Mineral Processing and Technology International Conference 2017

Transcription

1 IOP Conference Series: Materials Science and Engineering PAPER OPEN ACCESS Mineral Processing and Technology International Conference 2017 To cite this article: 2018 IOP Conf. Ser.: Mater. Sci. Eng View the article online for updates and enhancements. This content was downloaded from IP address on 12/07/2018 at 21:19

2 Preface Mineral Processing and Technology International Conference (mineprocèt) 2017 was a scientific meeting that is technically organized by in conjunction with Indonesian Science Expo (ISE) 2017 organized by Indonesian Institute of Sciences (LIPI). mineprocèt 2017 was held on October, 2017 at Balai Kartini, Jakarta, Indonesia. This symposium aimed to bring together researchers, academicians, and scholars all around the world to share information and their research results. This event was also expected to become a beneficial media in exchanging their innovative ideas and build research collaborations in the future. The symposium covered all scientific and technical activities in mineral processing and technology from basic to the advanced applications to pitch ideas, insight and findings for optimal and sustainable use of sub-economic mineral resources especially those related to mineral beneficiation, extractive metallurgy (bio-hydrometallurgy, pyrometallurgy, electrometallurgy), separation and purification, physical metallurgy and foundry, powder and nano technology, mineral industry application, energy and coal technology, mineral economy and policy, phytoextraction and environmental remediation, control and modelling for mineral processing. We specially invited 4 scientists as keynote speakers from various countries to share their knowledge to all participants. The total participants attending this symposium were 44 persons. This symposium has successfully attracted 39 submitted papers. Papers that have been presented in the mineprocèt 2017 were eligible for publishing in IOP Journal of Material Science and Engineering: Conference Series. The editorial board has decided to accept 33 papers from Indonesia, China, India and South Korea. The accepted papers have passed through strict reviewing process by scientific committee of this symposium. EDAS system has been used to facilitate the submission, reviewing, and revision processes. We would like to appreciate all of our co-organizers, supporting societies, sponsors, and staffs who have contributed generous amount of grants and effort to support us during the symposium. We hope this symposium has successfully enabled us to share and communicate our knowledge and skills and to build collaborations among the participants. We are looking forward to welcoming you in Indonesia again. See you in the next mineprocèt! Dr. Eng. Widi Astuti, ST, MT Editor-in-Chief Content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI. Published under licence by Ltd 1

3 Conference Organizers Scientific Organizing Committee Erik Prasetyo, Ph. D. Conference Chair/Editor Dr. Eng. Widi Astuti, ST, MT Conference Co-chair/Editor-in-Chief Fajar Nurjaman, ST, MT Conference Co-chair/Editor Editorial Board R. B. Cahyono, Chemical Engineering, University of Gadjah Mada D. Fryantoni, Research Unit Mineral Technology, S. Harjanto, Metallurgical Engineering, University of Indonesia T. Hidayat, Pyrometallurgy Innovation Centre, University of Queensland, Australia K. Isnugroho, Research Unit Mineral Technology, T. Kurniawan, Faculty of Machanical Engineering, Universiti Malaysia Pahang L. Mahardiani, Chemistry, University of Sebelas Maret Z. Mubarok, Metallurgical Engineering, Institute of Technology Bandung I. Perdana, Chemical Engineering, University of Gadjah Mada H. T. B. M. Petrus, Chemical Engineering, University of Gadjah Mada A. W. Pramono, Research Center for Metallurgy, A. Prasetya, Chemical Engineering, University of Gadjah Mada F. R. Rahman, UITM- Pulau Pinang, Malaysia I. Santoso, School of Chemical Technology, Aalto University, Finland Y. I. Supriyatna, Research Unit Mineral Technology, H. R. Sudibjo, Chemical Engineering, University of Gadjah Mada Sudibyo, Research Unit Mineral Technology, B. Suharno, Metallurgical Engineering, University of Indonesia S. Sumardi, Research Unit Mineral Technology, I. W. Warmada, Geological Engineering, University of Gadjah Mada Z. Zulhan, Metallurgical Engineering, Institute of Technology Bandung 2

4 Under auspice of Balai Penelitian Teknologi Mineral Lembaga Ilmu Pengetahuan Indonesia Jl. Ir. Sutami km. 15 Tanjung Bintang Lampung Selatan 35361, Indonesia Ph Fax

5 Keynote Speakers Tsuyoshi Hirajima Department of Earth Resource Engineering Kyushu University Prof. Tsuyoshi Hirajima is specialist in mineral processing, powder and recycling technology, which research interest is to promote the development of an advanced mineral processing technology with a special focus on low emission application and resources recycling, highly required in the present century, for a sustainable development of modern societies. Currently, his research group is studying the development of advanced mineral processing technology, resources recycling, waste treatment and utilization, and environmental remediation. He had authored and co-authored more than 200 peer reviewed scientific papers and several books. He is member of Society for Mining, Metallurgy and Exploration, The Japan Institute of Energy, The Mining and Materials Processing Institute of Japan, The Resources Processing Society of Japan, The Society of Powder Technology of Japan, Japan Society of Material Cycles and Waste Management and Energy and Resources Institute of Japan. M. Akbar Rhamdhani Deputy Chair Dept Mechanical Product Design Engineering Swinburne University of Technology Associate Professor M. Akbar Rhamdhani obtained his PhD from McMaster University Canada in Materials Science and Engineering. Akbar's research focuses on advanced metal/material refining and impurities removal, development of new processes for metal production, thermodynamics and kinetics of high temperature metal and chemical processes, and physical chemistry of interface. Akbar's recent research projects include: Thermodynamic behaviour of valuable trace elements during e- waste processing in copper smelting; Oxidation behaviour of rare-earth elements in permanent magnet scrap; Electrically enhanced silicon refining; Impurities control in electronic conductor grade aluminium; Removal of impurities from Titanium ore. Akbar has been a Visiting Professor at Katholieke Universiteit Leuven Belgium and University of Indonesia. He has been working with metals industries in Europe and Indonesia. Akbar is an author/co-author of more than 140 publications. Recently, Akbar has been awarded a number of international award including the 2015 Mann Redmayne Medal by IOM3 United Kingdom, the 2015 Marcus Grossmann Medal by ASM International USA, and the 2015 MetSoc Award by Metallurgical Society of Canada. 4

6 Naoko Okibe Department of Earth Resource Engineering Kyushu University Assoc. Prof. Naoko Okibe specializes in Biohydrometallurgy, Bioremediation, Bioengineering, Environmental Microbiology, which research interest includes bioleaching of waste catalysts, manganese removal from refinery waste waters using Mn(II)- oxidizing bacteria, bioleaching of waste PCBs, nickel laterite and refractory copper sulfides. She had authored and co-authored more than 35 peer reviewed scientific papers. She is currently member of Japan Society for Environmental Biotechnology, The Society for Biotechnology of Japan and The Mining and Materials Processing Institute of Japan. Agustinus R. Uria Faculty of Pharmaceutical Sciences Hokkaido University Dr. rer. nat. Agustinus R. Uria studied Biotechnology at Wageningen University, Netherlands, obtaining MSc degree on February 2004 through the Netherlands Fellowship Programmes (NFP) ( ). Under the scheme of DAAD long-term research grant ( ), he conducted his PhD project with Professor Joern Piel, developing metagenomics approaches to study natural product biosynthesis in uncultured symbiotic bacteria. Upon obtaining his doctoral degree (Dr. rer. nat.) on December 2012 from the University of Bonn, Germany, he moved to Swiss Federal Institute of Technology - ETH Zurich, Switzerland, working as a postdoctoral research associate at Institute of Microbiology from February 2013 to January Some of his research data were published in Nature, Science, Nature Chem Biol and ACS Chem Biol. He is currently a JSPS postdoc research fellow under the scheme of Japan Society for the Promotion of Science at Faculty of Pharmaceutical Sciences, Hokkaido University, Japan. 5