SAFETY DATA SHEET Revision Number 1 Product Name 1. Identification Silver Iodide Cat. : S178-100 Synonyms Recommended Use ne Laboratory chemicals. Uses advised against Information available Details of the supplier of the safety data sheet Company Fisher Scientific One Reagent Lane Fair Lawn, NJ 07410 Tel: (201) 796-7100 Emergency Telephone Number CHEMTRECÒ, Inside the USA: 800-424-9300 CHEMTRECÒ, Outside the USA: 001-703-527-3887 2. Hazard(s) identification Classification Classification under 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) Based on available data, the classification criteria are not met Label Elements ne required Hazards not otherwise classified (HNOC) Very toxic to aquatic life with long lasting effects 3. Composition / information on ingredients Component CAS- Weight % Silver iodide (AgI) 7783-96-2 > 98 4. First-aid measures Eye Contact Skin Contact Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Wash off immediately with plenty of water for at least 15 minutes. Page 1 / 6
Inhalation Ingestion Most important symptoms/effects tes to Physician Unsuitable Extinguishing Media Flash Point Method - Move to fresh air. Do not induce vomiting.. Treat symptomatically 5. Fire-fighting measures Autoignition Temperature Explosion Limits Upper Lower Sensitivity to Mechanical Impact Sensitivity to Static Discharge Specific Hazards Arising from the Chemical Keep product and empty container away from heat and sources of ignition. Hazardous Combustion Products ne known Protective Equipment and Precautions for Firefighters As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. NFPA Health 1 Flammability 0 Instability 0 Physical hazards N/A Personal Precautions Environmental Precautions 6. Accidental release measures Ensure adequate ventilation. Use personal protective equipment. See Section 12 for additional ecological information. Avoid release to the environment. Collect spillage. Methods for Containment and Clean. Up Handling Storage Exposure Guidelines 7. Handling and storage Ensure adequate ventilation. Keep containers tightly closed in a dry, cool and well-ventilated place. 8. Exposure controls / personal protection This product does not contain any hazardous materials with occupational exposure limits established by the region specific regulatory bodies. Legend Component ACGIH TLV OSHA PEL NIOSH IDLH Silver iodide (AgI) TWA: 0.01 ppm Component Quebec Mexico OEL (TWA) Ontario TWAEV Silver iodide (AgI) TWA: 0.01 ppm ACGIH - American Conference of Governmental Industrial Hygienists Page 2 / 6
Engineering Measures Ensure adequate ventilation, especially in confined areas. Personal Protective Equipment Eye/face Protection Skin and body protection Respiratory Protection Hygiene Measures Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166. Wear appropriate protective gloves and clothing to prevent skin exposure. Follow the OSHA respirator regulations found in 29 CFR 1910.134 or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. Handle in accordance with good industrial hygiene and safety practice. 9. Physical and chemical properties Physical State Solid Appearance Light yellow Odor Odorless Odor Threshold ph Melting Point/Range 552.2 C / 1026.0 F Boiling Point/Range Flash Point Evaporation Rate negligible Flammability (solid,gas) Flammability or explosive limits Upper Lower Vapor Pressure negligible Vapor Density Relative Density 5.68 @ 30 C Solubility Slightly soluble in water Partition coefficient; n-octanol/water Autoignition Temperature Decomposition Temperature Viscosity Molecular Formula AgI Molecular Weight 234.7727 10. Stability and reactivity Reactive Hazard Stability Conditions to Avoid Incompatible Materials ne known, based on information available Stable under normal conditions. Incompatible products. Strong oxidizing agents Hazardous Decomposition Products ne under normal use conditions Hazardous Polymerization Hazardous Reactions Hazardous polymerization does not occur. ne under normal processing. 11. Toxicological information Page 3 / 6
Acute Toxicity Component Information Toxicologically Synergistic Products Delayed and immediate effects as well as chronic effects from short and long-term exposure Irritation Sensitization Carcinogenicity The table below indicates whether each agency has listed any ingredient as a carcinogen. Component CAS- IARC NTP ACGIH OSHA Mexico Silver iodide (AgI) 7783-96-2 t listed t listed t listed t listed t listed Mutagenic Effects Reproductive Effects Developmental Effects Teratogenicity STOT - single exposure STOT - repeated exposure Aspiration hazard Symptoms / effects,both acute and delayed Endocrine Disruptor Information Other Adverse Effects Ecotoxicity Do not empty into drains. Persistence and Degradability Bioaccumulation/ Accumulation Mobility Waste Disposal Methods DOT TDG IATA IMDG/IMO... ne known ne known The toxicological properties have not been fully investigated. 12. Ecological information.. 13. Disposal considerations Chemical waste generators must determine whether a discarded chemical is classified as a hazardous waste. Chemical waste generators must also consult local, regional, and national hazardous waste regulations to ensure complete and accurate classification. 14. Transport information t regulated t regulated t regulated t regulated 15. Regulatory information International Inventories Component TSCA DSL NDSL EINECS ELINCS NLP PICCS ENCS AICS IECSC KECL Page 4 / 6
Silver iodide (AgI) X X - 232-038-0 - X X X X X Legend: X - Listed E - Indicates a substance that is the subject of a Section 5(e) Consent order under TSCA. F - Indicates a substance that is the subject of a Section 5(f) Rule under TSCA. N - Indicates a polymeric substance containing no free-radical initiator in its inventory name but is considered to cover the designated polymer made with any free-radical initiator regardless of the amount used. P - Indicates a commenced PMN substance R - Indicates a substance that is the subject of a Section 6 risk management rule under TSCA. S - Indicates a substance that is identified in a proposed or final Significant New Use Rule T - Indicates a substance that is the subject of a Section 4 test rule under TSCA. XU - Indicates a substance exempt from reporting under the Inventory Update Rule, i.e. Partial Updating of the TSCA Inventory Data Base Production and Site Reports (40 CFR 710(B). Y1 - Indicates an exempt polymer that has a number-average molecular weight of 1,000 or greater. Y2 - Indicates an exempt polymer that is a polyester and is made only from reactants included in a specified list of low concern reactants that comprises one of the eligibility criteria for the exemption rule. U.S. Federal Regulations TSCA 12(b) SARA 313 Component CAS- Weight % SARA 313 - Threshold Values % Silver iodide (AgI) 7783-96-2 > 98 1.0 SARA 311/312 Hazardous Categorization Acute Health Hazard Chronic Health Hazard Fire Hazard Sudden Release of Pressure Hazard Reactive Hazard Clean Water Act Component CWA - Hazardous CWA - Reportable CWA - Toxic Pollutants CWA - Priority Pollutants Substances Quantities Silver iodide (AgI) - - X - Clean Air Act OSHA Occupational Safety and Health Administration CERCLA California Proposition 65 This product does not contain any Proposition 65 chemicals State Right-to-Know Component Massachusetts New Jersey Pennsylvania Illinois Rhode Island Silver iodide (AgI) - X X - - U.S. Department of Transportation Reportable Quantity (RQ): DOT Marine Pollutant DOT Severe Marine Pollutant N N N U.S. Department of Homeland Security This product does not contain any DHS chemicals. Other International Regulations Page 5 / 6
Mexico - Grade Canada This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations (CPR) and the MSDS contains all the information required by the CPR WHMIS Hazard Class Prepared By n-controlled 16. Other information Regulatory Affairs Thermo Fisher Scientific Email: EMSDS.RA@thermofisher.com Revision Date Print Date Revision Summary 10-Feb-2015 10-Feb-2015 This document has been updated to comply with the US OSHA HazCom 2012 Standard replacing the current legislation under 29 CFR 1910.1200 to align with the Globally Harmonized System of Classification and Labeling of Chemicals (GHS) Disclaimer The information provided on this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guide for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered as a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other material or in any process, unless specified in the text. End of SDS Page 6 / 6