulations and Schedules, Clear Language version 22. - Official Mexican Standards NOM-8-STPS-2 and NOM-4-SCT2-994. Brazil NBR 47252. Responsible name Mr. Max Naggar Date of issue Date of previous issue 9/3/25 7/3/25 Version 3. Notice to reader To the best of our knowledge, the information contained herein is accurate. However, neither the above named supplier nor any of its subsidiaries assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist. Date of issue 9/3/25 Page 5/5